• Proceedings of the Korea Water Resources Association Conference
• /
• 2004.05b
• /
• pp.557-562
• /
• 2004

A surface-piercing barrier model is presented for understanding morphological development in the sheltered region and investigating the main factors causing the severe accumulation. Surface-piercing structures like vertical barriers, surface docks and floating breakwaters are recently favored from the point of view of a marine scenario since they do not in general partition the natural sea. The numerical solutions are compared with experimental data on wave profiles and morphological change rates within a rectangular harbor of a constant depth protected by surface-piercing thin breakwaters as a simplified problem. Our numerical study involves several modules: 1) wave dynamics analyzed by a plane-wave approximation, 2) suspended sediment transport combined with sediment erosion-deposition model, and 3) concurrent morphological changes. Scattering waves are solved by using a plane wave method without inclusion of evanescent modes. Evanescent modes are only considered in predicting the reflection ratio against the vertical barrier and energy losses due to vortex shedding from the lower edge of plate are taken into account. A new relationship to relate the near-bed concentration to the depth-mean concentration is presented by analyzing the vertical structure of concentration. The numerical solutions were also compared with experimental data on morphological changes within a rectangular harbor of constant water depth. Through the numerical experiments, the vortex-induced flow appears to be not ignorable in predicting the morphological changes although the immersion depth of a plate is not deep.

• Journal of electromagnetic engineering and science
• /
• v.5 no.2
• /
• pp.87-91
• /
• 2005

This paper presents a Monte-Carlo FDTD technique to determine the scattered field from a perfectly conducting surface like a sea surface, from which the useful information on the incoherent pattern tendency could be observed. A one-dimensional sea surface used to analysis scattering was generated using the Pierson-Moskowitz model. In order to verify the numerical results by this technique, these results are compared with those of the small perturbation method, which show a good match between them. To investigate the incoherent pattern tendency involved, the dependence of the back scattering coefficients on the different wind speed(U) is discussed for the back scattering case.

• Journal of electromagnetic engineering and science
• /
• v.10 no.2
• /
• pp.61-66
• /
• 2010

This paper is concerned with an analysis of the back scattering of electromagnetic waves from a target moving along random rough surfaces such as the desert, and sea. First, the discrete ray tracing method(DRTM) is introduced, and then, this method is applied to the back scattering problem in order to investigate the effect of the back scattering from random rough surfaces on the electric field intensities. Finally, numerical examples of various height deviations of the Gaussian type of rough surfaces are shown. It is numerically demonstrated that the back scattering is dominated by the diffractions related to the reflections from the random rough surfaces.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.30 no.6
• /
• pp.548-557
• /
• 2010

An ultrasonic resonance scattering spectroscopy technique is developed and applied for reconstructing elastic constants of a transversely isotropic cylindrical component. Immersion ultrasonic measurements are performed on tube samples made from a boron/aluminum composite material to obtain resonance frequencies and dispersion curves of different guided wave modes propagating in the tube. Theoretical analysis on the acoustic resonance scattering from a transversely isotropic cylindrical tube is also performed, from which complete backscattering and resonance scattering spectra and theoretical dispersion curves are calculated. A sensitive change of the dispersion curves to the elastic properties of the composite tube is observed for both normal and oblique incidences; this is exploited for a systematic evaluation of damage and elastic constants of the composite tube samples. The elastic constants of two boron/aluminum composite tube samples manufactured under different conditions are reconstructed through an optimization procedure in which the residual between the experimental and theoretical phase velocities (dispersion curves) is minimized.

