• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.05a
• /
• pp.677-680
• /
• 2015

In this paper, we propsed scheme to mitigate conflict and loss of message in vehicle communication. And vehicles that exist in the moving direction, were grouping to the cluster form. Through, to select best relay vehicle, transmit a message to the destination. In addition, we applied the double rayleigh fading environment so that can applied in real-environments. Therefore, vehicle communication network applied proposed scheme, can be problem of mitigate conflict and loss of message. Thus, Increase the reliability of the received signal.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.11 no.1
• /
• pp.53-65
• /
• 2012

Recently wireless intra-vehicle communication has received a great interest from the automotive industry and ultra wideband (UWB) technology is considered as one of the potential candidate for this system. Many research works have been done on the measurement and modeling of intra-vehicle communication channel. However, very little work has been reported for the performance analysis of various PHY layer methods under the intra-vehicle communication environment. This paper is to study IEEE 802.15.4a standard in intra-vehicle channel and to evaluate its performance. Channel model in chassis and engine compartment is considered for evaluation. Through simulation BER performance of system with different receiver structures is analyzed.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.21 no.10
• /
• pp.951-959
• /
• 2011

In this study, an OTM(on-the-move) antenna which is mounted on ground vehicles and is used for mobile communication between vehicle and satellite while moving was addressed. Since LOS(line-of-sight) of antenna should direct satellite consistently while vehicle moving to guarantee high satellite communication quality, active antenna LOS stabilization is a core technology for OTM antenna. Stabilization of a satellite tracking antenna which consists of 2-DOF gimbals, an elevation gimbal over an azimuth gimbal, was considered in this study. In consideration of driving mechanism which consists of gear train and flexible driving shafts, a two-mass-system dynamic model coupled with vehicle motion was presented. An internal PI-control loop + outer PI-control loop structure has been suggested in order to damp the torsional vibration and stabilize control system. The classical pole-placement method was applied to design control gains. In addition, a vehicle motion compensation control beside of the feedback control loop has been suggested to improve LOS stabilization performances. The feasibility of the proposed control design was verified along with some experimental results.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.10
• /
• pp.2136-2142
• /
• 2011

Smart Device Communications using the development of anti-theft system for vehicles have been investigated. because Progress of Smart Device If someone get the Key for Vehicle theft, he can be easily stolen vehicle. We thought about the concept of dual security devices. Using vehicle's identifier ID of CAN, when Comparing Smat phone identifier ID value and identifier ID received from the Can in the Head, If the same ID is compared. At this point after the activity of the vehicle's ACC On/Off the system allows the vehicle's ignition.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.10a
• /
• pp.120-123
• /
• 2009

The WiBro to start June 2006 is mobile internet service with 60km/h, 3Mbps. And current WiBro service is used in Seoul, the metropolitan area and the local major cities. This study suggests WiBro technology and analyzes wireless communication technology to vehicle-to-infrastructure communications for the unmanned vehicle control. We were driving vehicle with two laptop computer's WiBro unit for V2I communication environment. So each RAS(Radio Access Station) on center is tested coverage area, transmission rate, latency rate, lost rate and transmission rate to parking area environment.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.3
• /
• pp.433-438
• /
• 2013

Interference reduction method of vehicle collision avoidance sensor which is used for the low speed electric vehicle has been investigated. Various methods were attempted for the vehicle collision avoidance distance sensor, which received a transmitted signal from a front driving vehicle to measure the distance between two vehicles, to avoid interference by the own transmitter signal toward the rear following vehicle. In this study, -12dB of interference cancellation ratio was realized by using the phase cancellation method to the transmitted signal from the own vehicle. Proposed phase cancellation method is regarded to have the advantage of continuous monitoring in comparison to the conventional time sharing transmitting and receiving method.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.23 no.2
• /
• pp.1-14
• /
• 2005

Generally, printing inks are composed of pigment, vehicle and additive. Among others, the vehicle transfers the pigment to substrate and then binds it on the surface. So, rheological properties of the vehicle are an important factor which has influence on printability. Thus, in this study, rheology of the vehicle was investigated by using rotational rheometer according to molecular weight of resin. Also, emlusion rheology of water in oil type and its microstructure were examined with increasing the shear rate. Consequently, the following results were obtained: (1) By viscometric flow test, zero shear viscosity and shear thinning index of vehicle increased with increasing the molecular weight of resin. (2) By relaxation and creep test, relaxation time and retardation time of vehicle increased with increasing the molecular weight of resin. (3) By frequency sweep test, crossover point of vehicle increased with increasing the molecular weight of resin. (4) G' and G" of emlusions increased with increasing the molecular weight by amplitude sweep test. (5) The shape of water drop in emlusions was changed to the capillary tube.

• Journal of Auto-vehicle Safety Association
• /
• v.12 no.1
• /
• pp.15-25
• /
• 2020

This paper presents a longitudinal control algorithm for ensuring takeover time of autonomous vehicle using V2V communication. In the autonomous driving of more than level 3, autonomous systems should control the vehicles by itself partially. However if the driver's intervention is required for functional safety, the driver should take over the control reasonably. Autonomous driving system has to be designed so that drivers can take over the control from autonomous vehicle reasonably for driving safety. In this study, control algorithm considering takeover time has been developed based on computation method of takeover time. Takeover time is analysed by conditions of longitudinal velocity of preceding vehicle in time-velocity plane. In addition, desired clearance is derived based on takeover time. The performance evaluation of the proposed algorithm in this study was conducted using 3D vehicle model with actual driving data in Matlab/Simulink environment. The results of the performance evaluation show that the longitudinal control algorithm can control while securing takeover time reasonably.

• Journal of Korea Society of Industrial Information Systems
• /
• v.14 no.2
• /
• pp.51-58
• /
• 2009

In this paper, a system which uses Bluetooth and Zigbee wireless communication and mobile device is designed. The temperature within vehicle and the distance betweeen the vehicle and the obstacle is measured by ultrasonic sensor system. The measured data is sent to the mobile PDA and displayed to assist safe driving.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.3
• /
• pp.149-153
• /
• 2012

We propose a traffic information service for which traffic data are collected over ad-hoc networks from neighbor vehicles, processed to minimize the data size, and eventually provided to its destination. The proposed scheme simply relies on the existing navigtion systems in vehicles and wireless communication devices for vehicle-to-vehicle communication, rather than on a separately established server. It allows collecting and analyzing traffic status of large areas without incorporating separated monitoring systems, e.g., probe cars and enables to provide accurate traffic information to drivers in timely manner. We also evaluate its performance by ns-3 simulation.