• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.41 no.3
• /
• pp.13-21
• /
• 2009

Pulp and paper industry is a typical plant industry which usually consume lots of water and energy. Recently, environmental issues have become more important due to climate changes around the world, and reinforcement in the regulatory content in transfer and management of chemical material and that in environmental regulations for waste water and air. Paper industry is a source material recycle industry which recycle or reuse waste paper, recyclable wood, planned plantation or lumber from thinning and waste wood. Hence it can be said that paper industry is the representative industry for earth environment and of 21th century.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.37 no.1 s.109
• /
• pp.47-52
• /
• 2005

Enzymatic pulping properties of mixed office waste paper in standard disintegrator were investigated for successful enzymatic deinking of mixed office waste paper. Enzymatic pulping need more revolution in standard disintegrator than alkaline pulping and Cellusoft need more revolution than Denimax. The freeness of disintegrated pulp with enzyme was higher than those of disintegrated pulps with alkaline and heat killed enzyme. The freeness of disintegrated pulp with Denimax was higher than that of disintegrated pulp with Cellusoft. The freeness of disintegrated pulps were increased with a dosage of enzymes. The mechanical properties of disintegrated pulp were improved with enzyme addition comparing with heat killed enzyme. The tensile and burst index of hand sheet of disintegrated pulps with acidic Cellusoft were higher than that of others.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.30 no.3
• /
• pp.15-21
• /
• 1998

Crude enzymes of Trichoderma viride and Phanerochaete chrysosporium were evaluated for their effect to brightness and physical properties of recycled pulp from newspaper and corrugated container board. The brightness of recycled pulp from newspaper increased with crude enzymes from Trichoderma viride and Phanerochaete chrysosporium. The brightness of recycled pulp of corrugated container board increased with crude enzyme from Phanerochaete chrysosporium, but decreased with crude enzyme from Trichoderma viride. The Δbrightness with chemical bleaching of crude enzyme treated pulp was lower than that of heat killed enzyme treated pulp, but the final brightness of pulp was increased. Modification of recycled paper with crude enzymes can result in a substantial increase in physical properties with little no loss in pulp freeness.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.37 no.1 s.109
• /
• pp.53-60
• /
• 2005

The mechanical properties of deinked mixed office waste paper in relation to sorts and dosage of enzymes were investigated for successful enzymatic deinking of mixed office waste paper. The increasing of $\Delta$. freeness was most predominant in pulp of Denimax treated pulp. The tensile and burst properties are decreased with enzyme dosage while $\Delta$. freeness were increased. The fine content in disintegrated pulp was decreased with enzyme dosage of $0.4\%$ on the dried weight of paper. The water absorption of handsheets of enzyme deinked pulp was like as that of market roll tissue papers and the mechanical properties of handsheets of enzyme deinked pulp were improved with enzyme treatment comparing of market roll tissue papers.

• Korean Journal of Microbiology
• /
• v.14 no.1
• /
• pp.1-7
• /
• 1976

Effect of some nutrients on the growth of 3 yeast strains in the pulp mill waste liquor was determined during an attempt to lower the BOD content of the waste liquor and to produce the fodder yeast. The strains applied were Debaryomyces castelli Capriotti, D.phoffi Capriotti, and Cryptococcus luteolus (Saito)Skinner. The necessity of the addition of 0.2% ${NH_4}2SO_4$ 0.5% yeast extract, 0.2% $NH_2SO_4$, and 0.1% $MgSO_4$.$7H_2$O for the best growth of all three strains in the waste liquor was ascertained as a result. After 3-day treatment of the yeast cells on the waste liquor, the BOD content was lowered by about 60-70%. Harvested yeast cells contained ca. 75% water with 1.5-3% lipid, 40-46% protein, 50% carbohydrate and 3-5% ash on the dry weight basis, indicating the possibility of being utilized as the fodder yeast.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2008.04a
• /
• pp.222-228
• /
• 2008

The chemical composition and thermal, crystal characterization of oak mushroom waste were investigated in comparison with those normal oak wood for utilization of cellulose from oak mushroom waste. The oak mushroom waste contained a higher percentage of ash, and hot water extractives than oak wood. This results indicated that the materials inside the body are easily decomposed during the oak mushroom cultivation. The lower percentage of holocellulose and a-cellulose of oak mushroom waste caused by fungal decomposition too. Whereas, the thermal decomposition behavior and crystallinity of oak mushroom waste was similar to that of normal oak wood, which indicated that the cellulose characterization of oak mushroom waste is resistant to fungal decomposition. In additionally, a degree of polymerization of oak mushroom waste must be investigate for examination of cellulose crystalline characterization, especially.

