• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2011년도 전력전자학술대회
• /
• pp.13-14
• /
• 2011

This paper deals with the ZVS characteristics of a bidirectional DC/DC converter in idling mode. Simulations are carried out with the supercapacitor which maximum voltage is 50 V. It is found that the ZVS can be achieved as far as the supercapacitor voltage is below 94% of the maximum voltage in idling mode. Therefore, the switching loss in the mode can be small by control the upper limit of the supercapacitor voltage.

• 전기학회논문지P
• /
• 제58권3호
• /
• pp.310-315
• /
• 2009

This investigation was performed to study the characteristics of electricity and heat transfer that occur in the cylinder of electrode type humidifier during the process of water evaporation. Measurements were made to obtain the amount of water evaporation, the consumption of electric power, electrical conductivity, etc according to the materials and shapes of electrode. When the humidifier was in non-drain controlled mode, the number and amplitude of current cycle per minute increased gradually with the lapse of time, whereas for drain controlled mode, it decreased about 40[%] after draining water. It was found that for non-drain controlled mode, the thermal efficiency of humidifier which used SS400, STS316 and wire net electrode type was about 95~96[%] and it was 2~4[%] higher than that of drain controlled mode. Also, it was shown that the thermal efficiency of humidifier which used neighboring six-phase electrode balanced electrically was 4[%] higher than that of existing six-phase type.

• 제어로봇시스템학회논문지
• /
• 제5권8호
• /
• pp.932-940
• /
• 1999

In this paper, a new neural networks and neural network based sliding mode controller are proposed. The new neural networks are an mor self-recurrent neural networks which use a recursive least squares method for the fast on-line leammg. The error self-recurrent neural networks converge considerably last than the back-prollagation algorithm and have advantage oi bemg less affected by the poor initial weights and learning rate. The controller for suspension system is designed according to sliding mode technique based on new proposed neural networks. In order to adapt shding mode control mnethod, each frame dstance hetween ground and vehcle body is estimated md controller is designed according to estimated neural model. The neural networks based sliding mode controller approves good peiformance throllgh computer sirnulations.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 F
• /
• pp.2682-2684
• /
• 1999

This paper presents design and stability analysis of the constant frequency Flyback type converter using average current-mode control. The average current-mode control has been recently reported, and superior characteristics over a peak current-mode control such as a good tracking performance of an average current, no slope compensation and noise immunity. By the improvement of PM(Phase Margin) obt from applying the compensator in the current loop, the stability of designed flyback convert more improved. The validity of designed convert confirmed by simulation and experimental result

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 추계학술대회 논문집 학회본부 A
• /
• pp.184-186
• /
• 1999

This paper presents a method for security constrained optimal reactive power planning in electric power systems. This method deals with corrective mode optimal reactive power dispatch in each (n-1)contingency system state and determination of the location and amount of reactive sources in preventive mode. In this paper the proposed scheme uses Benders decomposition method to determine the proper amount and location of reactive support in order to maintain a proper voltage profile and minimize active power transmission losses. This method is tested on IEEE 30 bus test system to prove effectiveness.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 춘계학술대회논문집B
• /
• pp.213-219
• /
• 2000

In this work, it has been predicted the thermal performance of the engine cooling system in cases of stationary mode, constant speed mode, city-drive mode, and hill-climb mode by theoretical modeling of each component and numerical analysis. The modelling components are engine, radiator, heater, thermostat, water-pump, and cooling-fan. And also it has been developed the simulation program that can be used in case of design and system configuration changes. The comparison has not been made to verify the results of this work with experimental data, but the overall tendencies were agreed well with those of actual situation in four modes.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2008년도 추계학술대회 논문집
• /
• pp.94-97
• /
• 2008

In this paper, A Digital Voltage Mode Controller is designed for the Photovoltaic power converter applications. The designed Digital Voltage Mode Controller is derived analytically from the continuous time small signal model of the boost converter. Due to the small signal model based derivations of the control law, the designed control method can be applicable to K-factor Approach method and bilinear transformation. In order to show the usefulness of a designed controller, and the simulation results are verified.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 D
• /
• pp.2759-2761
• /
• 2001

Sliding mode is a robust control method and can be applied in the presence of model uncertainties and parameter disturbances. But there ane problems in sliding mode controller. Hard in modeling system parameters, chattering, etc. In this paper, new sliding controller design method is proposed for solving the above problems using fuzzy sliding mode contros(FSMC) scheme are considered. we propose that fuzzy logic system are used to approximate unknown system functions in desinging the SMC of Inverted Pendulum. In the method, a fuzzy logic system is utilized to approximate the unknown function f of the nonlinear system. As a simulation result of applying the inverted pendulum, the sliding controller shows good robust characteristics.

• 한국멀티미디어학회논문지
• /
• 제22권1호
• /
• pp.55-61
• /
• 2019

Almost all 3D displays have a brightness reduction in the 3D mode comparing to the 2D mode. When the brightness is reduced, one of the color attributes, the colorfulness, is decreased. In this case, the viewer feels that the image quality is deteriorated. In this paper, we proposed a method to compensate for the degradation of colorfulness due to brightness reduction in 3D mode for high quality 3D image viewing using the CIECAM02 model and the color correction matrix. As a result of applying the proposed method, we can confirm that the colorfulness is improved in 3D mode.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2011년도 추계학술대회 논문집
• /
• pp.130-135
• /
• 2011

A study of the bending-extension-transverse shear coupled random response of the composite beams with thin-walled open sections subjected to various types of concentrated and distributed random excitations is dealt with in this paper. First of all, equations of motion of thin-walled composite H-type cross-section beams incorporating a number of nonclassical effects of transverse shear and primary and secondary warping, and anisotropy of constituent materials are derived. On the basis of derived equations of motion, analytical expressions for the displacement response of the composite beams are derived by using normal mode method combined with frequency response function method.