• Journal of Practical Agriculture & Fisheries Research
• /
• v.23 no.2
• /
• pp.15-24
• /
• 2021

For the aquaculture industrialization of surf clam (Tresus keenae), it is important to basic data on the marine environment of the habitat of surf clam (T. keenae). In this study, we investigated the marine environment of habitat of surf clam (T. keenae) and sought to basic data for the preparation of surf clam (T. keenae) for artificial seed production. The water temperature of the habitat of surf clam (T. keenae) was the lowest in winter and appeared high in summer. The salt concentration showed it range from 31.2 to 33.9 psu. The pH showed it range from 7.69 to 8.70, with high pH in winter and low pH in summer. The dissolved oxygen(DO) was showed it range from 6.20 to 10.24 mg / L and the autumn was relatively higher than the spring and winter. The species composition of phytoplankton was about 30 to 40 species, and most of them were diatoms. The abundance of seasonal phytoplankton showed it range from 23.5 to 61.3 cells / ml, showing seasonal differences. The expression of dominant species also showed a difference depending on the season. As for the particle size composition of the sediment, sandy silt was the most distributed. Flow velocities appeared at 50-80 cm / s in the southeast direction at ebb tide and at 60-100 cm / s in the northwest direction at flood tide. The results of this study can be used as basic data for providing knowledge about the habitat and marine environment of surf clam (T. keenae) and for studying shellfish that inhabit the sedimentary layer.

• Korean Journal of Microbiology
• /
• v.49 no.1
• /
• pp.30-37
• /
• 2013

This study was carried out to assess the spatial and tidal effects on the water quality in the lower reaches of Taewha River, Ulsan, Korea and to understand the environmental factors affecting winter algal bloom in the river. From May, 2010 to January, 2011, water samples were collected at five locations (New Samho Bridge, Old Samho Bridge, Mungjung Stream, Taewha Bridge, and Mungchon Bridge) along the river at high and low tides of spring tide. We measured environmental parameters including salinity, dissolved oxygen (DO), biological oxygen demand (BOD), chemical oxygen demand (COD), chlorophyll a (Chl a) and various nutrient concentrations. Salinity increased towards the downstream direction. Average values of Chl a concentrations ranged $10-26mg/m^3$ at high tide and $11-53mg/m^3$ at low tide depending on sampling locations. It was noteworthy that there were strong increases in Chl a concentrations during the November 21 to December 22 sampling period especially at the Taewha Bridge. At the location, Chl a concentrations were measured as $138-296mg/m^3$ for the period; Rhodomonas lacustris of class Cryptophyceae was the dominant algal species. Chl a concentrations at the Taewha Bridge were positively correlated with such parameters as salinity, BOD, DO, COD, pH, and T-N, and negatively correlated with temperature and $NO_3{^-}$-N. On the other hand, at the Mungchon Bridge the highest concentration of Chl a was $55mg/m^3$ on August 25, and Chl a concentrations were positively correlated with $NH_3$-N, T-N, $PO_4{^{3-}}$-P, T-P, and heterotrophic plate counts. The results suggested that water quality in the lower Taewha River fluctuated a lot with the sampling locations and the patterns of algal blooms were different between Taewha Bridge and Mungchon Bridge sampling locations.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.11 no.2
• /
• pp.70-77
• /
• 2008

