• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.655-662
• /
• 2003

Slope stability is an important issue ill civil engineering works or in open pit mines where both economy and efficiency is required. These are the long-term stability problems which depend on the change of physical properties under a certain weather condition. These can also result in progress of weathering which can change mechanical or hydro-geological properties of rock mass considerably. In this study, weathering in nature was simulated by freeze-thaw test and Soxhlet test which represent mechanical and chemical weathering respectively. Measured were elastic wave velocities, absorption rate, volume change. Uniaxial compression strengths before and after the weathering tests were also measured. The change in weight and volume of the specimens were not clearly related to the weathering process, but P, S wave velocities were clearly decreased as weathering progresses. For some class of rocks, P-wave velocity was increased probably because of the saturation due to improved connectivity of the pre-existing pores. Based on the test results, stability of the slopes were analyzed using FLAC$\^$2D/. Due to the reduced strength parameters, the factors of safety were decreased for the selected sites.

• Proceedings of the KIEE Conference
• /
• 2003.10a
• /
• pp.36-38
• /
• 2003

In this paper, the surface modificatioin of PDMS (polydimethyl-siloxane) which is a useful material of microfluidic devices is presented. PDMS-based devices can be fabricated by casting the polymer in a mold, but the porosity and the hydrophobicity of PDMS make difficult to use as bio-medical devices. To overcome these disadvantages, the PDMS surface is grafted with HEMA (2-Hydroxyethyle methacrylate) treatments and $O_2$ plasma process. The $O_2$ plasma process is performed for 20 sec after curing PDMS, and PDMS is put in the prepared HEMA without Monomethyle Ether Hydroquinone. Residual monomers and homopolymers of HEMA-treated PDMS surface are removed using soxhlet extractor. The PDMS surface modification using HEHA without Monomethyle Ether Hydroquinone is experimented, and compare to when additing $FeCl_2{\cdot}2H_2O$. A method with a soxhlet extractor compare to the existing rinse method. The hydrophilicity is confirmed by the measurement of a contact angle, and we observe whether the hydrophilicity is retained.

• Korean Journal of Food Science and Technology
• /
• v.18 no.2
• /
• pp.105-109
• /
• 1986

Volatile components of pinenut were identified. Pinenut was extracted by simultaneous distillation and extraction method after Soxhlet extraction. The odor profile of the extract was very similar to that of pinenut. This extract was then fractionated into four fractions by Preparative TLC. These all fractions were analyzed by a combination of glass capillary gas chromatography (FTD, FID capillary GC) and mass spectrometry. One hundred and nine components, including 26 hydrocarbons,17 esters,16 aldehydes,12 ketones,31 alcohols, 11 bases, 2 acids and 3 miscellaneous components were identified.

• Analytical Science and Technology
• /
• v.15 no.5
• /
• pp.451-458
• /
• 2002

Determination were performed for the presence of three common environmental endocrine disrupting compounds (EDC), namely nonylphenol (NP), octylphenol (OP), di (2-ethylhexyl)phthalate in sewage sludge from 67 wastes plants, using Soxhlet extraction and GC/MS-SIM. NP and DEHP were detected in almost every sludges but OP was not detected. The range and mean value for NP of all sludge samples were nd~593, $62{\mu}g/g$ dry and the two statistic values for DEHP of those were 13~4733, $1176{\mu}g/g$ dry respectively. DEHP content was 20 times greater than NP in sludges. Concentrations of NP and DEHP in sludge from individual area were increased as following order ; Jeolla South and North Province (Cheju) < Chungcheong South and North Province (Kwangwon) < Gyungsang South and North Province < Wide City < Kyunggi Province.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.5
• /
• pp.402-410
• /
• 2008

Single-walled carbon nanotubes (SWCNTs) were currently produced together with some contaminants such as a metallic catalyst, amorphous carbon, and graphitic nanoparticles, which should be sometimes purified for their applications. This study aimed to develop efficient, scalable purification processes but less harmful to SWCNTs. We designed three-step purification processes: acidic treatment, surface functionalization and soxhlet extraction, and heat treatment. During the soxhlet extraction using tetrahydrofuran, specifically, carbon impurities could be easily expelled through a glass thimble filter without any significant loss of CNTs. Finally, SWCNTs were left as a bulky paper on the filter through membrane filtration. Vertically aligned SWCNTs on one side of bulky paper were well developed in a speparation from the filter paper, which were formed by being sucked through the filter pores during the pressurized filtration. The bucky paper showed a very high peak current density of field emission up to $200\;mA/cm^2$ and uniform field emission images on phosphor, which seems very promising to be applied to vacuum microelectronics such as microwave power amplifiers and x-ray sources.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.33 no.9
• /
• pp.1529-1536
• /
• 2004

This study was designed to determine total trans fatty acids (tFAs) content of processed foods commonly consumed in the Korean diet and to prepare the database for the estimation of tFAs intake in Koreans. Total fat and tFAs content was determined by Soxhlet extraction method and attenuated total reflection infrared spectroscopy (ATR-IR), respectively. The tFAs positional isomers were analyzed using GC/MS spectrometer. In margarines, the content of tFAs ranged from 8.27% to 28.53%. Shortenings contained higher levels of tFAs (1.98~11.33%) than lards (1.83~1.96%). The content of tFAs in grilled confectioneries was wide (7.37~26.54%). Instant popcorns contained the highest amount of tFAs. Fried chickens had 0.44 to 14.85% of tFAs and french fries had 5.18 to 27.01% of tFAs. In fried snacks (crispy) and chocolates, tFAs were not detected. The amount of tFAs per serving size was the highest in instant popcorn, followed by french fries, fried snack (tortilla), doughnuts, and grilled confectioneries. TFAs isomer of margarines was mostly C18:1${\Delta}$9t. In shortenings and lards, the most abundant positional isomer of tFAs was C18:1${\Delta}$9t and C18:2${\Delta}$9t ${\Delta}$12t. Correlation coefficient of tFAs content between IR and GC/MS method was $r^2$=0.91.

