• Tunnel and Underground Space
• /
• v.30 no.1
• /
• pp.63-75
• /
• 2020

When tunnel is excavated via drilling and blasting, the excessive overbreak is the primary cause of personal or equipment safety hazards and increasing the cost of the tunnel operation owing to additional ground supports such as shotcrete. The practical management of overbreak is extremely difficult due to the complex causative mechanism of it. The study examines the relationship between rock mass characteristics (unsupported face condition, uniaxial compressive strength, face weathering and alteration, discontinuities- frequency, condition and angle between discontinuities and tunnel contour) and the depth of overbreak through using feed-forward artificial neuron networks. Then, Overbreak Resistance Factor (ORF) has been developed based on the weights of rock mass parameters to the overbreak phenomenon. Also, a new concept of tunnel overbreak management system using ORF has been suggested.

• Journal of the Mineralogical Society of Korea
• /
• v.26 no.4
• /
• pp.273-283
• /
• 2013

The artificial rain (pH 4.0, pH 5.6 and pH 6.85) and weathering simulation test are applied in dolomitic marble for the prediction of deterioration of the stone monuments constructed with carbonate rock by acid rain. pH of the applied rain all increase to about neutral pH after reaction of marble. The contents of $Ca^{2+}$ and $Mg^{2+}$ have increased more than twofold in two acid rain and deionized neutral rain after reaction of marble. The weight of marble is expected to decrease $0.00037kg/m^2$ each test cycle by pH 4.0 rain. This weight reduction rate of marble is 1.4 and 3.1 times more in pH 5.6 and pH 6.85 rain respectively, and 3.7 times more in only artificial weathering test. The compressive strength of marble is expected to decrease 0.2468, 0.1791 and $0.1280kg/m^2$ per test cycle with pH 4.0, pH 5.6 and pH 6.85 rain, respectively. These results mean that more acidic rain more enfeeble the strength of marble. Dolomite and small amount of calcite are precipitated in the rains after reaction of marble.

• Tunnel and Underground Space
• /
• v.11 no.3
• /
• pp.206-216
• /
• 2001

Many failures in cut slopes occur during and following road construction. Failures are caused, in part, by a lack of understanding of the characteristics of rock mass including its geologic structure. The stability of rock slopes is closely related to factors that include the type of rock, development of geological structures, weathering, characteristics of rock, and the shape of the geologic features. Therefore, it is very important to consider these characteristics of rock mass in the evaluation of rock slope stability. In spite of investigation from many slope failures, these information data were not systematically stored and not efficiently utilized. In this study, a Database system named DB/SLOPE was developed using Oracle for systematic management of cut slopes. The developed database system can be used to estimate of slope stability and to predict of slope failure.

• Journal of the Mineralogical Society of Korea
• /
• v.19 no.2 s.48
• /
• pp.63-69
• /
• 2006

When rocks are exposed to the near surface environment, they are broken down due to several factors such as physical and chemical weathering during the geologic time. The feldspar and mica, which are the main rock-forming minerals, are easily broken down relative to other minerals. In order to reproduce some weathered minerals similar to the ones exist in natural weathered granite, there was an experimental interaction between fresh minerals and acidic solution. In low pH condition, biotite initially dissolved and its surface structure broke down, whereas plagioclase dissolved and had a needle-shaped dissolved morphology with some precipitates composed of Al element. The minerals were deeply dissolved in a strong acid condition, showing the prominent dissolved structure. Some etch pits and dissolved textures developed on the natural mineral surfaces are similarly found in our experiment, suggesting the development of mineral dissolution and weathering texture by the influence of the mineral's intrinsic nature.

• Journal of the Korean association of regional geographers
• /
• v.13 no.4
• /
• pp.422-437
• /
• 2007

Dokdo has historical and political meaning in relation to the territorial problems with Japan. The area can be the main factor to explain the formation and development process of East-Sea as exposure volcanic island at East-Sea with Ulreong-island. Accordingly, it also has an important meaning of physical geography aspects In this research, it is perceived the geomorphological development process of slope due to the salt weathering which is considered as the most important factor to understand whole geomorphology of Dokdo. And researched how a geomorphology of this sort affects to animal and plants. The peculiar geomorphology is tafoni which is a weathering geomorphology and one of the remarkable geomorphology in preservation of Dokdo. Tafoni at west part of Dongdo is distributed intensively near shoreline which is composed tuff. The shape of tafoni is mainly massive, circle and oval in Massive tuff breccia layer also is formed toward horizontality bedding direction in Bedded lapilli tuff. Tafoni in Dokdo is constituted after middle of Holocene. This fact can be proved by ranging at surface of sea-cliff which is formed wave erosion after middle of Holocene sea-level reaching to present level. Tafoni is also the most contribute factor of geomorphology dissection of Dokdo as it is eroded the bed rock with salt weathering. In bottom part of tafoni it has an important function for habitat of birds. Herbaceous plants are on it. To procrastinate of bed rock dissection by growth of Tafoni, conservation of vegetation and soil are most important factor.

