• 대한기계학회논문집B
• /
• 제25권11호
• /
• pp.1518-1526
• /
• 2001

In this paper, the mechanism of unsteady potential interaction and wake interaction in one stage axial turbine is numerically investigated at design point in two-dimensional viewpoint. The numerical technique used is the upwind scheme of Van-Leer's Flux Vector Splitting (FVS) and Cubic spline interpolation is applied on zonal interface between stator and rotor. The inviscid analysis is used to embody the influence of potential interaction only and viscous analysis is used to embody the influences of both potential interaction and wake interaction at the same time. The potential-flow disturbance from the stator into a rotor passage and the periodic blockage effect of rotor produce the unsteady pressure on the blade surface in inviscid analysis. After the wake is cut by rotor, two counterrotating votical patterns flanking the wake centerline in the passage are generated. So, these phenomena magnify the unsteady pressure in viscous analysis than that in inviscid analysis. The resulting unsteady forces on the rotor, generated by the combined interaction of the two effects by potential and wake interaction, are discussed.

• 한국유체기계학회 논문집
• /
• 제3권2호
• /
• pp.57-65
• /
• 2000

The aim of this paper is to understand the unsteady flow phenomena in a high speed centrifugal compressor channel diffuser. Instantaneous pressures aye measured at six locations in the diffuser using fast-response pressure transducers. Instantaneous pressure ratio decomposition was applied to analyze the pressure signal. In vaneless space where impeller-vaned diffuser interaction is strong, aperiodic unsteadiness is high and periodic pressure waveforms by blade passing are not clear at low flow rates, especially near vane suction side. High aperiodic unsteadiness decreases downstream of diffuser. The blade-to-blade pressure wave does not disappear in surge flow condition. In surge there exist not only large scale periodic surge wave but also blade-to-blade pressure wave.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 1999년도 유체기계 연구개발 발표회 논문집
• /
• pp.69-77
• /
• 1999

The aim of this paper is to understand the unsteady flow phenomena in a high speed centrifugal compressor channel diffuser. Instantaneous pressures are measured at six locations in the diffuser using fast-response pressure transducers. Instantaneous pressure ratio decomposition was applied to analyze the pressure signal. In vaneless space where impeller-vaned diffuser interaction is strong, aperiodic unsteadiness is high and periodic pressure waveforms by blade passing are not clear at low flow rates, especially near vane suction side. High aperiodic unsteadiness decreases downstream of diffuser. The blade-to-blade pressure wave does not disappear in surge flow condition. In surge there exist not only large scale periodic surge wave but also blade-to-blade pressure wave.

• 한국수자원학회논문집
• /
• 제45권5호
• /
• pp.455-464
• /
• 2012

이 논문에서는 관망시스템의 수격압 현상을 모의하기 위해서 합성 부정류 마찰 모형을 개발하였다. 부정류 마찰항을 고려하기 위한 방법으로 빈도 의존 마찰항과 순간 가속도 기반 마찰 모형을 합성하였으며, 특성선 방법을 모형 개발의 기반으로하였다. 관망에서의 부정류 모형으로 가장 널리 쓰이는 Zielke의 마찰항 모형과 Ramos의 마찰항 모형들과 종합적인 비교를 수행하였다. 모의 결과를 검증하기 위해서 고빈도로 수압을 측정할 수 있는 자료 획득체제를 구비한 관망시스템을 구축하였다. 정상상태에서 밸브 급폐로 야기된 수격압의 수압 시계열을 2가지 Reynolds수에서 확보하였다. 모의결과는 pilot 관망체제에서 확보한 실험 자료와 비교하였다. 부정류 마찰항 모형의 매개변수 보정을 위해서 시행착오 방법이 도입되었으며, 부정류 마찰항들을 비교한 결과는 수격압에서 수압이 감쇄되는 과정에 대한 전반적인 이해를 돕고자 하였다. 이와 같은 결과는 관망의 천이류를 적절히 예측하는데 부정류 마찰항의 적절한 고려가 필수적인 부분임을 알려 주고 있다.

