• Nuclear Engineering and Technology
• /
• v.33 no.3
• /
• pp.315-326
• /
• 2001

Direct ECC bypass phenomena that occur in a reactor vessel downcomer with a Direct Vessel Injection (DVI) system during the reflood phase of a Large Break Loss-of-Coolant Accident (LBLOCA) are experimentally investigated using a transparent l/7.5 scaled down test facility of the Upper Plenum Test Facility (UPTF). A series of separate effect tests are peformed in order to investigate the mechanisms of direct ECC bypass and to find out its scaling parameters. Various flow regimes and phasic distribution in downcomer are identified and mapped, and the fraction of direct ECC bypass is measured under a wide range of air and water injection conditions. From the counterpart test of the UPTF Test 21-D, the dimensionless gas velocity ( $j^{*}$$_{g,eff}$) is derived experimentally, which is believed to be a major scaling parameter for the fraction of direct ECC bypass. And it is found out that the direct ECC bypass is greatly affected by the spreading width of ECC water film and the geometric configuration of the downcomer.r.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2000.10a
• /
• pp.196-203
• /
• 2000

In this study, the evaluation method of diffusion characteristics of Suspended Soli&SS) and the generation limit(source and thick) are investigated, which is significantly affecting on marine examined by construction works such as dredging and reclamation. Dispersion characteristics of SS is examined by hydraulic tests and numerical works in consideration with the Pusan Port. Hydraulic model test was performed in 2-D wave flume to find the limit wave conditon of re-suspension of solid as well as the time dependent characteristics of settlement The results obtainded in the study are as follows; 1) The quantituative evaluation af SS is the basic parameter of marine environmental impact assessment in related with the port development The SS increases as the water content of sea bed solid increases and the density decreases. 2) The sea bed solid in Sinsundai area, Pusan Port has the water content range of 83~157% 3) The ratio of suspension velocity against settlement velocity is about 0.25 and SS concentration converges as the wave heigh. 4) The SS increases 2 time when time step increases 3 time(10 sec to 30 sec) in numerical simulation It means that the effect of the time step should be checked in detail to stable. The diffusion The diffusion coefficient are Affiected senstively in the dispersion process while sea ved friction coefficinet have not strong relation in the simulated area

• Journal of Power Electronics
• /
• v.13 no.4
• /
• pp.619-625
• /
• 2013

Switched mode power supplies (SMPS) are power electronic circuits extensively used in a wide range of applications. High frequency switching operation of SMPS causes electromagnetic emissions and has the potential to interfere with system operation, which in turn has an impact on system performance. This makes electromagnetic compatibility (EMC) an important concern. In this paper, a new and simple spread spectrum technique is proposed by modulating chaotic pulse position modulation (CPPM) and pulse width modulation (PWM). The resulting CPWM is implemented to reduce the conducted EMI in SMPS. The proposed method is found to be effective in reducing conduction EMI. The effectiveness and simplicity of the proposed method on spreading those dominating frequencies is compared to the EMI mitigation technique using an external chaotic generator. Finally, the levels of conductive EMI with standard PWM, CPWM with an external chaos generator and the proposed method are experimentally verified to comply with the CISPR 22A regulations. The results confirm the effectiveness of the proposed method.

• Journal of Korean Society for Geospatial Information Science
• /
• v.6 no.1 s.11
• /
• pp.105-116
• /
• 1998

The spreading of hot waste water discharged from the coastal power station is a new problem to marin e circumstances and the fishery. Because the survey of hot waste water discharges should be performed is multaneously across wide areas, it is very difficult. Some sensors of the Landsat can draw the spread and distribution of water temperature from wavelength range of thermal infrared. The present study applied the GIS after stretching DN for the purpose of drawing a more accurate distribution of water temperature. Accordingly, the pattern of water temperature distribution could be expressed more precisely for a broad area, and the spread and distribution of hot waste water could be analyzed economically.

• Journal of Periodontal and Implant Science
• /
• v.35 no.1
• /
• pp.177-185
• /
• 2005

The purpose of the study was to investigate the influence of an endodontic infection on presence of furcation involvement in periodontally-involved mandibular molars. All first and second mandibualr molars in 45 patients were selected if at least one was root-filled or had a possible periapical radiolucency. The sample consisted of patients from a referral population at a periodotnal clinic which represented an adult population with a mean age of 47.5 years (range 31 to 63) For mandibular molars with periapical destruction at both roots, frequency of horizontal furcation depth ${\geqq}$ 3 mm was significantly more compared to teeth without periapical destruction. Mean periodontal probing depth was significantly greater at mandibular molars with periapical destruction. It is suggested that a root canal infection in periodontitis-involved molars may potentiate periodontitis progression by spreading of endodontic pathgens through patent accessory canals and dentinal tubules. In conclusion, an endodontic infection in mandibular molars was found to be associated with additional attachment loss in the furcation area, and may thus be considered to be one of several risk factors influencing the prognosis of molars in periodontitis-prone patients.

