• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2011.11a
• /
• pp.127-134
• /
• 2011

A genetic algorithm (GA) has been employed to optimize the major design variables of the liquid rocket engine. Pressure of the main combustion chamber, nozzle expansion ratio and O/F ratio have been selected as design variables. The target engine has the open gas generator cycle using the LO2/RP-1 propellant. The gas properties of the combustion chamber have been obtained from CEA2 and the mass has been estimated using reference data. The objective function has been set as multi-objective function with the specific impulse and thrust to weight ratio using the weight method. The result shows about 4% improvement of the specific impulse and 23% increase of the thrust to weight ratio. The Pareto frontier line has been also obtained for various thrust requirements.

• Journal of Environmental Health Sciences
• /
• v.23 no.3
• /
• pp.85-90
• /
• 1997

The objective of this study was to investigate biodegradation of TPA(terephthalic acid) and EG (ethylene glycol), treatment efficiency of polyester weight loss wastewater and microbial characteristics by aerated submerged biolfilm(ASB) p.rocess. In a batch reactor, pH increased from 7.0 to 8. 5 in the biodegradation of TPA. Whereas, in case of EG, decreased from 7.0 to 5.2. COD concentration rapidly decreased within 24hr in the biodegradation of TPA and EG. COD removal velocity constant(k) were 0.065-0.088 hr$^{-1}$. The biodegradation velocity of TPA was 1.4 times faster than that of EG. The ratio of suspended biomass to the total biomass in the reactor was 18.3-33.3%, increased as a high ratio of EG content. Biofilm thickness, biofilm dry density and attached biomass were 346-432 $\mu$m, 41.8-61.9 mg/cm$^3$, 1.45-2.67 mg/cm$^2$, respectively. There values increased as a high ratio of TPA content. In the hydraulic retention time of 36 hr, organic loading rate of 4 kgCOD/m$^3\cdot$ day and packing ratio of 70%, the effluent concentrations of TCOD, SCOD in a continuous flow reator were 1,388 mg/l, 147 mg/l and removal efficiencies were 77%, 97.6%, respectively.

• Carbon letters
• /
• v.13 no.3
• /
• pp.133-138
• /
• 2012

According to kinetic mechanisms, liquid phase polymerization and solid phase polymerization are different in acrylonitrile (AN) polymerization, and so the relationship between the contribution ratio and molecular weight distribution (MWD) was obtained through theoretic analysis. The precipitation homopolymerization of AN was carried out in a mixture solution of dimethyl sulfoxide (DMSO) and water at $50{\sim}65^{\circ}C$ using ${\alpha}$,${\alpha}^{\prime}$-azobisisobutyronitrile as an initiator. The contribution ratio decreased and approached 0; the MWD also decreased and approached 2 with the increase of the $H_2O$/DMSO ratio from 10/90 to 90/10. The experimental data were found to coincide well with the theoretical equation derived from the mechanisms.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.27 no.3
• /
• pp.525-530
• /
• 1998

The effects of godulbaegi(Ixeris sonchifolia H.) powder on body weight gain, lipid and protein concentrations, and enzyme activities were studied in growing male rats for 4 and 8 week. The fats (Sprague-Dawley) were fed diets containing 5% godulbaegi or without. The body weght gain, food efficiency ratio, protein efficiency ratio, hemoglobin concentration and hematocrit value of rats fed godulbaegi diet were similar to the control diet. The ratio of spleen weight to body weight in godulbaegi group for 8 weeks was greater than in that of control group, but they were similar both feeding groups in liver and kidney. The concentrations of the total lipid and triglyceride in serum were increased in rats fed godulbaegi diet for 4 week than in those fed control diet, but those were decreased in rats fed godulbaegi diet for 8 week than in those fed the control diet. The concentrations of the phospholipid, total cholestrol and HDL-cholestrol in serum were decreased in rats fed godulbaegi diet for 8 week than in those fed control diet. The HDL-cholestrol/total cholestrol ratio and athergenic index were similar to both diet groups. There were no differences in growth, serum total protein, albumin concentrations, aspartate aminotransferase and alanine aminotransferase activities between rats fed godulbaegi diet and those fed the control diet.

• Journal of Advanced Marine Engineering and Technology
• /
• v.7 no.2
• /
• pp.15-21
• /
• 1983

Preparing for treatment and management of the emulsified fuel oil which will be generalized henceforth, this paper is an attempt to examine the viscosity-temperature characteristics of emulsified heavy fuel oil which is mixed with water and emulsifier in various mixture ratio by mechanical mixer. The experimental results are summarized as follows: 1. The viscosity-temperature characteristics of the emulsified C & B grade heavy fuel oil mixed with water of same or less weight, is changed according to log.log(v+0.6)=b-3.8log T. 2. The emulsifier has to be added to the emulsified A grade heavy fuel oil mixed with water of same or less weight, because it is instable. Especially if the emulsifier is sodium stearate, it is added more than 0.3% of the weight of oil and water. 3. In the emulsified A grade heavy fuel oil mixed with water and emulsifier, the higher the ratio of water addition becomes, the higher the viscosity is and the more the viscosity-temperature slope decreases. But the higher the ratio of emulsifier addition is, the more the viscosity-temperature slope increases. In this case, the linearity of viscosity-temperature characteristic curve is poorer than that of B and C grade heavy fuel oil. 4. In the emulsified A grade heavy fuel oil mixed with emulsifier of 0.3% or less, the emulsion type is O/W type when water addition ratio is 40%, but it is W/O type when it is 10%, 20%, 30% and 50%.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.2 no.4
• /
• pp.186-193
• /
• 1998

