• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2019.05a
• /
• pp.168-169
• /
• 2019

This study examined the effect of foam volume ratio and curing temperature the air dry density and compressive strength of lightweight concrete using bottom ash. Test results showed that the lightweight concrete possessed the compressive strength of 3.4~22.7 MPa at the air dry density of 1,041~1,583 kg/m3.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.8 no.4
• /
• pp.83-89
• /
• 2009

This study investigates two-phase cooling system of close-loop by using FC-72 and PCM(Phase change material). The cooling system consists of evaporator, cold plate, micro pump, and condenser. The heat input on the performance of evaporator is appreciated by visualizing the boiling on the evaporator. The heat performance of cooling system is investigated to determine the effects of volume fill ratio change at working fluid, pump flow rate change, and volume fill ratio change at PCM in cold plate. Experimental results show the ideal condition when the volume ratio of working fluid, the pump flowing, and the volume ratio of PCM are 60%, 6ml/min, and 60% respectively.

• Journal of ILASS-Korea
• /
• v.23 no.2
• /
• pp.90-95
• /
• 2018

The goal of this study is to experimentally observe the autoignition phenomena of a diesel/1-butanol mixture droplet in ambient pressure and $700^{\circ}C$ condition. A volume ratio of 1-butanol in the fuel was set to 25, 50 and 75%. A single droplet was installed at the tip of fine thermocouple, and the electric furnace dropped down to make elevated temperature condition. Droplet behavior during the experiment could be divided into 3 stages including droplet heating, puffing and autoignition/combustion. Puffing process intensively observed for the case of 1-butanol volume ratio of 25 and 50%, but did not occur at 75%. Increase of 1-butanol volume ratio hindered rise of the droplet temperature and delayed ignition. In addition, puffing process also affected on autoignition, so the ignition delay of 1-butanol volume ratio of 50% was became longer than that of 75% case.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2005.05b
• /
• pp.333-336
• /
• 2005

This paper presents a comparative evaluation of eight different types of steel fibers used as reinforcing material in concrete beams. The fibers which used ultra-strength steel fiber reinforced concrete were fiber length of 30 to 60mm, aspect ratio of 43 to 86, W/B ratio 0.16 to 0.30, fiber types of both ends hooked and straight shape and fiber volume fraction of 1 to 5$\%$. As for the test results, it estimated the influence of fiber volume, length and aspect ratio on the mechanical properties of high toughness concrete, the mechanical properties improved according to increase fiber volume, to increase aspect ratio and to long fiber length. And the resonable fiber volume in high toughness concrete was analyzed 2$\%$ based on the results of mechanical properties.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2020.06a
• /
• pp.183-184
• /
• 2020

This study evaluated the effect of foam volume ratio on shear friction behavior of bottom ash based lightweight aggregate concrete (LWA_BA). The LWA_BA with different foam volume ratio ranged between 8 and 25 MPa for compressive strength(f_ck), 17.3~62.5 kN for shear capacity at first shear crack(V_cr), 31.1~73.8 kN for shear friction capacity(V_n), and 0.01~0.03 mm for slip at maximum peak load(S₀). f_ck decreased with increase in the foam volume ratio, showing that this trend was also observed in V_cr, V_n, and S₀.

• The korean journal of orthodontics
• /
• v.23 no.2 s.41
• /
• pp.275-282
• /
• 1993

When mandibular prognathic patients are operated orthognathic surgery which reduce the oral cavity volume, tongue volume should be harmonized with oral cavity volume to be changed because prevent the relapse of malocclusion. To decide the need for tongue resection, the author measured the tongue volume and oral cavity volume with stone model which were taken by impression method and study the difference between the ratio of tongue and oral cavity volume in mandibular prognathic group and normal group. The samples were consisted of four groups, the 40 subjects of the control group, 40 subjects of the experimental group. Each group was subdivided into male and female group respectively. The results were as follows : 1. The tongue volume and oral cavity volume measurements are $20.7cm^3,\;32.7cm^3$ in the control group respectively, and $24.9cm^3,\;42.9cm^3$ in the experimental group respectively. 2. There is no difference in the ratio of the tongue volume to oral cavity volume in control group and experimental group. 3. Correlation coefficients between the tongue volume and oral cavity volume are 0.11, 0.29 in experimental group and control group respectively, and 0.43 in gross total group. 4. The tongue volume of male is larger than female(p<0.05).

