• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.8C
• /
• pp.1025-1033
• /
• 2004

This paper covers the detection of covert direct sequence spread spectrum signal without the PN(Pseudo Noise) code information. Due to its low probability of interception, the difficulty of spectrum surveillance increases. Detection parameters are the signal existence of given bandwidth, the length of spreading sequence used by transmitter, and the identification of spreading code for detected chip length. The triple correlation function(TCF) value which is one of the higher order statistical signal processing techniques can be used to detect spread spectrum signal without a prior knowledge, but, it has weakness that TCF results depend on the spread data sequence in actual application. This paper proposes the new scheme that not only overcomes the weakness but also presents better performance than the traditional TCF scheme. The performance comparison of conventional TCF with proposed technique shows that the triple correlation estimator(TCE) has better detection capability.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2010.11a
• /
• pp.741-742
• /
• 2010

• Journal of Biomedical Engineering Research
• /
• v.5 no.1
• /
• pp.5-8
• /
• 1984

As the ensemble averaged dz/dt signal during exercise gets smoothed, it is difficult to find the distinctive marks for estimation of stroke volume. The cross correlation function was made use of estmating these marks for automatic calculation by computer from the ensemble averaged dz/dt signal. LVET(Left Ventricular Ejection Time) and stroke volume were estimated based on the calculated parameters from the characteristic points. LVET, stroke volume calculated by hand, by the ensemble average and the cross correlation were compared for accuracy validation.

• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.3
• /
• pp.107-114
• /
• 2015

Binary Offset Carrier (BOC) signal planned for future Global Navigation Satellite System (GNSS) provided better positioning accuracy and smaller multipath error than GPS C/A signal. However, due to the multiple side peaks in the auto-correlation function (ACF) of the BOC modulated signals, a receiver may false lock onto one of the side peaks in the tracking mode. This false lock would then result in a fatal tracking error. In this paper, we propose an unambiguous tracking method for composite BOC (CBOC) signals to mitigate this problem. It aims to reduce the side peaks of the ACF of CBOC modulated signals. It is based on the combination of traditional CBOC correlation function (CF) and reference CF of unmodulated pseudo- random noise code (PRN code). First, we present that cross-correlation function (CCF) with unmodulated PRN code is close to the secondary peaks of the traditional CBOC. Then, we obtain an unambiguous correlation function by subtracting traditional CBOC ACF from these CFs. Finally, the tracking performance for the CBOC signals is examined, and it is shown that the proposed method has better performance than the traditional unambiguous tracking method in additive white Gaussian noise (AWGN) channel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.7
• /
• pp.559-565
• /
• 2014

In this paper, we propose an unambiguous correlation function for time-multiplexed binary offset carrier (TMBOC) signal tracking. Specifically, considering that the TMBOC modulation transmits two kinds of sine-phased BOC signals in time domain alternatively, we generate sub-correlation functions for each of the BOC signals by using split sine-phased BOC signals, and then, obtain a correlation function with no side-peak by recombining the sub-correlation functions. From numerical results, we confirm that the proposed correlation function offers an improved tracking error standard deviation performance than the TMBOC autocorrelation function.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.6C
• /
• pp.541-550
• /
• 2005

In this paper, we address the derivation of joint distributions and correlation coefficients for four pairs of statistics used commonly in a number of signal detection schemes. The upper and lower bounds of the correlation coefficients are obtained, and interesting relationships between the correlation coefficients are derived. Explicit values of the correlation coefficients are given in the form of tables and figures for easy reference. The results in this paper should be useful in comparing various detection statistics.

• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.3
• /
• pp.97-105
• /
• 2015

A navigation signal based on orthogonal tiered polyphase code was proposed. For the proposed signal, tiered polyphase code was used as the code of a pilot channel. Tiered polyphase code is a complex number type code, and thus the pilot channel and data channel were separated using the Walsh code which makes the correlation between different codes become 0. The results of the simulation indicated that the correlation characteristics and signal acquisition performance of the proposed signal were identical to those of tiered polyphase code, and that the disadvantage of tiered polyphase code could be supplemented through a data channel in terms of signal tracking.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.3
• /
• pp.204-209
• /
• 2004

A partial matched filter (PMF) for semi-coherent correlation code acquisition of the DSSS-CPFSK signal is proposed. It is a calculation-reduced structure of the hard-limited signal based FIR filter, yet its code acquisition time is equal to that of the hard-limited signal based FIR filter. The PMF eliminates duplicate calculations by utilizing the characteristic that the hard-limited DSSS-CPFSK signal has same value in several consecutive samples. For example, the PMF can achieve about 95% reduction in gate size, as compared to the hard-limited signal based FIR filter, when the modulation index of the DSSS-CPFSK signal is equal to 1.5 and the sample rate is equal to 40 sample/chip.

• Journal of Biomedical Engineering Research
• /
• v.12 no.3
• /
• pp.185-190
• /
• 1991

An automatized latency calculation method of an e-OAE(evoked otacoustic emission) is proposed. The e-OAE signal measured from a normal adult is averaged 1000 times to remove noises. This averaged signal is converted to digital signal and that is processed by IBM-AT computer for latency calculation. we separate the stimulated and the emitted signal on the time domain by a modified LPC (linear prediction coding) spectrum, and the latency is calculated by cross-correlation method. By proposed latency calculation method the latency is 7.9[ms] for normal adult. The performance of the proposed method is also compared with that of the auto-correlation and cross performance of the proposed method is also compared with that of the auto-correlation and cross-correlation method. The result show that the proposed method has same precision with the conventional methods and can automatically calculate latency without subjective observation.

• The Journal of the Acoustical Society of Korea
• /
• v.37 no.5
• /
• pp.271-275
• /
• 2018

There are several methods for estimating the time delay between incoming signals to two sensors. Among them, the GCC-PHAT (Generalized Cross Correlation-Phase Transform) method, which estimates the relative delay from the signal whitening and the cross-correlation between the different signal inputs to the two sensors, is a traditionally well known method for achieving stable performance. In this paper, we have identified a part of GCC-PHAT that can improve the periodicity. Also, we apply the auto-correlation method that is widely used as a method to improve the periodicity. Comparing the proposed method with the GCC-PHAT method, we show that the proposed method improves the mean square error performance by 5 dB ~ 15 dB at the SNR above 0 dB for white Gaussian signal source and also show that the method improves the mean square error performance up to 15 dB at the SNR above 2 dB for the color signal source.