• Journal of the Korean Ceramic Society
• /
• v.52 no.1
• /
• pp.66-71
• /
• 2015

$NaY_{1-x}(WO_4)_2:Ho^{3+}/Yb^{3+}$ phosphors with doping concentrations of $Ho^{3+}$ and $Yb^{3+}$ ($x=Ho^{3+}+Yb^{3+}$, $Ho^{3+}=0.05$, 0.1, 0.2, and $Yb^{3+}=0.2$, 0.45) were successfully synthesized via the cyclic microwave-modified sol-gel route; their upconversion properties were investigated. Well-crystallized particles showed a fine and homogeneous morphology with particle sizes of $2-5{\mu}m$. Under excitation at 980 nm, the synthesized particles exhibited yellow emissions based on a strong 550-nm emission band in the green region and a very strong 655-nm emission band in the red region. The Raman spectra of the doped particles indicated the domination of strong peaks at higher and lower frequencies induced by the incorporation of the $Ho^{3+}$ and $Yb^{3+}$ elements into the $Y^{3+}$ sites in the crystal lattice, which resulted in unit cell shrinkage that accompanied a new phase formation of the $WO_{4-x}$ group.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.5
• /
• pp.216-221
• /
• 2006

An investigation of the influence of $WO_3$ and $V_2O_5$ catalysts on the microstructure, phase formation and selective catalytic reduction (SCR) efficiency of the synthesized SCR powders has been carried out. A commercial anatase-$TiO_2$ was used as the catalysts support. For $WO_3(10wt%)/TiO_2$, the W loading to the $TiO_2$ support led to the lower in anatase to rutile transition temperature from $1200^{\circ}C$ of $TiO_2$ support to ${\sim}900^{\circ}C$. The transition temperature was also lowered to below $650^{\circ}C$ in the $V_2O_5$(5 and 10 wt%) added composition. The $WO_3(10wt%)/TiO_2$ SCR powder obtained at $450^{\circ}C$ showed near 100% of $NO_x$ conversion efficiency at $350{\sim}400^{\circ}C$ and for the powder prepared at $650^{\circ}C$ the same efficiency was achieved in wider temperature range $300{\sim}400^{\circ}C$. The highest $NO_x$ conversion efficiency of 100% was obtained in the $V_2O_5(5wt%)/TiO_2$ SCR composition calcined at $650^{\circ}C$ in the relatively wider temperature range $250{\sim}350^{\circ}C$, while the catalytic efficiency considerably decreased for the $V_2O_5(10wt%)/TiO_2$. The lowered conversion efficiency of $NO_x$ observed in the $V_2O_5(10wt%)/TiO_2$ composition calcined at $650^{\circ}C$ was considered to be correlated with the lowered surface area resulting from the increased crystallite growth by highly reactive vanadium loading.

• Korean Journal of Plant Resources
• /
• v.3 no.1
• /
• pp.41-63
• /
• 1990

The plants medicinal resources of Mt. Chu-woL were investigated 21times from APril, 1975 to August , 1977 and from JuLy, 1988 to August 1989In orther to analyze the vegetation of Chu-woL mountain area , medical wildplants structure and distribution. MedicaL wild plants of Chu-woL moun-tain consisted of 113 familis, 428 species in alL. The resources of important herb drugs were Polypodiaceae, Graminea, Liliaceae , Polygonaceae,Ranunculaceae, Brassicaceae, Rosaceae , Fabaceae, Apiaceae, tabiatae, so-lanaceae, Scrophulariaceae, Campanulaceae, Compositae. The herb drugswere comparatively more than in other mountains in our country .

