• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2020년도 전력전자학술대회
• /
• pp.145-147
• /
• 2020

본 논문에서는, 결합 인덕터 정류단을 갖는 위상천이 풀브릿지 컨버터에 적용할 수 있는 새로운 동기정류기 제어 기법을 제안한다. 결합 인덕터 정류단을 활용하면 1차측 환류 전류를 감소 시켜 도통 손실을 줄일 수 있지만, 동시에 줄어든 전류로 인하여 레깅-레그 스위치의 영전압 스위칭을 달성하기 어려워진다. 이를 해결하기 위하여 변압기의 자화 전류를 이용할 수 있지만, 컨버터가 넓은 출력 전압 범위로 설계되는 경우 낮은 시비율을 기준으로 작게 설계된 자화 인덕턴스로 인하여, 높은 시비율로 구동 시 과도한 자화 전류로 인한 불필요한 도통 손실이 증가하는 문제점을 갖는다. 제안하는 제어 기법은 기존 동기정류기 제어와 달리 동기정류기를 기존보다 먼저 구동시켜 1차측에 환류 전류를 순간적으로 재생성할 수 있고, 이를 이용하여 레깅-레그 스위치의 영전압 스위칭을 달성할 수 있다. 따라서, 작은 자화 전류로 영전압 스위칭을 달성할 수 있으므로 1차측의 도통 손실을 줄여 높은 효율을 얻을 수 있다. 제안하는 동기정류기 제어 기법의 효용성을 증명하기 위하여, 400V 입력, 27-54V/13A 출력에서 실험 검증을 진행하였다.

• Journal of Power Electronics
• /
• 제15권3호
• /
• pp.634-643
• /
• 2015

This paper presents a high frequency design approach for improving efficiency over a wide load range in the self-driven phase-shifted full-bridge converters for server power systems. In the proposed approach, a detailed ZVS analysis of the lagging leg switches in both the continuous conduction mode (CCM) and the discontinuous conduction mode (DCM) is presented. The optimum dead time and the determination of the appropriate operation mode are given for high efficiency according to the load conditions. Finally, the optimum operation conditions are defined to achieve a high-efficiency. A laboratory prototype operating at 80 kHz, rated 1 kW (12 V-83.3 A), is built to verify proposed theoretical analysis and evaluations. The experimental results show that the maximum efficiency is achieved as 95% and 83.5% at full load and 5% load conditions, respectively.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2004년도 전력전자학술대회 논문집(1)
• /
• pp.141-143
• /
• 2004

Distributed generation(DG) using microturbine will be adopted widely because of its various usages and merits such as high heat efficiency, environmental-friendliness. Commercialized DG using microtubine that rotates up to $60,000\~100,000[rpm]$ converters mechanical power to electricity by permanent magnet synchronous machine. This paper presents comparative test and simulation results of PMSM as generator. Test was done by diode rectifier and inverter. Parameters used in the simulation are driven from FEM analysis. Under various speed and load conditions, V-I characteristics matches well and it suggests the possibility of high speed PMSM as generator. DG operating at stand alone and grid connection mode will be developed.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 F
• /
• pp.1973-1976
• /
• 1998

Recently, new trend in telecommunication device is to apply low voltage, about 3.3V-1.5V. However, it is undesirable in view of high efficiency and power desity which is the most important requirement in the distributed power system. Rectification loss in the output stage, in on-board converter for distributed power system are constrained to obtain high efficience at low output voltage power suppies. This paper explains the basic operational principles of three kinds of ZVS DC/DC converters with self-driven synchronous rectifier. The three topologies are analyzed by simulation and exprimentation, and the characteristics comparisons of high efficience converter are carried out in view of the minimized rectification losses in the out stage.

• Journal of Electrical Engineering and Technology
• /
• 제13권2호
• /
• pp.761-768
• /
• 2018

In this paper, the performance analysis of a control topology based on the direct output power control (DPC) for robust and inexpensive permanent magnet-assisted synchronous reluctance generator (PMa-SynRG) system is presented. The PMa-SynRG might be coupled to an internal combustion engine running at variable speed. A three-phase PWM rectifier rectifies the generator output and supplies the dc link. A single-phase PWM inverter supplies constant ac voltage at constant frequency to the grid. The overall control algorithm is implemented on a TMS320F2812 digital signal processor board. Simulations results and experimental results verify the operation of the proposed system.

• Journal of Electrical Engineering and Technology
• /
• 제11권4호
• /
• pp.860-868
• /
• 2016

A bidirectional DC-DC converter (BDC) is an indispensable electrical unit for the electric vehicles (EVs). High efficiency, high power density, isolation, light weight and reliability are all essential requirements for BDC. In this paper, a 3 kW BDC for the battery charger of EVs is proposed. The proposed converter consists of a half-bridge structure on the primary side and an isolation transformer and a synchronous rectifier structure on the secondary side. With this topology, minimum number of switching devices are required for bidirectional power flow between the two dc buses of EVs. The easy implementation of the synchronous rectification gives advantages in terms of efficiency, cost and flexibility. The proposed BDC achieves high efficiency when operating in both modes (step-up and step-down). A 3 kW prototype is implemented to verify theoretical analysis and the performance of the proposed converter.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 F
• /
• pp.2184-2186
• /
• 1997

Potential-source controlled rectifier excitation system has been developed by KEPRI for synchronous generator in YOUNG-DONG thermal power plant. This paper describes the characteristics of redundant control system and transfer function of dual channel excitation control system. This system has been using a analog and digital circuit devices(hybrid type)

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 ITC-CSCC -2
• /
• pp.1027-1029
• /
• 2002

In this paper, we present the circuit topology and control scheme of single-phase dc/ac inverter based on class E dc/dc converter for automotive application. The proposed inverter consists of class E series resonant inverter and class E low dv/dt PWM synchronous rectifier with bi-directional switch.

• 반도체디스플레이기술학회지
• /
• 제6권2호
• /
• pp.45-48
• /
• 2007

The proposed method offers an improved DC/DC converter scheme to increase power density. It is based on half-bridge topology with newly introduced pulse-grouping control method, which helps to reduce the transformer size and the volume of semiconductor devices maintaining high efficiency. Test results with 85W(18.5V/4.6A) design shows that the measured efficiency is 93.5% with power density of $36W/in^3$.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2005년도 전력전자학술대회 논문집
• /
• pp.113-115
• /
• 2005

본 연구는 저전압 교류 전류원으로부터 직류 부하에 에너지를 공급하기 위하여, 새로운 컨버터를 제안한다. 컨버터는 풀브리지 MOSFET 정류기와 플라이백 컨버터의 2단 구조로 구성되어 있으며, LC공진을 이용하여 AC/DC 전력변환을 수행한다. 컨버터 효율 개선을 위하여 컨버터 회로 내의 스위칭 소자는 3상한에서 동작한다. 제안된 컨버터의 동작원리 및 동작모드를 해석하고, 시뮬레이션을 통해 해석결과를 검증하였다.