• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.3
• /
• pp.317-321
• /
• 1986

In this paper the design of a new microstrip wide-band microwave discdriminator is presented which is composed of a binary power divider, an open stub and a shorted stub. The microstrip line frequency discriminator is designed at the center frequency of 3.2GHz. Measured discriminating bandwidth is about 20% and return loss is 15dB or more over that frequency range. Experimetal results are in good agreement with the theory.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.2
• /
• pp.213-219
• /
• 2015

In this paper, we present a low-profile ultra-wide band half-wavelength loop antenna for UAV (Unmanned Aerial Vehicle) applications. The proposed antenna has an ultra-wide band using self-complementary principle. Also, the ground was located between radiators for reducing height of the antenna using image theory. Dimensions of proposed antenna have $0.20{\lambda}_L{\times}0.14{\lambda}_L{\times}0.16{\lambda}_L$ (${\lambda}_L$ is the free-space wavelength at lowest frequency). Measured -10 dB bandwidth was ultra-wide band as more than 50 : 1(over 0.3 GHz ~15 GHz). The radiation patterns of the antenna was omnidirectional like monopole antennas. Moreover, we tried the antenna mounted on under a fuselage of a scaled UAV. As a result, the proposed antenna on the UAV maintained ultra-wide band and omnidirectional radiation patterns at all frequencies.

• Journal of electromagnetic engineering and science
• /
• v.10 no.1
• /
• pp.18-24
• /
• 2010

A Ka-band microstrip array antenna for wide-range detection of moving targets is analyzed through a photonicassisted reactive-near-field characterization technique. The antenna array employs a 3-dB-tapered feed network to suppress the sidelobe level while retaining a wide azimuth beamwidth for a wide detection range. The relative nearelectric field patterns of the array and its 3-dB-tapered feed lines have been measured using an electro-optic fieldmapping technique for minimally invasive millimeter-wave sensing. A number of typical limitations on the technique, involving bandwidth, low signal-modulation depth, and high laser-induced noise in high-frequency applications, have been overcome by suppressing the carrier portion of the optical interrogation beam.

• Journal of electromagnetic engineering and science
• /
• v.9 no.3
• /
• pp.164-173
• /
• 2009

In this paper, two new circuit structures for European and U.S. ultra-wide band(UWB) bandpass filters(BPFs) with sharp roll-off characteristics are introduced. We show first that the ultra-wide bandpass property is obtained from a $\lambda$/4 open T resonator with a capacitively coupled $\lambda$/4 short-circuited line, which provides two attenuation poles at lower and upper cutoff frequencies. Then, two identical capacitively coupled input/output lines, which can be $\lambda$/4-length open ends or $\lambda$/2-length short ends, with the T-resonator, are adopted to suppress lower and higher frequency components outside of the pass band. There is coupling between the input and output lines providing two additional transmission zeros in the lower and upper transition bands of the filter. Since the coupling between the T-resonator with the $\lambda$/4 short-circuited line and the input/output lines limits the bandwidth of the filter to the European UWB band, both the $\lambda$/4 short-circuited line and the input/output lines are inserted between the two stacked T-resonators for the U.S. UWB band. The filter structures are simulated with ADS and HFSS and realized with low-temperature co-fired ceramic(LTCC) green tape which has the dielectric constant of 7.8. Measurement results agree well with HFSS simulation results.

• ETRI Journal
• /
• v.37 no.5
• /
• pp.945-950
• /
• 2015

A novel microstrip low-pass filter is presented to achieve an ultra-wide stopband with 11 harmonic suppression and very sharp skirt characteristics. The filter is composed of a modified U-shaped resonator (which creates two fully adjustable transmission zeroes), a T-shaped resonator (which determines a cut-off frequency), and four radial stubs (which provide a wider stopband). The operating mechanism of the filter is investigated based on a proposed equivalent-circuit model, and the role of each section of the proposed filter in creating null points is theoretically discussed in detail. The presented filter with 3 dB cut-off frequency ($f_c=2.35GHz$) has been fabricated and measured. Results show that a relative stopband bandwidth of 164% (referred to as a 22 dB suppression) is obtained while achieving a high figure-of-merit of 15,221.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.4 s.95
• /
• pp.345-350
• /
• 2005

