• ETRI Journal
• /
• v.46 no.2
• /
• pp.227-237
• /
• 2024

This study proposes a novel, conditionally applied neural network technique to reduce the overall peak-to-average power ratio (PAPR) of an orthogonal frequency division multiplexing (OFDM) system while maintaining an acceptable bit error rate (BER) level. The main purpose of the proposed scheme is to adjust only those subcarriers whose peaks exceed a given threshold. In this respect, the developed C-ANN algorithm suppresses only the peaks of the targeted subcarriers by slightly shifting the locations of their corresponding frequency samples without affecting their phase orientations. In turn, this achieves a reasonable system performance by sustaining a tolerable BER. For practical reasons and to cover a wide range of application scenarios, the threshold for the subcarrier peaks was chosen to be proportional to the saturation level of the nonlinear power amplifier used to pass the generated OFDM blocks. Consequently, the optimal values of the factor controlling the peak threshold were obtained that satisfy both reasonable PAPR reduction and acceptable BER levels. Furthermore, the proposed system does not require a recovery process at the receiver, thus making the computational process less complex. The simulation results show that the proposed system model performed satisfactorily, attaining both low PAPR and BER for specific application settings using comparatively fewer computations.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.8 s.338
• /
• pp.33-40
• /
• 2005

This paper presents a structure of the searcher using a diversity in array antenna systems operating in the cdma2000 1x signal environments. The new technique exploits the fact that the In-phase and quadrature components of interferers can respectively be viewed as an independent gaussian noise at each antnna element in most practical cdma signal environments. The proposed PN acquisition scheme is a singles-dwell PN acquisition system consisting of two stages, that is, the searching stage and the verification stage. The searching stage independently correlates the receiver multiple signals with PN generator of each antenna element for obtaining the synchronous energy at the entire region. Then, the searching results of each antenna element are non-coherently combinind. The verification stage compares the searching energy with the optimal threshold, which is predesigned in the lock detector, and decides whether the acquisition is successful or fail. In this paper, we analyzed the effect of tile diversity order to determine the mean acquisition time. In general, it is known that the mean acquisition time significantly decrease as the number of antenna elements increases. But, as the diversity order goes up, the enhancement of the performance is saturated. Therefore, to decrease the mean acquisition time of the searcher, we must design the optimal array antenna systems by considering the operating SNR range of the receiver, the probability of detection $P_D$ and that of false alarm $P_{FA}$ . The Performance of the proposed PN acquisition scheme is analyzed in frequency selective Rayleigh fading channels. In this paper, the effect of the number of antenna elements on PN acquisition scheme is shown according to the probability of detection $P_D$ and that of false alarm $P_{FA}$.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.3
• /
• pp.22-30
• /
• 2010

This paper proposes a combination system of Adaptive Modulation and Coding (AMC) and Multiple Input Multiple Output (MIMO), which improves the throughput and has a better reliability. In addition, the system includes Precoding, Antenna Subset Selection and MIMO Mode Selection scheme. Finally, we make a performance analysis of the proposed system. The principal environmental parameters for the simulation experiment consist of a frequency non-selective rayleigh fading channel and a Spreading Factor (SF) of 16. Other parameters may be included in order to fulfill the requirements of the HSDP A Standard. The proposed system has a higher throughput and more reliability than the conventional system, which does not include MIMO Mode Selection scheme, Precoding or Antenna Subset Selection. According to the simulation results, the proposed system reaches the maximum throughput at 8dB, presentlng an improvement of 6dB and twice higher throughput, respect to the conventional system. Specifically, at the point of -6dB, the conventional system reaches 2.5Mbps, while the proposed system reaches 6.4Mbps at the same SNR. Also, at the point of 2dB, each system reaches 7.5Mbps (conventional system) and 15.3Mbps (proposed system), with near twice the difference. According to the results exposed above, we can conclude that the system proposed in this paper has, as the greatest contribution, the improvement of the throughput, especially, the average throughput.

