• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.7
• /
• pp.907-913
• /
• 2011

Swirling flows are related to the spiral motion in the tangential direction in addition to the axial and radial direction using several swirl generators. These type of flows are used in combustion chambers to improve flame stability, heat exchanger to enhance heat transfer coefficients, agricultural spraying machines and some vertical pipes to move slurries or transport of materials. However, only a few studies three dimensional velocity profiles in a vertical pipe have been reported. In this present paper, 3 dimension particle image velocimetry(PIV) technique was employed to measure the velocity profiles in water along a vertical circular pipe with Reynolds number from 6000 to 13,000. A tangential inlet condition was used as the swirl generator to produce the required flow. The velocities were measured with swirling flow in the water along the test section using the PIV technique.

• Journal of Biomedical Engineering Research
• /
• v.26 no.2
• /
• pp.95-99
• /
• 2005

We have performed EEG current source imaging on the cortical surface using visual evoked potentials (VEPs) recorded inside a 3.0 T MRI magnet. In order to remove ballistocardiogram (BCG) artifacts in the VEPs, an improved BCG template subtraction technique is devised. Using the cortically constrained current source imaging technique and pattern-reversal visual stimulations, we have obtained current source maps from 10 subjects. To validate the EEG current source imaging inside the magnet, we have compared the current source maps to the ones obtained outside the magnet. The experimental results demonstrate that there is a strong correspondence between the current source maps, proving that current source imaging is feasible with the evoked potentials recorded inside a 3.0 T MRI magnet.

• Proceedings of the KIPE Conference
• /
• 2015.07a
• /
• pp.189-190
• /
• 2015

This paper investigates an economic and highly efficient power converter topology and its modulation scheme for 60kW rapid EV charger system. The target system consists of three-phase three-switch buck-type rectifier topology. A new Carrier Based PWM scheme along with its simple implementation using logic gates is introduced in this paper. This PWM scheme replaces the diode rectifier equivalent switching state with an active switching state producing the effectively same current flowing path. As a result, the distortion of input current during the polarity reversal of capacitor line voltage can be mitigated. The proposed modulation technique is confirmed through simulation verification. The proposed modulation technique and its implementation scheme can expand the operation range of the three-phase three-switch buck-type rectifier having ac input and capacitor ripple current of high quality.

• The Journal of the Acoustical Society of Korea
• /
• v.35 no.3
• /
• pp.167-174
• /
• 2016

Underwater communication is difficult to increase the communication capacity because the carrier frequency is lower than that of radio communications on land. This is limited to the bandwidth of the signal under the influence of the characteristics of an ocean medium. As the high transmission speed and large transmission capacity have become necessary in the limited frequency range, the studies on MIMO (Multiple Input Multiple Output) communication have been actively carried out. The performance of the MIMO communication is lower than that of the SIMO (Single Input Multiple Output) communication because cross-talk occurs due to multiusers along with inter symbol interference resulting from the channel characteristics such as delay spread and doppler spread. Although the adaptive equalizer considering multi-channels is used to mitigate the influence of the cross-talk, the algorithm is normally complicated. In this paper, time reversal mirror technique with the characteristic of a self-equalization will be applied to simplify the compensation algorithm and relieve the cross-talk in order to improve the communication performance when the signal transmitted from two channels is received over interference on one channel in the same time. In addition, the performance of the MIMO communication based on the time reversal mirror is verified using data from the SAVEX15(Shallow-water Acoustic Variability Experiment 2015) conducted at the northern area of East China Sea in May 2015.

• Journal of Fashion Business
• /
• v.25 no.5
• /
• pp.73-87
• /
• 2021

This study aimed to develop fashion designs by applying the PO (Provocative Operation) method as a 3D virtual clothing program and to derive the PO application method in fashion design. The first T-shirt design was presented as an existing thinking method, and the second design was developed by applying escape, reversal, exaggeration, distortion, and hopeful thinking techniques, which are techniques for 'provocation' of the PO method, to the first design. Thus, 18 T-shirt designs were developed as 3D virtual clothing, with 3 sets of 6 designs, including the 1st and 2nd designs. The method of using the 'provocation' techniques of the PO method in the development of fashion design derived from this was as follows. First, the 'escape' technique was designed in such a way that a part of the detail or structure was deleted, or a part of the structure or expression element of another item was applied. Second, the 'inversion' technique was expressed by inverting the position or shape of a detail or structure up, down, left, and right; fitting the structural detail or reversing the shape; or converting the structure and form. Third, the 'exaggeration' technique exaggerated the size, length, and volume of a structure's form or detail. Fourth, the 'distortion' technique was expressed as a distortion of lines or shapes or a visual distortion using the Trompe l'oeil technique. Fifth, the 'hopeful thinking' technique was developed and expressed from the idea of an hypothetical 'if' it was absurd, irrational, and unrealistic.

