• Proceedings of the KIEE Conference
• /
• 2008.05a
• /
• pp.189-190
• /
• 2008

This study was investigated a possibility of fault of glass insulator due to vibration on high-speed railway. The proper vibration of 1-glass insulator have many frequency band and high amplitude showed in high frequency than low frequency. The proper vibration of strut tube insulator was lowest 170Hz, highest 1.5kHz. The field signal amplitude of viaduct and open route were biggest moment pantograph of high-speed rail. The surface vibration(V3) amplitude of strut tube insulator was biggest. From the FFT analysis of viaduct and open route, the strut tube insulator effect by vertical vibration was big, the frequency was 82.5Hz and 105Hz, respectively. However, in comparison with the proper vibration of strut tube insulator, the resonance was not observed. Although the amplitude of insulator is high, the possibility of fault is low because the glass insulator deterioration by the accumulation of vibration do not happen.

• The Korean Journal of Emergency Medical Services
• /
• v.6 no.1
• /
• pp.199-207
• /
• 2002

This is a study to evaluate the effects of the safety of ambulance driving and the occurrence of ambulance traffic accidents and to provide basic information for the description of various factors to reduce the ambulance traffic accidents. The major instruments of this study were Korean Self-Analysis Driver Opinionnaire. Questionnaire contains 8 items which measure driver's opinions or attitudees: driving courtesy, emotion, traffic law, speed, vehicle condition, the use of drugs, high-risk behavior, human factor. To take the analysis of data, the total of 187 drivers were investigated ambulance drivers in Gwangju Metropolitan City from 2002. 1. September to 2002. 20. September. The data were analyzed by the path analysis SPSS program. The result are as follows : 1. There was desirable attitude group(58.4%) and undesirable attitude group(41.7%) on safety ambulance driving. 2. It have suggested that rist factors of ambulance traffic accident much affected with emotion and speed control on safety ambulance driving(Y(Accident) = -2.00 + 0.6 X1(Emotion Control) + 0.4 $X_2$(Speed control) + E). 3. Almost 92.1% of respondents have agreed to necessity of emergency medical technics for ambulance drivers.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.3
• /
• pp.81-88
• /
• 2014

These days the researches using IT technologies have been done to decrease the traffic accident. Especially, the optimal safety speed considering the weather conditions have to be calculated in real time to protect the traffic accident on the high way in the case of the rain and snow. In this paper, we have simulated the automatic warning broadcasting system for the freezing and foggy regions based on Web to protect the traffic accident. Also, we have developed the simulator that can provide the drivers with the optimal safety speed in real time to protect the traffic accident even under the worst weather conditions using the Fuzzy Reasoning rules.

• Journal of the Korean Society of Safety
• /
• v.26 no.6
• /
• pp.26-30
• /
• 2011

Experimental investigations were performed to examine the effects of different electrostatic discharge ignition energies on LPG/air mixture explosions in an explosion chamber. The chamber consisted of 500 mm in length, with a $100{\times}100mm^2$ cross section. Three different ignition energies were used: 0.30 mJ, 46 mJ and 98 mJ. Flame propagations were recorded by a high speed video camera. The results of flame speed and pressure obtained from the different ignition energies were discussed. It was found that as the energy increased, different flame initiations occurred. This caused the time interval in both the flame and pressure developments. It was also found that the flame speed and the pressure were less sensitive to both 0.30 mJ and 46 mJ, except for the ignition energy of 98 mJ.

• Journal of the Korean Society of Safety
• /
• v.32 no.2
• /
• pp.132-146
• /
• 2017

Appropriate speed limits at a reasonable level in urban roads are highly important factors for efficient and safe movement. Thus, it is greatly necessary to develop the objective models or methodology based on engineering study considering factors such as traffic accident rates, roadside development levels, and roadway geometry characteristics etc. The purpose of this study is to develop the estimate model of appropriate speed limits at each road sections in urban roads using traffic information big data and field specific data and to review the effects of accident decrease. In this study, the estimate method of appropriate speed limits in directional two or more lanes of urban roads is reflecting features of actual variables in a form of adjustment factor on the basis of the maximum statutory speed limits. As a result of investigating and testing influential variables, the main variables to affect the operating speed are the function of road, the existence of median, the width of lane, the number of traffic entrance/exit path and the number of traffic signal or nonsignal at intersection and crosswalk. As a result of testing this model, when the differences are bigger between the real operating speed and the recommended speed limits using model developed in this study, the accident rate generally turns out to be higher. In case of using the model proposed in this study, it means accident rate can be lower. When the result of this study is applied, the speed limits of directional two or more lane roads in Seoul appears about 11km/h lower than the current speed limits. The decrease of average operating speed caused by the decrease of speed limits is 2.8km/h, and the decrease effect of whole accidents according to the decrease of speed is 18% at research road. In case that accident severity is considered, the accident decrease effects are expected to 17~24% in fatalities, 11~17% in seriously injured road user, 6~9% in slightly injured road user, 5~6% in property damage only accidents.

