• 한국신재생에너지학회:학술대회논문집
• /
• 2008.05a
• /
• pp.402-405
• /
• 2008

SunPower's corporate mission is to reduce the installed cost of solar electricity 50% by 2012. As part of that mission, the company is continually exploring novel technologies that might enable progress towards the goal. This paper describes SunPower's efforts to decrease the levelized cost of electricity for solar power plants through the use of bifacial cell and system technology. The results of the first production run of SunPower bifacial cells and modules are presented. Future bifacial system development plans are reviewed.

• Solar Energy
• /
• v.18 no.3
• /
• pp.25-30
• /
• 1998

A sun tracking controller for PTC(parabolic trough concentrator) is a control system used to orient the concentrator toward the sun always, so that the maximum energy can be collected. The work presented here is a design and development of microprocessor based sun tracking control system for PTC. Sun tracking control system consists of a sun sensor and a single axis tracking control system. 80c196KC based control system consists of an analog input unit, 24V DC servomotor drive unit, I/O unit. Sun sensor has been constructed using photodiode and can detect the sun located within ${\pm}50^{\circ}$ measured from the sun sensor normal direction. The sun tracking system developed is being implemented and shows a good sun tracking performance.

• Proceedings of the PSK Conference
• /
• 2002.04a
• /
• pp.196.3-197
• /
• 2002

• Journal of Power Electronics
• /
• v.9 no.4
• /
• pp.631-642
• /
• 2009

The sun is a useful reference direction because of its brightness relative to other astronomical objects and its relatively small apparent radius as viewed by spacecrafts near the Earth. Most satellites use solar power as a source of energy, and so need to make sure that solar panels are oriented correctly with respect to the sun. Also, some satellites have sensitive instruments that must not be exposed to direct sunlight. For all these reasons, sun sensors are important components in spacecraft attitude determination and control systems. To minimize components and structural mass, some components have multiple purposes. The solar cells will provide power and also be used as coarse sun sensors. A coarse Sun sensor is a low-cost attitude determination sensor suitable for a wide range of space missions. The sensor measures the sun angle in two orthogonal axes. The Sun sensor measures the sun angle in both azimuth and elevation. This paper presents the development of a model to determine the attitude of a small cube-shaped satellite in space relative to the sun's direction. This sensor helps small cube-shaped Pico satellites to perform accurate attitude determination without requiring additional hardware.

• Korean Journal of Food Science and Technology
• /
• v.25 no.6
• /
• pp.672-676
• /
• 1993

Rheological properties of the aqueous solution of various polysaccarides and their effects as a stabilizer in fruit(peach) syrup and yogurt were investigated. Four kinds of modified starch(Sun Kolguard, Sun Registar, Mira Cleer 340 and Maps 449), three types of carrageenan(kappa, iota and lambda types) and pectin were used in this study. The 5% aqueous solution of each modified starch was gelatinized at $66^{\circ}C$. After gelatinization, Sun Kolguard showed the highest viscosity among those samples. The synergistic effect of carrageenan on 5% aqueous solution of Sun Kolguard was studied by changing the mixing ratio, and the result showed that the ratio 90:10(Sun Kolguard:carageenan) had the maximum synergistic effect and the effect of iota type carrageenan was higher than that of other types. The effect of Sun Kolguard as a stabilizer in fruit syrup were superior to other modified starches studied. The gelatinization temperature of the addition of iota carrageenan in starch added fruit syrup changed from $66^{\circ}C$ of 5% aqueous solution to $82^{\circ}C$. Furthermore, the viscosity after cooling of syrup which made iota carrageenan and starch added fruit syrup was more increased than simple starch added fruit syrup. The mixture of 90% Sun Kolguard and 10% iota carrageenan were estimated as the most appropriate stabilizer for manufacturing the fruit syrup and yogurt adding fruit syrup.