• Analytical Science and Technology
• /
• v.27 no.4
• /
• pp.201-212
• /
• 2014

Polycyclic aromatic hydrocarbons (PAHs) that are carcinogenic and persistent will be restricted in consumer products from December 27, 2015 by EU REACH regulation. Pretreatment using Soxhlet extraction and quantitative analysis by GC-MS were studied to develop the method for analyzing 18 PAHs in consumer products as well as to detect the amounts and the kinds of PAHs in consumer products such as grips of a bag and a hammer, a cable and a plastic sandal. Linearity and precisions were evaluated by analyses of the standard PAH solutions ranging from 0.3125 mg/L to 5.00 mg of each of 18 PAHs. Linearity of resulting standard curves for all 18 PAHs were obtained with $R^2$ above 0.999. Precisions of the retention times and the peak areas were found to be 0.00%~0.05% and 1.16%~3.69% of relative standard deviations, respectively. The recoveries for spiked samples were all around 95%~105% after Soxhlet extration using three different solvents such as dichloromethane, hexane and toluene. The limits of quantitation for 18 PAHs in solutions and polymer samples by GC-MS were evaluated to be 0.327 mg/L (Benzo[ghi]perylene)~0.464 mg/L (Acenaphthylene) and 1.635 mg/kg (Benzo[ghi]perylene)~2.32 mg/kg (Acenaphthylene) based upon dilution factor of 5, respectively. Under the developed analytical method, only trace amounts of phenanthrene were detected in three samples while 15 kinds of PAHs including phenanthrene were detected in a grip of hammer with concentrations of maximum 83.4 mg/kg of Phenanthrene and minimum 8.5 mg/kg of Acenaphthylene. Further studies are needed to decrease the quantitation limit and to check the feasibility of decreasing Soxhlet time as well as to demonstrate cases that the clean up is required.

• Polymer(Korea)
• /
• v.32 no.1
• /
• pp.13-18
• /
• 2008

For the evaluation of brominated flame retardants included in polymeric electronic devices, we investigated the extraction methods and solvent systems for four different types of polymers of PC (polycarbonate), PP (polyropylene), PET (poly(ethylene terephthalate)) and PBT (poly(butylene terephthalate)) using different solvent systems of hexane/acetone, THF, toluene, and THF/toluene. In order to compare the extraction efficiency of different methods and solvent systems, the deca-BDE (decabromo diphenyl ether) flame retardant was included in PC, PP, PET and PBT systems and subsequently extracted by soxhlet, ultrasonic, accelerated solvent, microwave and supercritical fluid extraction methods. The amount of the extracted flame retardant was monitored to evaluate the extraction efficiency. The ultrasonic extraction method was found not to be acceptable as an extraction method for the polymer systems mainly due to a low salvation efficiency of the organic solvents. Soxhlet, accelerated solvent and microwave extraction methods exhibited over 80% of extraction efficiency for toluene. The supercritical fluid extraction method, which has been used as an extraction method for flame retardants in polymers, showed the extraction efficiencies of ca. 100% for PC and PP in the optimal extraction conditions of $60^{\circ}C$ and 120 bar.

• Analytical Science and Technology
• /
• v.22 no.3
• /
• pp.219-227
• /
• 2009

The steroid compounds in Rhodiola sachalinensis were determined with adsorption column chromatographic purification and GC/MS. Sterols were extracted by sonication and Soxhlet with ethanol and dichloromethane, respectively. The extract was partitioned with chloroform and water using liquid-liquid extraction, and purified with a silica column after the sterols had been converted to the corresponding silyl derivatives with BSTFA. Eighteen free sterols, including $\beta$-sitosterol, stigmasterol and cycloartenol, and nine sterol conjugates were found from Rhodiola sachalinensis by GC/MS. Among them, cholest-5-ene-3-ol, cholesterol, stigmasterol, $\beta$-sitosterol were confirmed and quantified with sterol standards. Most sterols were presented in the chloroform part, with $C_{29}$ being the most abundant group in this sterol group. $\beta$-sitosterol was the most abundant compound with a relative content of 45.94% followed by ergost-7-ene-3-ol (11.33%), 4,14-dimethyl-ergosta-8,24(28)-diene-3-ol (7.07%), stigmasterol (6.09%), cycloartenol (5.43%) and 4-methyl-cholest-5-ene-3-ol (5.39%).

• Journal of Microbiology and Biotechnology
• /
• v.6 no.5
• /
• pp.358-360
• /
• 1996

Solvent extraction, soxhlet method, and supercritical fluid extracion were considered, respectively, as the method of choice for the recovery of DHA from lyophilized Thraustochitrium sp., and the results of corresponding extraction were compared. Supercritical fluid extraction seems to be the most appropriate process with respect to time, process simplicity, and extractant intoxicity.