• Wind and Structures
• /
• v.20 no.5
• /
• pp.701-718
• /
• 2015

The joint distribution of wind speed and wind direction at a bridge site is vital to the estimation of the basic wind speed, and hence to the wind-induced vibration analysis of long-span bridges. Instead of the conventional way relying on the weather stations, this study proposed an alternate approach to obtain the original records of wind speed and the corresponding directions based on field measurement supported by the Structural Health Monitoring System (SHMS). Specifically, SHMS of Sutong Cable-stayed Bridge (SCB) is utilized to study the basic wind speed with directional information. Four anemometers are installed in the SHMS of SCB: upstream and downstream of the main deck center, top of the north and south tower respectively. Using the recorded wind data from SHMS, the joint distribution of wind speed and direction is investigated based on statistical methods, and then the basic wind speeds in 10-year and 100-year recurrence intervals at these four key positions are calculated. Analytical results verify the reliability of the recorded wind data from SHMS, and indicate that the joint probability model for the extreme wind speed at SCB site fits well with the Weibull model. It is shown that the calculated basic wind speed is reduced by considering the influence of wind direction. Compared to the design basic wind speed in the Specification of China, basic wind speed considering the influence of direction or not is much smaller, indicating a high safety coefficient in the design of SCB. The results obtained in this study can provide not only references for further wind-resistance research of SCB, but also improve the understanding of the safety coefficient for wind-resistance design of other engineering structures in the similar area.

• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2004.11a
• /
• pp.233-238
• /
• 2004

In this study, speed survey has been conducted on Pusan Freeway to identify actual running speed. therefore, suggest that Highway Design Regulations and Highway Design Standard from Ministry of Construction and Transportation, which requires stopping sight distance for 20% less speed when rainy condition in accordance with Highway Safety Act, is not coincident with driver's characteristics. Consequently, it is prudent to compute stopping sight distance with 85th percentile running speed, considering driver's actual behavior and mountainous terrain.

• Proceedings of the KSR Conference
• /
• 2000.05a
• /
• pp.423-430
• /
• 2000

With speed-up of existing railway, a greater attention is paid to the riding safety and the comfort of the passengers. They are combined to some technical factors related to track such as alignment, derailment coefficient, and track bearing capacity, A quantitative analysis method for those technical factors is presented in this study. Calculating the allowable transit speed, the technical reviews of speed-up of Janghang-Line(Chunan∼Janghang) are conducted. And the alternatives for improving train speed in existing railway are proposed.

• Journal of the Korean Society for Railway
• /
• v.10 no.5
• /
• pp.540-545
• /
• 2007

The tilting train is able to tilt its body towards the center of the turning radius, preventing roll-over of the train as it runs on a curved rail at high-speed. This train, widely accepted for commercial purpose internationally, is very beneficial in that the operating time is shortened without much capital investment to the infrastructure where there are many curved rails. Over several years, the Korea Railroad Research Institute (KRRI) has developed such a train. In this paper, the safety of the Korean tilting train express (TTX) is investigated using a dynamic simulation model. Since proper safety standards have not been established for the TTX, those for the Korean train express (KTX) is employed to analyze the safety and ride comfort of the TTX. This study is useful in predicting the behavior of the TTX and ride comfort, and conforms that designed TTX is stable enough to satisfy the safety standards. It would be useful to recommend proper normal operating speed and determine the maximum safety speed, according to the result. Furthermore, it would be possible to provide basic reference data when analyzing the dynamic effect of the catenary system and the fatigue of the bogie.

• Wind and Structures
• /
• v.29 no.4
• /
• pp.279-297
• /
• 2019

Strong winds threaten the safety of vehicles on long-span bridges considerably, which could force traffic authorities to reduce speed limits or even close these bridges to traffic. In order to maintain the safe and economic operation of a bridge, a reasonable evaluation of the driving safety on that bridge is needed. This paper aims at carrying outdriving safety analyses for three types of vehicles on a long-span bridge in crosswinds by considering the aerodynamic interference between the bridge and the vehicles based on the wind-vehicle-bridge coupling vibration analysis. Firstly, CFD numerical simulations along with previously obtained wind tunnel testing results were used to determine the aerodynamic force coefficients of the three types of vehicles on the bridge. Secondly, the dynamic responses of the bridge and the vehicles under crosswinds were simulated, and based on those, the driving safety analyses for the three types of vehicles on the bridge were carried out for both cases considering and not considering the aerodynamic interference between the vehicles and the bridge. Finally, the effect of the aerodynamic interference on the safety of the vehicles was investigated. The results show that the aerodynamic interference between the bridge and the vehicles not only affectsthe accident critical wind speed but also the accident type for all three types of vehicles. Such effects are also different for each of the three types of vehicles being studied.