• Korean Journal of Materials Research
• /
• v.29 no.12
• /
• pp.798-803
• /
• 2019

The self-discharge behavior of zinc-air batteries is a critical issue induced by corrosion and hydrogen evolution reaction (HER) of zinc anode. The corrosion reaction and HER can be controlled by a gelling agent and concentration of potassium hydroxide (KOH) solution. Various concentrations of KOH solution and polyacrylic acid have been used for gel electrolyte. The electrolyte solution is prepared with different concentrations of KOH (6 M, 7 M, 8 M, 9 M). Among studied materials, the cell assembled with 6 M KOH gel electrolyte exhibits the highest specific discharge capacity and poor capacity retention. Whereas, 9 M KOH gel electrolyte shows high capacity retention. However, a large amount of hydrogen gas is evolved with 9 M KOH solution. In general, the increase in concentration is related to ionic conductivity. At concentrations above 7 M, the viscosity increases and the conductivity decreases. As a result, compared to other studied materials, 7 M KOH gel electrolyte is suitable for Zn-air batteries because of its higher capacity retention (92.00 %) and specific discharge capacity (351.80 mAh/g) after 6 hr storage.

• Child Health Nursing Research
• /
• v.22 no.1
• /
• pp.21-28
• /
• 2016

Purpose: The purpose of this study was to identify effects of EMLA (Eutectic Mixture of Local Anesthetics) cream application on pain perception and pain response during insertion of implanted venous access port needle in children with cancer. Methods: From December 2010 to August 2011, at U university hospital, 20 patients scheduled for implanted venous access port needle insertion were recruited, and randomly assigned to receive either EMLA or a placebo cream 1 hour before the implanted venous access port needle insertion. While conducting needle insertion, changes in pulse and oxygen saturation on the pulse oxymeter monitor were measured and pain behavior reaction was also measured during needle insertion in the treatment room. After conducting needle insertion, self-reported pain reaction, and mothers' perception of the children's pain reaction were measured. Collected data were statistically processed using SPSS version 17.0 for Windows, and analyzed using descriptive statistics, t-test. Results: Children's self-reported degree of pain, degree of pain as perceived by mothers and pain behavior reaction decreased significantly in the EMLA application group compared with the placebo group. Conclusion: Findings indicate that application of EMLA cream is effective in relieving pain in these children during implanted venous access port needle insertion.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.05a
• /
• pp.63-64
• /
• 2006

본 연구에서는 광에너지를 화학적인 에너지로 변환할 때, 디바이스의 전하전달 매개를 위한 electron transfer mediator로서 널리 이용되는 Viologen이 자기조립화된 수정진동자률 전기화학법의 하나인 순환전압전류법(Cyclic Voltammetry)을 이용하여 산화 환원 반응 (redox reaction) 특성과 주사속도와 피크전류와의 상관관계를 분석하였다. 먼저 수정진동자를 친수 처리한 후, 메탄올 용액과 아세토니트릴 용액을 섞은 용매에 Viologen 분자를 자기조립 (self-assembly)하여, 전해질 용액의 농도 변화에 따른 산화 환원반응 특성과 피크전류의 값을 측정하였다 주사 속도를 2 배씩 증가하여 피크전류와의 상관관계를 조사한 결과, 선형적인 증가를 보였으며, 이를 통해 가역적인 반응(reversible reaction)이 일어났음을 확인할 수 있었다. 또한, 산화 환원 반응과 동시에 측정된 수정진동자의 공진 주파수(resonant frequency) 변화로부터 전하이동(charge transfer) 특성에 의해 반응에 참가한 이온의 질량을 알 수 있었다.

• Korean Journal of Materials Research
• /
• v.12 no.9
• /
• pp.696-700
• /
• 2002

The Ti-aluminide intermetallic compound was formed from high purity elemental Ti and Al foils by self-propagating, high-temperature synthesis(SHS) in hot press. formation of $TiAl_3$ at the interface between Ti and Al foils was controlled by temperature, pressure, heating rate, and so on. According to the thermal analysis, it is known in this study that the heating rate is the most important factor to form the intermetallic compound by this SHS reaction. The V layer addition between Al and Ti foils increased SHS reaction temperatures. The fully dense, well-boned inter-metallic composite($TiA1/Ti_3$Al) sheets of 700 m thickness were formed by heat treatment at $1000^{\circ}C$ for 10 hours after the SHS reaction of alternatively layered 10 Ti and 9 Al foils with the V coating layer. The phases and microstructures of intermetallic composite sheets were confirmed by EPMA and XRD.

