• Journal of the Korean Ceramic Society
• /
• v.43 no.9 s.292
• /
• pp.582-587
• /
• 2006

Decomposition behavior of $ferro-Si_3N_4$was investigated with varying temperature and holding time in mud components for high temperature refractory applications. Porosities gradually increased with increasing temperature and holding time due to the carbothermal reduction of $Si_3N_4\;and\;SiO_2$. Silicon monoxide (SiO) as a intermediate resulted from evaporation of $Si_3N_4\;and\;SiO_2$ reacted with C sources to generate needle-like ${\beta}-SiC$ and Fe in $Si_3N_4$ acted as a catalyst in order to enhance growth of SiC grain with the preferred orientation. SiC generation yield increased with increasing holding time, all of the $Si_3N_4\;and\;SiO_2$ affected on SiC formation up to 2h. However, SiC generation was only dependent on residual $SiO_2$ over 2h, because the carbothermal reduction reaction of $Si_3N_4$ was no longer possible at that time.

• Journal of the Korean Ceramic Society
• /
• v.17 no.2
• /
• pp.69-74
• /
• 1980

This study deals with the wire content, wire diameter, aspect ratio , it's arrangement of steel, wire fiber and the sorts of castable which affected the character of steel wire fiber reinformced refractory castable. Two kinds of alumina based refractory castables, one is for 1650℃ and the other is for 1800℃, and stainless steel which is SUS 304 type 0.25, 0.34 , 0.37 and 0.50m/min diameter were used respectively. Aspect ratio was adjusted to 50, 75, 100 and steel fiber content was also adjusted to 1-4wt% each. The results of the experiment were as follows : 1. At firing temperature around 1,000℃, MOR is increased with increasing wire content and aspect ratio with decreasing firing temperature, which depends on the Romualdi's Fiber Spacing Theory. But for calculation of the fiber spacing, Swamy equation is more a aplicable to the extensive fiber mixing conditions. However, the condition differs from the above at firing temperature around 1,350℃ ,because of the degradation of wire and the progress of sintering of castable. 2. Linear change is getting larger corresponding to the increase of wire content, and the spaling resistivity is increasing corresponding to the increase of wire content and to aspect ratio, and with decreasing wire diameter. 3. Firing shrinkage under load is getting greater as higher wire content, and the shrinkage of the test pieces which fiber is vertically oriented is getting greater than the test pieces which fiber is randomly oriented.

• Journal of the Korean Ceramic Society
• /
• v.44 no.6 s.301
• /
• pp.331-337
• /
• 2007

High temperature reaction behaviors of various oxide materials (such as bauxite, pyrophyllite, mullite and fused silica powders) used in the refractory materials for tap-hole plugging of blast furnace were investigated with varying temperature in the carbon surrounding. Kinetics of carbothermal reduction of $SiO_2$ for forming SiC with high corrosion resistance were strongly dependent on it's crystalline phase. SiC generation yield increased with increasing catalyst amount in oxide regardless of generated SiO gas amount at temperature of $<1500^{\circ}C$. However, in case of fused silica over $1500^{\circ}C$, SiC generation yield was dominantly influenced by SiO amount without catalyst effect. Bauxite showed the most effective carbothermal reduction reaction, since bauxite have a large amount of catalyst and well-dispersed $SiO_2$ phase in oxide matrix.

• Annals of Clinical Neurophysiology
• /
• v.14 no.2
• /
• pp.59-63
• /
• 2012

Epilepsy has continued to provide challenges to epileptologists, as a significant proportion of patients continue to suffer from seizures despite medical and surgical treatments. Deep brain stimulation (DBS) has emerged as a new therapeutic modality that has the potential to improve quality of life and occasionally be curative for patients with medically refractory epilepsy who are not surgical candidates. Several groups have used DBS in drug-resistant epilepsy cases for which resective surgery cannot be applied. The promising subcortical brain structures are anterior and centromedian nucleus of the thalamus, subthalamic nucleus, and other nuclei to treat epilepsy in light of previous clinical and experimental data. Recently two randomized trials of neurostimulation for controlling refractory epilepsy employed the strategies to stimulate electrodes placed on both anterior thalamic nuclei or near seizure foci in response to electroencephalographically detected epileptiform activity. However, the more large-scale, long-term clinical trials which elucidates optimal stimulation parameters, ideal selection criteria for epilepsy DBS should be performed before long. In order to continue to advance the frontier of this field, it is imperative to have a good grasp of the current body of knowledge.

• The Journal of the Korean dental association
• /
• v.52 no.4
• /
• pp.203-217
• /
• 2014

Bisphosphonates are widely used in the treatment of many medical conditions, such as osteoporosis, multiple myeloma, Paget's disease, etc. However, side effect has been documented in the published data during the past years, osteonecrosis of the jaw in patients receiving long-term bisphosphonate therapy. Although pathogenesis of BRONJ(bisphophonate-related osteonecrosis of the jaw) is not yet fully understood, it is currently known to be a disease associated with suppressed bone turnover by bisphopbonate. Recent literature has indicated a similar association with nonbisphosphonate drugs used in cancer therapy including monoclonal antibodies denosumab and bevacizumab and multikinase inhibitor sunitinib. Accordingly, many studies have been carried out on the biochemical markers examination to assess the risk for BRONJ. The treatment of BRONI is reported with a review of the relevant literature. However, there is still a controversial discussion about the adequate treatment. It is necessary to accumulate further studies in order to establish more useful biochemical markers and effective treatment for BRONJ.