• 한국연소학회:학술대회논문집
• /
• 2000.12a
• /
• pp.212-216
• /
• 2000

Combustion phenomenon in scale-downed combustor is investigated. As the combustor volume decreases surface to volume ratio increases. for increased surface to volume ratio means increased heat loss and this increased heat loss affects reaction in combustion chamber. Plastic mini combustor is made. Stoichiometricaly premixed Hydrogen I air gas is used as fuel. Initial chamber pressure and chamber size are varied and the effects are evaluated. Peak pressure decreases with the decrease in chamber height. As initial chamber pressure decreases peak pressure decreases. And this change is more important than scale down effect till the chamber height of 1mm. With this result and further information following the experiments design parameter for micro engine can be established.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2002.05a
• /
• pp.187-190
• /
• 2002

To study adiabatic shear band formation of tungsten heavy alloys, 5 prismatic specimens are loaded by high velocity impacts and treated as plane strain problems. Their volume percent of tungsten particles in WHA are 81%, 93% and 97% respectively and for the fixed 81% volume percent, small size particle model, large size particle model, undulated particle models are considered and then, the effects of particle's volume ratio, geometry and size to the formation of shear band are discussed.

• Journal of Environmental Health Sciences
• /
• v.29 no.3
• /
• pp.28-34
• /
• 2003

This study was performed to compare the effects of chaff and sawdust as bulking materials on temperature, pH, weight and volume reduction and salinity in aerobic composting of food wastes. Volume ratios of food wastes to chaff in reactor of Control, Ch-l, Ch-2, Ch-3 and Ch-4 were 4:0, 4:1, 4:2, 4:3 and 4:4, respectively. Volume ratios of food wastes to sawdust in reactor of Control, Sd-l, Sd-2, Sd-3 and Sd-4 were 4:0, 4:1, 4:2, 4:3 and 4:4, respectively. Reactors were operated for 24 days with 1 hour stirring by 1 rpm and 2 hours aeration per day. The lowering of the volume ratio of food wastes to chaff and sawdust resulted in the reaction at higher reaction temperature and the elongation of the high temperature reaction period. The lowering of the volume ratio of food wastes to chaff and sawdust resulted in faster pH increase. In the volume ratio of 4:3 and 4:4, pH increased faster in food-chaff mixtures than in food-sawdust mixtures. The lowering of the volume ratio of food wastes to chaff and sawdust resulted in faster steady state in the weight reduction rate and the volume reduction rate. The weight reduction rates of chaff mixtures were higher than those of sawdust mixtures, but the volume reduction rates of sawdust mixtures were more higher than those of chaff mixtures. Salinity increased as composting reaction proceeded, due to reduction in mass weight. The final salinity of Control was 2.79%, and the final range of salinities of chaff and sawdust mixtures were 2.18∼2.37% and 1.86∼2.05%, respectively.

• Clinical and Experimental Reproductive Medicine
• /
• v.41 no.2
• /
• pp.86-91
• /
• 2014

Objective: The aim of the present study was to investigate the relationship between ovarian follicle count and volume on ultrasonography and serum hormone levels including the levels of the anti-$M\ddot{u}llerian$ hormone (AMH) and gonadotropin in women with the polycystic ovary syndrome (PCOS). Methods: A total of 118 Korean women aged 18-35 years who were newly diagnosed with PCOS at a university hospital were included in this study. Serum LH, FSH, and AMH levels were measured in the early follicular phase, and the total antral follicle count (TFC) and the total ovarian volume (TOV) were assessed by ultrasonography. The correlations between serum hormonal parameters and ultrasonography characteristics in women with PCOS were evaluated using Pearson's correlation coefficients and a linear regression analysis. Results: Serum AMH levels were significantly correlated with serum LH levels and LH/FSH ratios, and TFC and TOV were significantly correlated with each other on ultrasonography. Serum AMH and LH levels and the LH/FSH ratio were significantly correlated with TFC. Statistically significant correlations between TOV and the LH level (r=0.208, p=0.024) and the LH/FSH ratio (r=0.237, p=0.010) were observed. However, the serum AMH level was not significantly correlated with the ovarian volume, and this result did not change after adjusting for age and body mass index. Conclusion: Serum AMH is not related to the ovarian volume in women with PCOS. My results suggest that serum LH level and the LH/FSH ratio may be more useful than the serum AMH level for representing the status of the ovarian volume in women with PCOS.