• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2008년도 동계학술발표대회 논문집
• /
• pp.125-130
• /
• 2008

The main components of the KSTAR helium refrigeration system (HRS) can be classified into the warm compression system (WCS) and the cryogenic devices according to the operating temperature levels. The WCS itself consists of the compressor station (C/S) and the oil removal system (ORS). The process helium is compressed from 1 bar to 22 bar maximum in the C/S and downstream, the ORS removes the oil mixed in the helium to less than 10 ppbw as per the operation criteria of the cryogenic devices of the KSTAR HRS. After the installation, the pre-commissioning and commissioning activities were started on July, 2007. Before the start-up of the C/S, vibration measurement and the skid reinforcement jobs were performed for stable operation of the C/S. The results of the WCS performance tests met the requirements of the KSTAR HRS but satisfied the vibration level criteria only at the compressors' full load condition.

• 한국항공우주학회지
• /
• 제44권4호
• /
• pp.373-379
• /
• 2016

주기적 단속적으로 작동하는 위성부품의 열제어를 위하여 고상-액상 상변화물질(PCM, Phase Change Material)과 열관을 병렬로 결합한 열제어장치를 제안하였으며, 이의 성능을 수치해석을 통하여 검증하였다. 상변화 중 큰 잠열과 일정하게 유지되는 온도에 의하여 작은 방열판 면적에서도 부품의 최고온도를 제어할 수 있으며, 냉각기에는 PCM에 축적된 에너지가 방출됨으로써 보온히터 소모전력을 절약할 수 있다. 동일한 형태의 Al TBM(Thermal Buffer Mass)을 사용하면 비슷한 효과를 기대할 수 있으나, 질량과 보온히터의 소모전력이 증가하므로 PCM에 비하여 비효율적이다. 설계된 PCM 열제어장치는 발열량과 작동시간에 따라 그 양을 최적화할 수 있다.

• 한국도로학회논문집
• /
• 제20권4호
• /
• pp.1-6
• /
• 2018

PURPOSES : The objective of this study is to evaluate of the effect of thermal segregation reduction in asphalt paving using material transfer vehicles (MTVs). METHODS : Asphalt paving using MTVs was carried out, and the paved surface temperature was measured using an infrared camera. The amount of thermal segregation was estimated from temperature variations. RESULTS : The transportation of hot mix asphalt (HMA) using dump trucks caused temperature segregation that persisted in the paving surface if an MTV was not used. The average temperature variation was 8.58% in paved surfaces where an MTV was not used. However, the temperature variation was 3.10%, 2.86%, and 4.53% for the base layer, inter-layer, and surface layer, respectively, when an MTV was used. CONCLUSIONS : The use of an MTV in asphalt paving reduces thermal segregation approximately 2.3 times in an asphalt mat via a remixing process and also allows for a smoother work process because the paver never needs to stop to receive HMA. However, MTV equipment without pre-heating devices requires careful temperature control during the warm up process at the MTV during construction in the winter.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2007년도 춘계학술대회B
• /
• pp.3317-3322
• /
• 2007

THC(Total Hydrocarbon) emissions during cold start and warm-up phase constitute the majority of THC emissions during the FTP-75 mode. As the basic approach to improve the emission performance of Gasoline engine during transient phase, the effect of spark timing retard from MBT on THC emission characteristics is studied by engine test using a Fast response Flame Ionization Detector(FFID). A cyclic analysis of the combustion process shows that high THC emissions are produced first few cycles during the transient phase. This paper presents the results of engine performance and emission of Gasoline engine with various spark timing. consequently, This paper was focused on the combustion phenomena with various spark timing during transient phase which was analyzed by Fast response Flame Ionization Detector (FFID) equipment to measure the cyclic THC emission characteristics.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2005년도 전력전자학술대회 논문집
• /
• pp.466-468
• /
• 2005

Recently, the demand for the development of high quality and high speed laser printer and efficient power utilizations are required. Among complicate electro-mechanic devices in laser printer, the toner fusing unit consumes above 90[%] of all electrical energy needed for printing devices. Therefore, the development of more effective energy-saving toner fusing process becomes a significant task of much great demand. Generally, there are several way to implement fusing unit, among them this paper present a new hybrid induction heating method. The proposed induction heating method enables to increase coupling coefficient between heating coil and heat roller also to Increase total energy transfer efficiency. Therefore the proposed IH inverter system provide very fast W.U.T.(Warm UP Time), also high efficiency. Through experimental result, the proposed control system is verified.

• Journal of Power Electronics
• /
• 제6권2호
• /
• pp.178-185
• /
• 2006

Recently, the demand for the development of high quality and high-speed laser printers and efficient power utilization has required. Among complicated electro-mechanic devices in laser printers, the toner-fusing unit consumes above 90[%] of all electrical energy needed for printing devices. Therefore, the development of a more effective energy-saving toner fusing process becomes a significant task in great demand. Generally, there are several ways to implement a fusing unit. Among them this paper presents a new induction heating method. The proposed induction heating method enables the increase of coupling coefficient between heating coil and heat roller which also increases total energy transfer efficiency. Therefore, the proposed IH (Induction Heating) inverter system provides very fast W.U.T. (Warm UP Time) as well as higher efficiency. Through experimental results, the proposed control system is verified.

