• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11b
• /
• pp.902-907
• /
• 2002

An equivalent electroacoustic circuit approach of estimating the sound absorption coefficient for parallel perforated plate system is proposed. The proposed approach is validated by comparing the calculated absorption coefficients of a parallel single layer perforated plate system with the values measured by the two-microphone impedance tube method for various porosity and the number of perforated plate. The sound absorbing performances of parallel and series perforated plate systems are compared and discussed from a standpoint of frequency bandwidth with sound absorption. The proposed approach is further extended to the parallel double layer perforated plate system.

• Journal of Advanced Marine Engineering and Technology
• /
• v.30 no.3
• /
• pp.396-402
• /
• 2006

In this study, dynamic characteristics of water hammer pressure in water supply piping system with water hammer arrester has been investigated experimentally to characterize the transient pressure of water hammer in high rise building. Experiments were conducted to verify the absorption effects by water hammer arresters with 3 different gas volumes of water hammer pressure generated by sudden valve closure. As the results, it has been found that zoning and sizing of pipe diameter for suitable flow velocity and water hammer arresters with effective pressure absorption capacity have to be installed to protect water hammer problems in building water supply piping system.

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.14 no.1
• /
• pp.1-11
• /
• 1985

Solar/absorption cooling system was analyzed and its operating condition was examined. For the system, the optimum size of absorption refrigerator and collector area should be determined. As the temperature of water supplied to the generator increases, the collector efficiency decreases whereas the coefficient of performance of absorption refrigerator increases up to a certain point, and vice versa for decreasing of the temperature of water supplied to the generator . Thus if the reeling load is given, the appropriate operating condition can be determined between the two opposing trends by simulation program. As an example of the simulation, the case of Jejudo province was studied. Under the conditions (such as weather data and prices of components, etc.) given en the sample calculation, the result shows that the optimum temperature of water supplied to the generator turned out to be $80.3^{\circ}C$, and still shows a large economical disadvantage in present stage compared to the case of conventional vapor compression cooling/heating combined heat pump system.

• Journal of the Korean Society of Combustion
• /
• v.9 no.3
• /
• pp.27-35
• /
• 2004

Diode laser absorption sensors are advantageous because they may provide fast, sensitive, absolute, and selective measurements of species concentration. These systems are very attractive for practical applications owing to its compactness, resonable cost, robustness, and ease of use. In addition, diode lasers are fiber-optic compatible and thus enable simultaneous measurements of multiple species along a line-of-sight. Recent advances of room-temperature, near-IR and visible diode laser sources for telecommunication, optical data storage applications make it possible to be applied for combustion diagnostics based on diode laser absorption spectroscopy. Therefore, combined with fiber-optics and high sensitive detection strategies, compact and portable sensor systems are now appearing for variety of applications. The objectives of this research are to develope a new gas sensing system and to verify feasibility of this system. Wavelength and power characteristics as a function of injection current and temperature are experimentally found out. Direct absorption spectroscopy has been demonstrated in these experiments and has a bright prospect to this diode laser system.

• 한국가스학회:학술대회논문집
• /
• 1998.09a
• /
• pp.249-254
• /
• 1998

This paper describes the study of developing air-cooled absorption system which uses a new working solution instead of LiBr solution to improve the performance of system. The absorption chiller-heater considered was an air-cooled, double-effect, $H_2O/LiBr+HO(CH_2)_3$ system of parallel flow type. In this study, we found out the characteristic of new working solution through the cycle simulation and compared the result that of LiBr solution to evaluate. The new working fluid has a wider working range with $8\%$ higher crystallization limit at the saturated refrigerant pressure of 0.8kPa. The optimum designs and operating conditions of air-cooled absorption system were suggested based on this cycle simulation analysis. It was demonstrated that new working fluid substantially improves the performance of the absorption refrigeration machine and is expected to increase the COP by as much as $5\%$.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.17 no.3
• /
• pp.250-255
• /
• 2005

The objective of this paper is to develop a new energy transport system for district cooling application by using type 2 absorption cycle. Cold energy from the LNG storage system is utilized as the cooling source of the condenser and the rectifier. The pressures of the system, UAs of the evaporator and the desorber, and the inlet temperatures of the refrigerant to each component are considered as the key parameters. The results show that UA of the evaporator is more dominant parameter on COP than that of the desorber and the optimum system pressure for the demand side is estimated as 525 kPa. For the present system, it is recommended that the refrigerant inlet temperature of the evaporator be lower than $4.3^{\circ}C$ for long-distance transportation. It is concluded that the cold energy from the LNG storage system can be effectively applied to the long-distance transportation system for district cooling application with the type 2 absorption cycle. The optimum operation conditions are also predicted from the parametric analysis.