• Korean Journal of Heritage: History & Science
• /
• v.45 no.1
• /
• pp.70-85
• /
• 2012

Uiseong Tamni-ri Five-storied Stone Pagoda is composed of andesitic tuff and partially combined with tuff breccia and fine-grained granite. The andesitic tuff is identical to basement rock of Geumseongsan Mountain based on lithological, mineralogical and geochemical characteristics. The pagoda has suffered physical weathering such as crack and scaling, discoloration and biological colonization with complex reaction. Expecially, dark gray and brown discoloration appeared whole over the surface of the pagoda, and three to five-layered exfoliation and granular disintegration dominantly occurred in the fourth and fifth roof stones. It is assuming that the stone elements of the pagoda are evaluated as third to forth grades (average third grade) of weathering compared to fresh rock in Geumseongsan Mountain. The physical strength of the stone elements shows low values in the south and west sides of the pagoda that corresponds high weathering degree of the west side due to exfoliation, crack and granular disintegration. It is necessary to investigate the pagoda for precise deterioration assessment, monitoring and conservation treatment.

• Journal of Conservation Science
• /
• v.18 s.18
• /
• pp.19-32
• /
• 2006

The stone pagoda of the Bunhwangsa temple made by piling small brick-shaped stones. The major rock forming stone bricks are andesites with variable genesis. Rock properties of the pagoda roof stone suffer partly including multiple peel-offs, exfoliation, decomposition like onion peels, cracks forming round lines and falling off stone pieces. The stylobates and tabernacles in all the four directions the pagoda are mostly composed of granitic rocks. Those rock properties are heavily contaminated by lichens and mosses with the often marks of inorganic contamination by secondary hydrates that are dark black or yellowish brown. Within the four tabernacles and northern pagoda body situated to relatively high humidity. There are even light gray precipitate looking like stalactites between the northern and western rocks of the body Their major minerals are calcite, gypsum and clays. The stone lion standing in the southeast and northeast side are alkali granite, while that in the southwest and northwest lithic tuff. Total rock properties of the pagoda are 9,708 pieces, among the all properties, fractured blocks are 11.0%, fall out blocks are 6.7% and covered blocks by precipitates are 7.0%, respectively. The pagoda has highly deteriorated the functions of the rock properties due to physical, chemical and biological weathering, therefore, we suggest that this pagoda has need to do long term monitoring and synthetic conservation researches.

• Journal of the Korea Construction Safety Engineering Association
• /
• s.51
• /
• pp.30-43
• /
• 2010

Yehliu is located at Wanli of Taipei Country with a long cape. Because the rock layer of nearby seashore contains limestone subject to sea erosion, weathering and earth movements, Yehliu is full of seawater-eroded holes as well as numerous rocks in the shape of mushroom, candle, ginger, and chessboard. All these make this 1,700-meter-long cape a geology park with rich ecological resources and a prosperous fishing village. It indicates how the geological features formed by the foundation orogeny and collapsed due to the marine erosion over thousands of years.

• Economic and Environmental Geology
• /
• v.47 no.5
• /
• pp.467-477
• /
• 2014

Naturally occurring asbestos (NOA) occurs in rocks and soils as a result of natural weathering and human activities. The asbestos have been associated with ultramafic and mafic rocks, and carbonate rock. The previous studies on NOA were mainly limited to ultramafic and mafic rock-hosted asbestos in Korea. But, studies on carbonatehosted asbestos are relatively rare. Therefore, the purposes of this study were to investigate mineralogical characteristics of carbonate-hosted and metapelite-hosted NOA and to examine genesis of NOA occurred in the both rocks. The study area was Daerori, Seosan, Chungnam Province, Korea. The major rock formation consisted of limestone and schist which have been known to contain asbestos. Sampling was performed at outcrop which contained carbonate rock showing acicular asbestos crystals as well as pegmatitic intrusion that contacted with carbonate rock. PLM, XRD, EPMA, and EDS analyses were used to characterize mineral assemblages, mineralogical characteristics, and crystal habits of amphiboles and other minerals. BSEM images were also used to examine the genesis of asbestos minerals. The amphibole group was observed in all of the carbonate rocks, and actinolite and tremolite were identified in all rocks. These mineral habits were mainly micro-acicular crystals or secondary asbestiform minerals on the surface of non-asbestiform minerals appearing split end of columnar crystals produced by weathering. BSEM images showed residual textures of samples. The residual textures of carbonate rocks showed dolomite-tremolite-diopside mineral assemblages that formed during prograde metasomatism stage. Some carbonate rock also showed diopside-tremolite-talc mineral assemblages which were formed during retrograde metasomatism stage, as the residual textures. In result the presence of asbestos actinolite-tremolite in the carbonate rocks were confirmed in the areas where actinolite-tremolite asbestos was influenced by low temperature hydrothermal solution during metasomatism stage. These asbestos minerals showed the acicular asbestiform minerals, but even non-asbestiform minerals, a bundle or columnar shape, could transform to asbestiform minerals as potential NOA by weathering because the end of columnar shape of non-asbestiform minerals appeared as multiple acicular shaped fibers.

• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2003.04a
• /
• pp.151-159
• /
• 2003

This study presents method for self-calibration of the SEM(Scanning Electron Microscope) stereo image using the standard microprobe with same grid pattern and using parallel and central perspective projection equation. Result showed that parallel projection method is more suitable for standard microprobe. The maximum error of 3D coordinates acquired by this method did not exceed 5 $\mu\textrm{m}$, and DSM(Digital Surface Model) for three dimensional measurement of the rock sample was generated by the digital photogrammetry. This result can be used for quantification of micro scale change of shape and analysis of the micro morphology of rock due to weathering.