• Bulletin of the Korean Chemical Society
• /
• v.19 no.10
• /
• pp.1095-1099
• /
• 1998

The crystal structure of an acetylene sorption complex of dehydrated fully Mn(Ⅱ)-exchanged zeolite X, Mn46Si100Al92O384·30C2H2 (a=24.705(3) Å) has been determined by single-crystal X-ray diffraction techniques. The structure was solved and refined in the cubic space group Fd3 at 21(l) ℃. The complex was prepared by dehydration at 380 ℃ and 2 x 10-6 Torr for 2 days, followed by exposure to 300 Torr of acetylene gas for 2 h at 24 ℃. The structure was refined to the final error indices, R1=0.060 and R2=0.054 with 383 reflections for which I > 3σ(Ⅰ). In the structure, Mn2+ ions are located at two different crystallographic sites; sixteen Mn2+ ions at site I are located at the centers of the double six rings and thirty Mn2+ ions are found at site Ⅱ in the supercage, respectively. Each of these latter Mn2+ ions is recessed ca. 0.385(2) Å into the supercage from its three-oxygen plane. Thirty acetylene molecules are sorbed per unit cell. Each Mn2+ ion at site Ⅱ lies on a threefold axis in the supercage of the unit cell, close to three equivalent trigonally arranged zeolite framework oxygen atoms (Mn(Ⅱ)-O=2.135(9) Å) and symmetrically to both carbon atoms of a C2H2 molecules. At these latter distances, the Mn(Ⅱ)-C interactions are weak (Mn(Ⅱ)-C=2.70(5) Å), probably resulting from electrostatic attractions between the divalent cations and the polarizable π-electron density of the acetylene molecules.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.20 no.3
• /
• pp.219-223
• /
• 1987

A slightly modified method of Rashid and Potts(1980) to determine riboflavin in milk in which lead acetate was used as a precipitant was employed in tile present study to test applicability to determine that of fish as well. The lead acetate method was found to be sensitive, simple, inexpensive and rapid compared to the modified A.O.A.C. method by Cordon et al. (1979). But higher riboflavin values were obtained in this study than those reported so far. The riboflavin contents of 9 white fleshed fishes were in the range of $0.29\~0.48mg$ per 100g fresh sample. Linear regression equation Y=125.70X+0.71 (R=0.9993) was obtained for the calculation of riboflavin content in the white fleshed fish. Y is the concentration of riboflavin in the final solution to be chocked its OD at fluorometer and X is the dial reading of fluorometer. The stability of riboflavin as the freshness changes during icing storage$(at\;0^{\circ}C)$ was studied with file fish. During the initial stage of storage, the riboflavin content was found to by increased by $14\%$, but the difference was not statistically significant (p>0.05). K-value and VBN-value were increased along with storage time, but Proximate composition was not changed significantly during entire storage of 18 days.

• Transactions of the Korean hydrogen and new energy society
• /
• v.10 no.3
• /
• pp.177-184
• /
• 1999

The charge-discharge characteristics of the $Mg_2Ni-x$ wt.%Nd (x = 0~3) electrodes were investigated. The electrodes were prepared by the mechanical grinding of the induction-melted $Mg_2Ni$ alloy powders with Ni and/or Nd using planetary ball mill apparatus. The discharge capacity of the $Mg_2Ni$ alloy increased with the increase in the nickel content. The electrode possessing 100 wt.% nickel powder showed the initial capacity of 760 mAh/g and the capacity decay with the cycle number was less than that of the 55 wt.% nickel powder. The Nd was added to this composition. It was found that the $Mg_2Ni-100$ wt.%Ni -0.2 wt.%Nd alloy showed an excellent charge-discharge cycle characteristics compared with the other reported Mg-Ni alloy system. The discharge capacity was 400 mAh/g after 70 cycles. Such an improved cycle life seems to be attributed to the improvement in the corrosion characteristics of the alloy. The anodic polarization curve of the $Mg_2Ni-100$ wt.%Ni-0.2 wt.%Nd alloy exhibited better passivating behavior than that of the $Mg_2Ni-100$ wt.%Ni.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11C
• /
• pp.1541-1550
• /
• 2004

