• Journal of Advanced Navigation Technology
• /
• v.2 no.1
• /
• pp.22-33
• /
• 1998

In the coherent-on-receiver radar system using the magnetron source, frequency synthesizer is employed as a STALO(Stable Local Oscillator) to keep the intermediate frequency stable. In this paper, X-band(8.4GHz~9.7GHz) single loop frequency synthesizer is designed and implemented by an indirect frequency synthesis technique. Phase comparison is performed by a digital PLL(Phase-Locked Loop) chip and the loop filter is designed for the low phase noise. The effects of loop component characteristics on the output phase noise are analyzed for single loop structures, and the calculated results are compared with the measured data.

• Journal of electromagnetic engineering and science
• /
• v.11 no.2
• /
• pp.105-112
• /
• 2011

In phase-locked frequency synthesizers, a fast-lock technique is frequently employed to overcome the trade-off between a lock-time and a spurious response. The function of fast-lock in a conventional PLL (Phased Lock Loop) IC (Integrated Circuit) is limited by a factor of 16, which is usually implemented by a scaling of charge pumper, and consequently a lock time improvement of a factor of 4 is possible using the conventional PLL IC. In this paper, we propose a novel external active fast-lock loop filter. The proposed loop filter provides, conceptually, an unlimited scaling of charge pumper current, and can overcome conventional trade-off between lock-time and spur suppression. To demonstrate the validity of our proposed loop-filter, we fabricated an X-band frequency synthesizer using the proposed loop filter. The loop filter in the synthesizer is designed to have a loop bandwidth of 100 kHz in the fast-lock mode and a loop bandwidth of 5 kHz in the normal mode, which corresponds to a charge pumper current change ratio of 400. The X-band synthesizer shows successful performance of a lock-time of below 10 ${\mu}sec$ and reference spur suppression below -64 dBc.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.10
• /
• pp.971-978
• /
• 2013

This work presents a W band frequency synthesizer which is composed of 26 GHz VCO, Phase Locked Loop and frequency tripler using 65 nm RF CMOS process. Frequency tuning range of 26 GHz VCO covers the band from 22.8~26.8 GHz and final output frequency of the tripler is from 74 to 75.6 GHz. The fabricated frequency synthesizer consumes 75.6 mW and its phase noise is -75 dBc/Hz at 1 MHz offset, -101 dBc/Hz 10 MHz offset respectively.

• Journal of Radiopharmaceuticals and Molecular Probes
• /
• v.8 no.2
• /
• pp.87-93
• /
• 2022

[¹⁸F]FDG is known as the most widely used radiopharmaceutical in the imaging field of nuclear medicine worldwide. With the introduction of PET equipment, the demand for [¹⁸F]FDG has increased and the production volume has also increased. However, in order to increase production, the use of ¹⁸F radioisotope must be increased or [¹⁸F]FDG must be synthesized in high yield. Therefore, in order to meet the high yield and purity of radiopharmaceuticals, a radiopharmaceutical automatic synthesizer was required. As the use of [¹⁸F]FDG increased, automated synthesizer manufacturers supplied various types of radiopharmaceutical automated synthesizers to the market. In this study, we developed a commercialized [¹⁸F]FDG radiopharmaceutical automatic synthesizer (sCUBE FDG) using a disposable cassette type that complies with GMP developed by FutureChem, a leading radiopharmaceutical company. We used sCUBE FDG to verify the production process, radiopharmaceutical's quality (radiochemical purity, etc.), and radiochemical yield of [¹⁸F]FDG. As a result of optimizing the automatic synthesis process and synthesizing a total of 30 times, the production time was 35 ± 3 minutes and the average production yield was 65.6%.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.1
• /
• pp.69-75
• /
• 2010

In this paper, with using the clapp type VCO(Voltage Controlled Osillator) configuration a wideband frequency synthesizer in UHF band is proposed. In order to design a wideband frequency synthesizer, the variation of phase in the negative resistance circuit as well as the load circuit was analyzed. Based on this result we propose a method to widen the operation range of the VCO. A frequency synthesizer using the proposed wideband VCO was designed and fabricated. It is shown that the synthesizer has the operating frequency range of 740~1,530 MHz by 0~5 V varactor tuning voltage, and it had the output power of 2~-6 dBm. Moreover, the phase noise measured as -77 dBc/Hz at 10 kHz offset, and as -108 dBc/Hz at 100 kHz offset from the oscillation frequency.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.12
• /
• pp.57-63
• /
• 2016

