• Asian Journal of Turfgrass Science
• /
• v.24 no.2
• /
• pp.199-204
• /
• 2010

Much of the coal ash by thermal power plant has gradually been increased, however researches on the recycling of bottom ash has not been investigated enough so far. In this research, the lysimeter test was conducted to find out the possibilities of bottom ash as soil amendment to improve the physiochemical properties of sandy topsoil of turfgrass in golf course. The turfgrass growth test and leaching test were conducted on the lysimeter. The lysimeter columns were manufactured with various topsoil mixing ratios of 0, 10, 20, 30, and 50% of bottom ash with sand. As a result of leachate analysis through the lysimeter column, the higher ratios of bottom ash mixed affect significantly on water holding capacity of topsoil sand media with decreasing of the percolation rate. The results of leachate analysis in every three days interval, the pH of leachate increased with the bottom ash ratios, but the volume of $NO_3$-N, $NH_4$-N and K decreased significantly. However, the level of EC of leachate had constantly maintained. These results indicate that the application of bottom ash may improve turfgrass growth with water holding capability and fertility of sandy topsoil. However, the negative effects of the bottom ash also evaluated by reducing water permeability and solubility of $PO_4$-P by adsorption into soil particles. The results indicates that the reasonable mixing ratio of the bottom ash as soil amendment should be less than 20% (v/v) with sand which has a low water-holding and fertility in golf course topsoil layers.

• Journal of Korean Society of Environmental Engineers
• /
• v.39 no.4
• /
• pp.194-200
• /
• 2017

On-site Algae Collecting System (OACS) is one of urgent countermeasures to clean the raw water when the algae blooms severely. Rapid reaction capability, high efficiency and large capacity are required when applying OACS to large water areas. The total performance of OACS are always determined by unit process named Flotation, Trapping and Collection. The working efficiency and daily treatment quantity of OACS can be increased when it runs automatically. As the rapid development of OACS technology, in the first place, equipment are miniaturized and simple. And in the second place, automation process from Trapping to Collection are advanced. So, They produce results higher working efficiency, smaller residual sludge on treated water, system's advanced environmental friendly features and the increased amount of sludge by Collection process to achieve large capacity. Now OACS has overcome the algae multiplication rate to ensured the amount of removal algae. In another aspect, it is high economically feasible because of reducing operation cost against the large capacity.

• Microbiology and Biotechnology Letters
• /
• v.34 no.2
• /
• pp.174-179
• /
• 2006

Bacterium capable of using biphenyl as a sole source of carbon and energy were isolated from soil, and based on the results of 16S rDNA sequence, strain BK10 identified as a Sphingobium yanoiktiyae. The optimum cultural conditions were as follows; $NH_4NO_3$ 1g, $K_2HPO_4$ 1g, $MgSO_4{\cdot}7H_2O$ 0.5g, $CaCO_3$ 0.2 g per 1 liter of distilled water. The Sphingobium yanoikuyae BK10 strain was completely utilized biphenyl in mineral salt media containing biphenyl at concentration 500 $\mu$g/ml of biphenyl as a sole carbon and energy source within 48 hours. Optimumal pH and temperature for biphenyl degradation and cell growth of strains were 6.0$\sim$8.0 and 20$\sim$50$^{\circ}C$, respectively. Especially, at 30$^{\circ}C$, cell-growth were higher than other temperature. Cell grown on biphenyl has been shown to have a higher removal rate for biphenyl than grown on sucrose. This study shows that Sphingobium yanoikuyae BK10 strain had a high biodegradation capability of biphenyl and can be simulate a candidate compounds the bioremediation of PCBs (Polychlorinated biphenyl) contaminant soil and water.

• Journal of Korea Technology Innovation Society
• /
• v.19 no.4
• /
• pp.799-821
• /
• 2016

Unmanned Aerial Vehicles (UAVs) are essential systems for Intelligence, Surveillance, and Reconnaissance (ISR) operations in current battlespace. And its importance will be getting extended because of complexity and uncertainty of battlespace. In this study, we forecast the advancement of 96 UAVs during the period of 32 years from 1982 to 2014 using TFDEA. TFDEA is a quantitative technology forecasting method which is characterized as non-parametric and non-statistical mathematical programming. Inman et al. (2006) showed that TFDEA is more accurate in forecasting compared with classical econometrics (e.g. regression). This study got 4.06% point of annual technological rate of change (RoC) for UAVs by applying TFDEA. And most UAVs in the period are inefficient according to the global SOA frontiers. That is because the countries which develop UAVs are in the middle class of technological level, so more than 60% of world UAVs markets are shared by North America and Europe which are advanced countries in terms of technological maturity level. This study could give some insights for UAVs development and its advancement. And also can be used for evaluating the adequacy of Required Operational Capability (ROC) of suggested future systems and managing the progress of Research and Development (R&D).

• Korean Chemical Engineering Research
• /
• v.54 no.6
• /
• pp.746-752
• /
• 2016

In this study, soft carbon was prepared by carbonization of carbon precursor (pitch) obtained from PFO (pyrolysis fuel oil) heat treatment. Three carbon precursors prepared by the thermal reaction were 3903 (at $390^{\circ}C$ for 3 h), 4001 (at $400^{\circ}C$ for 1 h) and 4002 (at $400^{\circ}C$ for 2 h). After the prepared soft carbon was ground to a particle size of $25{\sim}35^{\circ}C$, the soft carbon was synthesised by the chemical treatment with boric acid ($H_3BO_3$). The prepared soft carbon were analysed by XRD, FE-SEM and XPS. Also, the electrochemical performances of soft carbon were investigated by constant current charge/discharge test, cyclic voltammetry and impedance tests in the electrolyte of $LiPF_6$ dissolved inorganic solvents (EC:DMC=1:1 vol%+VC 3 wt%). The coin cell using soft carbon of $25{\sim}35^{\circ}C$ with 3903 soft carbon ($H_3BO_3$/Pitch=3:100 in weight) has better initial capacity and efficiency (330 mAh/g, 82%) than those of other coin cells. Also, it was found that the retention rate capability of 2C/0.1C was 90% after 30 cycles.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4A
• /
• pp.352-360
• /
• 2008

