• Fashion & Textile Research Journal
• /
• v.10 no.5
• /
• pp.668-675
• /
• 2008

The purpose of this study was to collect data of skin temperature and physiological responses which is useful for standardization of insulation measurement in various garments. And we investigated sex and season difference of physiological responses of 60's males and 60's females in hot and cold environment. Healthy ten 60's males and ten 60's females volunteered as subjects. The experiment was conducted three times; One for winter condition($5^{\circ}C$, 45%), another for summer condition($30^{\circ}C$, 65%) and the other for nude condition as control($30^{\circ}C$, 65%). The subjects were sitting for 1 hour with suitable ensemble on each experimental condition in climate chamber. We measured skin temperature, rectal temperature, heart rate, oxygen uptake, sweat rate, blood flow, blood pressure and subjective sensations. We found that skin temperature and most of physiological responses were higher in male subject, summer condition than in female subject, winter condition.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2008.11a
• /
• pp.21-25
• /
• 2008

In this paper, the temperature history and the strength development of concrete corresponded to various bubble sheets layer and curing temperature. Based on the results, In case of the test temperature of -5℃, concrete subject in the exposure condition, result in a frost damage at initial stage by a fall of below zero temperature. In case of the combination of PE film and non woven fabric was after 36 hour, and combination of bubble sheet over double, a tremendous insulating effect of bubble sheet over double is confirmed due to the temperature of concrete fall of below zero temperature after 60 hours. Meanwhile, regarding the -15℃ of temperature, special measure for insulation curing is necessary to secure stability against early frost damage because frost damage was not affected by the lapping thickness of bubble sheet subjected to severe cold weather condition.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.579-582
• /
• 2005

In this study, the electrical characteristic of asymmetric high voltage MOSFET (AHVMOSFET) for display IC was investigated. Measurement data are taken over range of temperature (300K-400K) and various extended drain length, and gate oxide thickness ($175{\AA}$, $350{\AA}$). In high temperature condition, drain current decreased over 30% and max transconductance deceased over 40%, and specific on-resistance increased over 30% in comparison with room temperature.

• Textile Coloration and Finishing
• /
• v.13 no.2
• /
• pp.7-7
• /
• 2001

This paper investigated the dyeability and surface color of silk and cotton fabrics dyed with chustnut bur extract. Some experiments were performed under the various dyeing conditions such as dyeing temperature, dyeing time, repetition of dyeing, dyeing pH, mordanting condition, washing fastness and light fastness with silk and cotton fabrics. The results obtained were as follows 1. △E value was increased when dyeing temperature and time was higher, value of munsell was shifted from Yellow to Yellow-Red at hither dyeing temperature and time in silk and cotton fabrics. 2. Optimal dyeing pH was increased with acidity of dyeing solution in silk and cotton fabrics, and repetition of dyeing did not change the dye-uptake. 3. When mordanting time and temperature was higher, △E value was larger in silk and cotton fabrics. Silk and cotton fabrics with Fe-premordanting treatment had best dyeability, but treatment with Sn-mordanting was worst. 4. Washing fastness and light fastness was excellent in various dyeing condition at silk fabric but cotton was without practical use.

• Textile Coloration and Finishing
• /
• v.13 no.2
• /
• pp.93-103
• /
• 2001

This paper investigated the dyeability and surface color of silk and cotton fabrics deed with chustnut bur extract. Some experiments were performed under the various dyeing conditions such as dyeing temperature, dyeing time, repetition of dyeing, dyeing pH, mordanting condition, washing fastness and light fastness with silk and cotton fabrics. The results obtained were as follows 1. $\Delta{E}$ value was increased when dyeing temperature and time was higher, value of munsell was shifted from Yellow to Yellow-Red at hither dyeing temperature and time In silk and cotton fabrics. 2. Optimal dyeing pH was increased with acidity of dyeing solution in silk and cotton fabrics, and repetition of dyeing did not change the dye-uptake. 3. When mordanting time and temperature was higher, $\Delta{E}$ value was larger in silk and cotton fabrics. Silk and cotton fabrics with Fe-premordanting treatment had best dyeability, but treatment with Sn-mordanting was worst. 4. Washing fastness and light fastness was excellent in various dyeing condition at silk fabric but cotton was without practical use.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2019.05a
• /
• pp.197-198
• /
• 2019

The aim of the research is evaluating the feasibility of inspection for early age frozen damage and for expansion of concrete under the various time periods of -20℃ temperature condition. When the concrete samples were exposed for 12 hours and 24 hours, the frozen depth of the concrete were 10 and 60 mm, respectively, under the wet conditions. From the experiment results of temperature and expansion, only surface area suffered frozen damage for 12 hours exposing conditions while entire area suffered frozen damage for 24 hours exposing conditions.

• Journal of the Korean Society of Mechanical Technology
• /
• v.13 no.2
• /
• pp.55-61
• /
• 2011

This study analyzed on the characteristics of temperature distribution in an active regeneration DPF using computer simulation. In order to verify the boundary condition of analysis, results of temperature distribution in DPF are compared between experimental and computer simulation. Using this boundary condition, temperature distribution and filter's durability in DPF analyzed according to various operating conditions. The results of computational analysis are agreed well with experimental ones from the tendency of temperature distribution of axis and radius direction. The temperature increases and the axial temperature gradients in DPF according to velocity of exhaust gas are lowered as the high velocity of exhaust gas. But the temperature gradients of radius direction at exit side in DPF are grown as the high velocity of exhaust gas. The results according to inlet temperature of exhaust gas show that the increase ratios of temperature in DPF are grown as the high temperature of exhaust gas.

• Journal of the Korean Professional Engineers Association
• /
• v.10 no.1
• /
• pp.10-14
• /
• 1977

In accordance with introducing extra high voltage system, system power plants have to be operated in underexcited condition, which causes temperature rise at the stator end portion of turbine generator. This Paper deals with (1) various elements affecting temperature rise and (2) methods of pre-estimating temperature rise.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.24 no.2
• /
• pp.35-41
• /
• 1979

To observe the effects of temperature and photoperiod on the growth and yield of winter wheat (Triticum aestivum, L) eight varieties including Chang Kwang were tested at various treatments like longday-high temperature (24hrs-20\circ), shortdayhigh temperature (12hrs-20\circ), longday-low temperature (24hrs-14\circ) and shortday-low temperature (12hrs-14\circ). Among the traits measured, days to heading, plant height, spike length, number of spikes per hill and grain yield per hill were generally decreased at high temperature and long day treatment and increased at low temperature and shortday condition. Number of grains per spike was decreased at low temperature and short day condition while increased at longday and high temperature conditions. Grain weight was decreased significantly at high temperature and shortday while increased at low temperature and longday treatment.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.04a
• /
• pp.337-342
• /
• 1999

The Purpose of this study is to evaluate the strength characteristics of polyurethane(PUR) mortar cured under low temperature condition. PUR mortars are prepared with various catalyst content, methylene chloride(MC) content as a viscosity reducing agent, and curing age at low temperature condition of $0^{\circ}C$, -5$^{\circ}C$ and -1$0^{\circ}C$, tested for working life, compressive and flexural strengths. From the test results, the catalyst and MC contents affect the degree of hardening and blowing of PUR mortar. Strengths increase with an increasing catalyst content at low temperature. Flexural and compressive strength of PUR mortar are about 177kgf/$\textrm{cm}^2$ and 490kgf/$\textrm{cm}^2$ respectively at curing temperature of -1$0^{\circ}C$ with catalyst content of 0.4%. Therefore, it is apparent that this PUR mortars have a sufficient strengths for repair of concrete structures.