• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.15 no.4
• /
• pp.223-229
• /
• 2022

In this paper, the ignition trans used in boilers was studied. Regardless of the change in the ignition rod length and the ignition rod gap, the output frequency was measured between 59.5 and 61.3 Hz, and it was found that the low frequency circuit operated normally. When the ignition rod gap changed by 2 to 10 mm, the ignition rod length was measured from 2.8A to 3.45A at 30cm. The ignition rod length was measured from 9.37 A to 14.5 A at 500 cm and from 13.2 A to 32.6 A at 1000 cm. As the ignition rod length and the ignition rod gap increased, the current increased. As a result of measuring the secondary coil output voltage. The ignition rod length was measured from AC 0.84 kV to AC 1.75 kV at 30 cm, AC 1.17 kV to AC 1.944 at 500 cm, and AC 1.4 kV to AC 7.18 kV at 1000 cm. As the ignition rod length and the ignition rod gap increased, the output voltage of the secondary coil also increased. As a result of measuring the output voltage of the ignition trans, the ignition rod length was measured from DC 1.11 kV to DC 1.57 kV at 30cm, DC 2.49 kV to DC 3.72 kV at 500cm, and DC 3.78 kV to DC 9.42 kV at 1000cm, and the power voltage increased as the ignition rod length and interval increased.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.30 no.2
• /
• pp.47-54
• /
• 2020

To develop the bright-vivid red- and yellow-inorganic fluorescent pigments with high luminescence properties, A₃V₅O₁₄ (A = K and Rb) and Cs₂V₄O₁₁ inorganic pigments were synthesized by a water assisted solid state reaction (WASSR) method and a conventional solid state reaction method. Although impurity peaks corresponding to the AVO₃ and AV₃O₈ (A = K, Rb, and Cs) were observed in all samples prepared, the trigonal structure A₃V₅O₁₄ (A = K and Rb) and orthorhombic structure Cs₂V₄O₁₁ were successfully obtained as a main phase. These inorganic pigments showed the broad absorption band (under 550 nm) originated from CT transitions of VO₄ polyhedron, and the strong broad red- and green-emission bands due to ³T₂ → ¹A₁ and ³T₁ → ¹A₁ transitions of the [VO₄]^3- group. The A₃V₅O₁₄ (A = K and Rb) and Cs₂V₄O₁₁ pigments showed a bright-vivid red- and yellow-body color, where the a* values of the A₃V₅O₁₄ (A = K and Rb) were +35.5 and +45.9, respectively, and b* value of Cs₂V₄O₁₁ pigments was +50.3. The L* values of the A₃V₅O₁₄ (A = K and Rb) and Cs₂V₄O₁₁ inorganic pigments were over +45. These results indicate that the A₃V₅O₁₄ (A = K and Rb) and Cs₂V₄O₁₁ inorganic pigments could be an attractive candidate as a bright-vivid red- and yellow inorganic pigments.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.2
• /
• pp.386-393
• /
• 2004

In order to maintain load balancing in distributed systems in a decentralized manner, every node should obtain workload information from all the nodes on the network. It requires $Ο({v^2})$ traffic overheads, where v is the number of nodes. This paper presents a new synchronous dynamic distributed load balancing algorithm for a ( v,k+1,1)-configured network topology, which is a kind of 2k regular graph, based on symmetric balanced incomplete block design, where v equals ${k^2}+k+1$. Our algorithm needs only Ο(v√v) message overheads and each node receives workload information from all the nodes without redundancy. And load balancing in this algorithm is maintained so that every link has same amount of traffic by √v for transferring workload information.

• Proceedings of the KIEE Conference
• /
• 1999.07c
• /
• pp.1091-1093
• /
• 1999

This paper discusses the surveying of a power transmission line using Real Time Kinematic(RTK) GPS technology. The use of RTK provides users with an accurate position at the moment in time. Application result of a 765kV transmission line surveying proved to be more accurate and efficient than using a traditional EDM (Electro-magnetic distance measurement) method. More, decrease in numbers of trees cut down which is a major cause of public discontents was achieved. Improvements in doing a surveying of a power transmission line using GPS is expected in the future.

• Proceedings of the KIEE Conference
• /
• 1998.07e
• /
• pp.1647-1649
• /
• 1998

This paper describes the power frequency voltage and its countermeasure when a 765 kV transmission line is directly connected to a 345 kV line and operated at 345 kV voltage. The summary of this result is as follows : The western route of 765 kV transmission line doesn't need any countermeasure to reduce the power frequency voltage at the receiving end. The eastern route of 765 kV transmission needs 100 Mvar(3 phase) capacity of shunt reactor at the receiving end to reduce the power frequency voltage. The use of shunt reactors in the 765 kV transmission lines has unexpected problems, one of which is induction of high voltages on a de-energized circuit of two parallel lines. This paper examined the problem of resonance on two parallel transmission circuits in one routes.