• Resources Recycling
• /
• v.15 no.3 s.71
• /
• pp.58-65
• /
• 2006

The applicability of the waste pulp which produced in the paper recycling process as an adsorbent for the treatment of $Ni^{2+}$ ion in wastewater has been investigated taking the initial concentration of adsorbate, temperature, the amount of adsorbent, and solution pH as the experimental variables. In addition, the effect of the concentration of coexisting solute and pre-treatment of adsorbent on the adsorbability of $Ni^{2+}$ ion were also examined. The electrokinetic potential of waste pulp was observed to be positive below pH 7.8 and negative above this pH. The adsorption reaction of $Ni^{2+}$ ion reached its equilibrium within 4 hours after the reaction was initiated and the adsorbed amount of adsorbate was found to increase with its initial concentration. The adsorbability of $Ni^{2+}$ was raised with temperature so that its adsorption reaction was considered to be exothermic, which was substantiated by thermodynamic calculation. Also, the adsorbed amount of $Ni^{2+}$ was raised with the amount of waste pulp and with pH in the range of pH $3{\sim}6$. This behavior of the adsorption of $Ni^{2+}$ according to the solution pH was well agreed with the electrokinetic characteristics of waste pulp in solution. The amount of coexisting solute was observed to reversely affect on the $Ni^{2+}$ adsorption onto waste pulp under the experimental conditions. With regard to the pre-treatment of adsorbent with NaOH, the adsorbability of $Ni^{2+}$ was increased with the concentration of NaOH to a certain extent. However, it was found to decrease contrarily when the concentration of NaOH became too high.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2006.06b
• /
• pp.475-478
• /
• 2006

Environment-friendly shock-absorbing materials were made using a vacuum forming method from waste wood collected from local mountains in Korea. The waste wood was pulped by thermomechanical pulping. The TMP cushions showed superior shock-absorbing properties with lower elastic moduli compared to EPS and pulp mold. Even though the TMP cushions made using different suction times had many free voids in their inner fiber structure, their apparent densities were a little higher than EPS and much lower than pulp mold. The addition of cationic starch improved the elastic modulus of the TMP cushions without increasing the apparent density, which was different from surface sizing with starch. The porosity of the TMP cushions was a little greater than EPS and much less than pulp mold. Finally, the TMP cushions have great potential to endure external impacts occurring during goods distribution.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.38 no.2 s.115
• /
• pp.61-71
• /
• 2006

Environment-friendly shock-absorbing (cushioning) materials were made using a vacuum forming method from waste wood collected from local mountains in Korea. The waste wood was pulped by thermomechanical pulping. The TMP cushions showed superior shock-absorbing properties with lower elastic moduli compared to EPS(Expanded Polystyrene) and pulp mold. Even though the TMP cushions made using at different suction times had many free voids in their inner fiber structures, their apparent densities were a little higher than EPS and much lower than pulp mold. The addition of cationic starch improved elastic modulus of the TMP cushions without increasing the apparent density, which was different from surface sizing with starch. The porosity of the TMP cushions was a little greater than EPS and much less than pulp mold. Finally, the TMP cushions have great potential to endure external impacts occurring during goods distribution.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.39 no.3
• /
• pp.1-11
• /
• 2007

To evaluate the quality of waste paper used for the manufacture of linerboard, the types of papers and foreign materials in compressed waste paper currently used were investigated. The recycled fibers were obtained from printing paper, newspaper, wrapping paper, white coated paperboard and corrugated container. Their fibers were observed by using a microscope, and the mechanical properties of the recycled papers manufactured from the recycled fibers were investigated. The compressed wastepaper was composed of 54% paperboard, 20% printing paper, and 20% newsprint. The content of foreign materials was about 4%, showing higher contents compared to 1% of foreign substances provided by Korea paper manufacturers' association. The types of foreign materials were various, which include vinyls, plastics, metals, woods, styrofoams, and cloths. Sound fibers were generally observed in the recycled fibers of printing papers and wrapping paper. The recycled fibers of white coated board, corrugated container and newsprint showed to be generally damaged. The whiteness of each recycled fiber were highly affected by pulp bleaching and ink-particle mixing conditions. The values of breaking length and burst index were lower than those for corrugating medium and liner board specified in KS. Although the anatomical characteristics of recycled fibers varied, their strengths appeared to be similar. This result may be explained by the use of non-deinked fiber.