• 대한핵의학회:학술대회논문집
• /
• 2000.05a
• /
• pp.67.2-67.2
• /
• 2000

• Safety and Health at Work
• /
• v.7 no.3
• /
• pp.208-212
• /
• 2016

Background: Outdoor workers are at risk of high ultraviolet radiation exposure, and may have difficulty using sun protection. The objectives were to determine the prevalence of sun protection behaviors in a sample of outdoor construction workers, and to assess which factors predict better sun protection practices. Methods: Participants were recruited via construction unions. Workers answered a questionnaire on demographics, skin cancer risk, sun protection behaviors, and job. Sun protection behavior scores (from questions on sunscreen use, sleeved shirt, hat, shade seeking, sunglasses) were calculated by converting Likert-scale answers to scores from 0 to 4, and taking the mean (separately for work and leisure). Determinants of sun protection behavior scores were examined for work and leisure using generalized linear models. Results: Seventy-seven workers had complete questionnaire data (participation 98%). Sun protection behaviors used most often were hats (79% often/always) and sleeved shirts (82% often/always); least prevalent were shade-seeking (8% often/always) and sunscreen (29% often/always). For both work and leisure scores, the strongest predictor was skin type, with fairer-skinned individuals having higher sun protection behavior scores. Workers had higher scores at work than on weekends. Workplaces that required hats and sleeved shirts for safety purposes had higher protection behavior scores. Conclusion: This high-participation rate cohort helps characterize sun protection behaviors among outdoor workers. Workers practiced better sun protection at work than on weekends, suggesting that workplace policies supportive of sun protection could be useful for skin cancer prevention in the construction industry.

• Journal of Institute of Control, Robotics and Systems
• /
• v.18 no.5
• /
• pp.502-508
• /
• 2012

Heliostat, as a concentrator to reflect the incident solar energy to the receiver, is the most important system in the tower-type solar thermal power plant since it determines the efficiency and ultimately the overall performance of solar thermal power plant. Thus, a good sun tracking ability as well as a good optical property of it are required. Heliostat sun tracking system uses usually an open loop control system. Thus the sun tracking error caused by heliostat's geometrical error, optical error and computational error cannot be compensated. Recently use of sun tracking error model to compensate the sun tracking error has been proposed, where the error model is obtained from the measured ones. This work is a development of heliostat sun tracking error measurement and compensation method using BCS (Beam Characterization System). We first developed an image processing system to measure the sun tracking error optically. Then the measured error is modeled in linear polynomial form and neural network form trained by the extended Kalman filter respectively. Finally error models are used to compensate the sun tracking error. We also developed the necessary image processing algorithms so that the heliostat optical properties such as maximum heat flux intensity, heat flux distribution and total reflected heat energy could be analyzed. Experimentally obtained data shows that the heliostat sun tracking accuracy could be dramatically improved using either linear polynomial type error model or neural network type error model. Neural network type error model is somewhat better in improving the sun tracking performance. Nevertheless, since the difference between two error models in compensation of sun tracking error is small, a linear error model is preferred in actual implementation due to its simplicity.

• Korean Journal of Remote Sensing
• /
• v.31 no.4
• /
• pp.281-291
• /
• 2015

Sun glint correction methods of hyperspectral data that have been developed so far have not considered the various situations and are often adequate for only certain conditions. Also there is an inaccurate assumption that the signal in NIR wavelength is zero. Therefore, this study attempts to analyze the NIR spectral properties of sun glint effect in coastal waters. For the analysis, CASI-1500 airborne hyperspectral data, bathymetry data and in-situ data obtained at coastal area near Sin-Cheon, Jeju Island, South Korea were used. The spectral characteristics of radiance and reflectance at the five NIR wavelengths (744 nm, 758 nm, 772 nm, 786 nm, and 801 nm) are analyzed by using various statistics, spatial and spectral variation of sun-glinted area under conditions of the bottom types of benthos, barren rocks and sand with similar water depth. Through the quantitative analysis, we found that the relation of water depth or bottom type with sun glint is relatively less which is a similar result with the previous studies. However the sun glint are distributed similarly with the patterns of the direction of wave propagation. It is confirmed that the areas with changed direction of wave propagation were not affected by the sun glint. The spatial and spectral variations of radiance and reflectance are mainly caused by the effect of sun glint and waves. The radiance or reflectance of more sun-glinted areas are increased approximately 1.5 times and the standard deviations are also increased three times compared to the less sun glinted areas. Through this study, the further studies of sun glint correction method in coastal water using the patterns of wave propagation and diffraction will be placed.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.20 no.5
• /
• pp.81-88
• /
• 2010

Sun et al. proposed a new design of wearable token system for security of mobile devices, such as a notebook and PDA. In this paper, we show that Sun et al.'s system is vulnerable to off-line password guessing attack and man in the middle attack based on known plain-text attack. We propose an improved scheme which overcomes the weaknesses of Sun et al.'s system. The proposed protocol requires to perform one modular multiplication in the wearable token, which has low computation ability, and modular exponentiation in the mobile devices, which have sufficient computing resources. Our protocol has no security problem, which threatens Sun's system, and known vulnerabilities. That is, the proposed protocol overcomes the security problems of Sun's system with minimal overheads.