• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.15 no.2
• /
• pp.62-67
• /
• 2010

Swells occurred on the coast of the East Sea on February 24, 2008 caused a loss of three lives and also damaged several west coasts of Japan. The recent increase of swell intensity with number of accidents demands more accurate forecasting of swells in terms of time and location. The swells occurred in February 2008 are hindcasted using SWAN model to examine the accuracy of the model for future forecasting. The model results are compared with ReWW3 data as well as measurement wave data and specially, wave spectrum is analysed by comparing with observed spectrum at two wave stations located in the east coast of Korea. The SWAN model shows similar results with observation data in terms of significant wave heights and swell arrival time but the shapes of wave spectrum are different between model and in-situ measurement data. For further improvement of swell forecasting, more comparison and analysis with observed wave spectrum is necessary and wave directional spectrum data are required to study on the characteristics of swells in the East Sea.

• Journal of Acupuncture Research
• /
• v.28 no.3
• /
• pp.131-142
• /
• 2011

Objectives : The primary purpose of this study was to examine the effect of manual acupuncture at the $LI_4$, $ST_{36}$ and $LR_3$ on normal human EEG (Electroencephalogram). And the secondary purpose of this study was to analyze the relationships between the change of EEG wave form using correlation analysis. Methods : 32 channel EEG measurement was carried out in 25 healthy participants (23 males and 2 females). EEG was measured for 21 minutes including 15 minutes of retention time. In this study, power spectrum was used as a measure of complexity. Statistical analysis was performed using Spearman correlation. Results : The results were as follows; 1. In C4, O1, Fz, Pz, Cz, FCz, CP4, FC4, TP7, FT7 among 32 electrodes, ${\delta}$, $\theta$ and ${\beta}$ wave increased during 0-3 time intervals, and especially in case of TP7, FT7 ${\alpha}$ wave spontaneously decreased during 12~15 time intervals in manipulation group. 2. Between $\theta$ and ${\beta}$ wave and $\theta$ and ${\delta}$ wave, there was statistically significant positive correlation in C4, O1, Fz, Pz, Cz, FCz, CP4, FC4, TP7, FT7 according to Spearman correlation analysis. 3. Between ${\alpha}$ and ${\beta}$ wave, there was statistically significant positive correlation in TP7, FT7 according to Spearman correlation analysis. Conclusions : These results suggest that TP7 and FT7 could be typical electrodes representing change of EEG after manipulated acupuncture at the $LI_4$, $ST_{36}$ and $LR_3$. The relationships between the change of EEG wave form appear to have statistically significant positive correlation between $\theta$ and ${\beta}$ wave, $\theta$ and ${\delta}$ wave and ${\alpha}$ and ${\beta}$ wave.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.1
• /
• pp.166-174
• /
• 2009

Gijang Sea is located on the southeastern coast of Korea. This study establishes a basic system to identify optimal sites for the wave power generation. To achieve this goal, the field measurements were made at the field site in front of Dong-am fishing port at Gijang. In addition, we analyzed the offshore wave data at the Donghae buoy operated by Korea Meteorological Administration(KMA) and compared the data with the wave characteristics in Gijang Sea. The main results were as follows. In winter, the wave direction in Gijang Sea ranged between east and south($90{\sim}180^{\circ}$). The main wave direction was east($90^{\circ}$). The Significant wave heights and periods were under 2 m and $5{\sim}15$ sec, respectively. A comparison of water depth and wave direction constitutes one(condition) of the important parameters for selecting the optimal site for the wave power generation.

• New & Renewable Energy
• /
• v.3 no.3
• /
• pp.28-35
• /
• 2007

In this study, the wave power resources at the three locations [Sokcho, Hupo, and Onsan] on the east coast of Korea were estimated by using the field measurement data and were compared with the results of previous researches. It was found that seasonal variation of the wave power is very significant on the east coast of Korean peninsula. The wave power was the smallest in the summer season at all the locations. At Hupo and Onsan, the highest value of the monthly-averaged wave power was observed in September, probably because the pathways of typhoon in September were close to both locations. At the northest location, Sockcho, in contrast, the monthly highest value of the wave power appeared in January, probably owing to the influence of storm waves driven by Donghae twister. The estimated annual average wave power was 4.5 kW/m at Sokcho, which was about two times larger than those at other two locations. It is noteworthy that this result is completely different from past researches based on wave hindcasting data. In addition, the estimates of wave power by the past researches seemed to be smaller than those of the present study, especially at the northern region of the east coast.