• Journal of Radiation Protection and Research
• /
• v.43 no.1
• /
• pp.1-9
• /
• 2018

Background: In this study, we investigate the image quality of virtual monochromatic images synthesized from dual-energy computed tomography (DECT) at voltages of 80/140 kV and 100/140 kV. Materials and Methods: Virtual monochromatic images of a phantom are synthesized from DECT scans from 40 to 70 keV in steps of 1 keV under the two combinations of tube voltages. The dose allocation of dual-energy (DE) scan is 50% for both low- and high-energy tubes. The virtual monochromatic images are compared to single-energy (SE) images at the same radiation dose. In the DE images, noise is reduced using the 100/140 kV scan at the optimal monochromatic energy. Virtual monochromatic images are reconstructed from 40 to 70 keV in 1-keV increments and analyzed using two quality indexes: noise and contrast-to-noise ratio (CNR). Results and Discussion: The DE scan mode with the 100/140 kV protocol achieved a better maximum CNR compared to the 80/140 kV protocol for various materials, except for adipose and brain. Image noise is reduced with the 100/140 kV protocol. The CNR values of DE with the 100/140 kV protocol is similar to or higher than that of SE at 120 kV at the same radiation dose. Furthermore, the maximum CNR with the 100/140 kV protocol is similar to or higher than that of the SE scan at 120 kV. Conclusion: It was found that the CNR achieved with the 100/140 kV protocol was better than that with the 80/140 kV protocol at optimal monochromatic energies. Virtual monochromatic imaging using the 100/140 kV protocol could be considered for application in breast, brain, lung, liver, and bone CT in accordance with the CNR results.

• Proceedings of the KIEE Conference
• /
• 1995.07c
• /
• pp.1341-1343
• /
• 1995

The maximum transmission voltage in our country is going to change 345kV into 765kV owing to the increase of Electrical Power Demand and power System Stability. Our company is developing 800kV GIS and 765kV Transformer which are main equipments in 765kV substation. This paper describs the specification on 800kV GIS which we prepared for 800kV 8,000A 50kA GIS development. This specification is supported by Public Standards and Data. And, we are designing the 800kV GIS on this specification and drawing up the 800kV GIS layout for type test.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.15 no.5
• /
• pp.519-525
• /
• 2015

Positive bias stress-induced instability in amorphous indium-gallium-zinc-oxide (a-IGZO) bottom-gate thin-film transistors (TFTs) was investigated under high $V_{GS}$/low $V_{DS}$ and low $V_{GS}$/high $V_{DS}$ stress conditions through incorporating a forward/reverse $V_{GS}$ sweep and a low/high $V_{DS}$ read-out conditions. Our results showed that the electron trapping into the gate insulator dominantly occurs when high $V_{GS}$/low $V_{DS}$ stress is applied. On the other hand, when low $V_{GS}$/high $V_{DS}$ stress is applied, it was found that holes are uniformly trapped into the etch stopper and electrons are locally trapped into the gate insulator simultaneously. During a recovery after the high $V_{GS}$/low $V_{DS}$ stress, the trapped electrons were detrapped from the gate insulator. In the case of recovery after the low $V_{GS}$/high $V_{DS}$ stress, it was observed that the electrons in the gate insulator diffuse to a direction toward the source electrode and the holes were detrapped to out of the etch stopper. Also, we found that the potential profile in the a-IGZO bottom-gate TFT becomes complicatedly modulated during the positive $V_{GS}/V_{DS}$ stress and the recovery causing various threshold voltages and subthreshold swings under various read-out conditions, and this modulation needs to be fully considered in the design of oxide TFT-based active matrix organic light emitting diode display backplane.

• Journal of Auto-vehicle Safety Association
• /
• v.13 no.1
• /
• pp.26-30
• /
• 2021

K-city is an experimental area for developing self-driving cars. V2X communications such as WAVE, C-V2X and 5G are an essential technology for autonomous driving above level 4. In this paper, the research on the V2V communication environment was carried out through BSM receiving level analysis on the driving route in K-city. A stationary vehicle communicated with a test vehicle moving along urban area and suburban road in two different scenarios. The communication range and receiving levels obtained from this study will be used to develop and verify various safety scenarios using V2V communication within K-city in the future.

• Korean Journal of Mathematics
• /
• v.30 no.2
• /
• pp.391-402
• /
• 2022

For a given graph G = (V, E), a dominating set is a subset V' of the vertex set V so that each vertex in V ＼ V' is adjacent to a vertex in V'. The minimum cardinality of a dominating set of G is called the domination number of G and is denoted by γ(G). For an integer k ≥ 1, the k-th power G^k of a graph G with V (G^k) = V (G) for which uv ∈ E(G^k) if and only if 1 ≤ d_G(u, v) ≤ k. Note that G² is the square graph of a graph G. In this paper, we obtain some tight bounds for the sum of the domination numbers of a graph and its square graph in terms of the order, order and size, and maximum degree of the graph G. Also, we characterize such extremal graphs.