• Journal of Korea Foundry Society
• /
• v.30 no.1
• /
• pp.29-33
• /
• 2010

The microstructure of Al-5%Mg based alloy mainly consists of aluminum matrix with a small amount of AlMn phase. The addition of Sc or Zn to the base alloy significantly improved the as-cast tensile strength, while the addition of Fe deteriorated both strength and ductility. Although the Al-5%Mg based alloy was not heat-treatable, aging hardening could be observed in the case that Sc or Zn was added to the base alloy. TEM analysis showed that very fine AlSc or AlMgZn precipitates were formed after T6 heat treatment, resulting in enhanced strength. The corrosion resistance measured as corrosion potential was found to decrease a little by adding Zn, whereas other alloying elements were not clearly influential.

• BMB Reports
• /
• v.39 no.6
• /
• pp.782-787
• /
• 2006

A new protein was cloned and identified as the sixth subunit of Choristoneura fumiferana origin recognition complex (CfORC6). The newly identified 43 kDa protein CfORC6 is much bigger than DmORC6 (25.7 kDa) and HsORC6 (28.1 kDa), though it's 23.85% identical to DmORC6 and 23.81% identical to HsORC6. Although the molecular weight of CfORC6 is close to ScORc6 (50 kDa), CfORC6 is only 14.03% identical to ScORC6. By alignment, it was found that the N-terminal of CfORC6 has about 30% identities with other ORC6s, but about 100aa of C-terminal of CfORC6 has no identity with other ORC6s. Like ScORC6, CfORC6 has many potential phosphorylation sites, (S/T)PXK. Like DmORC6, CfORC6 has leucine-rich region in the relevant site. Northern Blot showed that CfORC6 mRNA is about 2,000nt. Southern Blot confirmed that there is one copy of CfORC6 gene in spruce budworm genome. Western blot showed that infection of Cf124T cells with CfMNPV didn't affect the expression levels of CfORC6, at least up to 26 hr post infection.

• Korean Journal of Oriental Medicine
• /
• v.7 no.1
• /
• pp.85-103
• /
• 2001

Objectives : Assuming that the characteristic of meridian system has been similar to this of electric potentials in human body and that measurements of electric potential at well(井穴) and sea(合穴) points in branches of the twelves meridians will be representative of measurements of the twelve meridians, to measure the electric potentials in twenty aged(TAG) and fifty aged(FAG) healthy volunteers groups when they were sleeping or awakening respectively, to do significance test for electric potential of meridian system among circadian rhythms(CR) and Sasang constitutions(SC). Methods : We selected who thirty healthy volunteers were diagnosed by a blood test, urine examination and differentiation of syndromes by five viscera among volunteers. When they were sleeping, their electric potentials of well and sea points in branches of the twelve meridians were simultaneously measured by physiograph. After a minute we measured them again, totally 5 times. And then when they were awakening, their electric potentials were measured 5 times by the above method. Results : Measurements were analyzed by statistical ANOVA test, we obtained that some of the electric potentials of TAG at sleeping significantly varied with CR, SC, and at awakening some of the electric potentials of FAG also significantly did with CR, SC.

• The Journal of Korean Academy of Orthopedic Manual Physical Therapy
• /
• v.27 no.2
• /
• pp.1-8
• /
• 2021

Background: Chronic neck pain (CNP) is associated with weakness in the deep neck flexor muscles, a shortening of the neck extensors, and a reduction in endurance. In addition, muscle imbalance can lead to neck pain and musculoskeletal dysfunction. This study compared neck extensor muscle fatigue, muscle strength, and muscle endurance time between patients with CNP and healthy adults during isometric neck extension. Methods: Thirty participants (15 patients with CNP and 15 healthy adults) were recruited in this research. The outcome measures included splenius capitis (SC) muscle fatigue, isometric neck extensor strength, and muscle endurance. The independent T-test was used to compare the continuous dependent variables between the CNP group and the healthy group. Results: The independent T-test indicated that muscle fatigue in the left SC differed significantly between the CNP group and the healthy group. A significant difference was also noted in the isometric neck extensor and neck extensor strength between the groups. Conclusion: Our results provided promising clinical evidence that patients with CLP have reduced neck extensor strength and endurance and increased SC muscle fatigue, which results in neck pain.

• Korean Journal of Food Science and Technology
• /
• v.40 no.4
• /
• pp.406-411
• /
• 2008

This study was conducted to examine the quality enhancement of fermented soybean pastes (cheonggukjang) using microorganisms with high enzyme activities and proper experimental design. The microorganisms for soybean paste fermentation were selected from a specific area of Gyeonggi and were idenlified by 16S rDNA sequence analysis. To prepare the cheonggukjang, an optimum mixing ratio of selected microorganisms was determined using contour plots and numerical optimization methods. A total of 39 microorganisms were isolated from the soybean paste, consisting primarily of Bacillus subtilis and Bacillus licheniformis, and no mold was found. Three microorganisms showing high enzyme activities were selected and used to formulate an optimum mixing ratio for cheonggukjang preparation. Based on levels of amino-nitrogen, ammonium-nitrogen, antioxidant activity values, and sensory preference results, the optimum mixing ratio of 50% of Bacillus sp. SC-1 and 50% SC-3 was suggested for the manufacture of high quality of cheonggukjang.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 1996.11a
• /
• pp.137-144
• /
• 1996