• Journal of the Korean Wood Science and Technology
• /
• v.47 no.6
• /
• pp.667-673
• /
• 2019

The performance of a wooden deck made of refractory materials that have difficulties in achieving target penetrations as stipulated in the specification and quality standards for treated wood in Korea, was assessed via a case study in this research. A wooden deck built in Jinju in 2009 was selected for this study because of its fabrication method using pressure and treated refractory materials. The penetration and retention analysis did not satisfy the domestic standard for treated wood. Inspection of the deck in 2019 revealed that the deck had been attacked by decay fungi. Cap rails showed much deeper and wider checking on their surface compared with the top and base rails, resulting in a severe fungal attack. The decking boards exhibited severe fungal decay primarily in the end parts. However, the rails and balusters without checks and posts were virtually free of fungal attack irrespective of the preservative penetration measures. Copper content in the soil 5 cm away from the deck was less than 150 mg/kg, implying that copper movement in the soil was very limited. These results suggest that the inhibition of surface propagation and the protection of end surfaces are essential factors in increasing the longevity of treated wooden decks; further, the results also showed that the deck was within an acceptable range from the point of copper contamination.

• Computers and Concrete
• /
• v.24 no.1
• /
• pp.19-35
• /
• 2019

In this paper, the effect of the type and amount of fibers on the physicomechanical properties of concrete containing fine recycled refractory brick (RRB) and natural aggregate subjected to elevated temperatures was investigated. For this purpose, forta-ferro (FF), polypropylene (PP), and polyvinyl alcohol (PVA) fibers with the volume fractions of 0, 0.25, and 0.5%, as well as steel fibers with the volume fractions of 0, 0.75, and 1.5% were used in the concrete containing RRB fine aggregate replacing natural sand by 0 and 100%. In total, 162 concrete specimens from 18 different mix designs were prepared and tested in the temperature groups of 23, 400, and $800^{\circ}C$. After experiencing heat, the concrete properties including the compressive strength, ultrasonic pulse velocity (UPV), weight loss, and surface appearance were evaluated and compared with the corresponding results of the reference (unheated) specimens. The results show that using RRB fine aggregate replacing natural fine aggregate by 100% led to an increase in the concrete compressive strength in almost all the mixes, and only in the PVA-containing mixes a decrease in strength was observed. Furthermore, UPV values at $800^{\circ}C$ for all the concrete mixes containing RRB fine aggregate were above those of the natural aggregate concrete specimens. Finally, regarding the compressive strength and UPV results, steel fibers demonstrated a better performance relative to other fiber types.

• Nuclear Engineering and Technology
• /
• v.54 no.6
• /
• pp.1954-1961
• /
• 2022

Lead-based fast reactor (LFR) has become one of the most promising reactors for Generation IV nuclear systems. A developing trend of LFR is high efficiency, along with operation temperatures up to 800 ℃ or even higher. One of key issues in the high-efficiency LFR is corrosion of cladding materials with lead at high temperatures. In this study, corrosion behavior of some refractory metals (Nb, Nb521, and Mo-0.5La) was investigated in static lead at 1000 ℃ for 1000 h. The results showed that Nb and Nb521 exhibited an intense dissolution corrosion with obvious lead penetration after corrosion, and lead penetration extended along the grain boundaries of the specimens. Furthermore, Nb521 showed a better corrosion resistance than that of Nb as a result of the elements of W and Mo included in Nb521. Mo-0.5La showed much better corrosion resistance than that of Nb and Nb521, and no lead penetration could be observed. However, an etched morphology appeared on the surface of Mo-0.5La, indicating the occurrence of corrosion to a certain degree. The results indicate that Mo-0.5La is compatible with lead up to 1000 ℃. While Nb and Nb alloys might be not compatible with lead for high-efficiency LFR at such high temperatures.

• Archives of Plastic Surgery
• /
• v.49 no.3
• /
• pp.365-368
• /
• 2022

Spinal extradural arachnoid cyst (SEAC) is a rare disease and has surgical challenges because of the critical surrounding anatomy. We describe the rare case of a 58-year-old woman who underwent extradural cyst total excision with dural repair and presented with refractory cerebrospinal fluid (CSF) leakage even though two consecutive surgeries including dural defect re-repair and lumbar-peritoneal shunt were performed. The authors covered the sacral defect using bilateral gluteus maximus muscle flap in tongue in groove and wrap around pattern for protection of visible sacral nerve roots and blockage of CSF leakage point. With the flap coverage, the disappearance of cyst and fluid collection was confirmed in the postoperative radiological finding, and the clinical symptoms were significantly improved. By protecting the sacral nerve roots and covering the base of sacral defect, we can minimize the risk of complication and resolve the refractory fluid collection. Our results suggest that the gluteus muscle flap can be a safe and effective option for sacral defect and CSF leakage in extradural cyst or other conditions.

• IMMUNE NETWORK
• /
• v.20 no.1
• /
• pp.7.1-7.11
• /
• 2020

Cancer immunotherapy, in the form of vaccination, adoptive cellular transfer, or immune checkpoint inhibitors, has emerged as a promising practice within the field of oncology. However, despite the developing field's potential to revolutionize cancer treatment, the presence of immunotherapeutic-resistant tumor cells in many patients present a challenge and limitation to these immunotherapies. These cells not only indicate immunotherapeutic resistance, but also show multi-modal resistance to conventional therapies, abnormal metabolism, stemness, and metastasis. How can immunotherapeutic-resistant tumor cells render multi-malignant phenotypes? We reasoned that the immune-refractory phenotype could be associated with multi-malignant phenotypes and that these phenotypes are linked together by a factor that acts as the master regulator. In this review, we discussed the role of the embryonic transcription factor NANOG as a crucial master regulator we named "common factor" in multi-malignant phenotypes and presented strategies to overcome multi-malignancy in immunotherapeutic-resistant cancer by restraining the NANOG-mediated multi-malignant signaling axis. Strategies that blunt the NANOG axis could improve the clinical management of therapy-refractory cancer.