In this study, to establish countermeasure from marine casualties as a basic study fur long-term prediction of topographical change around Jinudo in the Nakdong river estuary, spatio-temporal topographical change monitoring was carried out. Also, in order to estimate the deposition variations concerning SS (Suspended Solid) flux which moved at St.S1 during neap and spring tide, respectively. From the topographical monitoring, it was found that the annual mean ground level and deposition rate were 141 mm and 0.36 mm/day and all parts except the northern part of Jinudo had the active topographical changes and a tendency to annually deposit. From vertical distribution of SS net fluxes, $SS_{LH}$ (latitudinal SS net flux) during spring tide overall flows average 28 $kg/m^2/hr$ (eastward), and $SS_{LV}$ (longitudinal SS net flux) flows average 11.1 $kg/m^2/hr$ (northward). And, $SS_{LH}$ overall flows average 4.8 $kg/m^2/hr$ (eastward), and $SS_{LV}$ flows average 1.5 $kg/m^2/hr$ (northward) during neap tide similar with spring tide. The depth averaged values of the latitudinal and longitudinal SS net fluxes during spring tide were approximately 6 times higher than those during neap tide. As result of, it was considered that topographical change of southern part of Jinudo was affected by resuspension of bottom sediments due to strong current in bottom layer during flood flow.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.05a
• /
• pp.759-761
• /
• 2001

한반도 동해의 외해역(울릉도) 및 내해역에서(포항 및 묵호)의 조사된 T/P 해면자료와 TG해면자료간의 상관성이 각각 어떻게 나타나는가를 파악하기 위하여 본 연구를 수행하였다. 이때의 1992년 10월부터 1997년 12월까지 관측된 T/P자료와 TG자료를 각각 이용하였다. 본 연구로부터 우리는 다음과 같은 몇 가지 결과를 알 수 있었다. 1) 비교적 조석의 영향이 우세한 내해역에 위치한 포항 및 묵호가 외해역에 위치한 울릉도에 비해서 낮은 상관성을 보였다. 이러한 큰 차이는 M2, S2, Kl 분조 등에 의한 조석변형 때문에 발생하는 현상이다. 이것은 주로 T/P자료에 기인하는 조석오차이다. 2) 조석변형 때문에 발생하는 신호는 해양신호와 관계없는 잘못된 거짓신호로서 이를 제거하기 위해서는 lowpass filter를 적용하는 것이 좋다. 대체로 외해역의 경우는 60일, 120일, 180일, 200일의 필터를 순차적으로 처리함에 따라 상호 두 자료간의 유의성이 점차적으로 개선되는 것을 알 수 있었으나, 내해역의 경우에는 거의 유의성이 개선되지 않는 것으로 나타났다. 3) 200일의 필터를 처리했을 때, 외해역에 위치한 울릉도는 상관값이 0.91로 매우 높은 유의성을 보였고, 그리고 내해역에 위치한 포항 및 묵호는 각각 0.58 및 0.65로서 울릉도에 비해서 상대적으로 낮은 유의성을 보였다.

• Journal of Korea Water Resources Association
• /
• v.35 no.4 s.129
• /
• pp.425-442
• /
• 2002

The land reclamation area of Saemangeum(Kunsan) is located between $126^{\circ}10'\;E{\sim}126^{\circ}50'\;E\;and\;35^{\circ}35'\;N{\sim}36^{\circ}05'\;N$ at the western coast of the Korean peninsula. The reclamation area of Saemangeum has a range of 5.6m spring tide and the maximum tidal current speed is about $1.41m\;s^{-1}$. In ordinary spring tide. Most of the sediments deposited on the tidal flats are transported from the Geum river, the Mankyung river and the Dongjin river. The soil in this area consists of silty sand with the depth of 10m to 30m. The wind in winter is strong from the direction of northwest. Saemangeum coastal area is being constructed 33km the sea dike and 40,100ha reclamation area. The purpose of this study Is to find the residual circulations in four seasons before and after the dike construction by a robust diagnostic and prognostic numerical model.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2003.05a
• /
• pp.157-164
• /
• 2003

Introduction of wave model, considered the effect of tide, wind and wave induced currents at the coastal waters of complex bathymetry, is a very important factor for most coastal engineering design and disaster protection problems. As the steady state spectral wave model could simulate depth induced wave shoaling and refraction, current induced refraction effect, steepness induced wave breaking, diffraction, wind wave growth, and wave-wave interaction that redistribute energy, this would support and compensate the gap in the real field of design where other wave models could not deal and cause wrong estimation. In this study, for that sense, we applied the spectral wave model t the large coastal waters near Gaduck Island where the Busan new port construction project is going on, for better understanding and analysis of wave transformation process. We also compared the simulation results with the calculated from the existing model. From such a trial of this study, we hope that broader and sager use of the spectral model in the area of port design and disaster prevention system come through in near future.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.9 no.1
• /
• pp.36-44
• /
• 2006

