• Proceedings of the KIPE Conference
• /
• 2019.07a
• /
• pp.285-286
• /
• 2019

본 논문에서는 무선전력전송 시스템 중 보상회로의 구조가 간단하고 정전압 출력특성을 가진 SP보상구조의 보상회로의 설계에 대해 다룬다. 시스템 특성에 따라 능동적으로 효율 및 송수신패드의 사이즈를 증감 시킨 수 있는 알고리즘을 제안하고 이를 2kW급 Prototype 하드웨어에 적용하여 알고리즘의 타당성을 검증한다.

• Proceedings of the KIEE Conference
• /
• 1998.07f
• /
• pp.2067-2069
• /
• 1998

A prototype semiconductor switch for the command resonant charging system has been developed for a line type modulator, which charges parallel pulse forming network(PFN) up to voltage of 5 kV at repetition rates of 60 Hz. A phase controlled power supply provides charging of the 4.7 ${\mu}s$ filter capacitor bank to voltage up to 5 kV. A solid state module of series stack array of sixe matched SCRs(1.6 kV, 50 A) is used as a command charging switch to initiate the resonant charging cycle. Both resistive and RC snubber network are used across each stage of the switch assembly in order to ensure proper voltage division during both steady state and transient condition. A master trigger signal is generated to trigger circuits which are transmitted through pulse transformer to each of the 6 series switch stages. A pulse transformer is required for high voltage trigger or power isolation. This paper will discuss trigger method, protection scheme, circuit simulation, and test result.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.2
• /
• pp.39-46
• /
• 1990

In this paper, Rectangular microstrip patch array antenna. relative current of which is distributed to 1:2:2:1, is designed and fabricated by using Tschebyscheff's polynominal expression and is verified by theoretical analysis and experiment. Seeking for more accurate resonant frequency, an equivlent network, which is consisted including feed line and power distribution line, is analyzed by using the analysis method of transmission line mode. As a result of their comparison and examination, such as resonant frequency by fringing effects, by return loss, by experiment, it is conformed that errors are not barely and agreed with each other. is also agreed with a measured values.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.50 no.8
• /
• pp.376-381
• /
• 2001

The(1-x) MgTiO$_3$-xSrTiO$_3$(x=0.03~0.04) ceramics were fabricated by the conventional mixed oxide method. The structural and microwave dielectric properties were investigated by XRD, SEM, EDS and network analyzer. The sintering temperature and time were 1275$^{\circ}C$~135$0^{\circ}C$ and 2hours, respectively. In the XRD results of 0.96MgTiO$_3$-0.04SrTiO$_3$ceramics, the perovskite structure of SrTiO$_3$and ilmenite structure of MgTiO$_3$phase were coexisted. The dielectric constant($\varepsilon$(sub)${\gamma}$) and temperature coefficient of resonant frequency($\tau$(sub)f) were increased with addition of SrTiO$_3$. In thie case of 0.96MgTiO$_3$-0.04SrTiO$_3$ ceramics sintered at 13$25^{\circ}C$, the dielectric constant, quality factor(Q) and temperature coefficient of resonant frequency($\tau$(sub)f) were 20.13, 7956(at 7.27GHz), and +1.76ppm/$^{\circ}C$, respectively.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.8 no.1
• /
• pp.1-8
• /
• 2003

When solving the problems of electric power quality the converters with high Power factor are useful for the DC arc furnace power supply. In this paper, resonant converters of 50(60) Hz AC to DC arc described, where in each period of network voltage the capacitor and inductor of an oscillatory circuit are switched from series into parallel and vice versa parametrically. The duration of series and parallel connection and also the transformation ratio are dependent on load. Parallel oscillatory circuit restricts the short circuit current. These converters have high power factor from no-load to short-circuit and fit very well to supply are furnaces.

• Proceedings of the KIPE Conference
• /
• 2012.07a
• /
• pp.379-380
• /
• 2012

A bidirectional full-bridge CLLC resonant converter using a digital control method is proposed for a LVDC power distribution system. This converter can operate under high power conversion efficiency since the CLLC resonant network has soft switching capability for primary switches and output rectifiers. In addition, the power conversion efficiency of any directions is exactly the same as each other because of the symmetric structure of the converter. Intelligent digital control methods are proposed to regulate output voltage under any power flow directions. A 5kW prototype converter was designed for a high-frequency galvanic isolation of 380V dc buses using a digital signal processor to verify the performance of the proposed topology and algorithms.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.361-361
• /
• 2000

In the 2-mass system with flexible shaft, a torsional vibration is often generated because of the elastic elements in torque transmission as the newly required speed response which is very close to the primary resonant frequency. This vibration makes it difficult to achieve quick responses of speed and disturbance rejection. In this paper, 2-mass system is designed by using pole placement based on optimal control theory fur fast speed response and torsional vibration elimination and using neural network for disturbance rejection in particular. The simulation results show that the proposed controller based on neural network and full state feedback controller has better performance than 려ll state feedback controller, especially fur disturbance rejection.

• Journal of ILASS-Korea
• /
• v.28 no.3
• /
• pp.119-125
• /
• 2023

In this research, a network model was developed to predict combustion instability in an annular gas turbine combustor (GT24) for power generation. The model consisted of various acoustic elements such as several ducts and area changes which could represent a real combustor with a complex geometry, applied mass, momentum, and energy equations to each element. In addition, a one-dimensional network model through a cylindrical coordinate system has been proposed to predict various acoustic modes. As a result of the analysis, the key resonant frequencies such as longitudinal, circumferential, and complex modes were derived from the EV combustor of GT24, and the reliability of the current model was verified through comparison with the 3D Helmholtz solver.

• Proceedings of the KIPE Conference
• /
• 2016.07a
• /
• pp.221-222
• /
• 2016

본 논문에서는 급변하는 특징을 갖는 부하를 제어하기 위한 병렬부하 공진컨버터의 공진 네트워크를 설계한다. RPG(Remote Plasma Generator)는 플라스마를 생성하기 위한 장치로써 플라스마 발생 전, 후의 부하 조건이 급격하게 달라지는 특징을 갖는다. 이때 플라스마를 발생시키기 위해서는 고전압이 필요하며, 플라스마를 유지하기 위해서는 높은 스위칭 주파수와 일정 크기의 정현파 전류가 필요하다. 이러한 특성을 고려하여 공진 네트워크를 설계하고, 시뮬레이션을 통해 과정의 타당성을 입증한다.

• Proceedings of the KIEE Conference
• /
• 1999.07f
• /
• pp.2695-2697
• /
• 1999

A new three-phase voltage-fed inverter using partial resonant converter with high power factor and high efficiency is proposed. The proposed Flyback converter is constructed by using a resonant network in parallel with the switch of the conventional converter. The devices are switched zero voltage or zero current eliminating the switching loss. This paper introduces elimination of harmonics compared with conventional SPWM inverter and three-phase voltage-fed inverter using Flyback converter.