• Journal of Sensor Science and Technology
• /
• v.6 no.1
• /
• pp.24-34
• /
• 1997

In this study, two different types of complementary electrochromic devices using amorphous $WO_{3}$ films as a working electrode, $V_{2}O_{5}$ film and NiO film as counter electrodes respectively were investigated. For the devices using amorphous and crystalline $V_{2}O_{5}$ films of $100{\sim}150nm$ thickness with $ITO/WO_{3}/LiClO_{4}-PC/V_{2}O_{5}/ITO$ structure, an optical modulation of $50{\sim}60%$ were obtained at a potential range of $1{\sim}2V$. It has been shown that transmittance and reflectance of light could be electrically controlled by low applied voltage. For the devices with $ITO/WO_{3}/LiClO_{4}-PC/NiO/ITO$ structure in which NiO film was deposited by a RF reactive sputtering, the optical modulation in visible light region (${\lambda}=550nm$) and in near infrared light region (${\lambda}=850nm$) were 25% and 30%, respectively.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.22 no.2
• /
• pp.253-258
• /
• 2016

The $MnO_x-WO_3-TiO_2$ nanoscale powders were synthesized by sol-gel method in order to prevent the biological fouling on the ships and offshore structures. Powder characteristics and antifouling performance were investigated with respect to the crystalline, microstructure and surface property for application in self-polishing copolymer resins. The high antifouling activity of $TiO_2$-system biocide was attributed to its redox potential and soluble metal ions originating from tungsten oxides according to the improvements in the powder characteristics. Based on their physio-chemical characterizations, the specific surface areas of powders were about $90m^2/g$ and the grain size was in the region 100 ~ 150 nm. Powder characteristics and surface properties were improved by the addition of $WO_3$. Antifouling performance were analyzed according to their surface properties and static immersion tests to determine the effects of the $TiO_2$-system compounds. The surface of 2 wt. % added sample was clean for 5 month. This may be attributed to the ability of $MnO_x-WO_3-TiO_2$ powders to act as a promoter in antifouling agents.

• Journal of Sensor Science and Technology
• /
• v.29 no.1
• /
• pp.14-18
• /
• 2020

This study investigates the nitrogen dioxide (NO₂) sensing characteristics of an Si MOSFET gas sensor with a tungsten trioxide (WO₃) sensing layer deposited using the sputtering method. The Si MOSFET gas sensor consists of a horizontal floating gate (FG) interdigitated with a control gate (CG). The WO₃ sensing layer is deposited on the interdigitated CG-FG of a field effect transistor(FET)-type gas sensor platform. The sensing layer is deposited with different thicknesses of the film ranging from 100 nm to 1 ㎛ by changing the deposition times during the sputtering process. The sensing characteristics of the fabricated gas sensor are measured at different NO₂ concentrations and operating temperatures. The response of the gas sensor increases as the NO₂ concentration and operating temperature increase. However, the gas sensor has an optimal performance at 180℃ considering both response and recovery speed. The response of the gas sensor increases significantly from 24% to 138% as the thickness of the sensing layer increases from 100 nm to 1 ㎛. The sputtered WO₃ film consists of a dense part and a porous part. As reported in previous work, the area of the porous part of the film increases as the thickness of the film increases. This increased porous part promotes the reaction of the sensing layer with the NO₂ gas. Consequently, the response of the gas sensor increases as the thickness of the sputtered WO₃ film increases.

• Clean Technology
• /
• v.17 no.4
• /
• pp.370-378
• /
• 2011

Catalytic activity of $V_2O_5-WO_3/TiO_2$-based SCR catalyst was examined for the oxidation of gas-phase elemental mercury to oxidized mercury. Mercury species was not detected on the commercial SCR catalyst after the oxidation reaction of elemental mercury, regadless of the presence of HCl acting as oxidant and the reaction conditions. This suggests that elemental mercury oxidation by HCl could occur via a Eley-Rideal mechanism with gas phase or weakly-bound mercury on the surface of $V_2O_5-WO_3/TiO_2$ SCR catalyst. The activity for mercury oxidation was significantly increased with the increase of $V_2O_5$ loading, which indicates that $V_2O_5$ is the active site. However, turnover frequency for mercury oxidation was decreased with the increase of $V_2O_5$ loading, indicating the activity for mercury oxidation was strongly dependent on the surface structure of vanadia species. The activity for oxidation of elemental mercury under SCR condition was much less than that under oxidation condition at the same HCl concentration and reaction temperature.

