• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.10
• /
• pp.1096-1103
• /
• 2008

This paper proposes an individual order predistortion linearizer using intermodulation distortion(IMD) generator for cancellation the third and the fifth IMD of power amplifier. The IMD generator for controlling the third and the fifth IMD consist of common Emitter amplifier and Schottky diode. These signals are generated by series feedback of Schottky diode to obtain the inverse AM/AM and AM/PM characteristics of power amplifier. The individual order predistorters are consisted of individual IMD generator, power splitter and combiner. The test results show that the third and the fifth IMD can be improved by a maximum 13.5 dB and 0.9 dB in case of CW 2-tone signals. Also, the Adjacent Channel Leakage Ratio(ACLR) can be improved 2.3 dB, 2.5 dB at ${\pm}0.885$ MHz, ${\pm}1.23$ MHz offset frequency for CD-MA IS-95 2FA signals.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.149-153
• /
• 2005

A new method of power amplifier's linearity improvement using a Compact Microstrip Resonant Cell(CMRC) is proposed. It is found out that a CMRC at the input side gives better performance than that at the output. Tuning lines are used in the input and the output matching network to get the optimum performance. As a result, the 14.77 dB improvement fur the third-order IMD is obtained. And the size of the CMRC is only $17.1\times5.22mm$.

• Journal of IKEEE
• /
• v.3 no.2 s.5
• /
• pp.215-220
• /
• 1999

In fabricated linear power amplifier(LPA), the third-order inter-modulation distortion(IMD) for main amplifier alone is 10.61dBc, and the IMD for LPA with predistorter and feedforward loop combined is 32.50dBc. Therefore, the IMD characteristic results an improvement of approximately 22dB. The main amplifier efficiency with single tone input is close to 30%, and the efficiency of the overall LPA with predistorter is 27.4% and predicted feedforward loop efficiency without predistorter is about 20%. Therefore, LPA with predistorter and feedforward loop combined is improved by 7.4%.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.1 s.104
• /
• pp.67-73
• /
• 2006

This paper proposes a new predistortion linearizer with controlling intermodulation distortion(IMD) signals. This linearizer achieves independent control of third- and fifth-order intermodulation distortion products using amplitude modulation with even harmonic signals. A vector modulator that modulate fundamental signal with both second- and fourth-order harmonic components generated by harmonic generator circuits, generates the inverse characteristics third-and fifth-order intermodulation signals of power amplifier and controls amplitude and phase of them with each other modulation factors. As a results, this linearizer is suppressed IMD signals of power amplifier effectively. The test results show that the third IMD is cancelled more than 25 dB and the fifth order IMD is cancelled about 18 dB for CW two-tone signals. Also, it's improved the adjacent channel power ratio(ACPR) more than 7 dB for IS-95 CDMA signals.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.10 s.113
• /
• pp.943-952
• /
• 2006

The OFDM system is very good for the high data rate communication system. However, OFDM system has a high PAPR problem. This makes the OFDM signal distorted through the nonlinear HPA(High Power Amplifier). To solve this problem, generally, simple PAPR reduction methods have been considered. However, in this paper, we introduce IMD reduction method instead of PAPR. PAPR is the signal property and the IMD is signal component of the HPA output, which degrades the communication quality. So, instead of PAPR we want to use the IMD reduction method. This is to transmit a signal with the smallest distortion by considering the third order nonlinearity when the data is recovered. We use the TR method that was proposed for the PAPR reduction and we find out the BER performance of two methods. As results, we show that the IMD reduction method improves better BER performance than the PAPR reduction.

• Journal of electromagnetic engineering and science
• /
• v.10 no.2
• /
• pp.73-77
• /
• 2010

This paper proposes a novel memory effect measurement technique in RF power amplifiers(PAs) using a two-tone intermodulation distortion(IMD) signal with a very simple and intuitive algorithm. Based on the proposed predistortive tone cancellation technique, the proposed measurement method is capable of measuring the relative phase and magnitude of the third-order and fifth-order IMDs, as well as the fundamental signal. The measured relative phase between the higher and lower IMD signal for specific tone spacing can be interpreted as the group delay(GD) information of the IMD signal concerned. From the group delay analysis, we can conclude that an adaptive control of GD as well as the magnitude and phase is a key function in increasing the linearization bandwidth and the dynamic range in a predistortion(PD) technique.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.1
• /
• pp.32-37
• /
• 2007

A DMB CMOS power amplifier (PA) with high efficiency and linearity is present. For this work, a 0.13-um standard CMOS process is employed and all components of the proposed PA are fully integrated into one chop including output matching network and adaptive bias control circuit. To improve the efficiency and linearity simultaneously, an adaptive bias control circuit is adopted along with second harmonic termination circuit at the drain node. The PA is shown a $P_{1dB}$ of 16.64 dBm, power added efficiency (PAE) of 38.31 %, and power gain of 24.64 dB, respectively. The third-order intermodulation (IMD3) and the fifth-order intermodulation (IMD5) have been -24.122 dBc and -37.156 dBc, respectively.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.8
• /
• pp.580-587
• /
• 2003

In this paper, we introduce a novel model to analyze the linearity of a TW-EAM (traveling-wave electroabsorption modulator). The device length, microwave loss (ML), and internal reflection (IR) due to impedance mismatch have effect on the linearity of a TW-EAM. The longer devices have characteristics of lower biases with minimum IMDS (intermodulation distortions). ML decreases the output power as well as the IMD value. Internal reflection has different nonlinear characteristics according to the wavelength of the input frequency and the device length. There is little change in SFDR (spurious-free dynamic range) due to ML or IR. As a result, for a 50 GHz band RF-optical communication system, a 0.8 mm-long TW-EAM with the lowest ML would have better properties by using n, which is caused by impedance, mismatch at the output port.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.10
• /
• pp.97-102
• /
• 2004

In this paper, a new predistorter controlling modified individual order jntermodulation distortion signals is proposed. The proposed predistorter generates and controls predistorted third and high order IM signals independently. Using predistorted signals, jntermodulation distortion signals of power amplifier are suppressed effectively. The predistortion linearizer has been implemented to operate in Korean PCS basestation transmitting band (1840～1870MHz). The test results show that IMD3 and IMD5 (C/I) of power amplifier are improved more than 40dB and 23dB for CW two tone signals, respectively. The predistorter improves the adjacent channel power ratio (ACPR) more than 10dB at 885KHz offset point for CDMA (IS-95) signals.

• Proceedings of the IEEK Conference
• /
• 2001.06a
• /
• pp.193-196
• /
• 2001

To reduce third-order intermodulation distortion(IMD3) generated in the down-conversion process of the mixer, predistortion technique was proposed and its performance was verified fDr Cellular band circuit. This method is based on the fact that down converted IMD3 of a down conversion mixer could be canceled by that of predistortor with a fine tuned vector modulator. Two tone test has been performed at 836 Mhz with 442 KHz separation. The results showed that IM3 level was improved about 16dB and PldB of the mixer was increased 3dB. from the above results, the suggested technique is useful to design the down converters for communication system .