• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.9
• /
• pp.626-633
• /
• 2020

This study examined the behavior of the ground by comparing the methods using the results of the Terzaghi formula and the ground investigation data and method considering the dilatancy effect for a circular tunnel using the finite element method. In the case of the Terzaghi formula, the tunnel load can be overestimated and cause overdesign. The method using the results of the ground investigation data cannot be applied when a reasonable coefficient of earth pressure is not determined. This is because it behaves completely differently from the actual behavior, and unexpected problems can occur. In the case of the method considering the dilatancy effect, however, both the strength enhancement effect can be considered through the dilatancy angle and relative density. Therefore, the tunnel load was calculated most reasonably using the method considering dilatancy. Finite element analysis using the geotechnical survey results showed that the tensile stress acts at the top of the tunnel when the upper soil of the tunnel is shallow. On the other hand, additional verification is necessary, such as a comparison with the field measurement results. Through additional research, if normalized, the tunnel load can be calculated reasonably at the time of tunnel design, and safe and economical design is possible.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.9
• /
• pp.167-176
• /
• 2004

Underground structures will be affected by the additional surcharge loads such as traffic load et al. Terzaghi (1956) suggested the equation on the influences of surcharge loads in vertically backfilled spaces. In field, the shapes of backfill spaces are not always formed vertically. Then the Terzagi (1956) equation is not suitable to use because of boundary condition. This study suggests equation to calculate the stress in backfilled space caused by surcharge loads when the backfilled space is sloped symmetrically. The suggested equation is verified by carbon box test and numerical analysis. The experimental results show good agreement with the suggested equation but the numerical analysis result shows a little disagreement. The differences are estimated to be caused by the fact that ground made by carbon rod has become more dense and internal frction and wall friction has increased itself as surcharge load is added but that this increase can not be considered in the numerical analysis. The suggested equation shows good agreement with Terzaghi (1956) equation in case of sloped backfill ground. According to the results, it is considered that the suggested equation can be applied not only to sloped space but also to vertical space. Further investigation using full scale experiment is needed.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1998.03a
• /
• pp.111-118
• /
• 1998

• Proceedings of the Korean Geotechical Society Conference
• /
• 2001.03a
• /
• pp.387-394
• /
• 2001

An apparent earth pressure envelope for anchored walls proposed by FHWA was compared with Terzaghi & Peck's earth pressure envelope. The anchor design load, the maximum bending moment and the penetration depth were calculated by a simple beam analogy method for each type of envelope.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.10a
• /
• pp.570-580
• /
• 2005

NATM 터널에 작용하는 토압(이완하중)의 크기는 지형조건, 지질조건등에 따라 다르므로 정량적으로 산정하기에는 다소 어려움이 있으며, 실무적으로 Terzaghi(1946)가 제안한 암반의 이완하중을 적용하고 있다. Terzaghi 암반이완하중은 지형상 저토피, 편경사등을 고려하기에는 다소 무리가 있고 특히, 설계시 시공중 공용후 터널에 편토압이 작용한다고 예측하는 것은 더욱 어렵다고 할 수 있다. 본 연구에서는 저토피 편경사지형에서 터널의 문제점 보강대책방안에 대하여 종합 검토하였으며, 실제 지형상 저토피, 편경사를 이루나 암질이 양호하다고 판단되어 아칭 효과를 기대할 수 있을 것으로 예상되는 터널이 굴착과정중 설계시 추정된 지반조건과 상이하여 터널지보재(숏크리트)의 균열 및 이상 변위가 발생된 터널에서 보강대책방안으로 인버트폐합을 실시하여 안정된 터널굴착을 할 수 있었던 사례를 소개하고 저토피 편경사 지형에서 NATM 터널의 설계 시공시 유의사항에 대하여 검토하였다.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.14 no.3
• /
• pp.553-563
• /
• 1994

The behavior of earth retaining structure was investigated by considering coupling between soil springs in elasto-plastic soil. For the computation of soil reaction, soil on both sides of walls was simplified as e1asto-plastic springs, and the required horizontal displacement to mobilize Terzaghi's active and passive state was applied to construct the p-y curve. Reliability on computer program developed is verified through the comparison between prediction and in-situ measurements. Based on the results obtained, it is found that the prediction by using coupling between soil springs simulates well the general trend observed by the in-situ measurements. It is also found that the horizontal displacement required for the active state gives a very small effect to the displacement of walls in the sandy soil.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.12 no.4
• /
• pp.167-177
• /
• 1992

This study analyses theoretically the bearing capacity of shallow foundation, considering the effect of roughness of base. The new bearing capacity factors based on the concept of limit equlibrium are succesfully derived. The simplified formula corresponding to the newly derived expressions are developed as well. The results of the present study are comparable to the conventional theories i.e., Terzaghi's, Meyerhofs, Vesic's and Yamaguchi's. In conclusion it is recommended that the upper limit of friction angle of soil be ${\varphi}=40^{\circ}$, and the angle of base friction be adquetely used with various ranges of ${\varphi}$ for safe designs and constructions.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.1172-1177
• /
• 2008

The best way to gain optimal results on the bearing capacity is to perform the plate bearing test on field but it is not always possible. In the case of not performing the bearing test but estimating bearing capacity equations, it is not yet determined what equation is appliable. In this paper the results of bearing capacity equation and the loading tests of 12 samples were compared and what the one is more reliable than others was verified. The comparison showed that the range of the values using Hansen's equation was 0.67 and 1.44 times of the measured, that of Vesic's was 0.71 and 1.27, that of Meyerhof is 0.69 and 1.1, and that of Terzaghi was 0.87 and 1.57.

• Geotechnical Engineering
• /
• v.5 no.1
• /
• pp.19-26
• /
• 1989

In this study, the finite element method for nonlinear problems is developed theroretically to see the design loads of foundation, when the circular plate resting on elasto-viscoplastic soil medium is loaded axisymmetrically. The paper shows that the plastic zone of soil medium is displayed at the near the edge of plate at the first place; when the plastic zone of soil medium is linked around central axis, the external load is termed by allowable load or design load, and then the contact pressure changes abruptly, in this case it is approved to be the risk of shear failure. The results of numerical analysis using the Mohr-Coulomb yield criterion, and experimental analysis for a appropriate safety factor are approximative, but numerical results are smaller than the value based on Terzaghi's theory.

• Journal of the Korean GEO-environmental Society
• /
• v.22 no.8
• /
• pp.13-19
• /
• 2021

In the case of construction on soft ground - such as national expressways sponsored by Social Overhead Capital (SOC) - many problems occur due to excessive settlement: therefore, an accurate settlement prediction has a major impact on the selection of improvement methods, project budget and construction period. Most of the settlement prediction methods currently used in projects apply Terzaghi's Theory of One-Dimensional Consolidation which assumes the uniformity of the depth of the soft ground. However, the results of soft ground settlement predictions vary when the target layer is divided into multiple horizontal layers. This study analyzed the change in the consolidation settlement behavior according to the horizontal division of soft ground as well as with different loading height.