• 생물환경조절학회지
• /
• 제17권4호
• /
• pp.273-282
• /
• 2008

수분 공급을 제한하여 수분 부족 스트레스를 처리한 상추식물에서 산화적 스트레스와 관련된 monodehydroascorbate reductase (MDHAR)의 활성도, 엽록소 함량, 과산화수소의 함량 등과의 상관관계를 조사한 결과, 생육배지의 수분의 함량이 감소함에 따라 식물체내 과산화수소의 생성량이 증가($R^2$=0.8851)하였으며, 수용성단백질 함량은 점차 감소($R^2$=0.9826)하는 경향을 나타내었다. 총 엽록소함량은 수분 부족 스트레스를 처리한 공시작물에서의 함량이 정상 생육시 보다 그 함량이 대체적으로 낮은 경향을 보였으며, 엽록소 a와 엽록소 b함량 변화도 총 엽록소의 함량변화와 비슷한 경향을 보였다. 그러나 총 엽록소에 대한 카로티노이드의 비율은 수분 부족 스트레스를 처리한 식물에서 정상생육 시 보다 더 높은 경향을 보였다. 수분 부족 스트레스가 진행됨에 따라 아스코브산의 함량은 정상 생육 시 보다 더 높은 경향을 보였으나 환원형인 디하이드로아스코브산의 함량은 수분 부족 스트레스를 처리한 초기에 정상생육 시 보다 더 낮은 경향을 보였다. MDHAR의 활성도는 사이토졸(cytosolic) 분획과 엽록체(chloroplastic) 분획에서 공히 크게 증가하였으며 MDHAR의 mRNA 전사 정도도 수분 부족 스트레스가 진행됨에 따라 크게 증가하였다. 수분함량이 감소함에 따라 MDHAR의 활성도가 크게 증가하였으며, 또한 과산화수소의 함량이 증가함에 따라서도 MDHAR의 활성도가 크게 증가($R^2$=0.9937과 0.8645)되어 수분 부족 스트레스로 나타나는 요인들과 MDHAR 사이에 밀접한 관련이 있음을 확인할 수 있었다.

• Journal of Biosystems Engineering
• /
• 제39권1호
• /
• pp.39-46
• /
• 2014

Purpose: Monitoring and control of environmental condition is highly important for optimum control of the conditions, especially in greenhouses and plant factories, and the condition is not uniform within the facility. Objectives of the study were to investigate variability in soil water content and to provide information useful for better irrigation control. Methods: Experiments were conducted in a strawberry-growing greenhouse (greenhouse 1) and a cherry tomato-growing greenhouse (greenhouse 2) in winter. Soil water content, electrical conductivity (EC), and temperature were measured over the entire area, at different distances from an irrigation pump, and on ridge and furrow areas. Results: When measured over the entire greenhouse area, soil water content decreased and temperature and electrical conductivity increased over time from morning to afternoon after irrigation. Water content decreased by distance from the irrigation pump up to 70 m and increased after that, and temperature showed an inverse pattern. Soil water contents on the ridge were lower than those on the furrow, and the differences were 10.2~18.4%, indicating considerable variability. The lowest EC were observed on the furrow and highest values were observed on the ridge. Soil water contents were less and temperature levels were greater at the window side than in the center locations. Conclusions: Selection of number and location of soil water content sensor would be the first step for better water content monitoring and irrigation control. Results of the study would provide basic data useful for optimum sensor location and control for underground greenhouse environment.

• Journal of Biosystems Engineering
• /
• 제33권2호
• /
• pp.115-123
• /
• 2008

This study was conducted to develop an automatic soil water content control system for greenhouse, which consisted of drip irrigation nozzles, soil water content sensors, an on/off valve, a servo-motor assembly and a control program. The control logic adopted in the system was Ziegler-Nichols algorithm and rising time, time constant and over/undershoot ratio as control variables in the system was selected and determined by various control experiments to maintain small delay time and low overshoot. Based on the experimental results, it was concluded that the control system developed in the study could replace the unreliable conventional greenhouse soil water management.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2005년도 추계 학술발표회 제17권2호
• /
• pp.367-370
• /
• 2005

In this study, air meter method and capacitance measurement method to apply economically at quality control of ready-mixed concrete among various unit water content measurement technique was selected. Then, it was evaluated estimating performance of unit water content according to the change of water-binder ratio and unit water content. Also, it was examined influence about error occurrence of unit water content by change of properties of used materials. Finally, based on this study, it was proposed fundamental data to utilize measurement technique of unit water content to quality control. of ready-mixed concrete in construction field.

• The Korean Journal of Ecology
• /
• 제5권2_3호
• /
• pp.123-131
• /
• 1982

The growth and the resistance of Amorpha fructicosa L. under water control was experimented in frames out of doors. The plant grew in a wagner's pot under water control. The soil moisture content was controlled at 5%, 10%, 15% and 20%. The growth of leaf, stem and root in the groups of 5% and 10% soil moisture content were different from values in the groups of 15% and 20%. The T/R ratio in the groups of 5% and 10% soil moisture content were different from the ratio in the groups of 15% and 20% soil moisture content. The T/R ratio of former was lower than the latter, but the C/F ratio of the former was higher than the latter. RGR and NAR of Amorpha fructicosa decreased in 5% and 10% soil moisture content but increased in 15% and 20% soil moisture content during growing period. The maximum values of RGR and NAR were respectively 0.089 and 0.080 at 20% soil moisture content. The highest value of LAR was 1.560 at 5% soil moisture content. RGR and NAR were comparatively affected by soil moisture content.

