• Journal of Environmental Science International
• /
• v.24 no.1
• /
• pp.133-150
• /
• 2015

Wind profiler provides vertical profiles of three-dimensional wind vectors with high spatiotemporal resolution. The wind vectors is useful to analyze severe weather phenomena and to validate the various products from numerical weather prediction model. However, the wind measurements are not immune to ground clutter, bird, insect, and aircraft. Therefore, quality of wind vectors from wind profiler must be quantitatively evaluated prior to its application. In this study, wind vectors from UHF wind profiler at Ganwon Regional Meteorological Administration was quantitatively evaluated using 27 radiosonde measurements that were launched every two or three hours according to rainfall intensity during Intensive Observation Period (IOP) from June to July 2013. In comparison between two measurements, wind vectors from wind profiler was relatively underestimated. In addition, the accuracy and quality of wind vectors from wind profiler decrease with increasing beam height. The accuracy and quality of the wind vectors for rainy periods during IOP were higher than for the clear-air measurements. The moderate rainfall intensity lead to multi-peaks in Doppler spectrum. It results in overestimation of vertical air motion, whereas wind vectors from wind profilers shows good agreement with those from radiosonde measurements for light rainfall intensity.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.2
• /
• pp.45-49
• /
• 2009

In this paper, a direct down conversion LNA/Mixer has been designed and tested for 900Mhz UHF RFID application. The designed circuit has been implemented in 0.18um CMOS technology with 3.3V operation. In this work, a common gate input architecture has been used to cope with the higher input self jamming level. This LNA/Mixer is designed to support two operating modes of high gain mode and low gain mode according to the input jamming levels. The measured results show that the input referred P1dBs are 4dBm of high gain mode and 11dBm of low gain mode, and the conversion gains are 12dB and 3dB in high and low gain mode respectively The power consumptions are 60mW for high gain mode and 79mW for low gain mode. The noise figures are 16dB and 20dB in high gain mode and low gain mode respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.12 s.115
• /
• pp.1240-1248
• /
• 2006

This paper presents an UHF band(911 MHz) RFID tag antenna which has near-isotropic radiation pattern and easy conjugate impedance matching characteristics to any commercial chips of usual practice through the application of an inductively-coupled feeding. The proposed antenna of compact size $40{\times}46mm\;(0.12{\times}0.14{\lambda})$ has, at normal incidence, the maximum RCS of $-18.5dBm^2$ and the 3 dB RCS bandwidth of 9 MHz(1 %) in case of short chip load. It has the maximum and minimum RCS' of $-16.9dBm^2\;and\;-21.4dBm^2$ depending on the incident angles. The difference of about 4.5 dB is relatively small compared with that (about 70 dB) of a pure dipole antenna. The designed antenna has been fabricated and its RCS' have been measured varying the angles of incidence. The measured RCS' have been found to have good agreement with the simulated ones.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 2007.04a
• /
• pp.272-272
• /
• 2007

RFID의 개념과 그 요소를 소개하고 EPC Network & CNS의 개요, 특징, 자동윈리 등을 언급하였으며, HF/UHF 리더기의 설명과 관련 미들웨어의 기능과 특징, 활용방안에 대하여 실제품위주로 나타내었다. 구축된 사례를 중심으로 Application 과 의 연계 방향에 대하여 살펴보고자 한다.

• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.1766-1768
• /
• 2004

This paper describes the prediction of location of PD signals in GIS using the difference in the measured time between first and second wave arrival by the external-type PD sensors. It is well accepted that the electromagnetic wave in GIS propagates at the velocity of $3{\times}10^8$m/s. Consequently, we could identify the location of PD with high accuracy. The experience at the fields and the problems for the judgment are also discussed in detail.

• Journal of information and communication convergence engineering
• /
• v.6 no.4
• /
• pp.391-395
• /
• 2008

Wideband terminal and base station is required to serve not only existing 1st and 2nd generation mobile communication systems but also 3rd generation systems. In this paper, we present a feasibility study on coaxial feed compact wideband antenna for UHF RFID reader application. The original antenna was designed for partial discharge detection sensor in high voltage diagnostic system. However, we modified the original prototype to achieve shifted down resonant frequency for wideband wireless communication applications. The experimental result shows good return loss characteristics and radiation patterns except for the total gain at each resonant frequency. The maximum measured gain was 2.45 dBi$\sim$3.18 dBi at 910MHz.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.11
• /
• pp.527-531
• /
• 2006

Since 1996, KEPCO has been operating a wide range lightning detection system, LPATS, and been accumulating relative application techniques and statistical analysis skills. So, KEPRI already has its own basis to develope more accurate advanced detection technology and references to do comparative study. For three-dimensional imaging of lightning channels, UHF/VHF antenna systems were installed at 2 sites. The distance between two sites is about 30 km. These systems were used the AOA(Angle of Arrival) methods for lightning detection. In this paper, we would like to introduce about our system and its results.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.4
• /
• pp.161-165
• /
• 2006

In this paper, we developed HPF (high pass filter) consists of lumped LC components to decrease the noises that are detected in PD (partial discharge) measuring test, and adapted it to field test. We tested it under laboratory circumstances like the fields, and measured the phase change properties of detected signal in UHF sensor with Lemke Probe and oscilloscope (TDS-3054, Tektronix). As a result, we obtained available data showing the decrease of noises in the experiments with the developed HPF from the joint box of 22.9kV distribution line. The result can be adapted to prevent the degeneration of the XLPE power cable, and to observe and diagnosis the underground power transmission cable at the ultra-high voltage.

• Proceedings of the KIEE Conference
• /
• 2007.10a
• /
• pp.191-192
• /
• 2007

This paper presents a 900MHz fractional-N frequency synthesizer for radio frequency identification (RFID) reader using $0.18{\mu}m$ standard CMOS process. The IC meets the EPC Class-1 Generation-2 and ISO-18000 Type-C standards. To minimize VCO pulling, the 900MHz VCO is generated by a 1.8GHz VCO followed by a frequency divider. The settling time of the synthesizer is less than $20{\mu}m$. The frequency synthesizer achieves the phase noise of -105.6dBc/Hz at 200kHz offset. The frequency synthesizer occupies an area of $1.8{\times}0.99mm^2$, and dissipates 8mA from a low supply voltage of 1.8V.

• Aerospace Engineering and Technology
• /
• v.4 no.2
• /
• pp.171-191
• /
• 2005

This Technical Memo(TM) was written for the purpose of determining the type of UHF-band power divider which is applicable to KSLV-1. For this, some different kinds of power divider are compared with there types and characteristics. And then, we select three types of power divider(which is Wilkinson power divider, Quadrature hybrid divider and Ring hybrid divider) and perform Schematic and Momentum simulation for finding the optimized characteristics. With this results, in order to demonstrate the selected power divider, we manufactured UHF-band power dividers using FR-4 epoxy plate. By the measured results, we obtain the similar results compare with simulation and fabrication. And Quadrature hybrid power divider is suitable to application to KSLV-1.