• Journal of Institute of Control, Robotics and Systems
• /
• v.20 no.12
• /
• pp.1231-1237
• /
• 2014

This paper proposes a reduced-order disturbance observer based coordinated tracking controller for uncertain heterogeneous multi-agent systems. To this end, first the control problem is converted as a robust control problem. Then, a dynamic coordinated controller is designed based on the recently proposed reduced-order disturbance observer. Simulation results are given to show the effectiveness of the proposed control scheme.

• 제어로봇시스템학회:학술대회논문집
• /
• 1991.10a
• /
• pp.1-6
• /
• 1991

This paper is concerned with the design of a robust tracking controller using a state observer on a robotic manipulator under the disturbance. The controller is designed to follow a step or ramp reference input without steady state error in the presence of a disturbance and a system parameter variation. In most cases, since all the state vectors are not measured, unmeasurable state vectors must be estimated or reconstructed. A reduced order observer is proposed to estimate unmeasurable state vectors of the non-linear system. Some problems are caused by the Coulomb friction, the disturbance, and the spring effect of a link between the drive motor and the manipulator arm. The state variables, directly measured and estimated by the reduced order observer, are fed back to the controller. When the robot system exhibits the 'limit cycle, the feedback gains initially obtained by optimal control theory are changed. As a result, the limit cycle is eliminated by the new controller gains,

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.4
• /
• pp.652-658
• /
• 2016

In practical control systems differences between nominal and real systems arise from internal uncertainties and/or external disturbances. This paper presents a model-based low-order disturbance observer for a sinusoidal disturbance with unknown constant offset. By using the disturbance model of a biased harmonic signal, the proposed method can successfully estimate the biased sinusoidal disturbance with unknown amplitude and phase but known frequency. At the first stage of the observer design, a model-based disturbance observer is designed when all the system states are measurable. Next, a sufficient condition is presented for the proposed observer to estimate the sinusoidal disturbance with a minimal-order additional dynamics using only output measurement. Comparative computer simulations are performed to test the performance of the proposed method. The simulation results show the enhanced performance of the proposed disturbance observer.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.51 no.9
• /
• pp.515-521
• /
• 2002

This paper presents the scheme that improves control responsibility and stability of the controlled-PM electromagnet levitation system with zero Power controller. A magnetically levitation system is used widely because friction can almost be disappeared. But it is difficult to control due to restraint of controllable area and nonlinear characteristics of electromagnetic force, which is proportioned to a square of the magnetic flux density and is in inverse proportion to a square of the air-gap. So, the application of observer theory in which the levitation system is considered to be a linear dynamic model has resulted in omitting the time dependence on mover's speed. Consequently, the performance of the observer is quite poor during transients. Therefore, this paper proposed the controlled-PM electro-magnetic levitation control method in which the variable load is estimated by using the reduced order extended luenverger observer and its system is controlled at a new zero power equilibrium air-gap position. It is also verified that the proposed control method improve the control performance through simulation and experiment.

• Journal of Advanced Marine Engineering and Technology
• /
• v.32 no.4
• /
• pp.624-629
• /
• 2008

This paper presents a scheme for designing a state observer for container cranes. If the system is completely observable with a given set of outputs, then it is possible to determine the states that are not directly measured. We consider the reduced-order states observer with only trolley position detection and with trolley position and container angle detection. The gain matrix of the each state observer is adjusted using a RCGAs. A set of simulation works is carried out to demonstrate the effectiveness of the proposed scheme.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.7
• /
• pp.1247-1253
• /
• 2008

A design method of a T-S fuzzy model based reduced order nonlinear unknown input observer(NUIO) is presented. The fuzzy NUIO is designed based on the parallel distributed compensation(PDC) concept. It consists of a number of the linear UIOs, each of which is designed for each local linear model in the T-S fuzzy model of a class of nonlinear systems. The fuzzy NUIO provides not only the state estimates insensitive to the unknown inputs, for example, disturbances and faults etc., but also the estimates of the unknown inputs. Therefore, It can be employed in the state feedback control and disturbance rejection control of a class of nonlinear systems with unknown disturbances. It also applied to the robust residual generation for the fault detection and isolation systems and to the design of fault tolerant control systems. As an example, the NUIO is applied to an inverted pendulum system to show the state and disturbance estimation performance and to illustrate the fuzzy reduced order NUIO design method.

• International Journal of Control, Automation, and Systems
• /
• v.6 no.1
• /
• pp.142-148
• /
• 2008

In this paper, we deal with the problem of reducing the order of the detection filter for the linear time-invariant system. Even if the detection filter is generally designed in the form of full order linear observer, we show that it is possible to reduce its order when the response of fault signals is limited to a subspace of the estimation state space. We propose a method to extract the subspace using the observer canonical form considering the dynamics related to the remaining subspace acts as a disturbance. We designed a reduced order detection filter to reject the disturbance as well as to guarantee fault detection and isolation. A simulation result for a 5th order system is presented as an illustrative example of the proposed design method.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.10 no.4
• /
• pp.363-372
• /
• 2005

This paper presents an improved sensorless vector control system for high performance induction motor drives fed by a matrix converter with non-linearity compensation. The nonlinear voltage distortion that is caused by commutation delay and on-state voltage drop in switching devices is corrected by a new matrix converter model. A Reduced Order Extended Luenberger Observer (ROELO) is employed to bring better response in the whole speed operation range and a method to select the observer gain is presented. Experimental results are shown to illustrate the performance of the proposed system.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.52 no.4
• /
• pp.161-166
• /
• 2003

This paper proposes a sensorless vector control of interior permanent magnet synchronous motor(IPMSM) using a reduced order observer. This method introduce the auxiliary control inputs that can eliminate the nonlinear term in the electrical equations and realize the linearization of the motor model. The rotor speed estimate with the observer that needs only the q-axis current. The rotor position calculate using the estimated rotor speed. The speed and position control implement with the estimated value. The validity of the proposed scheme is confirmed by various response characteristics.

• Proceedings of the KIPE Conference
• /
• 1999.07a
• /
• pp.485-488
• /
• 1999

In this paper, a current control system for single phase PWM AC/DC converter without the source voltage sensors is proposed. The sinusoidal input current and unity effective power factor are realised based on the estimated source voltage in the controller. The estimation of source voltage is performed by the reduced-order Luenberger observer using actual currents. The estimated source voltage is used to accomplish unity power factor. The proposed method is proved by experiments.