• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.3 s.345
• /
• pp.21-32
• /
• 2006

A new SRAM circuit with row-by-row activation and low-swing write schemes is proposed to reduce switching power of active cells as well as leakage one of sleep cells in this paper. By driving source line of sleep cells by $V_{SSH}$ which is higher than $V_{SS}$, the leakage current can be reduced to 1/100 due to the cooperation of the reverse body-bias. Drain Induced Barrier Lowering (DIBL), and negative $V_{GS}$ effects. Moreover, the bit line leakage which may introduce a fault during the read operation can be eliminated in this new SRAM. Swing voltage on highly capacitive bit lines is reduced to $V_{DD}-to-V_{SSH}$ from the conventional $V_{DD}-to-V_{SS}$ during the write operation, greatly saving the bit line switching power. Combining the row-by-row activation scheme with the low-swing write does not require the additional area penalty. By the SPICE simulation with the Berkeley Predictive Technology Modes, 93% of leakage power and 43% of switching one are estimated to be saved in future leakage-dominant 70-un process. A test chip has been fabricated using $0.35-{\mu}m$ CMOS process to verify the effectiveness and feasibility of the new SRAM, where the switching power is measured to be 30% less than the conventional SRAM when the I/O bit width is only 8. The stored data is confirmed to be retained without loss until the retention voltage is reduced to 1.1V which is mainly due to the metal shield. The switching power will be expected to be more significant with increasing the I/O bit width.

• Journal of the Korean Geotechnical Society
• /
• v.32 no.1
• /
• pp.5-18
• /
• 2016

In this study, we grasped the resistance state of the back ground which had a notable influence on computing the lateral resistance of the laterally loaded pile group in the homogeneous ground by the model test. Resistance state was grasped as the depth of rotation-point, wedge failure angle, and wedge wing angle. The model experiment is performed by varying the width, spacing and number of piles and the relative density of sand in this study. According to the observation of the rear ground surface deformation of the piles in lateral load, rotation point ratio, wedge failure angle, and wedge wing angle of the front row were similar to those of the middle row; however, those of the back row were relatively smaller. The rotation point ratio, wedge failure angle and wedge wing angle of the piles in parallel were the same as those of a single pile. Based on the model test results, equations for estimation of the rotation-point, wedge failure angle, and wedge wing angle are proposed.

• Journal of the Korean Institute of Rural Architecture
• /
• v.15 no.2
• /
• pp.25-32
• /
• 2013

The purpose of this study is to analyze the residential space composition and extension of Jeonja-jip and Dureong-jip in Samcheok region. The results of this study are as follows. It appears three residential plan types - Jeonja-jip with Anmaru(a room made of wooden floor), Jeonja-jip without Anmaru and Dureong-jip with Anmaru- in survey region. It was needed the extension of residential space at Jeonja-jip(a house type with two-row rooms which be composed of 田type under one roof) and Dureong-jip(a house type with inner floor which be surrounded by rooms under one roof) because of shortage of sleeping space, working space and keeping space owing to growing large family. The solutions of these shortages will be the extension of space in houses. Jeonja-jip's basic type which is the Kyup-Jip(a house type with two-row rooms under one roof) of 一 type with 6 Kans(Kan, a unit to count room to divided with four posts) is transformed and extended to 田shaped house with 11 Kans toward X-axis orientation. Dureong-Jip's basic type which is ㄱ type with 7 Kans is transformed and extended to the Sekyup-Jip with 9 Kans and the Nekyup-Jip(a house type with four-row rooms under one roof) with 12 Kans toward Y-axis orientation by insertion and addition. Jeonja-jip was developed into Kyup-Jip with front 4 or 5 Kans and side 2 Kans instead of being done into Sekyup-jip or Nekyup-Jip with insufficient day lighting and ventilation problems. Jeonja-jip and Dureong-jip were stronger than any other traditional houses in tendency to reserve Magu(cowshed) and Chikkan(toilet) in a house.

• Korean Journal of Food Science and Technology
• /
• v.29 no.3
• /
• pp.470-475
• /
• 1997

This study was to determine the effects of rice varities on saccharification in producing sikhe using 45 different rice varities. Using Gancheok, Sinkeumo, Seoan and Gyehwa, sikhe showed the highest sweetness determined by refractometer, however sikhe using Sangiu, Namweon and Yeongdeog showed the lowest sweetness with difference of about 19%. Sugar composition of sikhe using Gancheok, rice variety, is fructose 3.6%, glucose 9.8%, maltose 78.3% and maltotriose 8.3%, analysed by High Performance Liquid Chromatography. Six-row malt showed better saccharification power than two-row malt. And 100 mesh sieved powder of malt was better in saccharification than 20 mesh sieved powder. Optimum saccharification temperature of six-row malt was $60^{\circ}C$.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.19 no.5
• /
• pp.648-654
• /
• 2009

In this paper, a method called bilateral diagonal 2DLDA is proposed for face recognition. Two methods called Dia2DPCA and Dia2DLDA were suggested to reserve the correlations between the variations in the rows and columns of diagonal images. However, these methods work in the row direction of these images. A row-directional projection matrix can be obtained by calculating the between-class and within-class covariance matrices making an allowance for the column variation of alternative diagonal face images. In addition, column-directional projection matrix can be obtained by calculating the between-class and within-class covariance matrices making an allowance for the row variation in diagonal images. A bilateral projection scheme was applied using left and right multiplying projection matrices. As a result, the dimension of the feature matrix and computation time can be reduced. Experiments carried out on an ORL face database show that the proposed method with three different distance measures, namely, Frobenius, Yang and AMD, is more accurate than some methods, such as 2DPCA, B2DPCA, 2DLDA, etc.