In this paper, we propose an advanced hardware architecture for fast multi-resolution motion estimation of the video coding standard MPEG-1,2 and MPEG-4 AVC. We describe the algorithm and derive hardware architecture emphasizing the importance of area for low cost and fast operation by using the shared memory, the special ram architecture, the motion vector for 4 pixel x 4 pixel, the spiral search and so on. The proposed architecture has been verified by ARM-interfaced emulation board using Excalibur Altera FPGA and also by ASIC synthesis using Samsung 0.18 m CMOS cell library. The ASIC synthesis result shows that the proposed hardware can operate at 140 MHz, processing more than 1,100 QCIF video frames or 70 4CIF video frames per second. The hardware is going to be used as a core module when implementing a complete MPEG-4 AVC video encoder ASIC for real-time multimedia application.

• Korean Journal of Food Science and Technology
• /
• v.43 no.6
• /
• pp.689-695
• /
• 2011

1,3-Dioleoyl-2-palmitoylglycerol (OPO)-rich human milk fat substitute (HMFS) was synthesized from tripalmitin (PPP)-rich fraction and oleic ethyl ester by a lipase-catalyzed interesterification. Response surface methodology (RSM) was employed to optimize the presence of palmitic acid at sn-2 position ($Y_1$, %) and of oleic acid at sn-1,3 ($Y_2$, %), with the reaction factors as substrate molar ratio of PPP-rich fraction to oleic ethyl ester ($X_1$, 1:4, 1:5 and 1:6), reaction temperature ($X_2$, 50, 55 and $60^{\circ}C$), and time ($X_3$, 3, 7.5 and 12 h). The optimal conditions for HMFS synthesis were predicted at the reaction combination of $55^{\circ}C$, 3 h and 1:6 substrate ratio. HMFS re-synthesized under the same conditions displayed 70.70% palmitic acid at the sn-2 position and 69.58% oleic acid at the sn-1,3 position. Reaction product was predominantly (90.35%) triacylglycerol (TAG) was observed in which the major TAG species, OPO, comprised 31.24%.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.7
• /
• pp.70-75
• /
• 2014

The experiment was done on traveling at the speed of 20km/h, 60km/h and 100km/h using the performance testing mode for chassis dynamometer. The experimental method were employed to measure the waveform of secondary ignition coil and exhaust emission. In this experiment, the correlation between the secondary waveform coming from ignition coil and exhaust emission were measured in decrepit vehicle. The secondary waveform characterized by the value of effective discharge energy. The following results are obtained by analyzing the data relativity between the effective discharge energy and exhaust emission. The variation rate of effective discharge energy was largest 60km/h, 20km/h, 100km/h velocity in the ordered named. As the vehicle velocity increases, the average variation rate of CO and $NO_X$ decreases and that of HC and $CO_2$ decrease. The value of effective discharge energy, CO, $NO_X$ and fuel consumption is measured badly in case of car with failures in MAP, spark plug and good in case of car with before and after maintenance regardless of vehicle velocities. The value of effective discharge energy is to be nearly parabolic shape as vehicle velocity increases. As the value of effective discharge energy increases, the value of $NO_X$, HC and $CO_2$ decrease, the value of CO increase. The most sensible factors of exhaust emission were CO, $NO_X$, and the small variation factors were HC, $CO_2$.

• Journal of Energy Engineering
• /
• v.25 no.1
• /
• pp.100-107
• /
• 2016

In this study confirmed the reduction effect of pollutant by applying Fi-EGR and FPI-EGR to hybrid combustion system realizing premixed flame and non-premxied flame at once. The results showed that NOx emission index decreased significantly in case of adopting EGR. Additionally, the hybrid combustion system with EGR resulted in a better performance compared to usual non-premixed combustion system such that it can reduce $NO_x$ emission at equivalent EGR ratios. Especially, in the case of 25% of FI-EGR ratio at hybrid combustion system that the ratio of non-premixed and premixed is 50 : 50, NOx emission index reduction rate was about 59% compared to $NO_x$ emission of non-premixed combustion system without EGR and in the case of 15% of FPI-EGR ratio at hybrid combustion system that the ratio of non-premixed and premixed is 70 : 30, $NO_x$ emission index reduction rate was about 48% compared to $NO_x$ emission of hybrid combustion system without EGR.

