• ETRI Journal
• /
• v.40 no.1
• /
• pp.26-38
• /
• 2018

To overcome considerable path loss in millimeter-wave propagation, high-gain directional beamforming is considered to be a key enabling technology for outdoor 5G mobile networks. Associated with beamforming, this paper investigates propagation power loss characteristics in two aspects. The first is beamwidth effects. Owing to the multipath receiving nature of mobile environments, it is expected that a narrower beamwidth antenna will capture fewer multipath signals, while increasing directivity gain. If we normalize the directivity gain, this narrow-beamwidth reception incurs an additional power loss compared to omnidirectional-antenna power reception. With measurement data collected in an urban area at 28 GHz and 38 GHz, we illustrate the amount of these additional propagation losses as a function of the half-power beamwidth. Secondly, we investigate power losses due to steering beam misalignment, as well as the measurement data. The results show that a small angle misalignment can cause a large power loss. Considering that most standard documents provide omnidirectional antenna path loss characteristics, these results are expected to contribute to mmWave mobile system designs.

• ETRI Journal
• /
• v.33 no.2
• /
• pp.184-193
• /
• 2011

Tailored for wireless local area networks, the present paper proposes a cross-layer resource allocation scheme for multiple-input multiple-output orthogonal frequency-division multiplexing systems. Our cross-layer resource allocation scheme consists of three stages. Firstly, the condition of sharing the subchannel by more than one user is studied. Secondly, the subchannel allocation policy which depends on the data packets' lengths and the admissible combination of users per subchannel is proposed. Finally, the bits and corresponding power are allocated to users based on a greedy algorithm and the data packets' lengths. The analysis and simulation results demonstrate that our proposed scheme not only achieves significant improvement in system throughput and average packet delay compared with conventional schemes but also has low computational complexity.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.2
• /
• pp.277-286
• /
• 2010

In this paper amplitude and phase distortion of the received signal through a fading channel results in a severe performance degradation of the communication system, Therefore we consider the variance of the maximum a posteriori phase estimate of sinusoidal signal by the Cramer-Rao bound in wireless fading channel. To find the Cramer-Rao lower bound for the variance of the phase, We use the derived probability density function(pdf) of the phase in Nakagami fading channel. We analyze the error performance of modulation signals using order statistics on generalized combining reception and find adequate diversity branch number.

• Journal of Korea Multimedia Society
• /
• v.22 no.9
• /
• pp.1011-1019
• /
• 2019

In this paper, we propose a system that can more precisely identify and monitor the position of the tool used in the assembling workplace such as automobile production. The proposed positioning monitoring system is a combination of UWB communication module and MEMS IMU sensor. Since UWB does not need modulation and demodulation function and has low power density, UWB is widely used in indoor positioning field. However, it may cause positioning error due to errors in RF transmission and reception process, which may cause positioning accuracy. Therefore, in this paper, we propose an algorithm that uses IMU as an auxiliary means to compensate for errors that may occur in positioning using only UWB. The tag and anchor of UWB module measure the transmission / reception time by transmitting signals to each other and then estimate the distance between tag and anchor. The MEMS IMU sensor serves to provide positioning calibration information. The tag, which is a mobile node and attached to a moving tool, measures the three-dimensional position of the tool and transfers the coordinate data to the anchor. Thus, it is possible to confirm whether or not the specific tool is properly used according to the prescribed regulations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.8C
• /
• pp.754-761
• /
• 2005

We derive and analyze a bit error rate(BER) expression of a Gray coded rectangular QAM(R-QAM) signal with maximal ratio combining diversity(MRC) reception over Nakagami-n(Rician) fading channels. The derived result is provided in terms of the Whittaker function and the confluent hypergeometric function. In addition, by performance comparison with M-PSK, we see the Nakagami-n fading channel characteristics. Because the derived expression is general, it can readily allow numerical e·valuation for various cases of practical interest such as line-of-sight (LOS) or satellite communication channel analysis.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.6
• /
• pp.11-17
• /
• 2001

Design and implementation of the MAC protocol processor prototype for high speed wireless LAN, which has interface with 5GHz OFDM PHY layer, is presented. We analyze the IEEE 802.11 MAC protocol specification and then separate the MAC protocol functions to be implemented by hardware and firmware and define the interface in which frames can be exchanged. That is, it is considered that high speed queue processing and interfaces with RISC processor and OFDM PHY layer. Protocol control and transmission/reception functions of the MAC functions are implemented in hardware in order to guarantee high speed processing in MAC layer. The developed MAC hardware block operates at 10MHz main clock. Therefore, transmission rate in PHY layer is about 80Mbps because data transmission/reception between MAC layer and PHY layer is performed as unit of octet. The designed FPGA MAC function chip has been implemented in wireless LAN test board and it is verified that DCF function is operated correctly.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.9
• /
• pp.3-11
• /
• 2016

Vehicle to Everything (V2X) communication has been growing to enhance traffic safety by employing advanced wireless communication systems. V2X communication is one core solution for governing and advancing future traffic safety and mobility. In this paper, we design the system level simulator (SLS) of Long Term Evolution (LTE)-based V2X and propose the adaptive transmission scheme for vehicle communication. The proposed scheme allocates the resource randomly in time and frequency domain, and transmit the message according to probability of transmission. The performance analysis is based on freeway case in periodic message transmission. Simulation results show that proposed scheme can improve the cumulative distribution function (CDF) of packet reception ratio (PRR) and average PRR.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.794-796
• /
• 2016

Recently terrestrial mobile multimedia broadcasting(T-DMB) service is being provided throughout the country are expanding and demand is increasing day by day. T-DMB has the advantage of being cheaper in cost than installing another mobile multimedia broadcasting. However, there are a variety data of additional and provide it difficult for localized emergency alert broadcasting services. In this paper, a method to solve this problem feature was designed to restrict incoming unidirectional / bidirectional authentication via T-DMB system. In the mobile device is received by the T-DMB broadcasting service authentication mechanism for re-transmission to the mobile device, and T-DMB receiving other registered users can view it impossible to receive the broadcast. Through the proposed system it is considered to be able to solve the problems of the existing T-DMB technology.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.11A
• /
• pp.1053-1062
• /
• 2008

This paper provides a general and compact expression for the probability density function (pdf) and the moment-generating function (MGF) of the maximal ratio combiner output over Rayleigh fading channels. It is then used to derive closed form expression bit error rate (BER) for M-PSK, M-PAM and M-QAM, respectively. A variety of simulations is performed and shows that they match exactly with analytic ones.

• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.155-156
• /
• 2008

This paper provides a general and compact expression for the probability density function (pdf) and the moment-generating function (MGF) of the maximal ratio combiner output over Rayleigh fading channels. It is then used to derive closed form expression outage probability for repetition code problem. A variety of simulations is performed and shows that they match exactly with analytic ones.