• Journal of Environmental Health Sciences
• /
• v.25 no.3
• /
• pp.103-107
• /
• 1999

Even if odorous compounds remain very low concentration in water, it cause strong odor. Because Geosmin and most of odorous compound had very low vaporization, those were difficult to analyze with GC/MSD and Purge & Trap. So, we needed pre-treatment method for decreasing amounts of extracting solvents, improving recovery efficiencies and increasing analytical efficiencies. This study developed efficient technology for analyzing odorous compounds, using various adsorbents and extracting solvents. The optimum adsorbent was XAD resins. Especially, XAD-2, XAD-7 and XAD-2010 were superior, but XAD-2 of these and the optimum extraction solvent is MTBE. Other extraction solvents' efficiency is in order of MTBE>Dichloromethane>n-Hexane>Diethylether. The optimum NaCl dosage for increasing efficiency is 5 g in liquid-liquid extraction method. The shaking time(0~24hr) has no concern with adsorption efficiency. The optimum adsorbent is XAD-2 resin and extraction solvent is MTBE. Dosing NaCl, adsorption efficiency is increased in liquid-liquid extraction method, but NaCl has no effect on liquid-solid extraction method. In this experimental results, this algae toxins(Mycrocystin, Anatoxin etc.).

• Membrane Journal
• /
• v.20 no.2
• /
• pp.151-158
• /
• 2010

This paper presents the synthesis of ampholyte immobilized hollow-fiber membranes and adsorption characteristic of metallic ions. This is prepared by radiation induced grafting polymerization of an epoxy group containing Glycidyl methacrylate (GMA) onto an existing polyethylene porous hollow-fiber membrane. Ampholyte ion-exchanged alkalic group, $-NH_2$ (amine function) of Taurine (TAU) is reacted with glycidyl of GMA for the synthesis of stable membrane. However, Sodium sulfite (SS) membrane is also prepared by making chemical bonds with GMA of porous hollow-fiber membrane for the comparison of adsorption characteristic of metallic ions. These are called as TAU and SS membranes, respectively. It is shown that TAU membrane shows a steady flux, 0.9 m/h regardless of the density of TAU, while the flux of SS membrane decreases rapidly as the density of $SO_3H$ group increases. SS membrane showed a negligible flux. TAU membrane with the density 0.8 mmol/g shows the amount of metallic ions adsorbed in the following order, Cu > Cd > Mg > Sb > Pb. In general, TAU membrane with high density and reaction time showed the high amount of metallic ions adsorbed and flux.

• Microbiology and Biotechnology Letters
• /
• v.18 no.6
• /
• pp.599-606
• /
• 1990

A chitinase-producing bacterium, Aeromonas salmonicida YA7-625, was isolated from domestic seashore muds. The preferable medium composition for the production of chitinase was as follows: colloidal chitin 1.26% (w/v), tryptone 2.95% (w/v), $MgSO_4-7H_20$ 0.15% (w/v) and $K_2HP0_4$, 0.15% (w/v) (pH 8.5). The highest enzyme production was observed after cultivation of 48 hours at 27OC. The chitinase of Aeromonas salmonicida YA7-625 was purified successively by ammonium sulfate precipitation, affinity adsorption, hydroxylapatite column chromatography and gel filtration. The optimal temperature and pH for the activity of purified chitinase were $50^{\circ}C$ and 7.0, respectively. The molecular weight of purified chitinase was ca. 200,000 daltons and apparent Km value of it was 1.276 mglml on colloidal chitin.

• Economic and Environmental Geology
• /
• v.41 no.6
• /
• pp.719-729
• /
• 2008

In this study, the speciation, adsorption, and transport of uranium in groundwater environments were simulated using geochemical models. The retarded transport of uranium by adsortption was effectively simulated using 3-D groundwater flow and reactive transport models. The results showed that most uranium was adsorbed(up to 99.5%) in a neutral pH(5.5$pCO_2(10^{-3.6}atm)$ condition. Under the higher $pCO_2(10^{-2.5}atm)$ condition, however, the pH range where most uranium was absorbed was narrow from 6 to 7. Under very low $pCO_2(10^{-4.5}atm)$ condition, uranium was mostly absorbed in the relatively wide pH range between 5.5 and 8.5. In the model including anion complexes, the uranium adsorption decreased by fluoride complex below the pH of 6. The results of this study showed that uranium transport is strongly affected by hydrochemical conditions such as pH, $pCO_2$, and the kinds and concentrations of anions($Cl^-$, ${SO_4}^{2-}$, $F^-$). Therefore, geochemical models should be used as an important tool to predict the environmental impacts of uranium and other hazardous compounds in many site investigations.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.5
• /
• pp.1481-1486
• /
• 2013

Bifunctional Fe-SBA-15-$SO_3H$ mesoporous materials with different Si/Fe molar ratios (3, 5, and 7) have been synthesized via a simple direct hydrothermal method and characterized by XRD, $N_2$-adsorption/desorption, TG/DTG and FT-IR techniques, and used as solid acid catalysts in the esterification of lactic acid with methanol. XRD and $N_2$ sorption characterizations show successful iron doping within the mesoporous channels of SBA-15-$SO_3H$. The FT-IR and TG/DTG characterizations also reveal the presence of iron. With the incorporation of Fe ions into the SBA-15-$SO_3H$, the acid sites substantially increased because of the self-separated acidity of the hydrolysis of $Fe^{3+}$ solutions. However, in the Si/Fe = 3 molar ratio, the catalytic conversion decreased which is caused by the reduced cooperation effect between the acid pairs due to the weakened hydrogen bonds and collapse of the pore structure. This further suggests that the mesoporous structure decreases with the decrease in Si/Fe ratio.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2001.04a
• /
• pp.182-186
• /
• 2001

An acid forest surface soil as a land farming medium was treated with a water plant alum sludge at 0 to 18%. Indian mustard was grown in the treated soil in a greenhouse for 5 weeks and watered with pH 4 tap water adjusted with a mixed acid (1HNO$_3$: 2H$_2$SO$_4$) during plant growth. Changes in soil property, leachate chemistry, plant growth, and plant uptake of elements by the sludge treatment were determined. The alum sludge treatment increased buffer capacity to acidity, hydraulic conductivity, water holding capacity, and phosphate adsorption of the soil and decreased bulk density and mobility of small particles. The sludge treatment reduced leaching of Al, Mg, K, Na, and root elongation. Plant did uptake less amount of the cations and P but more Ca with the sludge treatment.

