• Journal of Korean Society of Water and Wastewater
• /
• v.32 no.1
• /
• pp.47-53
• /
• 2018

This study investigated phosphorus removal from secondary treated effluent using coagulation-membrane separation hybrid treatment to satisfy strict regulation in wastewater treatment. The membrane separation process was used to remove suspended phosphorus particles after coagulation/settlement. Membrane separation with $0.2{\mu}m$ pore size of micro filtration membrane could reduce phosphorus concentration to 0.02 mg P/L after coagulation with 1 mg Al/L dose of polyaluminum chloride (PACl). Regardless of coagulant, the residual concentration of phosphorus decreased as the dose increased from 1.5 to 3.5 mg Al/L, while the target concentration of 0.05 mg P/L or less was achieved at 2.5 mg Al/L for the aluminum sulfate (Alum) and 3.5 mg Al/L for PACl. Moreover, alum showed better membrane flux as make bigger particles than PACl. Alum showed a 40% of flux decrease at 2.5 mg Al/L dose, while PACl indicated a 50% decrease of membrane flux even with a higher dose of 3.5 mg Al/L. Thus, alum was more effective coagulant than PACl considering phosphorus removal and membrane flux as well as its dose. Consequently, the coagulation-membrane separation hybrid treatment could be mitigate regulation on phosphorus removal as unsettleable phosphorus particles were effectively removed by membrane after coagulation.

• Journal of Ocean Engineering and Technology
• /
• v.22 no.4
• /
• pp.59-64
• /
• 2008

The mechanical properties of liquid phase sintered (LPS) SiC materials, with the addition of oxide powder, were investigated, in conjunction with a detailed analysis of their microstructures. LPS-SiC materials were fabricated at a temperature of 1820 $^{\circ}C$ under an argon atmosphere, using three different starting sizes of SiC particles. The sintering additive for the fabrication of the LPS-SiC materials was an $Al_2O_3-Y_2O_3$ mixture with a constant composition ratio ($Al_2O_3/Y_2O_3$: 1.5). The particle sizes of the commercial SiC powderswere 30 nm, 0.3 $\mu$m, and 3.0 $\mu$m. The flexural strength of the LPS-SiC materials was also examined at elevated temperatures. A decrease in the starting size of the SiC particles led to an increase in the flexural strength of the LPS-SiC materials, accompanying a highly dense morphology with the creation of a secondary phase. Such a secondary phase was identified as $Y_3Al_2(AlO_4)2$. The flexural strength of the LPS-SiC materials greatly decreased with an increase in the test temperature, due to the creation of a large amount of pores.

• Journal of the Korean Society for Heat Treatment
• /
• v.13 no.1
• /
• pp.27-34
• /
• 2000

This present study were investigated effect of Ni contents on the microstructure and strength characteristic in 9Cr ferritic heat-resistant steel added 1.7%W in place of Mo in order to restrain laves phase formation. The result obtained from this study are as follow. Volume fraction, number of particles per unite area and particle size of carbide decreased with increase of Ni contents. Other side, carbides of $M_{23}C_6$ type was mainly precipitated in this steel, but laves phases could not precipitated in spite of increasing of aging time. With increase of tempering temperature, hardness was increased, and maximum value was showed around 873k by secondary hardening due to precipitation of $W_2C$ type carbide and then, was decreased. Tensile and yield strength due to decrease precipitation amount of carbide and number of particles per unite area was decreased, but elongation and impact value was increased. In case of aged specimen after tempering than tempered specimen, strength was higher and elongation was lower due to increasing of precipitated amount of carbide and number of particles per unite area.

• Economic and Environmental Geology
• /
• v.56 no.5
• /
• pp.557-564
• /
• 2023

Nuclear materials such as uranium are used as fuel for nuclear power generation, but there is a high possibility that they will be used for non-peaceful purposes, so international inspections and regulations are being conducted. Isotope analysis data of fine particulate obtained from nuclear facilities can provide important information on the origin and concentration method of nuclear material, so it is widely used in the field of nuclear safety and nuclear forensics. In this study we describe the analytical method that can directly identify nuclear particles and measure their isotopic ratios for fine samples using a large-geometry secondary ion mass spectrometer and introduce its preliminary results. Using the U-200 standard material, the location of fine particles was identified and the results consistent with the standard value were obtained through microbeam analysis.

• Journal of Electrochemical Science and Technology
• /
• v.7 no.2
• /
• pp.161-169
• /
• 2016

Porous tungsten oxide thin films were prepared by electrodeposition and tested as anodes of lithium secondary batteries. The synthesized films were composed of nanoparticles of 60-140 nm size, with porosities of 30-40 %. Increasing the temperature turned out to be a more effective approach to introduce porosity in the structure than increasing the electrolyte viscosity. The assessment of the synthesized films as anodes of lithium secondary batteries revealed a much higher initial discharge capacity for the porous than the dense samples. The discharge capacity retention significantly increased with increasing porosity and was further enhanced by heat treatment. In particular, a thin film composed of particles of about 140 nm in size and with a porosity of 40 % exhibited an initial discharge capacity higher than 600 mAh/g and a remaining capacity above 300 mAh/g after 30 cycles. Following heat treatment, the remaining capacity of this sample after 30 cycles increased to about 500 mA h/g.