• The Transactions of the Korea Information Processing Society
• /
• v.6 no.9
• /
• pp.2524-2532
• /
• 1999

In this paper, we present a new buffer pool management scheme designed for video type news objects to build a cost-effective News On Demand storage server for serving users requests beyond the limitation of disk bandwidth. In a News On Demand Server where many of users request for video type news objects have to be serviced keeping their playback deadline, the maximum numbers of concurrent users are limited by the maximum disk bandwidth the server provides. With our proposed buffer cache management scheme, a requested data is checked to see whether or not it is worthy of caching by checking its average arrival interval and current disk traffic density. Subsequently, only granted news objects are permitted to get into the buffer pool, where buffer allocation is made not on the block basis but on the object basis. We evaluated the performance of our proposed caching algorithm through simulation. As a result of the simulation, we show that by using this caching scheme to support users requests for real time news data, compared with serving those requests only by disks, 30% of extra requests are served without additional cost increase.

• Geophysics and Geophysical Exploration
• /
• v.16 no.4
• /
• pp.211-216
• /
• 2013

In general, smoothing filters regularize functions by reducing differences between adjacent values. The smoothing filters, therefore, can regularize inverse solutions and produce more accurate subsurface structure when we apply it to full waveform inversion. If we apply a smoothing filter with a constant coefficient to subsurface image or velocity model, it will make layer interfaces and fault structures vague because it does not consider any information of geologic structures and variations of velocity. In this study, we develop a selective smoothing regularization technique, which adapts smoothing coefficients according to inversion iteration, to solve the weakness of smoothing regularization with a constant coefficient. First, we determine appropriate frequencies and analyze the corresponding wavenumber coverage. Then, we define effective maximum wavenumber as 99 percentile of wavenumber spectrum in order to choose smoothing coefficients which can effectively limit the wavenumber coverage. By adapting the chosen smoothing coefficients according to the iteration, we can implement multi-scale full waveform inversion while inverting multi-frequency components simultaneously. Through the successful inversion example on a salt model with high-contrast velocity structures, we can note that our method effectively regularizes the inverse solution. We also verify that our scheme is applicable to field data through the numerical example to the synthetic data containing random noise.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.5
• /
• pp.26-35
• /
• 2009

OFDM (Orthogonal Frequency Division Multiplexing) system is robust to frequency selective fading and narrowband interference in high-speed data communications. However, an OFDM signal consists of a number of independently modulated subcarriers and the superposition of these subcarriers causes a problem that can give a large PAPR(Peak-to-Average Power Ratio). Phase rotation method can reduce the PAPR without nonlinear distortion by multiplying phase weighting factors. But computational complexity of searching phase weighting factors is increased exponentially with the number of subblocks and considered phase factor. Therefore, a new method, which can reduce computational complexity and detect phase weighting factors efficiently, should be developed. In this paper, a modeling process is introduced, which apply metaheuristic algerian in phase rotation method and optimize in PTS (Particle Swarm Optimization) scheme. Proposed algorithm can solve the computational complexity and guarantee to reduce PAPR We analyzed the efficiency of the PAPR reduction through a simulation when we applied the proposed method to telecommunication systems.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.4
• /
• pp.69-74
• /
• 2010

A new package substrate for dynamic random access memory(DRAM) devices has been developed using selective aluminum anodization. Unlike the conventional substrate structure commonly made by laminating epoxy-based core and copper clad, this substrate consists of bottom aluminum, middle anodic aluminum oxide and top copper. Anodization process on the aluminum substrate provides thick aluminum oxide used as a dielectric layer in the package substrate. Placing copper traces on the anodic aluminum oxide layer, the resulting two-layer metal structure is completed in the package substrate. Selective anodization process makes it possible to construct a fully filled via structure. Also, putting vias directly in the bonding pads and the ball pads in the substrate design, via in pad structure is applied in this work. These arrangement of via in pad and two-layer metal structure make routing easier and thus provide more design flexibility. In a substrate design, all signal lines are routed based on the transmission line scheme of finite-width coplanar waveguide or microstrip with a characteristic impedance of about $50{\Omega}$ for better signal transmission. The property and performance of anodic alumina based package substrate such as layer structure, design method, fabrication process and measurement characteristics are investigated in detail.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.12A
• /
• pp.1319-1332
• /
• 2004