• 한국유체기계학회 논문집
• /
• 제5권3호
• /
• pp.15-24
• /
• 2002

This paper presents an experimental study on the unsteady flow phenomena such as leakage flow and rotating stall which have influences on the performance and stability of an axial flow fan. For this study, unsteady pressure were measured using high frequency pressure transducers mounted on the easing wall of rotor passage and analyzed by Double Phase-Locked Averaging Technique. As the flow rate was reduced to near stall point, the pressure difference between the pressure and the suction side of the blade was increased especially new the leading edge and the lowest pressure zone of suction side was gradually developed. From the result of unsteady pressure field on the casing wall, one period of rotating stall was divided into three zones and the flow characteristics on each zone were described in detail.

• 한국공작기계학회논문집
• /
• 제17권3호
• /
• pp.8-13
• /
• 2008

The paper proposes a model-based measurement of unsteady flow rate by using distributed parameter pipeline model and the measured pressure values at two distant points along the pipeline. The distributed parameter model of hydraulic pipeline is applied with consideration of frequency dependent viscosity friction and unsteady velocity distribution at a cross section of a pipeline. By using the self-diagnostics functions of the measurement method, the validity is investigated by comparison with the measured and estimated pressure and flow rate wave forms at the halfway section on the pipeline. The results show good agreement between the estimated flow rate wave forms and theoretical those under unsteady laminar flow conditions. The method proposed here is useful in estimating unsteady flow rate through an arbitrary cross section in hydraulic pipeline and components without installing an instantaneous flowmeter.

• 한국철도학회논문집
• /
• 제11권1호
• /
• pp.13-18
• /
• 2008

본 연구에서는 열차와 지하철 역사 형상긴의 유통 흐름에 대한 상호작용을 고려하여 승강장 스크린도어(PSD)봐 비정상 풍압해석을 수행하였다. PSD의 주목적은 열차가 역사 안으로 진입할 때, 인명사고를 예방하고 풍압, 오염된 분진, 소음 등을 차단하는데 있다. PSD에 대한 비정상 풍압수준을 정확하게 예측하기 위하여 이동격자법을 활용한 전산유체역학 기법이 적용되었다. 개방형 및 밀폐형 역사가 고려되었으며, 열차가 역사를 통과하는 경우와 역사에서 멈추는 경우에 대한 풍압 수준을 상호 비교하였다.

• 신재생에너지
• /
• 제8권3호
• /
• pp.6-13
• /
• 2012

This paper describes unsteady internal flow characteristics of a cathode air blower, used for the 1 kW fuel cell system. The cathode air blower considered in the present study is a diaphragm type blower. To analyze the flow field inside the diaphragm cavity, compressible unsteady numerical simulation is performed. Moving mesh system is applied to the numerical analysis for describing the volume change of the diaphragm cavity in time. Throughout a numerical simulation by modeling the inlet and outlet valves in a diaphragm cavity, unsteady nature of an internal flow is successfully analyzed. Variations of mass flow rate, force and pressure on the lower moving plate of a diaphragm cavity are evaluated in time. The computed mass flow rate at the same pressure and rotating frequency of a motor has a maximum of 5 percent error with the experimental data. It is found that flow pattern at the suction process is more complex compared to that at the discharge process. Unsteady nature of internal flow in the cathode air blower is analyzed in detail.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2006년도 학술발표회 논문집
• /
• pp.1395-1399
• /
• 2006

The current paper focuses the analysis of leakage detection in water pipeline systems by means of the transient analysis. In order to obtain pressure variation for evaluation the existing methodology, an extensive experimental process has been carried out in a single pipeline system. Several experimental tests were performed with and without a leakage in the system. Using the unsteady friction and improved unsteady friction factors, reasonable match between the computed and measured pressure were presented on the condition of the flow situations. The transient method attempts to estimate the leakage in water pipelines using observed pressure data collected during transient events on the system.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2001년도 춘계 학술대회논문집
• /
• pp.116-120
• /
• 2001

The impactive Pressure wave induced by pyro valve in the pressurization system of KSR-III may result in fatal failure or malfunction of valves, so it is important to know the pressure wave characteristic in the pressurization system. An unsteady flow analysis in the simplified pressurization system was peformed by Finite difference method.