• Journal of the Korean Geosynthetics Society
• /
• v.17 no.4
• /
• pp.109-118
• /
• 2018

Two-row overlap pile wall, currently under development for use in deep excavations, is a novel retaining structure designed to perform itself as a cutoff wall as well as a high-stiffness wall by constructing four overlapping piles arranged in zigzag manner at a time using a tetra-axis auger. This wall has a relatively complex cross-section, compared with other types of pile wall, which would make it difficult to determine design parameters related to cross-section. In this study, a flexural rigidity equation has been derived by analyzing both theoretically and statistically various wall cross-sections with different pile diameters and overlap lengths. The flexural rigidity equation was found to show the maximum error rate of 3%.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 1996.06c
• /
• pp.1009-1020
• /
• 1996

Direct-seeded rice can have comparable yield with transplanted rice if its inherent problems can be solved. It is a labor-saving technology and can significantly reduce production cost because seedling nursery , pulling , and transplanting are omitted. Turnaround time between cropping is reduced hence the possibility of a third annual crop. But direct-seeded rice is very vulnerable to pest attack (by birds, rats, and golden snails), desiccation, weed infestation, and prone to lodging resulting to unstable crop establishment and inconsistent yield. These problems can be solved by anaerobic seeding (sowing pre-germinated seeds under the soil). It requires precise seed placement into the soil to optimize its benefits. We developed a four-row anaerobic direct seeder (US $ 200 commercial price) for this purpose . It consist of a structural framework mounted with a drum -hopper metering device, flotation type drivewheels, spring-loaded and adjustable furrow closers, and furrow open rs, and a plastic rainguard. It can sow in line pre-germinated seeds into the soil thus permitting the use of mechanical weeders for a chemical-free weed control. Its performance was comparable with the Japanese two-row anaerobic seeder (costing US$400) in terms of seed placement and crop establishment. It was tested with five cultivars. Seeding rate varied from 38 kg/ha to 80kg/ha. Crop establishment ranged from 64 to 99 percent while grain yield varied from 3.0 t/ha to 5.4t/ha. A six-row anaerobic seeder was also developed and adapted to a powertiller for increased capacity , field efficiency , and easier operation. The anaerobic seeder is useful to farmers shifting to direct seeding to reduce rice production cost and to researchers conducting agronomic studies in direct-seeded rice. Blueprint of the machine is available free of charge from IRRI.

• Journal of architectural history
• /
• v.15 no.2
• /
• pp.95-114
• /
• 2006

This study was conducted on the premise that plan types of the public residential houses proposed after the 1945 implicatively showed the developing process of the modern housing. The formal characteristics created through the developing process were analyzed in Micro-Historically. Moreover, by providing a new viewpoint on the changes of the residential houses that occurred around 1945, we tried to provide the fundamental research background for the research on the developing processes of the future housing cultures. The research pursued mainly on the major spaces that became the modern change indices of housing plan changes from the traditional housings in 1940s to the modern housings such as the master bedrooms(An-Bang), kitchen, the main floored-space(Maru), and the secondary bedroom (Kune-Bang). The major experimental subjects are the 87 public residential plan types designed and supplied by the Korea Housing Cooperation in between 1945 and 1970. The study synthesized the developing process of the public residential houses from the traditional residential houses in 1940s through modern situation and intrusion of foreign housing cultures. Following results were derived from the study: First, various and experimental housing plan types had been proposed as public residential houses since 1945. Among them, the plan having the main floored-space(Maru) were the representative type of public residential houses and various series of houses were constructed based on this type. Second, the main floored-space(Maru) type had continued building connection order of the R-M-R that were used in the traditional houses. On the other hand, with decomposition of connecting ring between the main floored-space(Maru) and the kitchen, rationalization of women circulations and introduction of family-centered spaces had been resolved the demands of modern society. It had greate effect on settlement of the current double-row Maru plan type. Third, in Korea most of plan types for the public residential houses were proposed in between 1945 and 1965. Forth, the location of kitchen and relation between Maru and the master bedroom were arranged visually on the corner and center of the rear row with the micro change characteristics of the public residential houses. In this process, the front row was similar with traditional residential houses but the rear row was differentiated and developed with expansion of Maru and Ondol rooms, increase of closet spaces, and introduction of kitchen that divided spaces for sleeping and eating.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.4 no.1
• /
• pp.59-68
• /
• 1984

Theoretical equations are derived to estimate the larteral earth pressures acting on piles with various shape of pile section due to lateral soil movements. And also examination of characteristics of the equations and comparison with other equations are carried out. The equations can be derived by calculating the difference between the two earth pressures acting on front and back sides of pile's row under plastic state satisfying Mohr-Coulomb's yield criterion, which is developed on tile soil between two piles among the piles in a row. The theoretical equations can reasonably consider the pile section-shape, the pile interval and the plastic condition in the soils just around piles. Additionally, the factors about soils and piles influencing on the lateral earth pressures are clarified and the high reliability of the equations is proved.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.3
• /
• pp.269-278
• /
• 2011

We investigate the heat-transfer and pressure-drop characteristics of fin-and-tube heat exchangers with a copper plate or copper spiral fins. Twenty-four samples with different fin pitches and tube rows were tested. For both configurations, the effect of the fin pitch on the j factor is negligible, and the f factor increases with the fin pitch. The effect of the tube row depends on the configuration. For plate fin-and-tube heat exchangers, the j factor decreases as the row number increases; the reverse is true for spiral exchangers. We explain this by considering the flow pattern. The j factor for plate fin-and-tube heat exchangers is larger than that for spiral exchangers, and the difference decreases as the row number increases. The f factor of the plate fin-and-tube heat exchanger is also larger. We compare our results with existing predictions of correlations.