Multicarrier direct sequence code-division multiple access CDMA(MC DS-CDMA) is an attractive technique for achieving high data rate transmission even if the potentially large peak-to-average power ratio(PAPR) is an important factor for its application. On the other hand, code select CDMA(CS-CDMA) is an attractive technique with constant amplitude transmission of multicode signal irregardless of subchannels by introducing code selection method. In this paper we propose a new multiple access scheme based on the combination of MC DS-CDMA and CS-CDMA. Proposed scheme, which we called MC CS-CDMA, includes the sutclasses of MC DS-CDMA and CS-CDMA as special cases. The performance of this system is investigated for multipath Sequency selective fading channel and maximal ratio combining with rake receiver. In addition the PAPR of proposed system is compare with that of both MC BS-CDMA and CS-CDMA. Simulation results show that proposed system improves PAPR reduction than MC DS-CDMA at the expense of the complexity of receiver and the number of available non. Also, the numerical result shows that the proposed system is better performance than MC DS-CDMA due to the increasing processing gain and the number of time diversity gain.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.8 s.350
• /
• pp.47-58
• /
• 2006

Due to the movement of nodes, ad-hoc networks suffer from the problems such as the decrease of data delivery ratio, the increase of end-to-end delay, and the increase of routing overhead. The backup routing schemes try to solve these problems by finding the backup routes during the route discovery phase and using them when a route fails. Generally the backup routing schemes outperform the single-path routing schemes in terms of data delivery ratio, end-to-end delay, and routing overhead when the nodes move rapidly. But when the nodes don't move rapidly, the backup routing schemes generate more routing traffics than the single-path routing schemes because they need to exchange packets to find the backup route. In addition, when the backup route fails earlier than the main route, it can not use the backup route because in many backup route algorithms, the backup route is found only at the initial route discovery phase. RBR(Reactive Backup Routing Algorithm) proposed in this paper is an algorithm that provides more stable data delivery than the previous backup routing schemes through the selective maintenance of backup route and the backup route rediscovery. To do that RBR prioritize the backup routes, and maintain and use them selectively Thus it can also decrease the routing overheads. Also, RBR can increase data delivery ratio and decrease delay because it reestablishes the backup route when the network topology changes. For the performance evaluation, OPNET simulator is used to compare RBR with the single-path routing scheme and some of the well known backup routing schemes.

• Korea journal of population studies
• /
• v.21 no.1
• /
• pp.80-104
• /
• 1998

In order to examine differential mortality, the life tables for the insured persons in national pension scheme were estimated by sex and types of coverage(the insured in workplaces vs. the insured in rural areas). The averages of 1994-1996 data are used for insured in workplaces, but 1996 data are used for insured in rural areas. Life expectancies at the age of 18 are 59.5 years and 67.2 years each for insured males and females and thus 7.7 years longer for females than males in workplaces. Sex difference in mortality reduces as age increases, and more rapidly at younger ages than old ages. For insured in rural areas, life expectancies at the age of 18 are 51.4 years and 61.1 years each for insured males and females and thus sex difference is 9.7 years. The greater sex difference in mortality in rural areas can be explained by sex selective migration. The difference of life expectancy between insured in workplaces and insured in rural areas is 8.1 years for males, and 6.1 years for females. Because rural-urban difference in educational attainment is greater for males than females, the greater difference in life expectancy is observed for males than females.