• Journal of Environmental Science International
• /
• v.20 no.8
• /
• pp.1011-1019
• /
• 2011

The objective of this research is to evaluate optimal conditions of permeability and selectivity on the polysulfone membrane for efficiency of separation of $CH_4$ by checking four factors which are temperature, pressure, gas compositions and gas flow rates. When higher pressure was applied at the input, lower efficiency of recovery of $CH_4$ and higher efficiency of separation of $CH_4$ were shown. It has the tendency to show lower efficiency of recovery of $CH_4$ and higher efficiency of separation of $CH_4$ at the output as higher temperature at input. The lower flow rates make higher efficiency of recovery of $CH_4$ and lower efficiency of separation of $CH_4$. Finally, over 90% efficiency for $CH_4$ separation and recovery conditions are temperature ($-5^{\circ}C$), pressure (8 bar), gas composition rate (6:4) ($CH_4:CO_2$) and gas flow rate ($5\ell$/min). These conditions make higher separation and recovery efficiency such as 90.1% and 92.1%, respectively.

• Journal of Chest Surgery
• /
• v.25 no.11
• /
• pp.1203-1208
• /
• 1992

Current methods of myocardial protection has been improved with cardioplegia and hypothermia. We compared St. Thomas hospital cardiopleic solution without oxygenation[Group I], with oxygenation[Group II] and with oxygenation with filter[Group III] under isolated working heart model. Heart rate recovery was more significantly improved in Group II than Group I after 15 minutes of recovery time [p<0.05]. Maximal systolic pressure shows no difference as it increases with time. Cardiac ouputs were not diffrent between groups. Recovery time was shorter significantly in group II and group III than group I [p<0.05] Use of filter showed no difference. As a conclusion, oxygenated cardioplegic solutions improves ability to protect the heart against ischemia and it is manifested by improved recovery time and heart rate.

• Asian-Australasian Journal of Animal Sciences
• /
• v.14 no.12
• /
• pp.1675-1677
• /
• 2001

The effect of the presence or absence of corpus luteum in the ovaries of slaughtered buffaloes was studied for the oocytes recovery and their subsequent maturation and fertilization in vitro. On an average, 0.41 and 0.67 oocytes per ovary were recovered from ovaries with and without corpus luteum, respectively. Immature oocytes were matured in TCM-199 medium. Significant difference was observed in maturation rate between good (74%) and fair (37%) oocytes. However, there was no significant difference in cleavage rate between the two types. The results of this study show that although the presence of corpus luteum in the ovary at the time of recovery significantly affected availability of total oocytes and in-vitro maturation, but fertilization and cleavage remained unaffected under in vitro conditions.

• Journal of the Korean Society of Tobacco Science
• /
• v.7 no.2
• /
• pp.189-197
• /
• 1985

The purpose of this study is to improve the method and the apparatus for recovering freon-11 used in a process for increasing the filling capacity of tobacco. The first, the theoretical recovery rate of freon-11 was calculated from vapour pressure and thermodynamic properties of freon-11. The second, the usability of theoretical data was evaluated by the comparison between the theoretical data and the experimental data from the pilot plant. The result obtained under the present experiment condition was quite similar to the rate at 15kg/cm2 and 5$^{\circ}C$, but the theoretical data evaluated were 0.1 to 0.3% lower than the experimental data at 20 to 25kg/cm2 and 5$^{\circ}C$. The recovery rate of the cooling and the compression system was about 95% with freon-11 used in this system and that with freon-11 concentrate of waste gas was about 3 to 3.6% at 20 to 25kg/cm2 and 5$^{\circ}C$.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.3
• /
• pp.47-54
• /
• 1996

In this paper we propose a new timing recovery method by means of utilizing service data filling rate instead of timing information of transmitter. A proposed algorithm controls the phase locked loop in the opposite direction ot data filling rate of FIFO in receiver, and it is based on the fact that average of cell jitters is zero. The proposed method is simple compared with timing information method of transmitter. It can be utilized for timing recovery in synchronous digital hierarchy as well as in plesiochronous digial hierarchy without common reference clocks in end-to-end erminals. We implement the interactive video communication system and test the proposed algorithm. As a result, we hav econfirmed that it yields good perfomrnces in terms of jitters characteristics and hardware complexity.