• Textile Coloration and Finishing
• /
• v.27 no.4
• /
• pp.270-274
• /
• 2015

Molecules always show broad absorption band envelopes, and this results from the vibrational properties of bonds. The width of an absorption band can have an important influence on the color of a dye. A narrow band imparts a bright, spectrally pure color to the dye, whereas a broad band can give the same hue, but with a much duller appearance. Typically, half-band widths of cyanine dyes are about 25nm compared to value of over 50nm for typical merocyanine dyes. Thus, cyanine dyes are exceptionally bright. The factors influencing the width of an absorption band can be understood with reference to the Morse curves. The width of the absorption band depends on how closely the bond order of the molecules in the first excited state resembles that in the ground state. We have quantitatively evaluated the "molecular structure-absorption band shape" relationship of dye molecules by means of Pariser-Parr-Pople Molecular Orbital Method(PPP-MO).

• Journal of the Korean Institute of Gas
• /
• v.3 no.1
• /
• pp.14-20
• /
• 1999

This study describes the results of Coefficient of Performance(COP) analysis by cycle simulation for two types of absorption-compression hybrid cycle using the Water/Lithium Bromide solution pair. These types are basic hybrid systems introducing a mechanical compression process into the refrigerant vapor phase of the single effect absorption cycle. In absorption-compression hybrid cycles, coefficient of performance is improved compared with absorption cycle. Hybrid cycle Type 2 is considered as a key technology to support energy utilization system, given its capability of utilizing waste heat to drive system with a high level of efficiency.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.9 no.4
• /
• pp.135-144
• /
• 2014

This study has examined how the childcare teachers have been evaluating themselves on system absorption who have been working in the house of the children at the time when the sight of the society has been expanding to the house of the children through the spread of the understanding of the importance of the role and the strengthening of the leadership of the diverse types of the leadership of the childcare teachers in the house of the children, and also this study has observed the main causes affecting such situations. This study has also analyzed the main causes such as the cause of self understanding on job satisfaction of the children's house teachers, the cause of self understanding on the leadership of the principal, demographic characters, and characters related with the place of work affecting the system absorption(Emotional Absorption, Normative absorption, and lasting absorption) with the children's house teachers as the objects working in the area of the City of Seoul. The results of the analysis have showed that job satisfaction, individual consideration, intellectual stimulation, giving motive, age, schooling, type and scale of facility, grade and others have been appeared to have been significantly affecting the self evaluation on system absorption demographically. In other words, the child care teachers have had higher degree of reaction to the system absorption in affirmative direction when they come into contact with the leadership of the principal in raising the intellectual stimulation, providing the motivation, and giving consideration individually, and when they have higher evaluation on the job satisfaction they them selves understand. Based on such results the principal of the house of the children should spread the leadership for the careful operation of the house of the children for the teachers more positively, and what has been required was giving and developing the diverse operation service for the elevation of the job satisfaction of the childcare teachers.

• 한국가스학회:학술대회논문집
• /
• 1998.09a
• /
• pp.255-260
• /
• 1998

This study describes the results of Coefficient Of Performance(COP) analysis by cycle simulation for two types of absorption-compression hybride cycle using the water/Lithium Bromide solution pair, These types are basic hybride systems introducing a mechanical compression process into the refrigerant vapor phase of the single effect absorption cycle. In absorption-compression hybrid cycles, coefficient of performance is improved compared with absorption cycle. Hybride cycle Type ll is considered as a key technology to support energy utilization system, given its capability of utilizing waste heat to drive system with a high level of efficiency.