Cohesive sediment transport in coastal region has been studied by numerical modeling. A finite element numerical model was setup to simulate hydrodynamics and sediment transport in the coastal region with complex topography. Only physical features of observed sediments has been used to determine erosion rates of bottom sediments together with the previous research results. The simulation results using the simply determined equation of erosion rates were compared with time variations of the observed SS concentration and showed good agreements. In conclusion, this method can be used to estimate transport of cohesive sediment conveniently.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2006.06a
• /
• pp.195-196
• /
• 2006

Recently, there are increasing need to make a synthetic assessment about oceanic data which is collected over the various scientific field, in addition to just gathering oceanic data. In this study, we made a basic map using satellite image, aerial photo, multi-beam data, geological stratum data etc. And as well we are producing comprehensive SVT(Scientific Visualization Toolkit) which can visualize various kinds of oceanic data. These oceanic data include both survey data such as tidal height, tide, current, wave, water temperature, salinity, oceanic weather data and numeric modelling results such as ocean hydrodynamic model, wave model, erosion/sediment model, thermal discharged coastal water model, ocean water quality model. In this process, we introduce GIS(Geographic Information System) concepts to reflect time and spatial characteristics of oceanic data.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.6 no.1
• /
• pp.1-12
• /
• 2001

Tidal computations of $M_2,\;S_2,\; K_1$ and $O_1$ constituents in the northeast Asian sea are presented by blending the Topex/Poseidon (T/P) altimeter data into a hydrodynamic model with $5'{\times}5'$ resolution. A series of sensitivity experiments on a weighting factor, which is the control parameter in the blending method, are carried out using $M_2$ constituent. The weighting factor is set to be in inverse proportion to the square root of water depth to reduce noises which could occur in data-assimilative model by blending T/P data. Model results obtained by blending the T/P-derived $M_2,\;S_2,\; K_1$ and $O_1$ constituents simultaneously are compared with all T/P-track tidal data; Average values of amplitude and phase errors are close to zero. Standard deviations of amplitude and phase errors are approximately 2 cm and less than 10 degrees respectively. The data-assimilative model results show a quite good agreement with T/P-derived tidal data, particularly in shallow water region (h<250m). In deep water regions, T/P-derived tidal data show unreasonable spatial variations in amplitude and phase. The data-assimilative model results differ from T/P-derived data, but are improved to show reasonable spatial variations in amplitude and phase. In addition, the T/P-blended model results are in good agreement with coastal tide gauge data which are not blended into the model.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.24 no.2
• /
• pp.117-122
• /
• 1991

Microbial organisms including yeast, Acinetobacter sp. AG-3, Chlorococcum sp., Chlorella sp. and some of their combinations were tested to evaluate growth efficiency of Tigriopus japonicus. Body length and weight of the copepoda were measured during four days experiment. Acinetobacter sp. AG-3, dried yeast(produced Wago), Chlorella sp., Chlorococcum sp. and mixed culture were used as food sources. Yeast(Y.) was the most effective food for the growth during nauplius stage and efficiencies of bacteria(Bact.)+chlorococcum sp.(RA), Chlorococcum sp.(RA), Bact.+chlorella sp.(Ch.), Bact. and Ch. decreased in odor, while for the growth of copepodite and adult, Bact.+RA was the most effective food with decreased efficiency of Y., RA, Bact. + Ch., Bact., Ch. in order. The ratio of weight gain to the food uptaken, after the weight and food units were converted to carbon, was between 21.6 and $68.7\%$, This result suggests that some kinds of bacteria, algae and mixed cultural microorganisms could be good food sources for the growth of copepoda.