• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.45 no.6
• /
• pp.723-729
• /
• 2012

On 3 February 2011, a mass mortality of finless porpoises Neophocaena asiaeorientalis occurred at a dike of the Saemangeum Sea dike. A total of 249 carcasses were collected; these had been stranded by a sea dike and had floated into the lake formed by the dike. Eight bodies were measured, and four of these were dissected to analyze stomach contents. The blubber thicknesses of five bodies were compared with those of caught finless porpoises in the Yellow Sea from 2010. Finless porpoises at the Saemangeum Sea dike exhibited better nutritive conditions than finless porpoises in the Yellow Sea. Air temperature in January 2011 was lower than the prior 5-year average (P<0.05). Water temperature when the mass mortality occurred was lower than values observed in 2009 and 2010: values below $0^{\circ}C$ had been recorded, and the majority of the dike lake had frozen over. The mass mortality of finless porpoises may have been caused by these unusually low temperatures.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2000.10a
• /
• pp.66-71
• /
• 2000

This study was carried out to investigate the changes of tide velocity and sea bottom topology during the construction period of sea dike. The tide velocity and sea bottom depth were measured in Saemangeum area every year, and analyzed and compared to the initial data. The current and future changes of the tide velocity and direction according to the construction of Saemangeum sea dike were presented.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 1999.10c
• /
• pp.169-174
• /
• 1999

The reclamation area of Saemangeum (Kunsan) located between 126$^{\circ}$10' -126$^{\circ}$50'E and and 35$^{\circ}$35'N -36$^{\circ}$05'N at the western coast of Korea. The construction of the 33km sea dike is building in the Saemangeum area. When the construction of the sea dike in the coastal region takes plase, there exists a certain amount of soil which is diffused by the tidal current. Behavior of the soil diffusion usually depends on its intrinsic characteristics, bathymetry, construction method and used mchinery. The amount of soil at the construction acts as a pollutant which is the cause of changing the marine environment. When the soil material is diffused , it may form a layer which obstructs the light passing into the sea and causes the extinction or alteration of the living beings on the sea bottom. The settlement of soil material could change the sea bottom deposit. The purpose of MITIGATION is to harmonize the development and the conservation of environment, to restrict environmental destruction and to reproduce the enviroment damaged by the construction in the coastal region. The purpose of this study is to find the method by which we minimize the anti-function of development in the coastal region. Tide and tidal current are calculated using a two-dimensional numerical model before the construction of sea dike in Saemangeum Bay. The numerical results are compared well with field observations. On the basis of these results, we caculated the tide and tidal current after the construction of the sea dike in order to investigate the change of the tide and tidal current after the construction of the sea dike. Moreover, we calculated the tide and tidal current after the construction of submerged breakwater in order to preserve the enviornmental condition of creature habitat . We compared the tide and tidal current before and after the construction of submerbed breakwater, to investigate the possbility of MITIGATION in the fisheries.

• Proceedings of the Korean Society of Coastal and Ocean Engineers Conference
• /
• 1995.10a
• /
• pp.139-140
• /
• 1995

The reclamation area of Saemangeum(Kunsan) located between 126。10´E - 126。50´ E and 35。35´N - 36。05´N at the western coast of Korea. The construction of the 33km sea dike is building in the Saemangeum area. When the construction of the sea dike in the coastal region takes plase, there exists, a certain amount of soil which is diffused by the tidal current. (omitted)

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09a
• /
• pp.60-68
• /
• 2010

In this study, the seepage flow monitoring method by hydaulic head loss rate graph was developed for the purpose of monitoring the seepage flow from the see side or from the lake on sea dike in which seepage force was varied periodically. The hydraulic head loss rate was defined in this method. The value of the rate is in the range from 0 to 1. the value of 0 means perfectly free flow of seepage. the value of 1 means perfect waterproofing. The value of coefficient of determination in the hydraulic head loss rate graph closer to 1 means that the seepage flow way is stable. The value of coefficient of determination in the hydraulic head loss rate graph closer to 0 means that the hole may exist or the piping may be in the progress. The pore water pressure data measured in Saemangeum sea dike was analyzed with the developed method The result showed that the variation of seepage flow state was detected sensitively by this method and the interception effect of sea dike could be estimated quantitatively.

