• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.4
• /
• pp.967-975
• /
• 1998

This paper presents a system to cancel the multi-user interference of synchronous DS/CDMA systems by using the estimation circuit and the reference correlator. In the code-division multiple access(CDMA) scheme, the spectrum of the user's signal is directly spreaded by means of the Simplex coed or the phase offsetted PN code. It is interesting for the Simplex code and the PN code to have a similar correalation property. It these codes are used in DS/CDMA systems, the number of acceptable users can be increased in comparison with conventioal DS/CDMA systems. This thesis presents a interference cancellation model to cancel the multi-use interference in DS/CDMA systems by using Simples code of PN code as a spreading sequence. In AWGN environment, we analyze interference generated from other users and compare the resulting performance with that of the conventioanl receiver in same user side.

• 전기의세계
• /
• v.14 no.3
• /
• pp.10-17
• /
• 1965

This paper presents a method of the voltage-reactive power control in the long and short range operations and introduces a conception, "optimum control pattern." The optimum control pattern, aiming at the over-all system control, is defined as the optimum voltage distribution which minimizes the system operating cost under the conditions that the specified power be supplied and the system voltage be kept within the specified bounds. The following procedure was adopted to obtain this optimum pattern. In the first place, a power system was divided into three blocks, namely, load, substation and generator. Lagrange's, multiplier method is applied to each block in turn, paying attention only at the operating voltage distribution. Phase angles at each bus are then modified so that the continuity of active power is maintained. This procedure may be called "block relaxation method with Lagrange's multipliers." In a long range operation, this control pattern determines the optimum installation capacity of reactive power sources. In a short range operation, it also gives the reference state of real time control and the optimum switching capacity of reactive power souces. The real time control problem is also studied from the standpoint of cooperation of control devices such as generators, shunt capacitors, shunt reactors and ratio load controllers. A proposal for the real time control will contribute to the automation of power system operation in the near future. in the near future.

• Journal of electromagnetic engineering and science
• /
• v.11 no.2
• /
• pp.105-112
• /
• 2011

In phase-locked frequency synthesizers, a fast-lock technique is frequently employed to overcome the trade-off between a lock-time and a spurious response. The function of fast-lock in a conventional PLL (Phased Lock Loop) IC (Integrated Circuit) is limited by a factor of 16, which is usually implemented by a scaling of charge pumper, and consequently a lock time improvement of a factor of 4 is possible using the conventional PLL IC. In this paper, we propose a novel external active fast-lock loop filter. The proposed loop filter provides, conceptually, an unlimited scaling of charge pumper current, and can overcome conventional trade-off between lock-time and spur suppression. To demonstrate the validity of our proposed loop-filter, we fabricated an X-band frequency synthesizer using the proposed loop filter. The loop filter in the synthesizer is designed to have a loop bandwidth of 100 kHz in the fast-lock mode and a loop bandwidth of 5 kHz in the normal mode, which corresponds to a charge pumper current change ratio of 400. The X-band synthesizer shows successful performance of a lock-time of below 10 ${\mu}sec$ and reference spur suppression below -64 dBc.

• Journal of Digital Contents Society
• /
• v.10 no.1
• /
• pp.107-113
• /
• 2009

Recently, a number of research efforts have been taken to enhance interoperability and reusability of e-learning contents by developing ADL SCORM 2004 compliant contents. For useful and effective learning contents, content devlopers have to build the strategy of content sequencing in the phase of instructional design. However, many developers have difficulties in understanding the complicated specification of SCORM 2004 S&N(Sequencing&Navigation) and implementing SCORM sequencing. In this paper, we develop SCORM 2004 based best-practice sample contents utilizing SCORM sequencing and thus present a reference guide to the design and implementation of SCORM 2004 contents. It is expected that our sample contents illustrate an effective and useful application of SCORM 2004 as a de-facto e-learning standard, domestically and also internationally.

• Journal of Sensor Science and Technology
• /
• v.16 no.6
• /
• pp.475-483
• /
• 2007

This paper proposes a readout integrated circuit (ROIC) for $32{\times}32$ infrared focal plane array (IRFPA) detector, which consist of reference resistor, detector resistor, reset switch, integrated capacitor and operational amplifier. Proposed ROIC is designed using $0.35{\;}{\mu}m$ 2P-4M (double poly four metal) n-well CMOS process parameters. Low noise folded cascode operational amplifier which is a key element in the ROIC showed 12.8 MHz unity-gain bandwidth and open-gain 89 dB, phase margin $67^{\circ}$, SNR 82 dB. From proposed circuit, we gained output voltage variation ${\Delta}17{\};mV/^{\circ}C$ when the detector resistor varied according to the temperature.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.11
• /
• pp.3371-3381
• /
• 2010