• Progress in Superconductivity
• /
• v.4 no.1
• /
• pp.90-93
• /
• 2002

The sintering process of BSCCO 2223 tapes is a complex process that is very sensitive to parameters, such as temperature, oxygen partial pressure, heating and cooling rate and holding time. During the first heat treatment, 2212 phase of precursor powder is partially transformed into 2223 phase and some residual secondary phases, such as $(Bi,Pb)_2$$Sr_2$CuO／sub y／(2201), $(Ca,Sr)_2$CuO／sub y／(2/1AEC), (Ca,Sr)／sub 14／Cu／sub 24／O／sub 41／(14／24 AEC) etc. The secondary phases are difficult to be removed from the BSCCO 2223 matrix on the heat treatment. These secondary phases degrade the critical current density. In order to minimize the amount and size of alkaline earth cuprate(AEC) particles step heat treatment is applied during the first heat treatment under the varying atmosphere. Experimental results showed that by adapting the step heat treatment process, the amount and particle size of the secondary phases in the final tapes are decreased. Consequently, the BSCCO 2223grain texture and Jc properties are improved.

• Korean Journal of Materials Research
• /
• v.12 no.9
• /
• pp.712-717
• /
• 2002

New wet chemical method so called precipitation-evaporation method was suggested for preparing spinel structure lithium manganese oxide ($LiMn_2$$O_4$) for Li ion secondary battery. Using precipitation-evaporation method, $LiMn_2$$O_4$ cathode materials suitable for Li ion secondary batteries can be synthesized. Single spinel phase $LiMn_2$$O_4$ powder was synthesized at lower temperature compared to that of prepared by solid-state method. $LiMn_2$$O_4$ powder prepared by precipitation-evaporation method showed uniform, small size and well defined crystallinity particles. Li ion secondary battery using $LiMn_2$$O_4$ as cathode materials prepared by precipitation-evaporation method and calcined at $800^{\circ}C$ showed discharge capacity of 106.03mAh/g and discharge capacity of 95.60mAh/g at 10th cycle. Although Li ion secondary battery showed somewhat smaller initial capacity but good cyclic ability. It is suggested that electro-chemical properties can be improved by controlling particle characteristics by particle morphology modification during calcination and optimizing Li ion secondary battery assembly conditions.

• Journal of Environmental Health Sciences
• /
• v.44 no.1
• /
• pp.1-14
• /
• 2018

Objectives: The purpose of this study is to investigate the main cause of visibility impairment by analyzing the contributions of the light extinction coefficient of major air pollution components and the change of the light extinction coefficient by relative humidity. Methods: The characteristics of the light extinction coefficient calculated by the photochemical method using fine particle component data measured in 2015 in the Gwangju area were examined. Results: The extinction efficiency per unit mass of $PM_{2.5}$ particles was $4.5m^2/g$ and that of $PM_{10-2.5}$ particles was $0.6m^2/g$. This difference indicates that most of the visibility impairment in Gwangju was caused by $PM_{2.5}$ particles. When visibility was poor, the contribution of ammonium sulphate and ammonium nitrate was significantly increased. Relative humidity was also a major cause of visibility decay. The influx of air currents in Gwangju was mostly caused by the long distance movement of pollutants emitted from the eastern part of China. Ammonium sulphate and ammonium nitrate, which are hygroscopic secondary contaminants, were the main causative agents of visibility impairment. Conclusions: Ammonium sulphate and ammonium nitrate were the main causative agents of visibility impairment in Gwangju. The influx of air currents in Gwangju was mostly caused by the long distance movement of pollutants emitted from the eastern part of China.

• Korean Journal of Mineralogy and Petrology
• /
• v.33 no.3
• /
• pp.233-242
• /
• 2020

As studies and developments of nano-material increase, the release of the nano-sized material to water environment increase. Especially, silver nanoparticles have been found as dissolved and particulate state since nano-silver particle have been intensively used in industrial and our living environment due to the anti-bacterial effect of the nano-particles. The silver nano-particles and silver ion gives adverse effect on ecology and US-EPA set a secondary drinking water standards as 0.1 mg/L. Current study focused on the analysis of silver in groundwater, small scale water supply systems in Gyeongbook area. The results have been compared with the secondary drinking water standards and discussed at the point of characteristics of the local area and purpose of use of the water sample. Among the total of 298 samples, 2 samples exceed the secondary drinking water standards of EPA, 0.64% rate. Community drinking water and simplified water service showed relatively high detection rate and groundwater gave relatively higher concentration of silver indicating anthropogenic source and natural source could contribute simultaneously on groundwater.

• Journal of Radiation Protection and Research
• /
• v.46 no.2
• /
• pp.39-47
• /
• 2021

Background: The National Institutes for Quantum and Radiological Science and Technology-National Institute of Radiological Sciences (QST-NIRS) has continuously investigated the undesired radiation exposure in ion beam radiotherapy mainly in carbon-ion radiotherapy (CIRT). This review introduces our investigations on the secondary neutron dose in CIRT with the broad and scanning beam methods. Materials and Methods: The neutron ambient dose equivalents in CIRT are evaluated based on rem meter (WENDI-II) measurements. The out-of-field organ doses assuming prostate cancer and pediatric brain tumor treatments are also evaluated through the Monte Carlo simulation. This evaluation of the out-of-field dose includes contributions from secondary neutrons and secondary charged particles. Results and Discussion: The measurements of the neutron ambient dose equivalents at a 90#x00B0; angle to the beam axis in CIRT with the broad beam method show that the neutron dose per treatment dose in CIRT is lower than that in proton radiotherapy (PRT). For the scanning beam with the energy scanning technique, the neutron dose per treatment dose in CIRT is lower than that in PRT. Moreover, the out-of-field organ doses in CIRT decreased with distance to the target and are less than the lower bound in intensity-modulated radiotherapy (IMRT) shown in AAPM TG-158 (American Association of Physicists in Medicine Task Group). Conclusion: The evaluation of the out-of-field doses is important from the viewpoint of secondary cancer risk after radiotherapy. Secondary neutrons are the major source in CIRT, especially in the distant area from the target volume. However, the dose level in CIRT is similar or lower than that in PRT and IMRT, even if the contributions from all radiation species are included in the evaluation.