• Bulletin of the Korean Chemical Society
• /
• v.26 no.6
• /
• pp.939-942
• /
• 2005

For the detection of cyanobacterial toxin, an Enzyme-linked immunosorbent assay (ELISA) was integrated into a PDMS microchip. The conjugates of microcystin-LR (MCLR) and keyhole limpet hemocyanin (KLH) were adsorbed on the surface of polystyrene beads and these MCLR-KLH polystyrene beads were introduced into a microchamber. MCLR on the surface of polystyrene beads reacted with horseradish peroxides (HRP) conjugated anti-MCLR monoclonal antibody (mAb) which had a competitive reaction with MCLR in water sample. After the enzyme substrate 3,3,5,5-tetramethyl benzidine (TMB) was injected into the chamber and catalyzed by HRP, the color change was detected with a liquid-cord waveguide. This integration shortened the conventional ELISA analysis time from several hours to about 30 min with only 4.2 $\mu$L MCLR sample consuming which was useful for the environmental analysis. More over, troublesome operations required for ELISA could be replaced by simple operations. The microchip based detection system showed a good sensitivity of 0.05 $\mu$g/L and maintained good reliability through its quantitative range with low coefficients of variation (2.5-10.5%).

• Corrosion Science and Technology
• /
• v.19 no.6
• /
• pp.326-336
• /
• 2020

Galvalume steel (GL) is widely used in marine and industrial environments. It is characterized by better corrosion resistance than carbon steel. However, corrosion and economic losses may occur as the usage time is increased. Therefore, in this study, an outdoor exposure test of GL for 36 months was conducted across six regions of Korea. Parameters such as corrosion rate, chrominance (color, chroma, and brightness), glossiness, and surface appearance were analyzed. The results showed no significant change in appearance, and the initial corrosion rate was large, but a tendency to decrease with time was observed. Increased outdoor exposure time led to increase in the level of corrosion products. In the case of coastal areas where S, Cl, and other elements were detected, a relatively high decrease in Zn content was observed. Al forms a protective oxide film and exists in the coating layer, but Zn dissolves due to its chemical activity and low potential.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2008.11a
• /
• pp.195-201
• /
• 2008

When reinforced concrete is subjected to high temperature as in fire, there is deterioration in its properties of particular importance are loss in compressive strength, cracking and spalling of concrete, destruction of the bond between the cement paste and the aggregates and the gradual deterioration of the hardend cement paste. Assessment of fire-damaged concrete usually starts with visual observation of color change, cracking and spalling of the surface. In this paper, it was reported the trends of research and practical use on the Explosive Spalling Properties of the High-Strength Concrete.

• Journal of Applied Reliability
• /
• v.7 no.4
• /
• pp.173-181
• /
• 2007

Out door exposure to daylight and weather climate conditions can cause adverse effect on the properties of automotive plastic materials. The effects of sunlight exposure, especially ultra violet (UV) radiation, can break down the chemical bonds in a polymeric material. This degradation process is called photo-degradation and ultimately leads to color changes, cracking, chalking, the loss of physical properties and deterioration of other properties. To explore the effect of sunlight exposure on the automotive materials, this study investigated photo-oxidation degree and surface property change of molding parts by analytical methods. For the further study, accelerated weathering test methods are proposed, which can correlate with out door weathering, to predict long term performance of automotive plastic materials.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.28 no.4
• /
• pp.339-347
• /
• 2006

Oral leukoplakia is the most common premalignant lesion and malignant transformation has been reported from verrucal lekoplakia. Homogenous, benign leukoplakia develops into a line of squamous cell carcinoma such as verrrucous carcinoma, papillary squamous cell carcinoma and invasive squamous cell carcinoma. Early diagnosis and intervention of premalignant leukoplakia is up-most important to prevent transformation into a oral squamous cell carcinoma. Any change in surface, size and color warrants repeated biopsy. If verrucous carcinoma is evidently derived from the previous leukoplakia, wide surgical excision and periodic follow up is needed. Surgically removed lesion of leukoplakia has the tendency to recur. Follow-up is very important to patient and clinician. Although many therapies have been reported to oral leukoplakia and verrucal carcinoma, accepted treatment principle is not exist so far. But surgical removal is recommended as the treatment of choice.