• Carbon letters
• /
• v.26
• /
• pp.31-42
• /
• 2018

Adsorption is one of the best methods for wastewater purification. The fact that water quality is continuously decreasing requires the development of novel, effective and cost available adsorbents. Herein, a simple procedure for the preparation of a magnetic adsorbent from agricultural waste biomass and ferrofluid has been introduced. Specifically, ferrofluid mixed with wheat straw was directly pyrolyzed either by microwave irradiation (900 W, 30 min) or by conventional heating ($550^{\circ}C$, 90 min). Magnetic biochars were characterized by X-ray powder diffraction, $M{\ddot{o}}ssbauer$ spectroscopy, textural analysis and tested as adsorbents of As(V) oxyanion and cationic methylene blue, respectively. Results showed that microwave pyrolysis produced char with high adsorption capacity of As(V) ($Q_m=25.6mg\;g^{-1}$ at pH 4), whereas conventional pyrolysis was not so effective. In comparison to conventional pyrolysis, one-step microwave pyrolysis produced a material with expressive microporosity, having a nine times higher value of specific surface area as well as total pore volume. We assumed that sorption properties are also caused by several iron-bearing composites identified by $M{\ddot{o}}ssbauer$ spectroscopy ([super] paramagnetic $Fe_2O_3$, ${\alpha}-Fe$, non-stoichiometric $Fe_3C$, ${\gamma}-Fe_2O_3$, ${\gamma}-Fe$) transformed from nano-maghemite presented in the ferrofluid. Methylene blue was also more easily removed by magnetic biochar prepared by microwaves ($Q_m=144.9mg\;g^{-1}$ at pH 10.9) compared to using conventional techniques.

• Korean Chemical Engineering Research
• /
• v.51 no.2
• /
• pp.285-291
• /
• 2013

The effects of sensing materials, coating methods, diluent gases, and temperature have been studied in detail to make a quartz crystal microbalance based adsorption sensor system for detecting gases. In particular, sensor elements for detecting $NO_2$ and $SO_2$, that are known as major air pollutants, have been prepared by coating two different polymers, polypyrrole and poly(3,4-ethylenedioxythiophene). The sensor elements prepared in this work have high sensitivity and selectivity for $NO_2$ and $SO_2$ at ppm level concentrations. It was proven that the sensing characteristics and response rate of the sensing elements are highly dependent on the coating method and the loading mass of sensing materials.

• Journal of the Korean Chemical Society
• /
• v.57 no.6
• /
• pp.672-676
• /
• 2013

The corrosion inhibition nature of Ginger affinale extract for the corrosion of mild steel in 0.5N $H_2SO_4$ was investigated using weight loss, electrochemical impedance and potentiodynamic polarization methods. The results revealed that Ginger affinale extract acts as a good corrosion inhibitor in 0.5N $H_2SO_4$ medium. The inhibition efficiency increased with an increase in inhibitor concentration. The inhibition could be attributed to the adsorption of the inhibitor on the steel surface.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.264-269
• /
• 2001

Large amounts of orange juice are produced in Japan every yea.. Accompanied by the production of orange juice, large amount of juice residues are also generated in nearly the same amounts with juice. Although, at present, some of these residues are marketed as a feed for cattle after drying and mixing with lime, the marketing price is lower than its production cost and the difference is paid by the consumers as a part of the price of orange juice. In the present work, we developed new innovative use of orange juice residue, a biomass waste, as adsorption gel for removing toxic heavy metals such as lead. arsenic, selenium and so on as well as radioactive elements such as uranium and thorium from environments. The major components of orange juice residue are cellulose. hemicellulose and pectin, which are converted into pectic. acid, an acidic polysaccharide, by means of saponification with concentrated sodium hydroxide solution. In the previous work, we found that crosslinked pectic acid gel strongly an selectively adsorbs lead over other metals such as zinc an copper. On the other hand. it is well known that polysaccharides such as cellulose can be easily phosphorylated and that phosphorylated polysaccharides have high affinity to uranium and thorium as well as some trivalent metals such as ferric iron and aluminum. Taking account of the noticeable characteristics of these polysaccharides, 2 types of adsorption gels were prepared from orange juice residue: one is the gel which was prepared by saponificating the residue followed by crosslinking with epichlorohydrin and another is that prepared by crosslinking the residue followed by phosphorylation. The former gel exhibited excellent adsorptive separation behavior for lead away from zinc owing to high content of pectic acid while the latter gel exhibited that for uranium and thorium. Both types of adsorption gels exhibited high affinity to ferric iron, which enables selective and strong adsorption for some toxic oxo-anions of arsenic (V and III), . selenium and so on via iron loaded on these gels. These results demonstrate that biomass wastes such as orange juice residue can be effectively utilized fer the purpose of removing toxic heavy or radioactive metals existing in trace or small amounts in environments.