• Journal of Korea Water Resources Association
• /
• v.46 no.5
• /
• pp.491-504
• /
• 2013

In this study, wave breakings over a shelf region are investigated under irregular wave conditions through laboratory experiments in a wave flume. Numerical simulations based on the Boussinesq-type equations are also conducted. The characteristics of breaking waves such as significant wave height, crest and trough heights, the mean water level and the stable wave height are obtained by analyzing laboratory measurements in detail. Obtained results are compared with those of the Boussinesq-type equations model. A very reasonable agreements is observed. The broken waves over a horizontal bottom asymptotically approach a stable wave height($H_{stable}$). In this study, the relative stable wave height is found as $H_{stable}/h{\fallingdotseq}0.56$ for irregular wave.

• Journal of Korean Port Research
• /
• v.6 no.2
• /
• pp.43-64
• /
• 1992

This study discusses the interacting with deep water waves approaching from deep water based on the linear wave theory and steep sloping sea bottom floor by the numerical procedure. The results of particular interest are particle velocity and acceleration in x, y, z direction wave height amplification factor reflection coefficient and dimensionless pressure distribution on the steep sloping bottom with respect to the various incident wave angle. The wave loads relative to various bottom slopes, incident wave angles and wave periods on submerged breakwater and pipe are represented in comparison with mild sloping bottom the wave load parameters on the steep sloping bottom seemed to be influenced by variation of incident wave angle. In general the particle velocities and accelerations in x, y, z directions on the steep sloping bottom represented larger value or about two than those on the mild sloping bottom according to incident wave angle. However, the wave height amplification factors did not show distinct difference, but the slight variation with respect to the various incident angle showed on mild sloping bottom. The reflection coefficient increased with respect to increase of the incident angle on the steep sloping bottom the results also indicate that the very steep sloping beach produces a rather substantial amount of reflection as we expected. No significant variation of wave pressure was shown on the steep sloping bottom but it represented a certain amount of variation on the mild sloping bottom according to the various incident wave angle. The analysis at the OTEC site also showed similar results.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.697-700
• /
• 2003

The SASW method is a promising and effective way of profiling ground stiffness nondestructively. This method has been successfully applied to many geotechnical sites, but significant lateral variability, embedded obstacles, and pavement lead to the low reliability. To improve these problems, the horizontal wave component has been introduced to improve the reliability of the stiffness profile determined by the SASW method. To understand dispersion character of the horizontal component wave propagation in artificial profiles, FEM analysis had been performed. Used models are homogeneous half-space and two layered half- spaced layers.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2007.05a
• /
• pp.311-314
• /
• 2007

The experimental method of measuring dynamic properties of structures was presented. The method is based on the flexural wave propagation characteristics. Using the method, change in structural dynamic properties due to damage is measured. The crack has much more significant impact on the strain energy than the inertial effects. From this, the sensitivity of the dynamic stiffness on the crack location is estimated by calculating the strain energy. When the wave propagates, the strain and kinetic energies shows cyclic changed over space. The crack that occurred at locations where the wave energy is in the form of the potential energy affected most significantly the wave propagation characteristics. The effects of crack location on the wave propagation were used to determine the crack location.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2006.11a
• /
• pp.367-372
• /
• 2006

If the sea is narrowband, the Rayleigh distribution introduced by Longuet-Higgins can be used for the individual wave height distribution. However the Rayleigh distribution over-predicts the probability of high waves. Longuet-Higgins introduced alternative form of the Rayleigh distribution with an empirical constant. The wave height distribution can be fitted well by one parameter Rayleigh distribution with a proper choice of the empirical constant. The empirical constant is the ratio of the significant wave height based the time domain analysis and the spectral analysis. Here we examine wave data which contain extreme waves. Once again we confirmed that extreme wave height distribution can be modelled well by a modified Rayleigh distribution.

• Advances in aircraft and spacecraft science
• /
• v.7 no.3
• /
• pp.187-202
• /
• 2020

The exhaust nozzle serves back pressure of Pulse detonation combustor, so combustion chamber gets sufficient pressure for propulsion. In this context recent researches are focused on influence of nozzle effect on single cycle detonation wave propagation and propulsion performance of PDE. The effects of various nozzles like convergent-divergent nozzle, convergent nozzle, divergent nozzle and without nozzle at exit section of detonation tubes were computationally investigated to seek the desired propulsion performance. Further the effect of divergent nozzle length and half angle on detonation wave structure was analyzed. The simulations have been done using Ansys 14 Fluent platform. The LES turbulence model was used to simulate the combustion wave reacting flows in combustor with standard wall function. From these numerical simulations among four acquaint nozzles the highest thrust augmentation could be attained in divergent nozzle geometry and detonation wave propagation velocity eventually reaches to 1830 m/s, which is near about C-J velocity. Smaller the divergent nozzle half angle has a significant effect on faster detonation wave propagation.