• Journal of Nutrition and Health
• /
• v.18 no.1
• /
• pp.55-62
• /
• 1985

The storage stability of the developed Formula of infant foods was investigated. The results are summarized as follows : When formula A and B were stored at room temperature and refrigeration temperature, there was no remarkable changes in consistency. In frozen state, formula A showed more stability in consistency than formula B and formula A could be stored for 6 months without problems due to retrogradation of starch. The heat treatment of both A and B resulted in the increase of a-value, while L-and b-value showed no such change. But from the 4th month at room temperature, and 5th to 6th month at refrigeration appeared an increase in a -value, hence the browning reaction, while frozen samples did not show noticeable changes in surface color. The heat treatment also caused an increase in POV on both formula. The extent of changes in POV during storage varied with storage temperatures and samples.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.36 no.1
• /
• pp.61-66
• /
• 2004

Bleached chemithermomechanical pulp (BCTMP) was produced from CTMP of Betula maximowicziana Regel by two staged ozone-hydrogen peroxide bleaching in order to improve the optical properties of high yield pulp. This pulp was used for the evaluation of optical properties improvement, chemical characteristics of lignin in fiber and the relationship between lignin and optical properties in fiber cell wall. Hydrogen peroxide treatment improved the brightness, but the post color number (PC No.). There was little improvement on optical properties by ozone treatment, but this could be improved more by using two staged ozone-hydrogen peroxide bleaching. The hydrogen peroxide treatment did not make any change on chemical characteristics of lignin in cell wall, but by ozone treatment, it was found that the non-aromatic conjugated structure was existed in the surface of cell wall, but this could be removed by hydrogen peroxide treatment in two staged ozone-hydrogen peroxide treatment. Therefore, the optical properties was significantly improved, due to the removal of non-aromatic conjugated structure.

• Fashion & Textile Research Journal
• /
• v.3 no.1
• /
• pp.42-47
• /
• 2001

The hardening system of polyurethanes has usually caused by air pollution. bad working condition and fire hazard according to using orgarnic solvents. Therefore there have been researched on emulsion, water soluble and colloid-dispersion based water soluble instead of using organic solvents recently. This study synthesized polyurethane dispersing particle by means of mixing precursor and neutralized emulsion method. In the first step, polyurethane was preparated from isophorone diisocyanate and poly (ethylene-adipate) glycol, and got precursor by introducing dimethyl propionic acid as a hydrophilic group. Synthesized polyurethane was bonded to the surface of fiber and crosslinked as a anti-static agent, and then looked for the change of color and softening property.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2003.11a
• /
• pp.540-543
• /
• 2003

There are many stone monuments which are weathered by natural or artificial factors in Korea. The partly weathering in stone could accelerate the rate of weathering, so it is demanded to keep them from the further weathering. Consolidation is evaluated as one of the efficient treatments which have a good effectiveness in stone monuments. But following the former researches, the effectiveness of consolidation could be different, related to the kinds of stone or consolidants. Therefore, in this study, the change of properties was monitored in the long term for the exact evaluation of the stability of the consolidated stone. It is estimated that the pore structure of consolidated stone was filled by consolidant, according to the measurements of ultrasonic velocity, and the digital image analysis of the sample was shown that the color property of stone surface has varied during the curing.

• Textile Coloration and Finishing
• /
• v.13 no.2
• /
• pp.7-7
• /
• 2001

This paper investigated the dyeability and surface color of silk and cotton fabrics dyed with chustnut bur extract. Some experiments were performed under the various dyeing conditions such as dyeing temperature, dyeing time, repetition of dyeing, dyeing pH, mordanting condition, washing fastness and light fastness with silk and cotton fabrics. The results obtained were as follows 1. △E value was increased when dyeing temperature and time was higher, value of munsell was shifted from Yellow to Yellow-Red at hither dyeing temperature and time in silk and cotton fabrics. 2. Optimal dyeing pH was increased with acidity of dyeing solution in silk and cotton fabrics, and repetition of dyeing did not change the dye-uptake. 3. When mordanting time and temperature was higher, △E value was larger in silk and cotton fabrics. Silk and cotton fabrics with Fe-premordanting treatment had best dyeability, but treatment with Sn-mordanting was worst. 4. Washing fastness and light fastness was excellent in various dyeing condition at silk fabric but cotton was without practical use.