• The Korean Journal of Physiology and Pharmacology
• /
• v.1 no.6
• /
• pp.741-748
• /
• 1997

In the present study, we have investigated the effect of metabolic inhibition on the inward rectifier K current ($I_{K1}$). Using whole cell patch clamp technique we applied voltage ramp from +80 mV to -140 mV at a holding potential of -30 mV and recorded the whole cell current in single ventricular myocytes isolated from the rabbit heart. The current-voltage relationship showed N-shape (a large inward current and little outward current with a negative slope) which is a characteristic of $I_{K1}$. Application of 0.2 mM dinitrophenol (DNP, an uncoupler of oxidative phosphorylation as a tool for chemical hypoxia) to the bathing solution with the pipette solution containing 5 mM ATP, produced a gradual increase of outward current followed by a gradual decrease of inward current with little change in the reversal potential (-80 mV). The increase of outward current was reversed by glibenclamide ($10\;{\mu}M$), suggesting that it is caused by the activation of $K_{ATP}$. When DNP and glibenclamide were applied at the same time or glibenclamide was pretreated, DNP produced same degree of reduction in the magnitude of the inward current. These results show that metabolic inhibition induces not only the increase of $K_{ATP}$ channel but also the decrease of $I_{K1}$. Perfusing the cell with ATP-free pipette solution induced the changes very similar to those observed using DNP. Long exposure of DNP (30 min) or ATP-free pipette solution produced a marked decrease of both inward and outward current with a significant change in the reversal potential. Above results suggest that the decrease of $I_{K1}$ may contribute to the depolarisation of membrane potential during metabolic inhibition.

• Journal of Korean Neurosurgical Society
• /
• v.29 no.7
• /
• pp.954-958
• /
• 2000

In the removal of small subcortical lesion in the eloquent area like sensory-motor cortex, the prevention of neurologic deficit is important. We present our technique of identification of M-1, S-1 cortex in a case of subcortical granuloma located in sensorymotor cortex. To accurately localize mass, stereotactic craniotomy was planned. At the beginning of procedure, functional MRI of motor cortex was done with stereotactic headframe in place. Next, the stereotactic craniotomy about 4 cm was done under propofol anesthesia for cortical mapping. After reflection of dura, central sulcus was identified with phase-reversal response of intraoperative SEP(somatosensory evoked potential) of contralateral median nerve. Then the patient was awakened, and direct cortical stimulation was done. We observed the muscle contractions of elbow, hand and fingers and the paresthesia over forearm, hand, fingers on the M-1 and S-1 cortex. Through cortical mapping and stereotactic guidance, we concluded that the mass lie immediately posterior to central sulcus, then the mass was carefully removed through small transsulcal approach, opening about 1 cm of rolandic sulcus.

• Clean Technology
• /
• v.23 no.1
• /
• pp.1-14
• /
• 2017

At high nitrate concentrations, water must be treated to meet regulated concentrations because it results in threat to human health and eutrophication of natural water. However, it is almost impossible to remove nitrate by conventional water treatment methods such as coagulation, filtration and precipitation, due to its high water solubility. Therefore, other technologies including adsorption, ion exchange, reverse osmosis, denitrification, and electrodialysis are required to effectively remove nitrate. Each of these technologies has their own strengths and drawbacks and their feasibility is weighted against factors such as cost, water quality improvement, residuals handling, and pre-treatment requirements. An adsorption technique is the most popular and common process because of its cost effectiveness, ease of operation, and simplicity of design. Surface modifications of adsorbents have been enhanced their adsorption of nitrate. The nitrate-selective membrane process of electrodialysis reversal and reverse osmosis have proven over time and at many locations to be highly effective in removing nitrate contaminating problems in aqueous solutions. Both electrodiaysis and reverse osmosis methods generate highly concentrated wastes and need careful consideration with respect to disposal.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.6
• /
• pp.678-686
• /
• 2019

Underwater communication performance is degraded by the influence of Inter-Symbol Interference (ISI) due to multipath. Passive time reversal processing is the most effective technique for mitigating multipath, and the diversity combining method can be used to improve its performance. This paper analyzed communication performance using the beam diversity combining method, which combines signals obtained through the beam steering to various angles. Directions of arrival were estimated through the beam-time migration, which, in turn, was estimated from probe signals received by a vertical line array. The performance was analyzed based on the number and type of combinations among the estimated angles. In this paper, the data obtained from the Biomimetic Long range Acoustic Communications 2018 (BLAC18) experiment, which was conducted in the East sea, ~50 km east of Pohang, in October 2018, were used for the analysis. The output Signal to Noise Ratio (SNR) was used as communication indicators.

• The Research Journal of the Costume Culture
• /
• v.23 no.4
• /
• pp.628-643
• /
• 2015

This study is to assist in developing creative designs based on the humor available in the fashion world of Moschino. For the research method, this writing examined literature on humor and Moschino's fashion world and analyzed Moschino's fashion collection, show window, Maison Moschino, and collaborative products to conduct an empirical analysis of humor shown to the fashion media. The research results are as follows. The humor in Moschino's fashion appeared in the form of surrealistic humor with the depaysement technique, deconstructive wit in clothing, such as distortion, change, or exaggeration, and textual humor, including brand symbols, logos, and graffiti. Collection pieces indicated the brand's confirmative identity based on humor with the surrealistic depaysement technique and deconstructive wit through irregular phenomena, such as change, distortion, exaggeration, and illusion in clothing form. Additionally, such attributes added to Moschino's wit and humor in decorative costume components as graphic images, graffiti, and brand symbols, including smile, love, and reversal. The show window display delivered surprises and smiles through the production of surrealistic space borrowed from various objects. In particular, performance with surrealistic images helped to show the characteristics of parodic humor. Maison Moschino was a surrealistic space for the concept of the fairy tale and for practical experience, thus working as a communication channel for humor and emotion. Collaborative products also clearly reflected the identity of the designer's own humor, which showed scarcity value as well as differentiation.