• Korean Journal of Materials Research
• /
• v.26 no.10
• /
• pp.577-582
• /
• 2016

$Dy^{3+}$ and $Eu^{3+}$-codoped $SrWO_4$ phosphor thin films were deposited on sapphire substrates by radio frequency magnetron sputtering by changing the growth and thermal annealing temperatures. The results show that the structural and optical properties of the phosphor thin films depended on the growth and thermal annealing temperatures. All the phosphor thin films, irrespective of the growth or the thermal annealing temperatures, exhibited tetragonal structures with a dominant (112) diffraction peak. The thin films deposited at a growth temperature of $100^{\circ}C$ and a thermal annealing temperature of $650^{\circ}C$ showed average transmittances of 87.5% and 88.4% in the wavelength range of 500-1100 nm and band gap energy values of 4.00 and 4.20 eV, respectively. The excitation spectra of the phosphor thin films showed a broad charge transfer band that peaked at 234 nm, which is in the range of 200-270 nm. The emission spectra under ultraviolet excitation at 234 nm showed an intense emission peak at 572 nm and several weaker bands at 479, 612, 660, and 758 nm. These results suggest that the $SrWO_4$: $Dy^{3+}$, $Eu^{3+}$ thin films can be used as white light emitting materials suitable for applications in display and solid-state lighting.

• Bulletin of the Korean Chemical Society
• /
• v.2 no.2
• /
• pp.37-41
• /
• 1981

The elution behaviors of molybdate and tungstate through anion exchange column have been investigated in the various concentration of hydrochloric and perchloric acid. A discussion is made to evaluate the existing these equilibrium and constant according to acidity. In both acids of 0.01-2.0 M concentration range, the existing equilibrium for molybdate and its constant calculated at $20^{\circ}C$ is $10^{18.9}$ for $Mo_8O_2^{4-} + 20H^+ {\rightleftharpoons} 8MoO_2^{2+} + 10H_2O$. In the 3-3.5 M hydrochloric acid it is 0.16 for $MoO_2Cl_2 + Cl^- {\rightleftharpoons} MoO_2Cl^{3-}$ and for the case of tungstate, in the both acids of 0.01-1.0 M concentration range $10^{6.6}$ for $W_{12}O_{39}^{6-} + 6H^+ {\rightleftharpoons} 12WO_3{\cdot}3H_2O$. In higher concentration than 1.0 M both acids the following equilibrium seems to be existed. $12WO_3{\cdot}3H_2O {\rightleftharpoons} 12WO_3 + 3H_2O$

• Electrical & Electronic Materials
• /
• v.10 no.9
• /
• pp.909-915
• /
• 1997

To improve the electro-induced strain and to decease the hysteresis of that W $O_3$dopant of which amount is 0~0.8wt% was added to (P $b_{0.73}$/B $a_{0.27}$)(Z $r_{0.75}$/ $Ti_{0.25}$) $O_3$+0.1wt% $Y_{2}$/ $O_3$ceramics. At the specimen with 0.4 wt% W $O_3$the electromechanical coupling coefficient( $K_{31}$ ) showed the maximum value of 23.6% at D.C 10 kV/cm electric field. At the same W $O_3$addition amount the piezoelectric constant( $d_{31}$ ) and the electro-induced strain($\Delta$$\ell$/$\ell$)showed the highest values of 182$\times$10$^{-12}$ [C/N] 210$\times$10$^{-6}$ $\Delta$$\ell$/$\ell$at D.C. 10 kV/cm electric field. respectively0 kV/cm electric field. respectivelyvely.