• 생명과학회지
• /
• 제9권4호
• /
• pp.368-374
• /
• 1999

Three soybean cultivars, Hwangkeum, Tanyeob and Enrei were planted in the same pot under glasshouse conditions to investigate the influence of the different soil water content such as pF 1.4(wet), 2.1(control) and 3.6(dry) on the transpiration rate, dry matter production and water requirement. The transpiration rate remained the high constant rates under the wet soil condition and the control than the dry condition, and showed a linear correlation between transpiration rate and solar radiation under the all condition of soil water. The transpiration rate highly increased in the morning, but dramatically decreased in the other time in a day. The dry matter production was higher under the conditions of wet soil and the control than that under the dry condition. Also, the dry matter production Tanyeob was higher than other cultivars under all soil water content. The water requirement was higher for Enrei and lower Tanyeob than the control.

• 한국생물환경조절학회:학술대회논문집
• /
• 한국생물환경조절학회 2001년도 봄 학술발표논문집
• /
• pp.41-42
• /
• 2001

The objectives of this study were to investigate the effect of the physical properties of wick on the water absorption of substrate. Physical properties of wick in this study were cotton composition, width and length. The water Infiltration rate through the wick was 0.24 ㎝/s at 90 -95% cotton content, which was faster than at 80-85% (0.13 cm/s) and 70-75% (0.08 cm/s). As the cotton content increased, the water absorption of substrate became greater : the amount of absorbed water was about 5-7g higher at 90-95% than at 80-85% and 70-75% at a wick width of 1 ㎝, the velocity of water absorption through the wick was fastest with 0.25 ㎝ㆍs/sup -1/. The amount of absorbed water was higher at 3 ㎝ than at 1 and 2 ㎝. However, the water absorption rate through the cross - sectional area of wick (g H₂O /㎠/hr) was higher at a wick width of 2 ㎝ than at those of 1 and 3 ㎝. The amount of absorbed water in the substrate was higher at 2 : 1 than at 1 : 1 (length in substrate : length out of substrate). Absorbed water amount was larger at 30-40% initial moisture content than any other treatment.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계학술발표회 논문집(I)
• /
• pp.606-609
• /
• 2006

In this study, it was selected that in order to make an investigation into the status of the unit water content control of the ready-mixed concrete plants in the country, Capacitance Measurement Method out of various methods which are able to gauge the amount of unit water content in fresh concrete. Then, it were estimated that the quantity of unit water in fresh concrete and the technical standard of every mixture design of the six ready-mixed concrete plants chosen at random in the country. Finally, based on this study, it was proposed as fundamental data to utilize measurement techniques of the quantity of unit water for the quality control of the ready-mixed concrete in construction field.

• Journal of Information Processing Systems
• /
• 제20권3호
• /
• pp.399-408
• /
• 2024

The moisture content of crude oil notably affects various aspects of oil production, storage, transportation, and exploration. However, accurately measuring this moisture content is challenging because of numerous influencing factors, leading to a lack of precision in existing detection methods. This inadequacy hinders the progress of China's petroleum industry. To overcome these challenges, this paper proposes a conductivity-based method for measuring crude oil moisture content. By employing an embedded system, we designed a sensor comprising five electrodes. Additionally, we developed signal excitation and signal processing circuits. Moreover, a software program was designed to analyze and compute the output signal using fast Fourier transform operations. This facilitated the identification of flow patterns, computation of relevant flow rates, and establishment of correlation rates based on frequency spectral characteristics. Based on experimental results, we established a functional relationship between measurement parameters and crude oil moisture content. This study enhanced the precision of moisture content measurement, thereby addressing existing limitations and fostering the advancement of China's petroleum industry.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2006년도 춘계 학술발표회 논문집
• /
• pp.607-616
• /
• 2006

More strict construction control of railway roadbeds is demanded in high speed railway system because of heavier repeated dynamic loading than conventional railways. The aim of this study is to propose a compaction control methodology of crushed-rock-soil-fills including as large particles as $200\sim300mm$ in diameter, which are easily encountered in high speed railway roadbed. Field tensity evaluation and in turn compaction control of such crushed-rock-soil-fills are almost impossible by conventional methods such as in-situ density measurements or plate loading tests. The proposed method consists of shear wave measurements of compaction specimens in laboratory and in-situ measurements of fills. In other words, compaction control can be carried out by comparing laboratory and field shear wave velocities using as a compaction control parameter. The proposed method was implemented at a soil site in the beginning and will be expanded to crushed-rock-soil-fills in future. One interesting result is that similar relationship of shear wave velocity and water content was obtained as that of density and water content with the maximum value at the optimum moisture content.