• 한국신재생에너지학회:학술대회논문집
• /
• 2008.05a
• /
• pp.507-510
• /
• 2008

Characteristics of an autothermal reformer at various operating parameters have been studied in this paper. Numerical method has been used, and simulation model has been developed for the analysis. Full Combustion reaction, Steam Reforming(SR) reaction, Water-Gas Shift(WGS) reaction, and Direct Steam Reforming(DSR) reaction are assumed as dominant chemical reactions in the autothermal reformer. Simulation results are compared with experimental results for code validation. Operating parameters of the autothermal reformer are inlet temperature, Oxygen to Carbon Ratio(OCR), Steam to Carbon Ratio(SCR), and Gas Hourly Space Veolcity(GHSV). SR reaction rate decreases with low inlet temperature. If OCR is increased, $H_2$ yield is increased but optimal point is suggested. WGS reaction is activated with high SCR. When GHSV is increased, reforming efficiency is increased but pressure drop may decrease the system efficiency.

• Environmental Engineering Research
• /
• v.13 no.4
• /
• pp.192-196
• /
• 2008

The generation of high purity hydrogen from reformed hydrocarbon fuels, or syngas, is essential for efficient operation of the fuel cell (PEMFC, Polymer Electrolyte Membrane Fuel Cell). Usually, major components of reformed gas are $H_2$, CO, $CO_2$ and $H_2O$. Especially a major component, CO poisons the electrode of fuel cells. The water gas shifter (WGS) that shifts CO to $CO_2$ and simultaneously produces $H_2$, was developed to a two stage catalytic conversion process involving a high temperature shifter (HTS) and a low temperature shifter (LTS). Also, experiments were carried out to reduce the carbon monoxide up to $3{\sim}4%$ in the HTS and lower than 5,000 ppm via the LTS.

• Journal of Korean Society for Geospatial Information Science
• /
• v.2 no.2 s.4
• /
• pp.117-124
• /
• 1994

This paper aims at inspecting the reliability of GPS data, changing WGS 84 data into the longitude coordinates system after surveying a small number of geodetic survey or cadastre triangulation point and supplementry control point around the Kwang-Ju area, and grasping the several problems posed by introducing GPS to the cadastue or the general triangulation surveying from this time.

• Proceedings of the KIEE Conference
• /
• 2007.04a
• /
• pp.249-251
• /
• 2007

The proposed LDS(Link-status Dependent Scheduling) algorithm in HR-WPAN up to now aims at doing only throughput elevation of the whole network, when the crucial DEV(Device) is connected with worst-link relatively, throughput of this DEV becomes aggravation, The proposed the WGS(Worst-case Guaranteed Scheduling) _algorithm in this paper guarantees throughput of the DEV which is connected with worst-link in a certain degree as maintaining throughput of all DEVs identically even if a link-status changes, decreases delay of the whole network more than current LDS algorithm Therefore proposed WGS algorithm in this paper will be useful in case of guaranteeing throughput of a DEV which is connected worst-link in a certain degree in a design of HR-WPAN hereafter.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.31 no.10
• /
• pp.855-859
• /
• 2007

Hydrogen as an energy carrier in fuel cell offers perhaps the largest potential benefits of reduced emissions of pollutants and greenhouse gases. The generation of high-purity hydrogen from hydrocarbon fuels is essential for efficient operation of fuel cell. Reduction of carbon monoxide to an acceptable level of 10ppm involves high temperature and low temperature water gas shift (WGS), followed by selective oxidation of residual carbon monoxide. The WGS reactor was designed and tested in this study to produce hydrogen-rich gas with CO to less than 5000 ppm. In the water gas shift operation, gas emerges from the reformer is taken through a high temperature shift (HTS) catalyst to reduce the CO concentration to about $2{\sim}4%$ followed to about 5000 ppm via a low temperature shift (LTS) catalyst.

• 한국지형공간정보학회:학술대회논문집
• /
• 1994.04a
• /
• pp.14-30
• /
• 1994

Before GPS is practically used in Kores, we must fix a problem on the coordinate transfomation between WGS 84 and Korean geodetic system based on Bessel ellipsoid. On this article, I investigate various coordinate trans formation methods and review the researched results about the coordinate transformation which have been performed in Korea. With the inspection of which method is more applicable to Korea, I discuss about the future prospect and the fixing way for the problem of domestic coordinate transfomation.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.12 no.1
• /
• pp.69-76
• /
• 1994

In this paper, the characteristics of coordinate transformation between the WGS84 and the Bessel ellipsoids according to the assumed values of the geoidal height on Bessel ellipsoid at the geodetic datum origin of Korea were investigated. For this, based on GPS data of 11 control points in Chungnam and Chungbuk province, the mean shift values between ellipsoids were calculated in each case. The geoidal heights on the Bessel ellipsoid were modelled in the area and the coordinate transformation coefficients were derived, and then the accuracy of the transformed coordinates according to fluctuations in geoidal heights were studied.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.1 no.2
• /
• pp.39-52
• /
• 1995

There are numerous mapping, charting, geodetic systems and electronic digital products defined in various local geodetic datum. It becomes a straight forward requirement to simplify the complexity by referencing all the products to a common reference globally. WGS-84 is well known as a state-of-the-art global reference system based on the use of data, techniques and technology available within American Defence Mapping Agency(DMA). Its parameters can be translated into more accurate maps, charts and geodetic positioning compared to others previously. Since Global Positioning System(GPS/NAVSTAR), which is asssociated with World Geodetic System(WGS-84)in reference frame, has been widely used, the unified geodetic system has been required for GPS users in many fields.

• Environmental Engineering Research
• /
• v.23 no.3
• /
• pp.339-344
• /
• 2018

The Cu loading of a cubic $Ce_{0.8}Zr_{0.2}O_2$-supported Cu catalyst was optimized for a single-stage water gas shift (WGS) reaction. The catalyst was prepared by a co-precipitation method, and the WGS reaction was performed at a gas hourly space velocity of $150,494h^{-1}$. The results revealed that an 80 wt% $Cu-Ce_{0.8}Zr_{0.2}O_2$ catalyst exhibits excellent catalytic performance and 100% $CO_2$ selectivity ($X_{CO}=27%$ at $240^{\circ}C$ for 100 h). The high activity of 80 wt% $Cu-Ce_{0.8}Zr_{0.2}O_2$ catalyst is attributed to the presence of abundant surface Cu atoms and the low activation energy of the resultant process.

• Genomics & Informatics
• /
• v.20 no.1
• /
• pp.3.1-3.10
• /
• 2022

The recent development of whole-genome sequencing technologies paved the way for understanding the genomes of microorganisms. Every whole-genome sequencing (WGS) project requires a considerable cost and a massive effort to address the questions at hand. The final step of WGS is data analysis. The analysis of whole-genome sequence is dependent on highly sophisticated bioinformatics tools that the research personal have to buy. However, many laboratories and research institutions do not have the bioinformatics capabilities to analyze the genomic data and therefore, are unable to take maximum advantage of whole-genome sequencing. In this aspect, this study provides a guide for research personals on a set of bioinformatics tools available online that can be used to analyze whole-genome sequence data of bacterial genomes. The web interfaces described here have many advantages and, in most cases exempting the need for costly analysis tools and intensive computing resources.