• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.12
• /
• pp.1308-1315
• /
• 2009

A full-polarimetric scatterometer(HPS: Hongik Polarimetric Scatterometer) for X-band is designed, fabricated, and verified using the theoretically well-known point-targets in this paper. The X-band full-polarimetric scatterometer consists of an OMT(Orthogonal-Mode Transducer)+horn antenna, the angle control part for the OMT+horn antenna, a transmitter/receiver with a network analyzer and a frequency-conversion circuitry, and a movable support of these parts. We use an inclinometer sensor to control the vertical and horizontal incidence angles. The full polarimetric data can be obtained because of the polarization switches and the OMT. The accuracy of the scatterometer system is verified by measuring the polarimetric RCS(Radar Cross Section) of one of the theoretically well-known point-targets, i.e., a corner reflector.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.5
• /
• pp.853-862
• /
• 2019

In this paper, we designed a 4.5kW X-band SSPA transmitter to replace the TWTA search radar transmitter with low MTBF and high maintenance cost. The transmitter is designed for the performance of over 520W average transmission output and 4.0kW maximum transmission output. In particular, by implementing a graceful degradation, it is designed to maintain better performance than conventional TWTA transmitter up to 40% (13 assembly modules) failure level of 200W power amplifier assembly. Through an experiment on the effective range of X-band, the performance of proposed transmitter verified the values of the maximum transmission output 6.1kW, spurious output 69.16dBc, RF pulse rising time 15.2ns and RF pulse falling time 16.3ns. The experiment confirmed the change of output power according to the graceful degradation due to fault injection.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2004.07a
• /
• pp.331-331
• /
• 2004

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2004.11a
• /
• pp.421-421
• /
• 2004

• Composites Research
• /
• v.35 no.3
• /
• pp.201-215
• /
• 2022

This paper presents the development of thin and lightweight ultra-high temperature radar-absorbing ceramic composites composed of an aluminosilicate ceramic matrix-based geopolymer reinforced ceramic fiber and sendust magnetic nanoparticles in X-band frequency range (8.2~12.4 GHz). The dielectric properties with regard to complex permittivity of ceramic/sendust-aluminosilicate composites were proportional to the size of sendust magnetic nanoparticle with high magnetic characteristic properties as flake shape and its concentrations in the target frequency range. The characteristic microstructures, element composition, phase identification, and thermal stability were examined by SEM, EDS, VSM and TGA, respectively. The fabricated total thicknesses of the proposed single slab ultra-high temperature radar absorber correspond to 1.585 mm, respectively, exhibiting their excellent EM absorption performance. The behavior of ultra-high temperature EM wave absorption properties was verified to the developed free-space measurement system linked with high temperature furnace for X-band from 25℃ to 1,000℃.

• Journal of Advanced Navigation Technology
• /
• v.16 no.6
• /
• pp.893-899
• /
• 2012

In this paper, a simple design method of stepped septum polarizer suitable for X-band satellite communication is proposed. This method is compared to two other conventional design methods in terms of time consumption and complexity of design procedure. In addition, an equivalent circuit modeling is used to analyze and design for the polarizer based on waveguide. For the validity of satisfying the satellite communication, electrical performances have been verified through the simulation and measurement results.

• ETRI Journal
• /
• v.27 no.1
• /
• pp.75-80
• /
• 2005

This paper addresses a fully-integrated low phase noise X-band oscillator fabricated using a carbon-doped InGaP heterojunction bipolar transistor (HBT) GaAs process with a cutoff frequency of 53.2 GHz and maximum oscillation frequency of 70 GHz. The oscillator circuit consists of a negative resistance generating circuit with a base inductor, a resonating emitter circuit with a microstrip line, and a buffering resistive collector circuit with a tuning diode. The oscillator exhibits 4.33 dBm output power and achieves -127.8 dBc/Hz phase noise at 100 kHz away from a 10.39 GHz oscillating frequency, which benchmarks the lowest reported phase noise achieved for a monolithic X-band oscillator. The oscillator draws a 36 mA current from a 6.19 V supply with 47.1 MHz of frequency tuning range using a 4 V change. It occupies a $0.8mm{\times}0.8mm$ die area.

• Korean Journal of Applied Biomechanics
• /
• v.21 no.3
• /
• pp.345-352
• /
• 2011

The purpose of this study was to determine how spandex wear with compressive band affects biomechanical parameters during a golf swing. Nine male golf players, each with at least 6 years golf experienc(handy 4.5${\pm}$5.4), were recruited as the participants. Eight pairs of surface electrodes were attached to the left and right side of the body to monitor the pectoralis major(PM), external abdominal oblique(AO), erector spinae(ES), and vastus lateralis(VL). This study showed that the angular velocity of the club in EG were increased during the down swing phase but X-Factor and X-factor Stretch were reduced. Average and maximum nEMG (normalized EMG) values of the left AO(external abdominal oblique) were less in EG(experimental group) compared with CG(control group) during the back swing, whereas those of left PM(pectoralis major) in EG were greater than CG. It is more likely that EG performed effectively golf swing without excess muscle activity. Thus, the spandex wear with compressive band played an important role in improving swing performance with injury prevention. This has led to suggestions of the need for further kinetic and kinematic analyses to evaluate its function.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.5
• /
• pp.715-722
• /
• 2000

In this paper, the PLDRO is designed and implemented for X-band. It is comprised of tunable high Q resonator with a varactor diode for frequency tuning, loop filter and a 1/8 prescaler which up to 10GHz. Also, it is implemented a TCXO and a VCO signal into the phase detector and achieved a highly stable signal source. From the measurement, the designed PLDRO has the output power of 2.5dBm at 8GHz and phase noise of -64.33dBc at 10KHz offset from carrier. Its characteristic is 26 dBc. This PLDRO has much better temperature stability.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.7 no.2
• /
• pp.71-77
• /
• 1982

This poper proposes the method of the balanced-mixer realization in the X-Band frequency range by the MIC coplanar magic-tee. This magic-tee is composed with microstrip and slot, as suggested by Ronde. The characteristics of balancing and isolation in this magic-tee is more preferable to those of the rat-race or hybrid ring in the wide frequency range. So, experimentally in this paper the characteristics of the MIC balanced-mixed are obtained with the VSWR less than 1, 2(in Local and Signal Arms) and the Conversion Loss, 6 dB in that frequency range, when the mixer is designed in the 3rd order (in E-arm) and 2nd order(in H-arm) Chebyshev matching networks, and with two symmetrical Schottkey Barrier Diodes.