The kinetic coefficients far decomposition of the cured phenol resin (SC-1008) using a modified Arrhenius relationship have been determined from thermogavimetric analyses (TGA). The kinetic parameters were determined by multiple heating rate technique developed by Freideman and Henderson. Weight loss (decomposition) and weight loss rate (decomposition rate)were measured and recorded for three heating rates; $5^{\circ}C$/min ,$10^{\circ}C$/min, and $20^{\circ}C$/min. Relatively good agreement was obtained between measured and calculated decomposition as a function of temperature. By separating the reaction, the reaction order and pre exponential factor become empirical parameters which provide a "best fit" of the data. However, this method yields an extremely accurate reproduction of the thermograms over a wide range of heating rates. This is the desired result for kinetic parameters used in thermal models.al models.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.7
• /
• pp.2178-2182
• /
• 2011

Recently, the synthesis of ordered macroporous materials has received much attention due to its potential use as photonic band gap materials.$^1$ In this study, we have used the three-dimensional (3D) latex array template impregnated with benzenesulfonic acid (BSA), which is capable of catalyzing the reaction using tetraethyl orthosilicate (TEOS) as a precursor and distilled water. The polystyrene (PS) templates were reacted with TEOS in $scCO_2$ at 40 $^{\circ}C$ and at 80 bar. In the reactor, TEOS was filtrated into the PS particle lattice. After the reaction, porous silica materials were obtained by calcinations of the template. The stability test of the PS template in pure $CO_2$ was conducted before the main experiment. Scanning electron microscopy (SEM) images showed that the reaction in $scCO_2$ takes place only on the particle surface. This new method using $scCO_2$ has advantages over conventional sol-gel processes in its capability to control the fluid properties such as viscosity and interfacial tension. It has been found that the reaction in $scCO_2$ occurs only on the particle surface, making the proposed technique as more rapid and sustainable method of synthesizing inverse opal materials than conventional coating processes in the liquid phase and in the vapor phase.

• Korean Journal of Veterinary Research
• /
• v.50 no.1
• /
• pp.37-42
• /
• 2010

Evaluation of the myelography was studied in miniature pigs. Radiographs and computed tomographic (CT) images of the whole spine were obtained at clinically healthy twelve miniature pigs of 4 (8.7-10 kg) and 12 (26-31 kg) months. The assessments of the spinal cord were made in accordance with the Pavlov's method and compared area ratio [at spinal cord (SC), vertebral canal (VC) and vertebral body (VB)]. The Pavlov's ratio in the cervical spine was significant larger than that of thoracolumbar in radiographic myelography. On CT myelography, the area of the spinal cord had a significant difference between the cervical and thoracolumbar spine. Among the cervical spine, the ratios of spinal cord and vertebral body (SC : VB), vertebral canal and vertebral body (VC : VB) were minimum at the level of 4th cervical spine in both ages, while maximum at the level of 6th cervical spine in both months. In case of lumbar spine, the ratios of spinal cord and vertebral body (SC : VB) were the largest at the level of 4th lumbar spine in 4 months and at the level of 3rd lumbar spine in 12 months. In addition, the ratio of spinal cord and vertebral body (SC : VB) of the cervical spinal cord was significant lower at 4 months but the lumbar spinal cord showed lower pattern at 12 months old miniature pigs.

• Macromolecular Research
• /
• v.16 no.1
• /
• pp.6-14
• /
• 2008

Polypropylene (PP)-layered silicate nanocomposites were developed using a new processing method involving a supercritical carbon dioxide ($scCO_2$)-assisted co-rotating twin-screw extrusion process. The nanocomposites were prepared through two step extrusion processes. In the first step, the PP/clay mixture was extruded with $CO_2$ injected into the barrel of the extruder and the resulting foamed extrudate was cooled and pelletized. In the second step, the foamed extrudate was extruded with venting to produce the final PP/clay nanocomposites without $CO_2$. In this study, organophilic-clay and polypropylene matrix were used. Maleic anhydride grafted polypropylene (PP-g-MA) was used as a compatibilizer. This study focused on the effect of $scCO_2$ on the dispersion characteristics of the clays into a PP matrix and the rheological properties of the layered silicate based PP nanocomposites. The dispersion properties of clays in the nanocomposites as well as the rheological properties of the nanocomposites were examined as a function of the PP-g-MA concentration. The degree of dispersion of the clays in the nanocomposites was analyzed by X-ray diffraction and transmission electron microscope. Various rheological properties of the nanocomposites were measured using a rotational rheometer. In the experimental results, the $scCO_2$ assisted continuous manufacturing extrusion system was used to successfully produce the organophilic-clay filled PP nanocomposites. It was found that $scCO_2$ had a measurable effect on the clay dispersion in the polymer matrix and the melt intercalation of a polymer into clay layers.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.26 no.1
• /
• pp.53-58
• /
• 2012

The aim of this study was to investigate the antimicrobial, antiperspirant and deodorant effect of herb mixtures including Schisandra chinensis(SC). This herb mixtures including Schisandra chinensis was made of Astragalus membranaceus(AM), Triticum aestivum(TA), Atractylodes japonica(AJ) and peppermint essential oil extracted from Mentha piperita(MP). We examined antimicrobial activity, antiperspirant activity and L-leucine dehydrogenase activity of the herbal extracts. We found that the mixture of SC and MP have the best antimicrobial effects on B. subtilis subsp. spizizenii and mixture of SC, AJ, AM and TA have best antiperspirant effect. Moreover, the combination of SC and AM showed the most inhibitory effect on L-leucine dehydrogenase activity. These results suggested that the herb mixtures Including Schisandra chinensis have good antimicrobial and antiperspirant effects.