• 대한토목학회논문집
• /
• 제13권2호
• /
• pp.191-199
• /
• 1993

정상 2차원 이송확산(移送擴散) 방정식의 수치해석에 의하여 난류전단(亂流剪斷) 흐름에서의 정상(定常) 수평(水平) 선오염원(線汚染源)의 확산(擴散)을 모의하였다. 유속과 난류확산계수(亂流擴散係數)의 수심에 따른 변화가 없을 경우에 대한 해석해와 비교한 결과, 일정 유속 및 난류확산계수(亂流擴散係數)를 가정할 경우 수심방향 확산(擴散)을 과대평가하는 것으로 나타났다. 무차원화된 지배방정식에 따르면 수심방향 확산(擴散)을 지배하는 물리적 변수는 마찰계수(摩擦係數)뿐이다. 마찰계수(摩擦係數)에 대한 확산과정의 민감도(敏感度) 분석(分析)으로부터 수심방향 확산속도(擴散速度)는 대략 마찰계수(摩擦係數)의 제곱근에 비례함을 알 수 있었다. 오염원(汚染源)의 초기 방류위치에 따른 민감도(敏感度) 분석(分析) 결과, 가장 신속한 수심 방향 확산(擴散)을 가져오는 최적의 방류위치는 수심의 중간정보다 위쪽이며, 마찰계수(摩擦係數)가 커질수록 그 위치가 수면쪽에 가까와지는 것으로 나타났다.

• 한국물환경학회지
• /
• 제27권6호
• /
• pp.905-913
• /
• 2011

This study was conducted to characterize the discharge feature of pollutant load from the upper and lower watershed influencing on the water quality of South Han River using the empirical equation and Factor Analysis. The results of regression analysis between flow rate and pollutant load were as follows. In the streams of the upper watershed of South Han river, $BOD_5$ and $COD_{Mn}$ were increased as the flow rate was increased. Also, steep increases in SS and TP were observed with positive correlation with the flow rate while change in TN was slightly shown. On the other hand, in the streams of the lower watershed of South Han river, $BOD_5$ was negatively correlated with the flow rate, being decreased with the increase in the flow rate. However, changes in $COD_{Mn}$, TN, SS, and TP showed a similar trend with those observed in the upper watershed. With Factor Analysis of the water quality and various components, it was appeared that the flow rate, SS, and TP were significantly correlated each other and they were indicated as the principal component influencing on water quality in the streams of the upper watershed. In contrast, $BOD_5$, $COD_{Mn}$ and TOC were significantly correlated each other and they were included as the principal pollution component of the streams in the lower watershed. From these results, it was conclusive that the upper watershed of South Han River was mainly affected by non point source pollutants while the lower watershed was influenced by point source pollutants from the developed areas.

• Nuclear Engineering and Technology
• /
• 제54권5호
• /
• pp.1754-1759
• /
• 2022

The activity of gamma-ray emitting nuclides is calculated assuming that each gamma-ray is detected individually; thus, the magnitude of the coincidence summing signal must be considered during activity calculations. Here, the correction factor for the coincidence summing effect was calculated, and the detection efficiencies of two HPGe detectors were compared. The CANBERRA Inc. GC4018 high-purity Ge detector provided an estimate for the peak-to-total ratio using a point source to determine the coincidence summing correction factor. The ORTEC Inc. GEM60 high-purity Ge detector uses EFFTRAN in LVis to obtain the parameters of the detector and source model and the gamma-gamma and gamma-X match estimates, in order to determine the coincidence summing correction factor. Nuclide analyses, radioactivity comparisons, and analyses of reference material samples were performed utilizing certified reference materials to accurately determine the detection efficiencies. For both Co-60 and Y-88, the detection efficiency for a point source increased by an average of at least 12-13%, whereas the detection efficiency determined using LVis increased by an average of at least 13-15%. The calculated radioactivity values of the certified reference material and reference material samples were accurate to within 3% and 6% of the measured values, respectively.

• 전기학회논문지
• /
• 제62권3호
• /
• pp.355-364
• /
• 2013

Respect to the input AC voltage and output DC voltage, conventional three-phase PWM rectifier is classified as the voltage type rectifier with boost capability and the current type rectifier voltage with buck capability. Conventional PWM rectifier can not at the same time the boost and buck capability and its bridge is weak in the shoot- through state. These problems can be solved by Z-source PWM rectifier which has all characteristic of voltage and current type PWM rectifier. By shoot-through duty ratio control, the Z-source PWM rectifier can buck and boost at the same time, also, there is no need to consider the dead time. This paper proposes the input AC voltage sensorless control method of a three-phase Z-source PWM rectifier in order to accomplish the unity input power factor and output DC voltage control. The proposed method is estimated the input AC voltage by using input AC current and output DC voltage, hence, the sensor for the input AC voltage detection is no needed. comparison of the estimated and detected input AC voltage, estimated phase angle of the input voltage, the output DC voltage response for reference value, unity power factor, FFT(Fast Fourier Transform) of the estimated voltage and efficiency are verified by PSIM simulation.