The purpose of this research is to seek properties of flowing light-weight aggregate concrete and possibility of application. The experimental analysis results by using light-weight aggregate and industrial waste such flyash, furnace slag are as follow. 1) The research shows that flowing light-weight aggregate concrete of slump 23~27cm, slump flow 58~69 cm is possible, but material segregation is appeared above slump 26.5cm and slump flow 65 cm. 2) If mixing ratio of flyash is increase, strength deterioration is about 25 % in early age. It showed that effectiveness of long time strength improvement because strength manifestation ratio is above 95% in a long term. 3) This research showed possibility of substitution of blast furnace slag because strength deterioration by using mixing of furnace slag was appeared small deterioration range as below 10 %. 4) Each experimental compressive strength ratios were 77 %(1st week), 86 %(2nd week), 109 %(8th week), 115 %(13th week), 125 % (26th week) on the basis of 28 days. If mixing ratio of flyash is increase, long term strength increase ratio is improved.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.12
• /
• pp.2785-2792
• /
• 2013

An elevator is driven by the friction between the pulley and wire rope. A balancing counter weight is connected to the elevator car with a wire rope. This structure is essential to drive elevators while it always has weight unbalance problems on each side. The overbalance-ratio of elevators may be an important factor for safety and structural efficiency; however, it is not yet clearly defined in the Requirements of Korea Elevator Inspection. This paper describes these "weight unbalance ratio" for control of elevators to reduce the number of accidents. It includes the analysis of current elevator maintenance situations and also proposes some fundamental improvement schemes for safety.

• Biomaterials and Biomechanics in Bioengineering
• /
• v.4 no.1
• /
• pp.9-20
• /
• 2019

Living beings are formed of advanced biological and mechanical systems which exist for millions of years. It is known that various animals and insects right from small ants to huge whales have different weight carrying capacities, which is generally expressed as a ratio of their own bodyweights i.e., Strength to Bodyweight Ratio (SBR). The puzzle is that when a rhinoceros beetle (scientific name: Dynastinae) can carry 850 times its own bodyweight, why a man cannot accomplish the same feat. There are intrinsic biological and mechanical reasons related to their capacities, as per biomechanics. Yet, there are underlining principles of engineering and structural mechanics which tend to solve this puzzle. The paper attempts to give a plausible answer for this puzzle through structural mechanics and experimental modeling techniques. It is based on the fact that smaller an animal or creature, it has larger value of weight lifting by self-weight ratio. The simple example of steel prism model discussed in this paper, show that smaller the physical model size, larger is its SBR value. To normalize this, the basic length of the model need to be considered and when multiplied with SBR, a constant is arrived. Hence, the aim of the research presented is to derive this constant on a pan-living being spectrum through size/scaling effect.

• Fisheries and Aquatic Sciences
• /
• v.26 no.4
• /
• pp.256-267
• /
• 2023

The suitability of any fish species for successful aquaculture requires basic information on its reproduction and growth. This study investigated some facets of the reproductive biology of Synodontis shall (Mochokidae) from River Siluko in Nigeria. Fish samples were collected forth-nightly for a duration of fourteen (14) months-March 2015 to April, 2016 with the assistance of artisanal fishermen. Fishes were identified using taxonomic guides and standard techniques were used for determination of sex ratio, gonad maturation and fecundity. Linear regression method was used to define the correlation between fecundity and fish length, body weight and ovary weight. Results showed that sex ratio did not indicate a significant divergence (p > 0.05) from the 1 male to 1 female distribution ratio (1:1.41). Gonad morphology revealed paired gonads. Testes and ovaries were classified into four maturity stages: immature, resting, ripening and ripe. Gonadosomatic index ranged from 0.04 to 5.68 (males) and 0.03 to 20.19 (females). Absolute fecundity ranged from 1,014 to 4,520 eggs (mean = 2,592 eggs) and did not correlate significantly (p > 0.05) to ovary weight. This study has contributed to existing data on the biology of freshwater fish species in Nigeria and provided valuable information for fishery management tools in the conservation and utilization of this valuable freshwater fish species.

• Journal of Sericultural and Entomological Science
• /
• v.26 no.2
• /
• pp.16-25
• /
• 1984

The sericin fixation of silk fabrics by epoxy resins was studied in the presence of aqueous salt solution in different solvents at the indicated temperature for the desired time. Heavy weight gains were obtained in the reaction with glycerol diglycidyl ether (EX-313) and ethylene glycol diglycidyl ether (EX-810) catalyzed by potassium thiocyanate in such solvents as carbon tetrachloride and p-chloroethylene. The obtained results were summarized as follows; 1) The tested resins were found similar in reaction behavior to silk fabric. The effect of fixation and weight gains was higher in EX-810 than EX-313. 2) The weight gains were increased with reaction time and temperature, and degumming ratio reached a constant value in 90 min at 70$^{\circ}C$. 3) The weight gains and the degumming ratio reached an equilibrium at 3-5% of epoxy concentration. 4) The weight gains were remarkably influenced and increased by the concentration of salt solution. The degumming ratio reached an equilibrium over 0.5N concentration of salt. 5) The weight gains were increased with the dipping time in gently-sloping. The degumming ratio reached an equilibrium over 15 min dipping. 6) The effect of sericin fixation of hydrophobic solvents, such as Carbon Tetrachloride, p-Chloroeth-ylene, Cyclohexane, Xylene and Toluene, was found suitable. 7) The effect of drying temperature was not remarkable on the weight gains and the degumming ratio. 8) There was a slight decrease in the moisture regain of sericin-fixed silk and it may be possible to maintain the moisture regain in the sericin-fixed silk by the epoxy resins. 9) The results on testing physical properties of sericin-fixed silk fabric were as follows; The crease recovery was almost not different from undegummed fabric, but inferior to degummed fabric. The tensile strength was improving in accordance with the effect of sericin fixation, either the elongation did.