• Korean Journal of Metals and Materials
• /
• v.50 no.9
• /
• pp.677-684
• /
• 2012

A feasible way to fabricate in-situ Al/TiC composites was investigated. An elemental mixture of $Al-TiO_2-C$ pellet was directly added into an Al melt at $800-920^{\circ}C$ to form TiC by self-combustion reaction. The addition of CuO initiates the self-combustion reaction to form TiC in $1-2{\mu}m$ at the melt temperature above $850^{\circ}C$. Besides the CuO addition, a diluent element of excess Al plays a significant role in the TiC formation by forming a precursor phase, $Al_3Ti$. Processing parameters such as CuO content, the amount of excess Al and the melt temperature, have affected the combustion reaction and formation of TiC, and their influences on the microstructures of in-situ Al/TiC composites are examined.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.2
• /
• pp.325-329
• /
• 2002

In this study, the dependency of the behavior of propagating front on the reaction condition in frontal polymerization reaction has been studied. We have used some multifunctional acrylates as a monomer and ammonium persulfate as an initiator for the polymerization reactions. In frontal polymerization, a method of producing polymeric materials via a thermal front that propagates through the unreacted monomer/initiator solution, the behavior of self propagating front shows various dynamic patterns depending on the reaction condition. We have obtained some spin modes of propagating front in the number of 'hot spots' or 'spin heads' by changing the reaction condition. The effect of the reactor tube diameter on the mode of propagating front has also been studied by using some reactor tubes with different size of tube diameter and it has been examined in some detail by adopting an experimental method of two-tubes system.

• Korean Journal of Crystallography
• /
• v.9 no.1
• /
• pp.44-47
• /
• 1998

A reduction/oxidation reaction between A1 metal powder and SiO2 powder was performed by Self-propagating High-temperature Synthesis (SHS) reaction induced by microwave energy to produce a composite of Al2O3 and Si powders by using a 2.45 GHz kitchen model microwave oven. A Microwave Hybrid Heating(MHH) method was applied by using SiC powders as a suscepting material to raise the temperature of the disk samples and the heat increase rate of over 100℃/min were obtained before the reaction. The reaction started around 850℃ and the heat increase rate jumped to over 200℃/min after the reaction took place.

• Bulletin of the Korean Chemical Society
• /
• v.18 no.11
• /
• pp.1186-1191
• /
• 1997

Solvolyses of methanesulfonyl chloride (CH3SO2Cl) in water and methanol have been studied theoretically using ab initio self-consistent reaction field (SCRF) molecular orbital method. All stationary structures including transition state on the potential energy surface in solution have been found and compared with the gas phase structures. The overall reaction occurs via a concerted SN2 mechanism with a non-cyclic trigonal bipyramidal transition state, and the activation barrier is lowered significantly in solution. The transition state for the hydrolysis reaction is looser than that for the methanolysis reaction, and this is in accord with the experimental findings that an SN2 type mechanism, which is shifted toward an SN1 process or an SAN process in the hydrolysis and alcoholysis reaction, respectively, takes place. The catalytic role of additional solvent molecules appears to be a purely general-base catalysis based on the linear transition structures. Experimental barrier can be estimated by taking into account the desolvation energy of nucleophile in the reaction of methanesulfonyl chloride with bulk solvent cluster as a nucleophile.

• Korean Journal of Human Ecology
• /
• v.16 no.5
• /
• pp.921-932
• /
• 2007

This study is to examine the relationship between their parent-child communication and their reactive characteristics to the PSCD(Parent-Self-Centered-Drawing) test of the Female high-School Students. The study subjects are 209 Female high-School Students, and research tools are PSCD test and a measure of parent-child communication. The data were analyzed with a paired t-test, one-way ANOVA and Scheffe's post-hoc test. Results are as follows. First, they perceived positively communication toward mother more than communication toward father. Second, as for communication toward father according to the subjects' reaction to the father figure, female students show difference in ommission of facial parts, ommission of body parts, balance of body parts, facial expression and positive and negative symbols. Third, as for communication toward mother according to the subjects' reaction to the mother figure, female students show difference in ommission of facial parts, ommission of body parts, balance of body parts, facial expression and negative symbols. Forth, according to the female students' reaction to the self figure, they show different levels of communication toward father and self in regard of facial expression and distance between the figures. On the other hand, they show different levels of communication toward mother with respect to ommission of facial parts, ommission of body parts, balance of body parts, facial expression and distance between the figures. The authors conclude that the PSCD is a useful tool for measuring the level of parent-child communication.

• International Journal of Costume and Fashion
• /
• v.16 no.1
• /
• pp.87-107
• /
• 2016

Small luxury purchase as self-gifting is one of the latest consumer trends in self-gifting. Although this consumption trend continues to grow in various fields, little research has been conducted on related consumer behavior. As such, this study was conducted to empirically investigate the current consumer behavior involved in purchase of small luxury self-gifts. The objectives of this study are to determine the current status of self-gifts markets, identify motives and orientations of self-gifting, and investigate the effects of the motives on self-gifts orientations. A total of 199 respondents were used in data analyses. Regarding motives for self-gifting, four motives - self-comfort, self-reward, anxiety, and showing off - were identified; regarding self-gifting orientations, five factors - rationalization (emotional comfort, product attributes, self-defense, and conformity) and the luxury being within one's spending limit - were identified. The study determined the effects of the motives on the orientations, and the effects of the motives and the orientations on post-purchase consumer reaction. This study conducted an empirical investigation on small luxury self-gifting and moreover, the study determined the motives, orientations, and consequences of self-gifting, which have not yet been explained in the literature.