• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.1
• /
• pp.51-57
• /
• 2009

Biofouling in seawater reverse osmosis (SWRO) desalination process causes many problems such as flux decline, biodegradation of membrane, increased cleaning time, and increased energy consumption and operational cost. Therefore biofouling is considered as the most critical problem in system operation. To control biofouling in early stage, detection of the most problematic bacteria causing biofouling is required. In this study, six model bacteria were chosen; Bacillus sp., Flavobacterium sp., Mycobacterium sp., Pseudomonas aeruginosa, Pseudomonas fluorescens, and Rhodobacter sp. based on report in the literature and phylogenetic analysis of seawater intake and fouled RO membrane. The adhesion to RO membrane, the high pressure resistance, and the hydrophobicity of the six model bacteria were examined to find out their fouling potential. Rhodobacter sp. and Mycobacterium sp. were found to attach very well to RO membrane surface compared to others used in this study. The test of hydrophobicity revealed that the bacteria which have high hydrophobicity or similar contact angle with RO membrane ($63^{\circ}$ of contact angle) easily attached to RO membrane surface. P. aeruginosa which is highly hydrophilic ($23.07^{\circ}$ of contact angle) showed the least adhesion characteristic among six model bacteria. After applying a pressure of 800 psi to the sample, Rhodobacter sp. was found to show the highest reduction rate; with 59-73% of the cells removed from the membrane under pressure. P. fluorescens on the other hand analyzed as the most pressure resistant bacteria among six model bacteria. The difference between reduction rates using direct counting and plate counting indicates that the viability of each model bacteria was affected significantly from the high pressure. Most cells subjected to high pressure were unable to form colonies even thought they maintained their structural integrity.

• Journal of Korean Society of Environmental Engineers
• /
• v.35 no.7
• /
• pp.495-502
• /
• 2013

This work was performed to investigate proper condition of coagulation treatment as UF process pretreatment that consider UF permeate flux and residual Al concentration. The coagulant used an alum as $Al_2(SO_4)_3{\cdot}16H_2O$ and PACl (r = 1.5) made this study. The experiment was tested in adjusting conditions such as alum dose, flocculation time and coagulation pH of seawater. Consequently, higher coagulant dose lead to elevation of UF permeate flux while residual aluminium also increased in condition of pH 8.0. The most suitable condition which has a good permeate flux and low residual aluminium, in this works, was coagulant dose of 0.7 mg/L (as Al, alum) and 1.2 mg/L (as Al, PACl) and coagulation pH 6.5. In addition, applying the flocculation time with 1.2 mg/L of PACI reduced. The flocculation time reduced UF permeate flux in using alum.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.38 no.1
• /
• pp.65-69
• /
• 2005

We have developed a new method of manufacturing salts by horizontal spray drying technique, using the concentrated deep ocean water after desalination processes. We studied the chemical characteristics of the spray-dried salts. Sodium content in the spray salts is $28.4\%$, which is $10-30\%$ lower than that of bay salts, bamboo salts and boiling salts $(32-38.2\%)$. However, the contents of magnesium, potassium and calcium of the spray salts are 2.5 times, 3 times and 4.5 times higher relative to those of bay salts, respectively. On the one hand, sulfur content in spray salts is 14 times lower than those of bay salts, which is caused by their volatilization during spray and vaporization of the concentrated seawater. Enrichment factors of Mg (0.8), K (0.9) and Ca (1.0) in the spray salts are relatively higher than those in bay salt (0.2-0.3), bamboo salt (0.15-0.4) and boiled salt (0.4-0.7), respectively. On the contrary, enrichment factor of sulfur in spray salts is observed to be 0.07, which is considerably lower than those in other salts (0.3-0.7). It means that the minerals like Mg, K and Ca can be well conserved from seawater to salts through spray drying techniques, while volatile elements like sulfur, lead, mercury and organic compounds can be easily removed from seawater via spray and heating processes.

• Journal of the Korean GEO-environmental Society
• /
• v.14 no.8
• /
• pp.23-27
• /
• 2013

In this study, efficiency of pre-treatment of turbid seawater was measured where micro-air bubbles were used to remove particles in seawater after input of natural coagulant PGA. Artificial seawater was prepared having the intended trubidity using marine sediments and microalgae. 73.7% of turbidity removal was achieved when 0.5g/L of $AlCl_3{\cdot}6H_2O$ was added in the artificial seawater, but 92.4% of turbidity removal was observed when 0.05g/L of PGA was added in the artificial seawater containing microalgae. In addition, much greater turbidity removal was achieved for microalage than sediments. For both cases, input of 0.1g/L PGA and following additional input of micro-air bubbles for 5 seconds resulted in the maximum removal efficiency where reaction time of coagulation was 1 min and flotation by micro-air bubbles was 10 min. From this study, we concluded that micro-air floation after coagulation could be a possible economical pre-treatment method for highly turbid seawater.

• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.1368-1369
• /
• 2011

이 연구는 최근 물 부족시대를 대비한 차세대 기술로 각광 받고 있는 해수담수화설비의 동력을 기존의 화석연료에서 신재생에너지로 전환하고 있는 세계적인 추세와 기술동향을 살펴보고 국내 적용 가능성을 검토한 것이다. 특히 태양열, 태양광, 풍력 등을 활용하여 MENA(Middle East Asia & North Africa), 스페인, 지중해 연안 등의 지역에서 추진 중인 프로젝트의 성과를 살펴보고, 이를 토대로 극심한 물 부족으로 불편을 겪고 있는 국내 해안 도서지역에 적용할 수 있는 방안을 검토하였다.

• Proceedings of the KAIS Fall Conference
• /
• 2011.12b
• /
• pp.391-393
• /
• 2011

본 연구에서는 원자력 발전 및 화력 발전소에서 Turbine 운전 시 열교환기 및 콘덴서에 증기를 응축시 열효율을 높여주기 위해 콘덴서 Tube 내에 이물질 및 스케일을 Sponge Ball을 이용하여 자동으로 제거하는 장치로서 콘덴서 튜브 클리닝 시스템(CTCS)에 사용되고 있는 Screen 재료인 Duplex Stainless Steel UNS S31803의 파손사례에 대해 연구하였다. 파손원인 분석은 스크린의 강도해석, 재료의 화학분석시험, 조직시험 및 점용접부의 신뢰성 시험(Peel-off test)으로 수행되었고 저항용접부의 용접 불량 때문에 발생하였을 확인하였다.

• Proceedings of the KIEE Conference
• /
• 2005.07a
• /
• pp.223-225
• /
• 2005

This paper will be introduce a new paradigm and prospects for energy supply system in near future which produces electric and district heat cogeneration with dispersed power grid with small nuclear power units. Recently, in nuclear field, a lot of effort has been done in nuclear major countries to develop small and medium reactor for enhancement of nuclear peaceful use as like in district heating, electric power generation, seawater desalination or hydrogen generation. This paper presents a new way and prospects for power source in distribution system by using the distributed & remote cogeneration system using small reactor.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.5
• /
• pp.548-553
• /
• 2015

The conventional ejector-diffuser system makes use of high pressure primary stream to propel the secondary stream through pure shear action for the purposes of transport or compression of fluid. It has been widely used in many industrial applications such as seawater desalination, solar refrigeration, marine engineering, etc. The present study is performed numerically to study the performance of a two-stage ejector-diffuser system. The detailed flow phenomenon of the ejector-diffuser system has been critically predicted by means of the numerical approach using compressible Reynolds averaged Navier-Stokes (RANS) equations. The axi-symmetric supersonic ejector-diffuser flow has been solved by a fully implicit finite volume scheme with a two-equation k-omega turbulence model. The numerical results are validated with existing experimental data. Detailed flow physics and their contributions on ejector performance are detected to compare both single-stage and two-stage ejectors. The performance improvement on the ejector-diffuser system is discussed in terms of the mass flux ratio and the coefficient of power.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1996.09a
• /
• pp.121-145
• /
• 1996

Due to more stringent regulations in drinking water, membrane separation has been playing an increasingly important role. Seawater desalination by reverse osmosis is a typical example and has been used world-wide. Although the existing technology based on coagulation and media filtration is well established and reliable technology, with the advance of industrial and agricultural activities it is difficult for this technology to remove contaminants such as nitrate and synthetic organic chemicals. To meet the drinking water standards and produce higher quality water, several membrane filtration research programs have been initiated which include Japanese MAC21 and New MAC21 projects. In this paper, potable water application of reverse osmosis (RO) and nanofiltration(NF) and their case histories will be explained in more detail.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.6
• /
• pp.513-518
• /
• 2015

Salinity gradient power (SGP) has attracted significant attention because of its high potential. In this study, we evaluate reverse electrodialysis (RED) with various compositions of available resources. The polarization curve (I-V characteristics) shows linear behavior, and therefore the power density curve has a parabolic shape. We measure the power density with varying compartment thicknesses and inlet flow rates. The gross power density increases with decreasing compartment thickness and increasing flow rate. The net power density, which is the gross power density minus the pumping power, has a maximum value at a compartment thickness of 0.2 mm and an inlet flow rate of 22.5 mL/min. The power density in RED is also evaluated with compositions of desalination brines, seawater, river water, wastewater, and brackish water. A maximum power density of $1.75W/m^2$ is obtained when brine discharged from forward osmosis (FO) and river water are used as the concentrated and the diluted solutions, respectively.