• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.17 no.2
• /
• pp.52-56
• /
• 2007

We have installed an ultra high vacuum (UHV) molecular beam epitaxy (MBE) system and investigated into the characteristics of MBE-grown ZnSe/GaAs [001] using scanning electron microscopy (SEM), atomic force microscopy (AFM), we confirmed that layer's surface was dense and uniform of molecular layer. We used x-ray diffractometer (XRD) and confirmed two peaks correspond to GaAs [001] substrate and ZnSe epilayer, respectively. We observed photoluminescence (PL) peak approximately at 437 nm and measured PL mapping of 2 inch ZnSe epilayer.

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1813-1815
• /
• 1996

With the three dimensional magnetic field measuring system dealt with in this paper, accurate measurements and analyses of ELF magnetic fields in the vicinity of UHV overhead transmission lines and substations have been conducted. For the field measurements multiturn loop-type sensors have been developed with special consideration of taking lower frequency and spatial components without any distortion. So the measuring system has the frequency bandwidth of 8[Hz] to about 53[kHz] and the response sensitivity of $9.88[mV/{\mu}T]$ in average. A brief description of design rules of the measuring system and measurement procedures is given. The actual surrey near 154 and 345[kV] overhead transmission lines and power subststions was carried out and analyzed. It may be inferred from these results that the maximum magnetic field intensities under typical UHV overhead transmission lines do not exceed $20[{\mu}T]$ so that the field measurements satisfy sufficiently all limits or guidelines that various authorized international institutes recommend.

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1923-1924
• /
• 1996

Some part of the route in KEPCO 765kV transmission line being constructed passes through a high mountain area which is 800m above the sea level (Taebaek, Sabuk area in Gangwon province). This area is the top part of Taebaek mountains corresponding to the backbone of korean peninsula and has lots of snow during the winter season because the winter seasonal wind gone up along the mountainside of Taebaek Mts. meets open air of the East sea. KEPCO has experienced 63 faults of T/L between 1968 and 1993 in this area, which is a very serious problem. Especially 154kV Hwang-Ji T/L fault in 1990, 2 was a unprecedented case which needs to be analyzed carefully to take proper measures. After reviewing ice and snow loading conditions and analyzing the fault of Hwang-Ji T/L, we're going to determine the revisement of ice and snow loading condition in this area to increase reliability of 765kV transmission line.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.4
• /
• pp.1221-1224
• /
• 2013

The atomic layer deposition (ALD) of $ZrO_2$ was conducted in ultrahigh vacuum (UHV) conditions. The surface was exposed to $ZrCl_4$ and $H_2O$ in sequence and the surface species produced after each step were identified in situ with X-ray photoelectron spectroscopy (XPS). $ZrCl_4$ is molecularly adsorbed at 140 K on the $SiO_2$/Si(111) surface covered with OH groups. When the surface is heated to 300 K, $ZrCl_4$ loses two Cl atoms to produce $ZrCl_2$ species. Remaining Cl atoms of $ZrCl_2$ species can be completely removed by exposing the surface to $H_2O$ at 300 K followed by heating to 600 K. The layer-by-layer deposition of $ZrO_2$ was successfully accomplished by repeated cycles of $ZrCl_4$ dosing and $H_2O$ treatment.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.5C no.3
• /
• pp.111-114
• /
• 2005

Organic monolayers were fabricated onto Au(l l l) substrate by self-assembly method using dipyridinium. Also, organic single molecule in the organic monolayers was selected to measure the current-voltage (I-V) curves by using the ultrahigh vacuum scanning tunneling microscopy (UHV-STM). The organic molecule used in the experiment was dipyridinium dithioacetate, which contains thiol functional group and can be self-assembled easily onto Au(l l l) substrate. The concentration of dipyridinium dithioacetate for self-assembly procedure was I [mM/L]. To confirm the formation of self-assembled mono layers (SAMs), the differences of thickness of the self-assembled organic monolayers were observed by using an ellipsometer, and the morphology and I-V curves of the SAMs were investigated by using UHV-STM. The applied voltages were from -2 [V] to +2 [V], temperature was 300 [K]. The vacuum for measuring current of the organic single molecule was 6 $\times$ 10$^{-8}$ [Torr]. As a result, properties of the negative differential resistance (NDR) in constant voltage were found.

• Wind and Structures
• /
• v.38 no.6
• /
• pp.477-492
• /
• 2024

This study presents a comprehensive investigation of wind load characteristics and wind-induced responses associated with different wind incidence angles and terrains of the 1000kV UHV substation frame. High-frequency force balance (HFFB) force measurement wind tunnel tests are conducted on the overall and segment models to characterize wind loads characteristics such as the aerodynamic force coefficients and the shape factors. The most unfavorable wind incidence angles and terrains for aerodynamic characteristics are obtained. A finite element model of the substation frame is built to determine the wind-induced response characters based on the aerodynamic force coefficients and bottom forces of the segment models. The mean and root mean square (RMS) values of displacement responses at different heights of the frame structure are compared and analyzed. The influence of wind incidence angle and terrains on wind-induced responses is also examined. The displacement responses in terms of the crest factor method are subsequently transformed into dynamic response factors. The recommended values of dynamic response factors at four typical heights have been proposed to provide a reference for the wind resistance design of such structures.

• Proceedings of the Korean Vacuum Society Conference
• /
• 1996.06a
• /
• pp.183-184
• /
• 1996

• Proceedings of the Korean Vacuum Society Conference
• /
• 1996.06a
• /
• pp.99-99
• /
• 1996

• Proceedings of the Korean Vacuum Society Conference
• /
• 1997.07a
• /
• pp.89-90
• /
• 1997

• Proceedings of the Korean Vacuum Society Conference
• /
• 1993.07a
• /
• pp.84-85
• /
• 1993