• Korean Institute of Interior Design Journal
• /
• v.26 no.6
• /
• pp.42-52
• /
• 2017

In this modern world of drastic change, folding architecture was an alternative that offered a novel architectural insight. Today, the folding technique is being used above and beyond architecture, spreading to fashion, lighting, medicine, etc. Especially in the interior space design field, the folding technique is in the limelight as an alternative to create an original space for modern society. However, research and experiments into folding mainly remains at philosophical interpretation or architectural examples, and even these were mostly before the 2000s. Therefore, the present study determined it necessary to look deeply into the post-2000s folding technique focusing on interior space. In this paper, 33 cases of indoor space where folding technique appears are derived, and classified them again by use. The folding technique which was the first step of Sophia Vyzoviti's experiment on her book, "Folding Architecture" was extracted and used as the framework. We summarizes the range of application of folding techniques (interior space in general, floor, wall, ceiling, etc.) and major folding techniques by combining photographs, drawings, and descriptions of the works of the architects. This paper summarizes the characteristics of the space described comprehensively, and draws out the spatial characteristics of the modern interior space where the folding technique appears.

• IE interfaces
• /
• v.10 no.3
• /
• pp.75-93
• /
• 1997

Unlike individual applications, it is extremely hard to obtain user requirements for group systems, since there exists very complicated dynamics in group. This may result in spreading a great amount of products with a broad range of contents. Thus, this study presents a comparative analysis of groupware products. As a result, these products have been categorized into three areas which include cooperation/document management systems, collaborative writing systems, and decision-making/meeting systems. While the systems reviewed here focus on the cooperation/document management systems, the other two areas will be dealt in details in part Ⅱ. The first area ends up with two large categories such as proprietary groupware products and intranet groupware products. However, it has been observed that there is a natural convergence between these two categories. Consequently, the comparative analysis has been performed in terms of functions provided on the two categories and a combined category. Each group of the functions has been divided into three parts which consist of basic functions, quasi-basic functions, and others. Such a decision has been made based on the frequency rate of the functions provided in the products. With a more strict rule, the basic functions comprise electronic mail, sanction, bulletin board, document management, scheduling, security, Web browser, and Internet connectivity. This study also provides a framework for integrated functional model of groupware systems. The basic functions are merged into the model. However, the model is so flexible that it can partially include the quasi-functions in addition to the basic functions. In the future, it is expected that a large number of products will stem from the modification of the functional model.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.10
• /
• pp.945-948
• /
• 2016

Recent premium smartphones commonly employ a metal frame and this trend is currently spreading over mid-range smartphones. However, the metal frame becomes a good coupling path of electromagnetic noises emitted from digital components in smartphones and then increases radio-frequency interference(RFI) to RF antennas located at top and bottom sides of smartphones. This paper proposed a metal frame with EBG(Electromagnetic Band Gap) structure to reduce the noise coupling to antenna by suppressing surface wave on the metal frame. By simulation, it is confirmed that the proposed metal frame with $7{\times}6$ mushroom-type EBG array pattern with multi-via can reduce the noise coupling to RF antenna by about 20 dB.

• Journal of ILASS-Korea
• /
• v.27 no.1
• /
• pp.1-10
• /
• 2022

In this study, an experimental investigation on the effects of the pressure ratio on the wall-impingement spray characteristics of nitrogen gas using a compressed natural gas (CNG) injector was conducted. The transient development of the impingement spray was recorded by a high speed camera with Z-type Schlieren visualization method. The spray behavior under various pressure ratio conditions were analyzed. The experimental results showed that the pressure ratio has positive effect on the development of spray wall-impingement. The effects of the above factor were evaluated in a constant volume chamber at atmospheric conditions. The data from test showed that, with the increase of the pressure ratio, the spray tip penetration (STP) quickly increases before the impingement and gradually increases after the impingement. Additionally, the spray velocity first increases and then sharply decreases on regardless of the injection pressure level. As the spray spreading angle increases, spray area and volume increases rapidly with the increase in STP at the beginning of injection, and finally entered a stable range, has a great correlation with the increase of pressure ratios.

• BMB Reports
• /
• v.57 no.2
• /
• pp.104-109
• /
• 2024

Gefitinib exerts anticancer effects on various types of cancer, such as lung, ovarian, breast, and colon cancers. However, the therapeutic effects of gefitinib on cervical cancer and the underlying mechanisms remain unclear. Thus, this study aimed to explore whether gefitinib can be used to treat cervical cancer and elucidate the underlying mechanisms. Results showed that gefitinib induced a caspase-dependent apoptosis of HeLa cells, which consequently became round and detached from the surface of the culture plate. Gefitinib induced the reorganization of actin cytoskeleton and downregulated the expression of p-FAK, integrin β1 and E-cadherin, which are important in cell-extracellular matrix adhesion and cell-cell interaction, respectively. Moreover, gefitinib hindered cell reattachment and spreading and suppressed interactions between detached cells in suspension, leading to poly (ADP-ribose) polymerase cleavage, a hallmark of apoptosis. It also induced detachment-induced apoptosis (anoikis) in C33A cells, another cervical cancer cell line. Taken together, these results suggest that gefitinib triggers anoikis in cervical cancer cells. Our findings may serve as a basis for broadening the range of anticancer drugs used to treat cervical cancer.