• 한국농공학회논문집
• /
• 제49권3호
• /
• pp.79-88
• /
• 2007

This paper suggests a hierarchial method to select the target sites for the nonpoint source pollution management considering factors which reflect the interrelationships of significant outflow characteristics of nonpoint source pollution at given sites. The factors consist of land slope, delivery distance to the outlet, effective rainfall, impervious area ratio and soil loss. The weight of each factor was calculated by an analytic hierarchy process(AHP) algorithm and the resulting influencing index was defined from the sum of the product of each factor and its computed weight value. The higher index reflect the proposed target sites for nonpoint source pollution management. The proposed method was applied to the Baran HP#6 watershed, located southwest from Suwon city. The Agricultural Nonpoint Pollution Source(AGNPS) model was also applied to identify sites contributing significantly to the nonpoint source pollution loads from the watershed. The spatial correlation between the two results for sites was analyzed using Moran's I values. The I values were $0.38{\sim}0.45$ for total nitrogen(T-N), and $0.15{\sim}0.22$ for total phosphorus(T-P), respectively. The results showed that two independent estimates for sites within the test water-shed were highly correlated, and that the proposed hierarchial method may be applied to select the target sites for nonpoint source pollution management.

• 한국대기환경학회지
• /
• 제9권1호
• /
• pp.44-50
• /
• 1993

The suspended particulate matters had been collected by a cascade impactor having 9 size fragnated stages for 2 years (Dec. 1989 to Nov. 1991) in Kyung Hee University-Suwon Campus. The particulate matters were then collected on each stage by membrane filters. The weight concentration on each stage was estimated by a microbalance and further chemical element concentrations were determined by an XRF system. The study focused on developing of a receptor model using the TTFA (target transformation factor analysis) to apportion aerosol mass with the 30 ambient data sets. Each data set consists of the 8 size-ranged subdata sets characterized by 13 element variables. Even though a couple of sources could not be identified, three to five sources were extracted from each aerosol size-range, and then 9 statistical source profiles were generated. Finally, source contribution of particulate matters on each size-range could be estimated in Suwon area.

• 한국관개배수논문집
• /
• 제14권2호
• /
• pp.181-193
• /
• 2007

The characteristics of non-point source pollutant loads in middle-stream of Nakdong River Were studied through analysis of pollutant loads of 8 sub-watersheds divided based on administrative district. The pollutant concentration of each sub-watershed was collected from Nakdong-River Water Research Institute and Daegu Regional Environmental Office, respectively. Pollution items analysed in this study were BOD, SS, T-N and T-P. High degree of non-point pollution was observed from Gumi, Goryeong, Gyeongsan, Daegu and Sungju, and pollution was usually increased during rainy season. This result indicates that a given pollution condition within the watershed can be more sensitive than location factor to the level of water quality. The main sources of non-point pollution were population and livestock, as well as landuse factor, and were found to significantly contribute to the water pollution. Alternative solutions for controlling pollution sources, therefore, should be provided to meet target levels of water quality in this region.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2015년도 추계학술대회 논문집
• /
• pp.209-210
• /
• 2015

This paper presents a new model predictive control method without the effect of a weighting factor in order to reduce common-mode voltage (CMV) for a three-phase voltage source inverter (VSI). By utilizing two active states with same dwell time during a sampling period instead of one state used in conventional method, the proposed method can reduce the CMV of VSI without the weighting factor. Simulation is carried out to verify the effectiveness of the proposed predictive control method with the aid of PSIM software.

• 대한안전경영과학회지
• /
• 제12권4호
• /
• pp.183-190
• /
• 2010

This paper selects length of berth, area of yard, unloading capacity and number of berth as the input indexes, and cargo turnover as output index to research the source of TFP(Total Factor Productivity) growth of 23 main ports in Korea. The major conclusions are as follows. The TFP of the trade ports in Korea is at the fluctuating stage, but it generally displays a rising trend, and it’s growth originate from the growth of technical efficiency. The Growth rates of TFP of trade ports in the different areas are different, and the sources of growth are also different, but the changing trends are basically the same. Four major factors to the increase of TFP are following: competition between ports, reform of property system, harbor-hinterland economic and international trade, modeling, imitation and innovation in management, technology and system.

• 전기학회논문지
• /
• 제62권6호
• /
• pp.767-781
• /
• 2013

In this paper, we proposes the AC input voltage and current sensorless control scheme to control the input power factor and DC output voltage of the three-phase Z-source PWM rectifier. For DC-link voltage control which is sensitive to the system parameters of the PWM rectifier, fuzzy-PI controller is used. Because the AC input voltage and current are estimated using only the DC-link voltage and current, AC input voltage and current sensors are not required. In addition, the unity input power factor and DC output voltage can be controlled. The phase-angle of the detected AC input voltage and estimated voltage, the response characteristics of the DC output voltage according to the DC voltage references, the FFT results of the estimated voltage and current, efficiency, and the response characteristics of the conventional PI controller and fuzzy-PI controller are verified by PSIM simulation.