An X-band push-push VCO for low cost applications is proposed. The designed push-push oscillator achieves a wide tuning range in the X-band by the collector bias tuning instead of extra varactor diodes. The measurement shows a wide tuning bandwidth of $900\;\cal{MHz}\;from\;10.9\;\cal{GHz}\;to\;11.8\;\cal{GHz}$ with a drain bias voltage varying from 4 to 9 V, excellent fudamental suppression of $-30\;\cal{dBc}$ and good phase noise of $-115\;\cal{dBc/Hz}\;@\;1\;\cal{MHz}$ offset.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.6
• /
• pp.57-62
• /
• 2008

In this paper, a folded helical monopole antenna for TDMB receiving and a trapezoidal fractal microstrip patch antenna for GPS were designed and fabricated for the vehicle shark antenna. To minimize null which is generating toward antenna axis direction and to receive both vertical polarization and horizontal polarization for TDMB antenna, we fold 90 degree helical monopole element. GPS antenna to get wide bandwidth and gain improvement was designed an air substrate trapezoidal microstrip patch antenna. Fabricated TDMB and GPS antenna were measured for S11 and radiation pattern, and compared with a commercialized antenna. TDMB antenna shows 3 dB higher antenna gain and receiving signal strength than the commercial one. GPS antenna shows the gain of 4.31 dBi at the resonant frequency, which is $3{\sim}5\;dB$ higher gain over whole operating band and 135MHz wide bandwidth at 2:1 VSWR than the conventional ceramic antenna.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.3
• /
• pp.348-351
• /
• 2013

Recently, a brain imaging system with microwave devices has been proposed. The brain imaging system requires a small antenna which has ultra wide band(UWB) operating frequency bandwidth(0.5~2 GHz) and non-varying boresight of antenna over the frequency band. This paper proposes asymmetric corrugations on a tapered slot antenna (TSA) so that the size of the TSA is reduced by 14 % while 10 dB return loss bandwidth is satisfied over the operating frequency band from 0.5 GHz to 2 GHz. A miniaturized TSA with symmetric corrugations shows tilted boresight whilst frequency is getting lower; however, the proposed TSA with asymmetric corrugations maintains direction of boresight for different frequencies. This enhancements make an asymmetric corrugated TSA meet the requirement of the brain imaing system.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.13 no.2
• /
• pp.14-22
• /
• 1976

This research was started to develop a VHF television antenna which secures good pictures in spite of the disturbance from tile rear side. In a year of research, an antenna which front to banck ratio is gyrator than 30dB and whose side lobe level is smaller than -30dB alas been developed. This new antenna was designed log-periodically for the sake of wide frequency bandwidth which is necessary to cover all tile high channel. And it was found having characteristics of anti-interference against the disturbance wave from tole behind, and anti-ghosts from the reflected waves. Furthermore, the gain of this new antenna is reasonablly high, because of its low side lobe level. After all, the developed antenna is silpposcd to increace the service area considervably and to improve the TV receiving certainly.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.9
• /
• pp.57-66
• /
• 2014

This paper presents a low-complexity barrel distortion correction processor for wide-angle cameras. The proposed processor performs the barrel distortion correction jointly with the color demosaicking, so that the hardware complexity can be reduced significantly. In addition, to reduce the required memory bandwidth, an efficient memory interface is proposed by utilizing the spatial locality of the memory access in the correction process. The proposed processor is implemented with 35K logic gates in a $0.11-{\mu}m$ CMOS process and its correction speed is 150 Mpixels/s at the operating frequency of 606MHz, where the supported frame size is $2048{\times}2048$ and the required memory bandwidth is 1 read/cycle.