• Journal of Fisheries and Marine Sciences Education
• /
• v.26 no.3
• /
• pp.639-646
• /
• 2014

A heat exchanger using two-phase loop thermosyphons was developed as a waste heat recovery system. An experimental study was carried out on the heat transfer characteristics of two-phase loop thermosyphons heat exchanger and the results from the experiments were used to see the possibility which the two-phase loop thermosyphons could be an alternate solution for waste heat recovery system. In the present work, R134a has been used as the working fluid and the filling rate do working fluid and heat flux have been used as the experimental parameters. The results show that the filling rate of working fluid and heat flux are very important factors for the operation of two-phase loop thermosyphons. The experimental results showed the provisional results as a waste heat recovery system.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.16 no.12
• /
• pp.1197-1203
• /
• 2004

This study investigates the air leakage and heat transfer characteristics of a rotary-type air-to-air heat exchanger with a fiber polyester matrix. The leakage airflow rate is measured using a tracer gas method for various ventilation rates and rotational speeds of the matrix wheel. A correlation equation for air leakage is obtained by combining the pressure leakage and the carryover leakage. The pressure leakage is observed to be a function of ventilation airflow rate only, and the carryover leakage is found to be a linear function of rotational speed. The real efficiency of the heat exchanger can be obtained from its apparent efficiencies by taking into account the air leakage ratio. As the ventilation rate increases, the heat recovery efficiency decreases. As the rotational speed of the matrix increases, the efficiency increases initially but reaches a constant value for the rotational speeds over 10 rpm.

• International Journal of Precision Engineering and Manufacturing
• /
• v.4 no.6
• /
• pp.5-11
• /
• 2003

The number of the enterprises which utilize network technology has been increasing for solving problems such as productivity improvement, market trend analysis, and material collection for making decision. Especially, the management of equipment and the recovery time reduction when machines break down are very important factors in productivity improvement of the enterprise. Currently, most of the remote trouble diagnosis of equipment using the internet have just one function of transmitting the trouble information to the user. Therefore it does not directly reflect the user's recovery experience or the developer's new recovery methods. If the user's experienced recovery methods or the developer's recovery methods as well as the basic recovery methods are reflected online or on the internet, it makes it possible to recover faster than before. In this paper, we develop a Remote Monitoring Server (RMS) for chip mounters, and make it possible to reduce the recovery time by reflecting the user's experience and developer's new methods in addition to presenting the basic recovery methods. For this, trouble recovery concept will be defined. Based on this, many functions(trouble diagnosis, the presentation of the basic recovery methods, user's and developer's recovery method, counting function of the trouble number of each code, and presentation of usage number of each recovery methods) were developed. By utilizing the reports of the actual results of chip mounter and the notice function of the parts change time, the rate of operation of the chip mounter can be improved.

• Proceedings of the KIEE Conference
• /
• 2005.10b
• /
• pp.487-489
• /
• 2005

This paper proposes a symbol timing recovery method that is simple in structure and can provide high speed symbol synchronization. Transmitter and receiver are not synchronized in communication systems using digital modulation. Receiver should search the timing variation of transmitter continuously. The proposed timing recovery method searches sample position by comparing previous sample value with next sample value. This method can be applied to digital and optical transceivers with high data rate.

• ETRI Journal
• /
• v.36 no.6
• /
• pp.1066-1069
• /
• 2014

We propose a lane adaptive recovery scheme for multiple lane faults in a multi-lane-based Ethernet link. In our scheme, when lane faults occur in a link, they are processed not as full link faults but as partial link faults. Our scheme provides a higher link utilization and lower packet loss rate by reusing the available lanes of the link and providing a low recovery time of under a microsecond.