• Korean Journal of Soil Science and Fertilizer
• /
• v.45 no.6
• /
• pp.943-948
• /
• 2012

This study was conducted to estimate the effect of nitrogen reduction by applying ryegrass and to determine the relationship between yield and nitrate concentration of soil solution for cucumber cultivation in plastic film house. Nitrogen levels with recovery of ryegrass ($42.3Mg\;ha^{-1}$) was 0, 50, 75, 100 % of 199 kg N $ha^{-1}$ as N recommendation by determining soil EC value. Yield and nitrate concentration in soil solution was investigated during cucumber cultivation. Yields of N treatments applied ryegrass showed 64.3, 70.9, 70.3, and $76.5Mg\;ha^{-1}$, respectively, it could reduce about 25-50% of nitrogen application compared to yield ($68Mg\;ha^{-1}$) of NPK plot applied 199 kg N $ha^{-1}$. Nitrate concentration in soil solution was average 26.0, 30.1, 41.4, $58.5mg\;L^{-1}$ during cucumber cultivation and was related between yield and average nitrate concentration of soil solution following as; $Y=49.3+0.63X+0.0034X^2$ ($R^2=0.778^{**}$). However, it needs to conduct extra-experiment due to high variation of nitrate concentration during cultivation periods.

• Korean Journal of Environmental Agriculture
• /
• v.26 no.1
• /
• pp.1-6
• /
• 2007

In view of energy supply, biogas can be seen as alternative fuel by substituting considerable amount of fossil fuel and may be utilized for heat and power production or for transport fuel production ($CH_4-enriched$ biogas). The aim of this research is to analyse the emission of $NO_x$ and CO from biogas fired combustion engine for electric power production. The result indicate a significant effect of biogas composition ($CH_4-CO_2$ ratio) and biogas flow rate on the air pollutants emission. The emission factors from this study were compared with those of U.S. EPA. Low $CH_4-CO_2$ ratio condition typically shows the lower $NO_x$ and CO emission than higher $CH_4-CO_2$ ratio condition. At normal $CH_4-CO_2$ ratio (7:3) emission factors of $NO_x$ and CO were 1.29 and 30.43 g/MMBtu, respectively. At low $CH_4-CO_2$, ratio (6:4) emission factors of $NO_x$ and CO were 0.646 and 60.86 g/MMBtu, respectively, It should be emphasized that the actual emission may vary considerably from these results due to operating conditions including torque load and engine speed.

• Journal of radiological science and technology
• /
• v.18 no.1
• /
• pp.63-70
• /
• 1995

In this pauper, the back, forward, side and $45^{\circ}$ oblique scatter dose were measured the X-ray exposure conditions 60, 80, 100, 120kV, FFD 100cm, FS $20\times20cm$, toward the $25\times25cm\times10\sim20cm$ of solid water, paraffin and MiX-DP phantom, and Pb, Cu, Al, and styrofoam meterials, by the electrometer and 5.3 cc ionization chamber. The obtained results are summarized as following. 1. The percentage depth dose(PDD) at the range of the diagnostic x-ray energy were appeared 50 % depth dose at the 2 cm depth with 60 kV, and 5 cm depth with 120 kV X-ray, 10 % depth dose at the 10 cm depth with 60 kV and 14 cm depth with 120 kV X-ray, 5 % below depth dose at the 20 cm depth. 2. The back scatter dose which were generated the surface of Pb, Cu and Al metal plates were 10 % below, and than the back scatter dose at the Pb plate were a most amount of these which were about 10 %, and were appeared the order of Cu and Al. 3. The percentage forward scatter were appeared from 50 % to 65 %, and the more phantom thicknees become, the more forward scatter were increased with the ratio of 5 % per 5 cm thickness. 4. The percentage back scatter which were generated the tissue equivalence meterials solid water, paraffin and MiX-DP were from 20 % to 40 %, and than the back scatter dose at the solid water were a mest amount of those, and paraffin and MiX-DP were appeared with the next values. 5. The percentage $90^{\circ}$ lateral and $45^{\circ}$ oblique side scatter dose were measured from 4 % to 12 %. a most amount of scatter dose which were generated from the patient in radiography were the forward scatter, the next values were the back scatter, the third values were the $90^{\circ}$ lateral scatter.