• 한국자동차공학회논문집
• /
• 제8권6호
• /
• pp.87-100
• /
• 2000

HC and CO emissions during the cold start contribute the majority of the total emissions in the legislated driving cycles. Therefore, in order to minimize the cold-start emissions, the fast light-off techniques have been developed and presented in the literature. One of the most encouraging strategies for reducing start-up emissions is to place the light-off catalyst, in addition to the main under-body catalyst, near the engine exhaust manifold. This study numerically consider three-dimensional, unsteady compressible reacting flow in the light-off and under body catalyst to examine the impact of a light-off catalyst on thermal response of the under body catalyst and tail pipe emission. The effect of flow distribution on the temperature distribution and emission performance have also been examined. The present results show that flow distribution has a great influence on the temperature distribution in the monolith at the early stage of warm-up process and the ultimate conversion efficiency of light-off catalyst is severly deteriorated when the space velocity is above $100,000hr^{-1}$.

• 한국수자원학회논문집
• /
• 제49권6호
• /
• pp.459-467
• /
• 2016

홍수범람모의에 주로 활용되는 LISFLOOD-FP 모형은 하도에서 1차원 운동파 방정식을 이용하고, 상대적으로 평평하여 흐름이 확산되는 홍수터에서 단순화된 2차원 확산파 방정식을 이용하여 흐름을 해석한다. 본 연구에서는 분포형 수문모형인 LISFLOOD-FP 모형의 하천홍수위 예측 적용성을 검토하기 위하여 배수영향을 받는 만경강 하류구간에서 기 발생한 홍수사상을 대상으로 모형을 보정하고 검증하였다. 모형의 주요 매개변수인 Manning 조도계수와 하류단 경계조건의 민감도를 분석하였고, 초기조건 영향을 검토하기 위하여 warm-up 유무에 따른 해석결과를 비교하였다. 그 결과, 운동파 모형임에도 불구하고 배수영향을 받는 만경강 하류구간의 홍수위를 비교적 잘 재현하는 것을 확인하였고, 민감도 분석은 실제 홍수사상의 적용 시 여러 가지 매개변수와 경계 조건에 의해 홍수위 값이 상이한 결과를 나타났다. 이러한 결과를 바탕으로 운동파 수문모형의 적용시 홍수위 해석에 대한 충분한 검증 및 검토가 필요하다고 사료되며, 검증된 모형을 바탕으로 다양한 유역의 홍수범람모의에 적용이 된다면 향후 홍수피해 저감을 위한 정책적인 의사결정에 기여할 수 있을 것으로 판단된다.

• 한국실내디자인학회논문집
• /
• 제23권2호
• /
• pp.99-107
• /
• 2014

Façade design makes the customer to select and remember of commercial space. Therefore, if it can be identified characteristics of perception in image evaluation, it will be possible to easy visiting space and re-selection with motivation through identity and differentiation of commercial space. For this study, cafes among commercial facilities were selected for the appreciation of the differentiated design features attracting customer's eyes through space image evaluation by gender. The followings are the conclusions drawn from the study. First, when the features of mean and deviation of [Factor 1] were employed for the appreciation of the perceptual characteristics of both men and women, it was clearly found that customers regards the facade design as a coarse one even though they are confused about whether the facade design is the straightened-up one. Second, customers perceive facade design as the one which is bright but not unique through [Factor 2] while in the process of selecting adjectives to describe it men's perception as to "being vivid but interesting" was dispersed and women's as to "Being bright" was also dispersed, too but the women perceived it as "being opaque". Third, it was revealed that the perceptual characteristics of [Factor 3] were perceived as "warm but boorish" and "warm but crude" by men and women respectively. Fourth, most (80%) of the adjectives employed for vivid description of their perception by both genders were found to be consistent.

• Journal of Veterinary Science
• /
• 제23권1호
• /
• pp.3.1-3.12
• /
• 2022

Background: Domestic yaks are the most important livestock species on the Qinghai-Tibetan Plateau. Adult female yaks normally breed in the warm season (July to September) and enter anestrous in the cold season (November to April). Nevertheless, it is unclear how ovarian activity is regulated at the molecular level. Objectives: The peculiarities of yak reproduction were assessed to explore the molecular mechanism of postpartum anestrus ovaries in yaks after pregnancy and parturition. Methods: Sixty female yaks with calves were observed under natural grazing in Haiyan County, Qinghai Province. Three yak ovaries in pregnancy and postpartum anestrus were collected. RNA sequencing and quantitative proteomics were employed to analyze the pregnancy and postpartum ovaries after hypothermia to identify the genes and proteins related to the postpartum ovarian cycle. Results: The results revealed 841 differentially expressed genes during the postpartum hypoestrus cycle; 347 were up-regulated and 494 genes were down-regulated. Fifty-seven differential proteins were screened: 38 were up-regulated and 19 were down-regulated. The differential genes and proteins were related to the yak reproduction process, rhythm process, progesterone-mediated oocyte maturation, PI3K/AKT signaling pathway, and MAPK signaling pathway categories. Conclusions: Transcriptome and proteomic sequencing approaches were used to investigate postpartum anestrus and pregnancy ovaries in yaks. The results confirmed that BHLHE40, SF1IX1, FBPX1, HSPCA, LHCGR, BMP15, and ET-1R could affect postpartum hypoestrus and control the state of estrus.