This paper describes implementation of the RF frequency synthesizer with $0.18{\mu}m$ silicon CMOS technology being used as an application of the IEEE802.15.4g SUN sensor node transceiver modules. Design of the each module like VCO, prescaler, 1/N divider, ${\Delta}-{\Sigma}$ modulator, and common circuits of the PLL has been optimized to obtain high speed and low noise performance. Especially, the VCO has been designed with NP core structure and 13 steps cap-bank to get high speed, low noise, and wide band tuning range. The output frequencies of the implemented synthesizer is 1483MHz~2017MHz, the phase noise of the synthesizer is -98.63dBc/Hz at 100KHz offset and -122.05dBc/Hz at 1MHz offset.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.8
• /
• pp.777-786
• /
• 2003

The phase noise characteristics of the phase-locked loop frequency synthesizer were predicted based on the analysis for phase noise contribution of noise sources. The proposed phase noise model in this paper more accurately predicts the phase noise spectrum of frequency synthesizer. To accurately model the phase noise contribution of noise sources in frequency synthesizer, the phase noise sources were analyzed via modeling of the frequency divider and phase noise components using Leeson model for reference signal source and VCO. The phase noise transfer functions to VCO from noise sources were analyzed by superposition theory and linear operation of phase-locked loop. To evaluate the phase noise prediction model, the frequency synthesizers were fabricated and were evaluated by measured data and prediction data.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.8
• /
• pp.809-815
• /
• 2003

It is very important to get very high switching speed as well as low phase noise of frequency synthesizer in the OFDM/FH communication system. In this paper we compare the phase noises and switching speeds of the conventional PLL and digital hybrid PLL(DH-PLL) frequency synthesizer, also, we investigate the effect of phase noise on the performance of OFDM/FH communication system. DH-PLL has high switching speed property at the cost of circuit complexity and more power consumption. Unlike the conventional PLL in which the phase noise and switching speed have the trade off relationship in respect of loop filter bandwidth, DH-PLL frequency synthesizer can perform fast switching speed and low phase noise simultaneously. Under the condition of same hopping speed requirement, DH-PLL can achieve faster switching speed and lower SNR penalty compared with conventional PLL in the OFDM/FH communication system.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.2
• /
• pp.73-78
• /
• 2011

A frequency synthesizer for DAB applications is designed using $0.18{\mu}m$ CMOS process with 1.8V supply. NP-core type is chosen for VCO core to improve low power characteristic and symmetric characteristic of output waveform. VCO range is 1302.34 MHz - 1949.51 MHz using switchable capacitor bank and varactor bank. Varactor biases that improve varactor capacitance characteristics were minimized as two, $K_{vco}$(VCO gain) is maintained using technique of varactor bank switching. Intervals of $K_{vco}$ are maintained adding VCO frequency compensation logic. Each block of VCO and frequency synthesizer designed $0.18{\mu}m$ CMOS process with 1.8V supply is verified by Cadence Spectre, measured VCO consumes 9mA current, and is 39.8% tuning range, total power consumption of the frequency synthesizer is 18mW.

• Journal of the Institute of Convergence Signal Processing
• /
• v.10 no.2
• /
• pp.141-145
• /
• 2009

A C-to-SystemC synthesizer which processes the input behavior according to high-level synthesis, and then transforms the synthesis result into SystemC module code is implemented in this paper. In the synthesis process, the input behavioral description in C source code is scheduled using list scheduling algorithm and register allocation is performed using left-edge algorithm on the result of scheduling. In the SystemC process, the output from high-level synthesis process is transformed into SystemC module code by combining it with SystemC features such as channels and ports. The operation of the implemented C-to-SystemC synthesizer is validated through simulating the synthesis of elliptic wave filter in SystemC code. C-to-SystemC synthesizer can be used as a part of tool-chain which helps to implement SystemC design methodology covering from modeling to synthesis.