• Journal of The Korean Society For Urban Railway
• /
• v.6 no.4
• /
• pp.383-392
• /
• 2018

This study investigated the change of additional axial stress of rail and reaction force at bridge bearings due to the track-bridge interaction when laying CWR on non-ballasted railway bridges including truss bridges with relatively long span. According to the results of the present study, additional axial stresses of rail and reaction forces at bridge bearings showed a large increase when CWR is installed on the non-ballasted railway bridge. The additional axial stress of rail can be acceptable if sufficient lateral resistance can be obtained. However, if the reaction force increases, there is a risk of damage of the bearing or pier, and therefore, it is necessary to take measures to mitigate the reaction force. It is found that additional axial stress of rail decreases when considering the frictional resistance of the bridge movable support, but its effect on the bearing reaction force is very small. On the other hand, when the longitudinal track restraint decreases, both additional axial stress of rail and bearing reaction force are reduced to a large extent. Also, when the ZLR fastening devices are applied to the region where the additional axial stress of rail is highest, bearing reaction force as well as additional axial stress of rail greatly decreased. Therefore, the application of ZLR fastening devices with the reduction of the longitudinal track restraints is very effective for installing CWR on non-ballasted railway bridges.

• Women's Health Nursing
• /
• v.9 no.3
• /
• pp.224-234
• /
• 2003

Purpose: This study was to test the effects of a full body massage on labor pain and delivery stress reaction for primipara during labor. Method: This study employed a quasi- experimental method(nonequivalent control group, pre-post test design). The subjects of this study were 57 primipara hospitalized at the U OB & GYN hospital in Inchon from November 1. 2001 to July 31, 2002. 28 women were assigned to the experimental group and 29 to the control group. The experimental group was given 20 minutes full body massage for each of three delivery phases. The control group was given conventional delivery care. The levels of labor pain were measured by the Visual Analogue Scale and the expression scores of the labor pain and the levels of delivery stress reaction were measured by pulse rate, respiration rate, and blood pressure, and State-Anxiety Scale. Data were analyzed using the repeated measures analysis of covariance(ANCOVA), t-test, $X^2$- test, simple ANCOVA with SPSS program. Result: There was no interaction effect between time and group(F=.370, p=.693), but significant time effects were found for subjective labor pain(F=3.840, p=.028). There was no interaction effect between time and group(F=.112, p=.894), but significant group effects were found for objective labor pain(F=12.299, p=.001). There was no interaction effect between time and group for PR(F=.172, p=.843), RR(F=.626, p=.539), SBP(F=.089, p=.915), DBP(F=.748, p=.479), but significant group effects were found for SBP(F=7.547, p=.008). The level of status anxiety of the experimental group was significantly lower than the control group(F=11.787, p=.001). Conclusion: This study showed that the full body massage has partially positive effect on labor pain and delivery stress reaction. Therefore this study suggested that the full body massage might be used clinically to help primipara during labor.

• Journal of environmental and Sanitary engineering
• /
• v.6 no.2
• /
• pp.59-68
• /
• 1991

The word of stress was wsed in the field of physics as a external force from 17th century, but the meaning of this stress had chafed to the internal and exteral demand fort the human body in medical area. All the stumulants which make stress was called as j stressor. When animals get stress blucose excreted from liver to adapt for the emergent state ant some related hormone secrete convert protein and lipid to glucose for the purpose of energy supply to muscle. As a results heart rate, blood pressure, respiration rate are increased and musclse are strengthed. These physiolgical reactions ate controlled by autonomic nerve system under the control of hyothalamus in brain. Autonomic nerve system and endocrinary system are react harmoiously to stress reaction. According to the stress reaction, adrenomedullary system are stimulated, and epinephrine, morepinephrine are exceted. Author experimented the effect of the immobilizational stress to rat by analyzing the variaition of catecholamine secrction, the Na concentration and the effect of the antistresf effect by Panax Ginseng which is a traditional Korean herb medicine. The concentration of the norepinephrine, epinephrin, and dopamin in normal rat are 1 578 ng/ml, 0.365 ng/ml, and 0.731 ng/ml respectively, but in the immobilyzed stress groIn the concentration were increased to 1.915 ng.ml, 0.854 ng/ml, and 2,361 ng/ml which she the high show the higher concentration of catecholamine to stressor.

• Journal of the Korean Academy of Child and Adolescent Psychiatry
• /
• v.26 no.4
• /
• pp.266-272
• /
• 2015

Objectives : This study examined the impact of peer's suicide on mental health of middle-school students. The aim of this study was to describe the course of posttraumatic stress and grief reaction, suicide ideation, and depression score among adolescents after exposure to peer's suicide and to examine the relationship between posttraumatic stress and other mental health scores in these subjects. Methods : Thirty seven middle school students who were exposed to the suicidal death of a peer completed self-report measures to assess levels of depression, grief reaction, post-traumatic stress, and suicide ideation at 1 month and 8 months after the peer's suicide. Results : There was no significant change in mental health scores between 1 month and 8 months. Level of posttraumatic stress after 8 months was related to acute grief response. Subjects who experienced a clinically significant level of suicidal ideation and posttraumatic stress showed more mental health problems. Conclusion : The results suggested that peer's suicide strongly impacted mental health issues of adolescents at a critical time of adolescent development. Clinicians should perform a thorough evaluation of mental health problems for youth who experienced peer's suicide and help them in management of their grief reaction.