Recently Task Group (TG) 4 of the Institute of Electrical and Electronics Engineers (IEEE) 802.15a has been recommended a system with ranging capability in existence of multiple Simultaneous operating piconets (SOPs) as well as low-cost, low-power. According to the ranging service, coherent and non-coherent based ranging schemes using ternary code have been adopted as a standard. However it is hard to estimate an accurate time of arrival (TOA) in case of using direct sequence based TOA estimation method because pulse repetition interval (PRI) offered by TG is more limited than the maximum excess delay (MED) of channel. To mitigate inter pulse interference (IPI) problem, this paper proposes a non-coherent TOA estimation scheme using non-periodic transmission (NPT) pattern. The proposed receiver is based on a non-coherent energy detection considering with motivation of low rate wireless personal area network (LR-WPAN). TOA information is estimated via proper comparison with a prescribed threshold after the sliding correlation and search back window (SBW) process for reducing TOA error. To verify the performance of proposed ranging scheme, two distinct channel models approved by IEEE 802.15.4a TG are considered. According to the simulation results, we could conclude that the proposed scheme have performed better performance than the conventional method on the existence of multiple SOPs.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.4
• /
• pp.29-39
• /
• 2009

The need for radio spectrum is recently considered as a huge hurdle towards the rapid development of wireless networks. Large parts of the spectrum are allocated to licensed radio services in proprietary way. However, enormous success of the wireless services and technologies in the unlicensed bands has brought new ideas and innovations. In recent years cognitive radio has gained much attention for solving the spectrum scarcity problem. It changes the way spectrum is regulated so that more efficient spectrum utilization is possible. Multi-hop relay technology on the other hand has intensively been studied in the area of ad hoc and peer-to-peer networks. But in cellular network, only recently the integration of multi-hop capability is considered to enhance the performance significantly. Multi-hop relaying can extend the coverage of the cell to provide high data rate service to a greater distance and in the shadowed regions. Very few papers still exist that combine these methods to maximize the spectrum utilization. Thus we propose a network architecture combining these two technologies in a way to maximize the system throughput. We present the throughput capacity equations for the proposed system model considering various system parameters like utilization factor by the primary users and primary users' transmission radius and through extensive numerical simulations we analyze the significance of work.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.1
• /
• pp.16-24
• /
• 2011

The sound speed of seawater can be calculated by the empirical formula as a function of temperature, salinity and pressure. It is little affected by salinity because the average salinity is 34 psu and varies within a few psu seasonally and spatially in the ocean. Recently, low-salinity water of 24 psu flows into the western sea area of Jeju Island due to the flood of the Yangtze River in China during summer, affecting sound speed profile. In this paper, it was analyzed how environmental changes affected to the underwater communication - the sound speed of low-salinity water was calculated, and the communication channel was estimated by the simulated acoustic rays while the transmitting and receiving depth and the range were varied with and without the low-salinity layer. And The BER (Bit error rate) was calculated by BPSK(Binary phase shift key) modulation and the effects of the low-salinity water on the BER was investigated. The sound speed profile was changed to have positive slope by the low-salinity layer at the sub-surface up to 20 m of depth, forming acoustic wave propagation channel at the sub-surface resulting in the decrease of most of the BER Consequently, this paper suggests that it is important to consider changes of the ocean environment for correctly analyzing the underwater communication and the detection capability.

• Journal of the Korean Electrochemical Society
• /
• v.19 no.3
• /
• pp.63-68
• /
• 2016

$Li_4Ti_5O_{12}$ is prepared through a solid-state reaction between anatase $TiO_2$ and $Li_2CO_3$ for the negative electrode active materials in quick-charging lithium-ion batteries. The small amount of carbon black (0, 0.5, 1.0, and 3.0 wt%) is added for the reduction of powder agglomeration during heat-treatment. As the amount of the added carbon black increases, the tap density of $Li_4Ti_5O_{12}$ powder gradually decreases. Furthermore, the $Li_4Ti_5O_{12}$ powder prepared with 1.0 wt% of carbon black shows the highest sieved fraction at the powder classification by 325 mesh standard sieve. The $Li_4Ti_5O_{12}$ powders with various contents of carbon black are almost same at the rate capability for the negative electrode materials in lithium-ion batteries.

• Journal of the Korean Electrochemical Society
• /
• v.15 no.1
• /
• pp.27-34
• /
• 2012

$Li_3V_2(PO_4)_3$/carbon composite materials are synthesized from a sucrose-containing precursor. Amorphous $Li_3V_2(PO_4)_3/C$ (a-LVP/C) and crystalline $Li_3V_2(PO_4)_3/C$ (c-LVP/C) are obtained by calcining at $600^{\circ}C$ and $800^{\circ}C$, respectrively, and electrochemical performance as the negative electrode for lithium secondary batteries is compared for two samples. The a-LVP electrode shows much larger reversible capacity than c-LVP, which is ascribed to the spatial $Li^+$ channels and flexible structure of amorphous material. In addition, this electrode shows an excellent rate capability, which can be accounted for by the facilitated $Li^+$ diffusion through the defect sites. The sloping voltage profile is another advantageous feature for easy SOC (state of charge) estimation.