In this study, quantitative and pattern recognition analysis for the quality evaluation of Magnoliae Flos using HPLC/UV was developed. For quantitative analysis, eleven major bioactive lignan compounds were determined. The separation conditions employed for HPLC/UV were optimized using ODS $C_{18}$ column ($250{\times}4.6\;mm$, $5\;{\mu}m$) with isocratic elution of acetonitrile and water with 1% acetic acid as the mobile phase at a flow rate of 1.0 mL/min and a detection wavelength of 278 nm. These methods were fully validated with respect to the linearity, accuracy, precision, recovery, and robustness. The HPLC/UV method was applied successfully to the quantification of eleven major compounds in the extract of Magnoliae Flos. The HPLC analytical method for pattern recognition analysis was validated by repeated analysis of twenty one reference samples corresponding to seven different species of Magnoliae Flos and nine samples purchased from market. The results indicate that the established HPLC/UV method is suitable for the quantitative analysis and quality control of multi-components in Magnoliae Flos.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.8
• /
• pp.1147-1150
• /
• 2004

Hypericin (1,3,4,6,8,13-hexahydroxy-10,11-dimethylphenanthro[1,10,9,8-opqra]perylene-7,14-dione), an antidepressant which is also known to be a potent protein kinase C (PKC) inhibitor was synthesized as a precursor for radioiodine labeling via two step reactions. Malignant glioma cells express higher PKC activity compared to untransformed glial cell. Here we report the synthesis and radioiodine labeling of hypericin as a potential brain tumor imaging radiopharmaceutical. The reference compound, 2-iodohypericin, and its radiolabelled analogues, 2-[$^{123}I$]iodohypericin and 2-[$^{124}I$]iodohypericin have been prepared by the reaction of hypericin with NaI or [$^{123}I$]NaI or [$^{124}I$]NaI. The labeling yield was 60-65% for each analogue and the optimal reaction time was 10 min. The purification and isolation of the labelled products were achieved by a reversed-phase HPLC.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.1
• /
• pp.239-246
• /
• 2011

In this study, quantitative and pattern recognition analysis for the quality evaluation of Cimicifugae Rhizoma using HPLC/UV was developed. For quantitative analysis, three major bioactive phenolic compounds were determined. The separation conditions employed for HPLC/UV were optimized using ODS $C_{18}$ column ($250{\times}4.6mm$, $5{\mu}M$) with isocratic elution of acetonitrile and water with 0.1% phosphoric acid as the mobile phase at a flow rate of 1.0 mL/min and a detection wavelength of 323 nm. These methods were fully validated with respect to the linearity, accuracy, precision, recovery, and robustness. The HPLC/UV method was applied successfully to the quantification of three major compounds in the extract of Cimicifugae Rhizoma. The HPLC analytical method for pattern recognition analysis was validated by repeated analysis of twelve reference samples corresponding to five different species of Cimicifugae Rhizoma and seventeen samples purchased from markets. The results indicate that the established HPLC/UV method is suitable for the quantitative analysis and quality control of multi-components in Cimicifugae Rhizoma.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.6
• /
• pp.1153-1157
• /
• 2004

This paper describes a new programmable DLL_based frequency synthesizer. Generally, PLLs have been used for frequency synthesis. Inherent fast locking DLLs are also used for frequency synthesis. However, DLL needs a frequency multiplier for various frequencies. A conventional frequency multiplier used in DLL has a restriction in which a multiple is fixed. However, the proposed DLL can generate clocks which are from 6 times to 10 times of the reference clock. Frequency range of the proposed DLL is from 600MHz to 1GHz. The idea has been confirmed by HSPICE simulations in a $0.35-\mu\textrm{m}$ CMOS process.

• Transactions on Electrical and Electronic Materials
• /
• v.9 no.3
• /
• pp.123-127
• /
• 2008

The paper is to solve the problem of existing audio signal transfer system which has a difficulties of system organization and the increase of additional install cost and unfriendly interior. To solve the existing system, we drew the new audio signal transfer system based on PLC and evaluated it. A transmitter and a receiver were designed using the PLC chip INT5500CS. An audio signal transfer system was configured with a CD player to which audio signals are sent from the transmitter and a speaker connected to the receiver. For performance evaluation of this system, a USBPre external sound card and Smaart Live 5 which is a PC-based sound measuring program were added. As a result of our experiment, the measured signal level is $2{\sim}3$ dB lower than reference signal, latency is 16.69 ms, and the specific character of coherency is bad in high frequency band. Otherwise, this system transmits and receives signals over 90 % in good condition as a result of measuring pink noise, frequency (1 kHz), and phase, magnitude. In view of the result so far achieved, the system designed this study has excellent performance, it resolves defect of existing audio signal transfer system.