• Laser Solutions
• /
• v.15 no.4
• /
• pp.6-11
• /
• 2012

Laser beam can be either absorbed or scattered in porous ceramic material and its optical characteristics need to be understood. Electro-magnetic multiphysics software was used to simulate and understand the actual scattering phenomena in porous materials. 785nm femtosecond laser was irradiated on the surface of ceramic material and strong scattering occurred in drilling process. The computer results showed the scattering and absorption phenomena of Aluminum oxide were a mixture of dielectric and metallic material. The computer simulation showed the laser beam was almost extinct at the aspect rate of 5 approximately.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.3
• /
• pp.338-346
• /
• 1998

In-Building communication network is realized by spherical reflector installed on the ceiling and a pair of circularly polarized antennas. Before realizing the system, the scattering characteristics of a spherical conductor is computed and experimented. In this paper, the computational results using vector spherical wave equation and experimental results of the scattering characteristics of a spherical conductor are dicussed. From the results, the omnidirectional scattering level is confirmed and polarity difference over 13 dB is ensured in light region. With the base on omnidirectional scattering pattern of spherical conductor in light region, spherical reflector is effectable in as Wireless In-Building communication network.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.4
• /
• pp.81-86
• /
• 2001

126-kHz bistatic sea surface scattering measurements were conducted in the shallow waters off the east coasts of Korea. The range from source to receiver was altered to change the scattering angle at the grazing angles of 38％ and 52％ . Unlike bottom scattering signal, the arrival time and the amplitude of sea surface scattering signals were varied due to the fluctuation of sea surface. The measured forward scattering strengths were compared to model predictions of Kirchhoff approximation and small slope approximation. In overall, the tendency of the scattering strengths showed reasonable agreement among the experimental data, Kirchhoff approximation, and small slope approximation.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.1
• /
• pp.87-93
• /
• 2002

The previous RST postulates that the scattering field, within each modal partial wave, comprise of the resonance and the background components. The new RST is recently developed by the product expansion of the scattering functions in the field of acoustics. The new formulation suggests that the scattering coefficients consist of resonance, non-resonance, and their interactional portions. In the scattering problems of acoustic waves, the moduli and phase of the resonance coefficient are obtained correctly by the new RST. In our recent works the new RST was successfully applied to the scattering problem of electromagnetic waves for coated conducting cylinder and sphere. In this paper, the new RST is extended to the 2-dimensional scattering problem of electromagnetic waves for a homogeneous dielectric cylinder, and the numerical results are compared with the previous RST.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.12
• /
• pp.2328-2339
• /
• 1992

The propagation of coherent time-harmonic elastic L-and SV-waves is studied in a medium with random distribution of cylindrical inclusions. The purpose of the research is to characterize the dynamic elastic moduli and the attenuation properties of fiber-reinforced composite materials. The cylindes representing the fibers are assumed to be distributed in parallel with each other and the direction of incident waves are normal to the cylinder axes. A multiple scattering formula using the single scattering coefficients in conjunction with the Lax's quasicrystalline approximation is derived from which the dispersion relation for such medium is obtained. In order to formulate the multiple scattering interaction between cylinders, the pair correlation functions are generated by the Monte Carlo simulation technique. From the numerically evaluated complex wavenumbers, the propagation speed of the average wave, the coherent attenuation and the effective elastic moduli are presented as functions of frequency and fiber volume fraction.

• Journal of the Korean Vacuum Society
• /
• v.14 no.3
• /
• pp.143-146
• /
• 2005

A new method of x-ray photon correlation spectroscopy (XPCS) using coherent x-rays is developed recently for probing the dynamics of surface height fluctuations as a function of lateral length scale. This emerging technique applies the principles of dynamic light scattering in the x-ray regime. The short wavelength and slow time scales characteristic of XPCS extend the phase space accessible to scattering studies beyond some restrictions by light and neutron. In this paper, we demonstrate XPCS to study the dynamics of surface fluctuations in thin supported polymer films. We present experimental verification of the theoretical predictions for the wave vector and temperature dependence of the capillary wave relaxation times for the supported polymer films at melt for the film thicknesses thicker than 4 times of the radius of gyration of polymer. We observed a deviation from the conventional capillary wave predictions in thinner films. The analysis will be discussed in terms of surface tension, viscosity and effective interactions with the substrate.