• Korean Journal of Metals and Materials
• /
• v.49 no.6
• /
• pp.462-467
• /
• 2011

In order to understand why annealing at $480^{\circ}C$ for several hour prevents the initiation of PWSCC, the residual stress variation with isothermal annealing at $480^{\circ}C$ and isochronal annealing between 480 and $800^{\circ}C$ in cold rolled Alloy 600 was investigated by the XRD method. The isothermal annealing decreased residual stress slightly in the rolling direction but not in the transverse direction, whereas the isochronal annealing for two hours increased residual stress. It seemed that the decrease in residual stress by isothermal annealing was due to lattice contraction by an ordering reaction because the isothermal annealing increased hardness. The effects of the isochronal annealing could be interpreted as the influence of thermal expansion and a disordering reaction.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.05a
• /
• pp.1195-1201
• /
• 2002

Researches on the FRF-based substructuring method have been mainly focused on vibratory response analysis. Present study Is concerned about the application of the method to the dynamic stress analysis of a air-conditioner compressor mounting bracket in a passenger car. This is performed by using reaction forces that can be obtained by the FRF-based substructuring method. The air-conditioner system, composed of a compressor and bracket, Is analyzed by using the FRF-based substructuring method. The experimental and numerical FRFs are combined to calculate the system responses and reaction forces at the connection point. The dynamic reaction forces plugged into the bracket FE model to compute the stresses of the bracket Dynamic strains by the present method are compared with those from strain-gage test for bracket system on shaker. The comparison shows possibility of practical usage of the method for the real problem

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2001.10a
• /
• pp.513-516
• /
• 2001

Water stress measurements of rice that use spectral reflection characteristics have been conducted to detect a water stress of rice during growing stage. Water stress reaction was measured using a spectroradiometer in the wavelength range from 300nm to 1100nm. In order to maintain all the experimental conditions, the measurement time have been settled at a fixed solar radiation times. Spectral reflectance were measured as a function of the moisture content. The results indicate that the spectral reflectance of rice was dependent on moisture content. As the moisture content is lowered the spectral reflectance of rice formed in NIR wavelength range increased. This effect can be best explained in terms of water stress.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.2
• /
• pp.45-50
• /
• 2005

To improve mean-life and reliability of power cable, in this study, we have investigated electrical properties and stress-strain showing by changing the content of carbon black that is semiconductive additives for underground power transmission. Specimens were made of sheet form with the nine of specimens for measurement. Volume resistivity of specimens was measured by volume resistivity meter after 10 minutes in the pre-heated oven of both 25±1 [℃] and 90±1 [℃]. And stress-strain of specimens was measured by TENSOMETER 2000. A speed of measurement was 200[mm/min], ranges of stress and strain were 400[Kgf/㎠] and 600[%]. In addition tests of stress-strain were progressed by aging specimens in air oven. From this experimental results, volume resistivity was high according to increasing the content of carbon black. And yield stress was increased, while strain was decreased according to increasing the content of carbon black. And stress-strain were decreased some after aging because of oxidation reaction of chemical defect. We could know EEA was excellent more than other specimens from above experimental results.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.6
• /
• pp.33-42
• /
• 2002

Ground reaction curve is a very important information for evaluating the side wall displacements and installation time of the tunnle support. The ground reaction curve can be estimated by analytical closed form solutions derived on the supposition of circular section and isotropic stress condition. The conditions of stress field and tunnel configurations, however, are quite different in practice. Therefore, it is necessary to investigate the effects of stress anisotropy and tunnel configurations in order to use simply in practical design. This paper describes a study of influence factors in the ground reaction curve. In order to evaluate the applicability of analytical closed form solution in practical design, two sets of parametric studies were carried out by numerical analysis in elastic tunnel behaviour: one set of studies investigated the influence of the K and the other set investigated the influence of the tunnel configurations such as circular and horse-shoe shape. In the studies, K value varies between 0.5 and 3.0, initial ground vertical stress varies between 5～30MPa far each K values. The results indicated that the self-supportability of ground is larger in the ground having lower K value. However, it is suggested that the applicability of closed form solution may not be adequate to determine directly the installation time of the support and self-supportability of ground. It is necessary to consider stress anisotropy and tunnel configurations.

• Journal of Ocean Engineering and Technology
• /
• v.13 no.1 s.31
• /
• pp.94-104
• /
• 1999

In order to evaluate the performance of axially of laterally loaded piles experimentaly, pile load tests can be carried out at the site Otherwise stress analyses or subgrade reaction analyses can solve the problem. In this study, stress analysis using FLAC code and subgrade reaction analyses using load transfer curves recommended by API(1993) were performed consistently on the basis of a result of site investigations, and the result of analyses was compared with the measured. As a result the behavior of pile heads was analyzed accurately for both axially and laterally loaded tests. Furthermore axially transferred loads were calculated appropriately for the measured and axial loads were transferred mainly mainly by the frictional resistance rather than by the tip resistance. Consequently, it can be commented that both analysis methods of soil-pile systems are applicable at teh objective site and that solutions may be more accurate if material properties from the site investigation are more explicit.