• Journal of Korean Society of Rural Planning
• /
• v.7 no.1 s.13
• /
• pp.61-76
• /
• 2001

During the performance of large scale tidal land reclamation project along the coast line, the construction of large scale structures such as sea-dikes, closing estuaries will induce big changes of near-shore hydraulic behavior. In this paper, its is aimed to verify the change of tide and currents after the construction of sea-dike of the Saemangeum project along the coast line. Numerical scale model "TRISULA" which development by Delft Hydraulics in the Netherlands was used. "TRISULA" is adopting the finite difference numerical scheme, and mostly using for hydro-dynamic solution along the sea and estuaries. Model boundary is covering $100{\times}170$ Km and constructed with $133{\times}337$ grids. Outer side boundary is divided 48 sections, and input 37 tidal components are gained from another big scale numerical "Yellow Sea" model. Model calibrations & verifications were performed th field tide & current datas which were measured along sea-dike alignment during Aug. $1997{\sim}Apr$. 1999. And then, numerical simulation with the tide condition dated 17 Apr. 1999 was performed with & without sea-dike construction condition for the comparison. Evaluated boundary is 20 km out-side from sea-dike alignment. Four cross lanes were set up, each of lane contains 3 points, for the comparison of sea-dike construction effects. Results showing the tidal amplitude is reducing approximately 20 cm after the construction of sea-dike during spring tide condition, amplitude 6.9m. Currents after construction of sea-dikes along the alignment, the northern part shows 50%(inner), 90%(outer) and the southern part shows 10%(inner) 50%(outer) of the currents before construction.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.9
• /
• pp.4326-4333
• /
• 2012

Phytoplankton standing stocks had been researched in Saemangeum water region from 2001 to 2010 belong to the construction period of Saemangeum dike. The big change of phytoplankton standing stocks was shown, reaching 57 - 85,219 cells/ml according to the sampling seasons and stations. Inside of Saemangeum lake, a flux of fresh water and sea water made the phytoplankton standing stocks changed spatiotemporally. Meanwhile, the water bloom was frequent with continuously high standing stocks of fresh water stations and the standing stocks outside of the dike have been normal. In the long-term point of view, the standing stock did not show a big change comparing to the before and after of closing the dike(April, 2006).

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2000.10a
• /
• pp.47-53
• /
• 2000

Saemangeum coastal area is being constructed the 33km sea dike and 40,000ha reclamation area. The purpose of this study is to find the residual circulations in spring before and after the dike construction by a robust diagnostic and prognostic numerical model. Heat flux at the sea surface in May was adopted on the basis of the daily inflow of solar radiation at the earth surface, assuming an average atmospheric transmission and no clouds, as a function of latitude and time of year(George L.P.,J. E. William,1990). The discharge from the Geum, the Mankyung and the Dongjin rivers was adopted on the basis of experience formula of river flow in May(The M. of C.,Korea, 1993). Water temperature and salinity along the open boundaries are obtained from the results of field observations. The results of spring of the residual flow in the Saemangeum coastal area by a prognostic numerical model lead to the following conclusions: Water temperature in spring is the highest, salinity is the lowest and density is the lowest at the upper layer near the coast after the dike construction. The flow pattern at the upper layer during spring is anti-clockwise circulation between Wi and Shinsi islands. The flow pattern at the lower layer is clockwise circulation between Wi and Shinsi islands.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2001.10a
• /
• pp.306-309
• /
• 2001

The objective of this study is to evaluate the changes of hydraulic environment after the construction of Saemangeum sea-dikes. Numerical simulation on the tidal condition of dated 17 Apr. 1999 is performed with and without sea-dike construction status for the comparison. Results show the tidal amplitude is reducing approximately 20 cm after the construction of sea-dike during spring tide condition of 6.9 m amplitude. Currents after construction of sea-dikes along the alignment, the northern part shows 50% (inner), 90% (outer) and the southern part shows 10% (inner), 50% (outer) of the current before construction.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2005.10a
• /
• pp.272-277
• /
• 2005

Initial mixing characteristics in near field regions were analyzed by FLOW-3D, for analyzing mixing behavior of submerged discharge from freshwater lake in sea water. FLOW-3D model was applied to the region near Geum-ho dike for its verification. Simulation results from FLOW-3D were compared to the observed data for the verification periods. FLOW-3D showed resonable prediction results compared to the observed data, except underestimation in area near outfall. Particularly, FLOW-3D showed a good prediction for movement of buoyancy jets. In addition, FLOW-3D model was applied to the region near Saemangeum dike, which is to be constructed in near future. It was expected that the results of model application to Saemangeum area could provide substantial information in planning submerged discharge facilities. Based on the model applications to Saemangeum area, it was recommended that outfall should be located to the distance which gave an enough depth of outfall from water surface.